Yidong Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yidong Zhang has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Zhenwei Dong
College of Chemical and Materials Engineering, Xuchang University, Xuchang, P.R. China
5 shared publicationsLei Zhao
School of Electronic and Information Engineering, Lanzhou City University, Lanzhou, P.R. China
4 shared publicationsZhi Zheng
Key Laboratory of Micro-Nano Materials for Energy Storage and Conversion of Henan Province, Institute of Surface Micro and Nano Materials, Xuchang University, Xuchang 461000, PR China
4 shared publicationsHuimin Jia
College of Chemical and Materials Engineering, Xuchang University, Xuchang, People’s Republic of China
3 shared publicationsChengqun Yu
Chinese Academy of Sciences
2 shared publicationsChuncai Pan
College of Urban Planning & Environment Science, Xuchang University, Xuchang, Henan Province, 461000, P. R. China
2 shared publications
Latest Publications
- 14 May 2026
- Published by Springer Nature in Applied Physics A
- Vol. 132 (6) , 503
Highly sensitive and selective ethanol gas sensor based on ZnO nanosheets: the effect of grain boundary potential barrier
- 14 May 2026
- Published by Springer Nature in Applied Physics A
- Vol. 132 (6) , 503
Highly sensitive and selective ethanol gas sensor based on ZnO nanosheets: the effect of grain boundary potential barrier
- 10 February 2025
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 48 (1) , 1-10
Enhanced NiO-based gas sensing performance to ethanol: the case of polyvinylidene fluoride
- 10 February 2025
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 48 (1) , 1-10
Enhanced NiO-based gas sensing performance to ethanol: the case of polyvinylidene fluoride
- 1 September 2023
- Published by Springer Nature in Applied Physics A
- Vol. 129 (9) , 1-10
Enhanced gas sensing performance to ethanol of ZnO based on Ag modification by a simple solid-state reaction method
- 1 September 2023
- Published by Springer Nature in Applied Physics A
- Vol. 129 (9) , 1-10
Enhanced gas sensing performance to ethanol of ZnO based on Ag modification by a simple solid-state reaction method
- 27 August 2023
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 46 (3) , 1-7
Preparation of ZnO nanorod-based gas sensor and its ethanol gas sensing performance
- 27 August 2023
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 46 (3) , 1-7
Preparation of ZnO nanorod-based gas sensor and its ethanol gas sensing performance
- 21 January 2022
- Published by Wiley in Surface and Interface Analysis
- Vol. 54 (6) , 600-606
Study on the nanoscale current of ZnO film by photoassisted peak force tunnel atomic force: A novel technique for UV detection
ZnO film‐based ultraviolet (UV) detector was fabricated by photoassisted peak force tunnel atomic force (PFTUNA) on fluorine tin oxide (FTO) substrate. The PFTUNA current in dark and in UV light was ~0.1 and 2.0 nA, respectively. The UV sensitivity (photocurrent/dark current) is more than 20. The response time and the recovery time are ~0.12 and 0.32 s, respectively. The UV sensing mechanism is that the holes will transport to the ZnO surface to capture the adsorbed oxygen ions to weaken the depletion layer under UV illumination. The PFTUNA current between the tip and the ZnO film is consistent with the Richardson–Schottky (RS) thermionic emission model.
- 21 January 2022
- Published by Wiley in Surface and Interface Analysis
- Vol. 54 (6) , 600-606
Study on the nanoscale current of ZnO film by photoassisted peak force tunnel atomic force: A novel technique for UV detection
ZnO film‐based ultraviolet (UV) detector was fabricated by photoassisted peak force tunnel atomic force (PFTUNA) on fluorine tin oxide (FTO) substrate. The PFTUNA current in dark and in UV light was ~0.1 and 2.0 nA, respectively. The UV sensitivity (photocurrent/dark current) is more than 20. The response time and the recovery time are ~0.12 and 0.32 s, respectively. The UV sensing mechanism is that the holes will transport to the ZnO surface to capture the adsorbed oxygen ions to weaken the depletion layer under UV illumination. The PFTUNA current between the tip and the ZnO film is consistent with the Richardson–Schottky (RS) thermionic emission model.
