Boris Dortschy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Boris Dortschy has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Aldebaro Klautau
UFPA
3 shared publications - Alireza Samani
Department of Electrical and Computer Engineering, McGill University, Montreal, Quebec Canada H3A 0E9
1 shared publication - Behrooz Makki
Ericsson Research, Ericsson, Gothenburg, Sweden
1 shared publication - Charitha Madapatha
Department of Electrical Engineering Chalmers University of Technology Gothenburg Sweden
1 shared publication - Danilo Zanatta Filho
School of Electrical and Computer Engineering, University of Campinas - UNICAMP
1 shared publication David Patel
Department of Electrical and Computer Engineering, McGill University, Montreal, Quebec, H3A 0E9, Canada
1 shared publication
Latest Publications
- Open Access
A Comparison between Network-Controlled Repeaters and Reconfigurable Intelligent Surfaces
Network-controlled repeater (NCR) has been recently considered as a study-item in 3GPP Release 18, and the discussions are continuing in a work-item. In this paper, we introduce the concept of NCRs, as a possible low-complexity device to support for network densification and compare the performance of the NCRs with those achieved by reconfigurable intelligent surfaces (RISs). The results are presented for the cases with different beamforming methods and hardware impairment models of the RIS. Moreover, we introduce the objectives of the 3GPP Release 18 NCR work-item and study the effect of different parameters on the performance of NCR-assisted networks. As we show, with a proper deployment, the presence of NCRs/RISs can improve the network performance considerably.
Open AccessA Comparison between Network-Controlled Repeaters and Reconfigurable Intelligent Surfaces
Network-controlled repeater (NCR) has been recently considered as a study-item in 3GPP Release 18, and the discussions are continuing in a work-item. In this paper, we introduce the concept of NCRs, as a possible low-complexity device to support for network densification and compare the performance of the NCRs with those achieved by reconfigurable intelligent surfaces (RISs). The results are presented for the cases with different beamforming methods and hardware impairment models of the RIS. Moreover, we introduce the objectives of the 3GPP Release 18 NCR work-item and study the effect of different parameters on the performance of NCR-assisted networks. As we show, with a proper deployment, the presence of NCRs/RISs can improve the network performance considerably.
- 14 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 24 (9) , 2034-2037
SNR-Based Pre-Emphasis for Transmission of Frequency-Multiplexed Radio Signals in Fronthaul
We propose an SNR estimation procedure for systems that transmit frequency-multiplexed analog signals in a channel. It is agnostic to the type of radio signal transmitted, can be performed without increasing the required bandwidth, and without interrupting the transmission of the signals. We simulate the transmission of frequency-multiplexed OFDM signals in an optical channel with intensity modulation of the laser and direct detection, where we show the accuracy of the estimation comparing the estimated SNR to the analytical SNR of the channel. We also evaluate the performance by applying the estimated SNR to derive a pre-emphasis used to transmit the signals. In a first evaluation scenario, the OFDM signals transmitted at higher carrier frequencies without pre-emphasis present lower SNR because of the channel response. In contrast, in a second scenario, all the signals present very close SNR due to the pre-emphasis deployed, which could allow optimizing signal transmission by maximizing the minimum SNR at the channel output.
- 14 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 24 (9) , 2034-2037
SNR-Based Pre-Emphasis for Transmission of Frequency-Multiplexed Radio Signals in Fronthaul
We propose an SNR estimation procedure for systems that transmit frequency-multiplexed analog signals in a channel. It is agnostic to the type of radio signal transmitted, can be performed without increasing the required bandwidth, and without interrupting the transmission of the signals. We simulate the transmission of frequency-multiplexed OFDM signals in an optical channel with intensity modulation of the laser and direct detection, where we show the accuracy of the estimation comparing the estimated SNR to the analytical SNR of the channel. We also evaluate the performance by applying the estimated SNR to derive a pre-emphasis used to transmit the signals. In a first evaluation scenario, the OFDM signals transmitted at higher carrier frequencies without pre-emphasis present lower SNR because of the channel response. In contrast, in a second scenario, all the signals present very close SNR due to the pre-emphasis deployed, which could allow optimizing signal transmission by maximizing the minimum SNR at the channel output.
- 2 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 31 (10) , 799-802
25 and 50 Gb/s/${{\lambda}}$ PAM-4 Transmission Over 43 and 21 km Using a Simplified Coherent Receiver on SOI
We demonstrate 25 and 50 Gb/s four-level pulse amplitude modulation (PAM-4) transmission over 43 and 21 km standard single mode fiber (SMF), respectively using a silicon photonic 120° hybrid based integrated simplified coherent receiver in the C-band. The integrated receiver is composed of an edge coupler, a vertical grating coupler, a polarization splitterrotator, a 3×3 multimode interference coupler based 120° hybrid and three germanium p-i-n photodetectors. For 25 Gb/s PAM- 4 transmission, we achieved receiver sensitivities of -18, -17.5, -16.6, -14.5, and -9.8 dBm in back-to-back (B2B) and after 10.5, 21, 31, and 43 km, respectively at a bit error rate (BER) below the hard-decision forward error correction (HD-FEC) threshold (i.e., 3.8 × 10–3) without using any receiver equalizer. While for the 50 Gb/s PAM-4 transmission, receiver sensitivities of - 13.6 dBm in B2B, -13.5 and -11.6 dBm after 10.5 and 21 km are obtained using 31-tap linear feed-forward equalizer (FFE). Furthermore, we achieved up to 44 Gb/s receiver equalizerfree PAM-4 transmission over 10.5 km below the HD-FEC. The characterization of the receiver at different wavelengths within the C-band is provided as well.
