JWJ. Weiße

J. Weiße

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


J. Weiße has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Simulation Study of Electronic Device Designs for the Control of SiC Color Centers as Spin Qubits

    by Fabian J. Magerl, Christophe Pixius, Julietta Förthner, Patrick Berwian, Eberhard Bär, Jörg Schulze

    Point defects in 4H silicon carbide (4H-SiC), such as the silicon vacancy, also known as color centers, offer considerable potential for quantum applications in the fields of quantum sensing as well as computing and communication. The latter two necessitate indistinguishable photons for entanglement swapping and consequently demand precise control over the electronic transition energies, i.e. emission and absorption wavelengths of color centers. One way to achieve this is through monolithic integration of electronic devices in combination with integrated photonics in 4H-SiC. This is considered a potential pathway for scalable quantum photonic integrated circuits. In this paper, we investigate the suitability of a signal-ground-modulator and a vertical pin diode in combination with a waveguide to (i) achieve local field strengths of 5 to 20 MV/m in the crystal’s c-direction, (ii) stabilize the charge state of the silicon vacancy by controlling the local Fermi level, (iii) meet the requirements for photonic single-mode operation, and (iv) minimize the absorption of the evanescent wave due to metal contacts. The findings of the electronic and optical simulations conducted with Synopsys Sentaurus and Ansys Lumerical suggest that the signal-ground-modulator, commonly used in integrated photonics, rarely attains the requisite field strength. In contrast, the vertical pin diode has the potential to meet these requirements even at reduced bias voltages. Furthermore, the intrinsic layer of the diode offers a wide region in which to host the color center in its optically active, negatively charged state.

  • Deeper insight into lifetime-engineering in 4H-SiC by ion implantation

    by J. Erlekampf, B. Kallinger, J. Weiße, M. Rommel, P. Berwian, J. Friedrich, T. Erlbacher

    Lifetime-engineering in 4H-SiC is important to obtain a low forward voltage drop in bipolar devices with high blocking voltages above 10 kV. It is known that the implantation of carbon and subsequent thermal annealing can be used to improve the minority carrier lifetime of as-grown epitaxial layers due to annihilation of carbon vacancies and, therefore, reduce the lifetime limiting defect Z 1 / 2 . In this paper, the ion implantation of other ions (N, Al, B, and As) besides carbon and their impact on minority carrier lifetime and point defect concentration are shown. Special attention is paid to the effect of ion implantation with subsequent electrical activation by high temperature annealing. A strong influence of the implantation dose and, therefore, corresponding resulting doping concentration was found. A lifetime enhancement could be found for some implanted species for higher implantation doses whereas the detrimental effect of high temperature annealing dominated at low implantation doses. The results reveal that the implantation dose and the occupied lattice sites are important parameters to achieve a lifetime enhancement. A model is presented which explains the different impacts of various implanted ions and a more detailed understanding of lifetime-engineering by ion implantation. With this knowledge, it was possible to reduce the detrimental Z 1 / 2 defect in a large part of thick epitaxial layers with conventional shallow ion implantation and high temperature annealing. Consequently, the minority carrier lifetimes of the epitaxial layers could be enhanced.


  • Open Access

    Aluminum acceptor activation and charge compensation in implanted p-type 4H-SiC

    by J. Weiße, M. Hauck, M. Krieger, A. J. Bauer, T. Erlbacher

    In 4H silicon carbide, aluminum implantation causes unusual high compensation ratios as obtained from Hall effect investigations by fitting the neutrality equation with a single acceptor. We show that this approach cannot fully describe the experimental data, in particular in case of moderate doping and at high measurement temperatures above 450 K. We develop two extended models by adding an additional acceptor- or donor-like defect to the equation. Both approaches describe the data well. However, it turns out that an additional aluminum-correlated acceptor is the more reasonable choice. In this case, the compensation ratio stays almost independent of the implantation dose between 30 % and 40 %. The deep acceptor is located at EV + (280400) meV.