Fei Xiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fei Xiao has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Jilong Liu
National Key Laboratory of Electromagnetic Energy, Naval University of Engineering, Wuhan, China
3 shared publications - Shun Li
School of Electrical and Electronic Engineering, Huazhong University of Science and Technology, Wuhan, China
2 shared publications - Wei Kang
National Key Laboratory of Science and Technology on Vessel Integrated Power System, Naval University of Engineering, Wuhan 430033, China
2 shared publications - Xinsheng Zhang
National Key Laboratory of Electromagnetic Energy, Naval University of Engineering, Wuhan, China
2 shared publications - Yalu Mu
School of Electrical Engineering, Southeast University, Nanjing, China
2 shared publications - Yaxiang Fan
National Key Laboratory of Science and Technology on Vessel Integrated Power System, Naval University of Engineering, Wuhan, China
2 shared publications
Latest Publications
- 19 May 2024
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 19 (8) , 5075-5089
Research of Sensorless Control Method for PMSM Based on Specific Voltage Feed-forward Decoupling
- 19 May 2024
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 19 (8) , 5075-5089
Research of Sensorless Control Method for PMSM Based on Specific Voltage Feed-forward Decoupling
- 29 November 2023
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 19 (4) , 2323-2336
Optimization of Sensorless Control Performance for a Low-Switching Frequency Permanent Magnet Synchronous Motor Drive System
- 29 November 2023
- Published by Springer Nature in Journal of Electrical Engineering & Technology
- Vol. 19 (4) , 2323-2336
Optimization of Sensorless Control Performance for a Low-Switching Frequency Permanent Magnet Synchronous Motor Drive System
- Open Access
Minimum-Output-Current-Ripple Control of Current-Fed Three-Level Phase-Shift Full-Bridge Converter
Electrified ports using medium-voltage DC (MVDC) renewable energy microgrids require current-fed dc/dc converters in application scenarios such as battery or ultracapacitor charging units and hydrogen production systems. This paper designs a three-level phase-shift full-bridge (TL-PSFB) converter that interfaces with the MVDC microgrid. Its operation in the current source mode requires a wide output voltage range and small output current ripple. Firstly, the dual-output TL-PSFB topology is introduced, and the principle of phase-shift pulse width modulation (PS-PWM) is presented. Secondly, the principle of the traditional constant-conduction-duty-cycle (CCDC) strategy is analyzed. Then, a minimum-output-current-ripple (MOCR) strategy is proposed by analyzing the relationship between output current ripple, conducting-duty cycle, and phase-shift duty cycle, and a constant current control combined with the MOCR strategy is designed. The output current ripple of the MOCR strategy is smaller than that of the CCDC strategy in a full range of operating conditions. Under the same output current ripple design index, the value and loss of the filter inductor can be reduced with the MOCR strategy. In addition, the MOCR strategy can widen the output voltage regulation range and increase the bus voltage utilization without causing significant changes to the total harmonic distortion (THD) of primary voltage. Finally, experimental results verify the correctness of the theoretical analysis.
Open AccessMinimum-Output-Current-Ripple Control of Current-Fed Three-Level Phase-Shift Full-Bridge Converter
Electrified ports using medium-voltage DC (MVDC) renewable energy microgrids require current-fed dc/dc converters in application scenarios such as battery or ultracapacitor charging units and hydrogen production systems. This paper designs a three-level phase-shift full-bridge (TL-PSFB) converter that interfaces with the MVDC microgrid. Its operation in the current source mode requires a wide output voltage range and small output current ripple. Firstly, the dual-output TL-PSFB topology is introduced, and the principle of phase-shift pulse width modulation (PS-PWM) is presented. Secondly, the principle of the traditional constant-conduction-duty-cycle (CCDC) strategy is analyzed. Then, a minimum-output-current-ripple (MOCR) strategy is proposed by analyzing the relationship between output current ripple, conducting-duty cycle, and phase-shift duty cycle, and a constant current control combined with the MOCR strategy is designed. The output current ripple of the MOCR strategy is smaller than that of the CCDC strategy in a full range of operating conditions. Under the same output current ripple design index, the value and loss of the filter inductor can be reduced with the MOCR strategy. In addition, the MOCR strategy can widen the output voltage regulation range and increase the bus voltage utilization without causing significant changes to the total harmonic distortion (THD) of primary voltage. Finally, experimental results verify the correctness of the theoretical analysis.