- 2 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 31 (10) , 799-802
25 and 50 Gb/s/${{\lambda}}$ PAM-4 Transmission Over 43 and 21 km Using a Simplified Coherent Receiver on SOI
We demonstrate 25 and 50 Gb/s four-level pulse amplitude modulation (PAM-4) transmission over 43 and 21 km standard single mode fiber (SMF), respectively using a silicon photonic 120° hybrid based integrated simplified coherent receiver in the C-band. The integrated receiver is composed of an edge coupler, a vertical grating coupler, a polarization splitterrotator, a 3×3 multimode interference coupler based 120° hybrid and three germanium p-i-n photodetectors. For 25 Gb/s PAM- 4 transmission, we achieved receiver sensitivities of -18, -17.5, -16.6, -14.5, and -9.8 dBm in back-to-back (B2B) and after 10.5, 21, 31, and 43 km, respectively at a bit error rate (BER) below the hard-decision forward error correction (HD-FEC) threshold (i.e., 3.8 × 10–3) without using any receiver equalizer. While for the 50 Gb/s PAM-4 transmission, receiver sensitivities of - 13.6 dBm in B2B, -13.5 and -11.6 dBm after 10.5 and 21 km are obtained using 31-tap linear feed-forward equalizer (FFE). Furthermore, we achieved up to 44 Gb/s receiver equalizerfree PAM-4 transmission over 10.5 km below the HD-FEC. The characterization of the receiver at different wavelengths within the C-band is provided as well.
- 1 March 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1395-1399
Optimal solution for the fixed margin problem in digital subscriber lines
Digital Subscriber Lines (DSL) are today one of the most important means for delivering high-speed data transmission. Dynamic Spectrum Management (DSM) is an emerging technique for dealing with crosstalk, one of the technology's most harmful problems. DSM judiciously designs users' power spectral densities so that the overall system performance is improved. This works aims at presenting a new insight in one of the most popular DSM schemes, the OSB. OSB is adapted to the Fixed Margin problem associated with DSL transmission. The result, presented and analyzed in this paper, is an algorithm that is able to operate in the whole area of feasible points in the rate region for a given DSL service. The algorithm is designed to use the minimum amount of power to serve a given set of rates in the system, an approach which saves power by using it more cleverly and is much closer to current market demands.
- 1 March 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1395-1399
Optimal solution for the fixed margin problem in digital subscriber lines
Digital Subscriber Lines (DSL) are today one of the most important means for delivering high-speed data transmission. Dynamic Spectrum Management (DSM) is an emerging technique for dealing with crosstalk, one of the technology's most harmful problems. DSM judiciously designs users' power spectral densities so that the overall system performance is improved. This works aims at presenting a new insight in one of the most popular DSM schemes, the OSB. OSB is adapted to the Fixed Margin problem associated with DSL transmission. The result, presented and analyzed in this paper, is an algorithm that is able to operate in the whole area of feasible points in the rate region for a given DSL service. The algorithm is designed to use the minimum amount of power to serve a given set of rates in the system, an approach which saves power by using it more cleverly and is much closer to current market demands.
- 1 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, III-353-III-356
Bit Loading for Precoded DSL Systems
Crosstalk is one of the main impairments of digital subscriber line (DSL) systems. To combat this impairment, several techniques were proposed in the literature that employ some form of precoding in the downstream. However, most existing bit allocation algorithms are not applicable to precoded DSL systems when the power in each transmission line is constrained. In this paper, we propose a bit allocation algorithm for this scenario. The proposed algorithm maximizes the bit rate given the available power. It somewhat extends single-user algorithms in that it sequentially allocates bit to the "best" user and tone. In the proposed algorithm we use a definition of "best" that is suitable for precoded systems. Simulation results show that the proposed algorithm achieves almost the same rates as those of power allocation algorithms, which do not take into account the discrete nature of the transmitted information.
- 1 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, III-353-III-356
Bit Loading for Precoded DSL Systems
Crosstalk is one of the main impairments of digital subscriber line (DSL) systems. To combat this impairment, several techniques were proposed in the literature that employ some form of precoding in the downstream. However, most existing bit allocation algorithms are not applicable to precoded DSL systems when the power in each transmission line is constrained. In this paper, we propose a bit allocation algorithm for this scenario. The proposed algorithm maximizes the bit rate given the available power. It somewhat extends single-user algorithms in that it sequentially allocates bit to the "best" user and tone. In the proposed algorithm we use a definition of "best" that is suitable for precoded systems. Simulation results show that the proposed algorithm achieves almost the same rates as those of power allocation algorithms, which do not take into account the discrete nature of the transmitted information.
- Open Access
- p. 2092-2096
DSM performance on practical DSL systems based on estimated crosstalk channel information
- p. 2092-2096
Open AccessDSM performance on practical DSL systems based on estimated crosstalk channel information