- 7 October 2019
- Published by Emerald Publishing in Microelectronics International
- Vol. 36 (4) , 160-164
Observation of the enhanced tunnel current of NiO thin films in grain boundary by peakforce TUNA
Purpose: The purpose of this paper is to investigate the nanoscale electric performance of NiO thin films in grain boundary and grain face. Design/methodology/approach: PeakForce tunnel atomic force is applied to visualize the nanoscale current imaging of the NiO thin film on fluorine tin oxide substrate. Findings: The results show that the grain boundary has a significant impact on the nanoscale current of the NiO film. The electronic conductivity and in grain boundary is higher than that of the NiO film in grain face. The width of the conductive zone in the NiO film over grain boundaries is ∼ 60 nm. The tunnel current between the tip and the NiO film is consistent with the Fowler–Nordheim tunnel model. Originality/value: The higher tunnel current in grain boundary is probably attributed to the enhanced energy band bending and adhesion force.
- 7 October 2019
- Published by Emerald Publishing in Microelectronics International
- Vol. 36 (4) , 160-164
Observation of the enhanced tunnel current of NiO thin films in grain boundary by peakforce TUNA
Purpose: The purpose of this paper is to investigate the nanoscale electric performance of NiO thin films in grain boundary and grain face. Design/methodology/approach: PeakForce tunnel atomic force is applied to visualize the nanoscale current imaging of the NiO thin film on fluorine tin oxide substrate. Findings: The results show that the grain boundary has a significant impact on the nanoscale current of the NiO film. The electronic conductivity and in grain boundary is higher than that of the NiO film in grain face. The width of the conductive zone in the NiO film over grain boundaries is ∼ 60 nm. The tunnel current between the tip and the NiO film is consistent with the Fowler–Nordheim tunnel model. Originality/value: The higher tunnel current in grain boundary is probably attributed to the enhanced energy band bending and adhesion force.
- 29 April 2019
- Published by Springer Nature in Journal of Materials Research
- Vol. 34 (16) , 2757-2764
Enhanced electroluminescence performance of all-inorganic quantum dot light-emitting diodes: A promising candidate for hole transport layer of Cu-doped NiO nanocrystals
- 29 April 2019
- Published by Springer Nature in Journal of Materials Research
- Vol. 34 (16) , 2757-2764
Enhanced electroluminescence performance of all-inorganic quantum dot light-emitting diodes: A promising candidate for hole transport layer of Cu-doped NiO nanocrystals
- 25 February 2016
- Published by Taylor & Francis in Synthesis and Reactivity in Inorganic, Metal-Organic, and Nano-Metal Chemistry
- Vol. 46 (10) , 1565-1570
The First Observation of Ni and Ni2O3Phases in the Sol-Gel Ag-Doped NiO Film
In this work, Ag-doped NiO film was prepared by a simple sol-gel method using the Ni (Ac)2. 4H2O and AgNO3 as precursor. The prepared films have been studied by X-ray diffraction (XRD), atomic force microscopy, X-ray photoelectron spectroscopy, and UV-visible spectrophotometer. Differently, some Ni or Ni3+ phases were found in the final films compared with previous reports. On the low concentration of Ag doping (1.5 mol%), the Ag-doped NiO film had formed the solid solution. The obvious phase separation was observed when the concentration of Ag dopant reached to 10% (mol).
- 25 February 2016
- Published by Taylor & Francis in Synthesis and Reactivity in Inorganic, Metal-Organic, and Nano-Metal Chemistry
- Vol. 46 (10) , 1565-1570
The First Observation of Ni and Ni2O3Phases in the Sol-Gel Ag-Doped NiO Film
In this work, Ag-doped NiO film was prepared by a simple sol-gel method using the Ni (Ac)2. 4H2O and AgNO3 as precursor. The prepared films have been studied by X-ray diffraction (XRD), atomic force microscopy, X-ray photoelectron spectroscopy, and UV-visible spectrophotometer. Differently, some Ni or Ni3+ phases were found in the final films compared with previous reports. On the low concentration of Ag doping (1.5 mol%), the Ag-doped NiO film had formed the solid solution. The obvious phase separation was observed when the concentration of Ag dopant reached to 10% (mol).