- Open Access
Modeling and Design of High-Power Enhanced Leakage-Inductance-Integrated Medium-Frequency Transformers for DAB Converters
For dual active bridge (DAB) converters, integrating the phase-shifting inductance (PSI) in the medium-frequency transformer (MFT) is an effective way to improve the overall power density. Different from the existing leakage-inductance-integrated (LII) structure, a concentric-winding (CW) enhanced leakage-inductance-integrated (ELII) structure, which includes an additional core, is proposed in this paper. In order to explain the operating mode of CW ELII MFT, a magnetic circuit model is established, and the analysis is carried out under the typical DAB excitation. The total leakage inductance of CW ELII MFT is divided into the winding leakage inductance and the additional leakage inductance for calculation. The integrated structure makes the heat dissipation of the MFT challenging. Therefore, the air–water combined cooling method is adopted in the design. A thermal resistance model is built for the winding air channel under forced convection. On this basis, MFT designs with different integration structures for different leakage inductance requirements are compared. Finally, a 200 kW/4 kHz/200 μH MFT prototype was designed and manufactured, which achieved the power density of 5.16 kW/dm3 and the efficiency of 99.30%. The prototype was tested in a DAB converter, which is a module of a 2 MW modular multilevel converter-bidirectional DC–DC converter (MMC-BDC).
Open AccessModeling and Design of High-Power Enhanced Leakage-Inductance-Integrated Medium-Frequency Transformers for DAB Converters
For dual active bridge (DAB) converters, integrating the phase-shifting inductance (PSI) in the medium-frequency transformer (MFT) is an effective way to improve the overall power density. Different from the existing leakage-inductance-integrated (LII) structure, a concentric-winding (CW) enhanced leakage-inductance-integrated (ELII) structure, which includes an additional core, is proposed in this paper. In order to explain the operating mode of CW ELII MFT, a magnetic circuit model is established, and the analysis is carried out under the typical DAB excitation. The total leakage inductance of CW ELII MFT is divided into the winding leakage inductance and the additional leakage inductance for calculation. The integrated structure makes the heat dissipation of the MFT challenging. Therefore, the air–water combined cooling method is adopted in the design. A thermal resistance model is built for the winding air channel under forced convection. On this basis, MFT designs with different integration structures for different leakage inductance requirements are compared. Finally, a 200 kW/4 kHz/200 μH MFT prototype was designed and manufactured, which achieved the power density of 5.16 kW/dm3 and the efficiency of 99.30%. The prototype was tested in a DAB converter, which is a module of a 2 MW modular multilevel converter-bidirectional DC–DC converter (MMC-BDC).
- 12 September 2021
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 41 (2) , 994-1018
Detecting Anomalies in Videos using Perception Generative Adversarial Network
- 12 September 2021
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 41 (2) , 994-1018
Detecting Anomalies in Videos using Perception Generative Adversarial Network
- Open Access
Lyapunov-Function-Based Feedback Linearization Control Strategy of Modular Multilevel Converter–Bidirectional DC–DC Converter for Vessel Integrated Power Systems
The modular multilevel converter–bidirectional DC–DC converter (MMC–BDC) has been proposed to be utilized in the vessel integrated power system to interconnect the medium voltage bus and the distributed energy storage elements. In the shipboard applications, MMC–BDC faces unbalanced sub-module power operation because of the inconsistent state-of-charge (SOC) of the energy storage elements. Researchers have investigated into the unbalanced operation principle of MMC–BDC and proposed some unbalanced operation control strategies, but these traditional strategies do not perform well in both aspects of operating range and efficiency. Therefore, this paper proposes a novel Lyapunov-function-based feedback linearization control strategy for the independent sub-module voltage control of MMC–BDC, which not only shows wide unbalanced operation range and high efficiency, but also realizes the decoupling and symmetrical control of the sub-module capacitor voltages.
Open AccessLyapunov-Function-Based Feedback Linearization Control Strategy of Modular Multilevel Converter–Bidirectional DC–DC Converter for Vessel Integrated Power Systems
The modular multilevel converter–bidirectional DC–DC converter (MMC–BDC) has been proposed to be utilized in the vessel integrated power system to interconnect the medium voltage bus and the distributed energy storage elements. In the shipboard applications, MMC–BDC faces unbalanced sub-module power operation because of the inconsistent state-of-charge (SOC) of the energy storage elements. Researchers have investigated into the unbalanced operation principle of MMC–BDC and proposed some unbalanced operation control strategies, but these traditional strategies do not perform well in both aspects of operating range and efficiency. Therefore, this paper proposes a novel Lyapunov-function-based feedback linearization control strategy for the independent sub-module voltage control of MMC–BDC, which not only shows wide unbalanced operation range and high efficiency, but also realizes the decoupling and symmetrical control of the sub-module capacitor voltages.
- 1 March 2020
- Published by Springer Nature in Journal of Power Electronics
- Vol. 20 (2) , 428-442
Model analysis, simplified control and sensitivity verification of modular multilevel DC-DC converter with parallel branches
- 1 March 2020
- Published by Springer Nature in Journal of Power Electronics
- Vol. 20 (2) , 428-442
Model analysis, simplified control and sensitivity verification of modular multilevel DC-DC converter with parallel branches
- Open Access
An Approach to State of Charge Estimation of Lithium-Ion Batteries Based on Recurrent Neural Networks with Gated Recurrent Unit
State of charge (SOC) represents the amount of electricity stored and is calculated and used by battery management systems (BMSs). However, SOC cannot be observed directly, and SOC estimation is a challenging task due to the battery’s nonlinear characteristics when operating in complex conditions. In this paper, based on the new advanced deep learning techniques, a SOC estimation approach for Lithium-ion batteries using a recurrent neural network with gated recurrent unit (GRU-RNN) is introduced where observable variables such as voltage, current, and temperature are directly mapped to SOC estimation. The proposed technique requires no model or knowledge of the battery’s internal parameters and is able to estimate SOC at various temperatures by using a single set of self-learned network parameters. The proposed method is evaluated on two public datasets of vehicle drive cycles and another high rate pulse discharge condition dataset with mean absolute errors (MAEs) of 0.86%, 1.75%, and 1.05%. Experiment results show that the proposed method is accurate and robust.
Open AccessAn Approach to State of Charge Estimation of Lithium-Ion Batteries Based on Recurrent Neural Networks with Gated Recurrent Unit
State of charge (SOC) represents the amount of electricity stored and is calculated and used by battery management systems (BMSs). However, SOC cannot be observed directly, and SOC estimation is a challenging task due to the battery’s nonlinear characteristics when operating in complex conditions. In this paper, based on the new advanced deep learning techniques, a SOC estimation approach for Lithium-ion batteries using a recurrent neural network with gated recurrent unit (GRU-RNN) is introduced where observable variables such as voltage, current, and temperature are directly mapped to SOC estimation. The proposed technique requires no model or knowledge of the battery’s internal parameters and is able to estimate SOC at various temperatures by using a single set of self-learned network parameters. The proposed method is evaluated on two public datasets of vehicle drive cycles and another high rate pulse discharge condition dataset with mean absolute errors (MAEs) of 0.86%, 1.75%, and 1.05%. Experiment results show that the proposed method is accurate and robust.
- 1 November 2015
- Published by Elsevier in ISA Transactions
- Vol. 59, 443-449
Current harmonics elimination control method for six-phase PM synchronous motor drives
- 1 November 2015
- Published by Elsevier in ISA Transactions
- Vol. 59, 443-449
Current harmonics elimination control method for six-phase PM synchronous motor drives
- Open Access
- 1 March 2013
- Published by Institution of Engineering and Technology (IET) in IET Electric Power Applications
- Vol. 7 (3) , 199-206
Sensorless control of high‐power interior permanent‐magnet synchronous motor drives at very low speed
A novel sensorless control scheme is proposed for an interior permanent‐magnet synchronous motor drives at very low speed based on sliding‐mode observer (SMO) in this study, which substitutes a sigmoid function for the sign or saturation function with a variable boundary layer, overcomes the time delay caused by the low‐pass filter and the chattering problem used in the conventional SMO. In this study, an adaptive SMO is employed to estimate the rotor speed and extended electromotive force, a three‐phase soft phase‐locked loop technology is used to estimate rotor position because of its strong robustness since under voltage phase unbalance or polluted and variable‐frequency environment. The global asymptotic stability of the proposed adaptive SMO is verified using Lyapunov stability analysis with considering motor parameter variations. Experimental results are presented to verify the principles and to demonstrate the effectiveness of the proposed method at very low speed from 2 to 17 r/min.
- 1 March 2013
- Published by Institution of Engineering and Technology (IET) in IET Electric Power Applications
- Vol. 7 (3) , 199-206
Open AccessSensorless control of high‐power interior permanent‐magnet synchronous motor drives at very low speed
A novel sensorless control scheme is proposed for an interior permanent‐magnet synchronous motor drives at very low speed based on sliding‐mode observer (SMO) in this study, which substitutes a sigmoid function for the sign or saturation function with a variable boundary layer, overcomes the time delay caused by the low‐pass filter and the chattering problem used in the conventional SMO. In this study, an adaptive SMO is employed to estimate the rotor speed and extended electromotive force, a three‐phase soft phase‐locked loop technology is used to estimate rotor position because of its strong robustness since under voltage phase unbalance or polluted and variable‐frequency environment. The global asymptotic stability of the proposed adaptive SMO is verified using Lyapunov stability analysis with considering motor parameter variations. Experimental results are presented to verify the principles and to demonstrate the effectiveness of the proposed method at very low speed from 2 to 17 r/min.