JHJianquan Hu

Jianquan Hu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jianquan Hu has a total of 29 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A 2.1–49.8-GHz Distributed Amplifier With Gain-Compensating Techniques

    by Jianquan Hu, Changzi Xie, Dawei Zhang, Shixiong Liang, Yi Wu, Ming Yin, Kaixue Ma

    In this letter, an ultrabroadband distributed amplifier (DA), fabricated by using 0.25- $\mu $ m GaAs E/D-mode pseudomorphic high electron-mobility transistor (pHEMT) process with $f_{T}$ of 57GHz and extending the operation frequency up to 49.8GHz, is presented. To alleviate the gain roll-off of DA at high operation frequency caused by the parasitic parameters of transistors and the losses of artificial transmission lines, a gain cell with a signal path to compensate the gain is proposed. Measurement results show that the DA using the proposed gain cell features an 8.1-dB average gain in the frequency range from 2.1 to 49.8GHz, a typical group delay of 58ps, and a peak OP ${}_{\mathrm {1 dB}}$ of 14dBm. Integrated the biasing circuit on chip, the implemented DA occupies a chip area of $1.3\times 1.5$ mm including test pads.

  • A High-Efficiency Class-F PA Utilizing Parasitic Compensation Based on Metal-Integrated Suspended Line (MISL) Platform

    by Peiyi Yu, Yongqiang Wang, Jianquan Hu, Kaixue Ma

    This letter presents the first demonstration of a high-efficiency Class-F power amplifier (PA) implemented on a metal-integrated suspended line (MISL) platform. To mitigate the detrimental effects of parasitic elements inherent in the transistor, a compensation network designed from the device’s parasitic model is integrated. This approach enables precise harmonic impedance control at the intrinsic current source plane, thereby enhancing design flexibility and improving PA performance. Experimental results show that the proposed MISL-based Class-F PA achieves a peak power gain of 11.7 dB and a peak drain efficiency (DE) of 79% within the 3.2–3.4-GHz band. These results highlight the potential of MISL technology for PA applications, offering the advantages of low loss, good heat dissipation, and self-packaging.


  • Co-Design of a K -Band Phase Shifter With Low RMS Phase/Amplitude Errors for SATCOM Applications

    by Jianquan Hu, Dawei Zhang, Changzi Xie, Quanyuan Feng, Kaixue Ma

    In this letter, a 16–23-GHz active vector-summing phase shifter (VSPS), achieving a 360° phase-shifting range with a 6-bit resolution, is presented for low-Earth-orbit (LEO) satellite communication (SATCOM) applications. An improved in-phase/quadrature signal generator of quadrature all-pass filter (QAF) is proposed by the introduction of a compensation capacitor while several gain-enhancement techniques are deployed on the buffer amplifier to enhance the gain flatness. By taking several measures, the flat gain response, low gain variation, and low phase error for all phase shifting states are thereby achieved. Fabricated by using 130-nm RF CMOS SOI process, the implemented VSPS features from −8.8- to −7.9-dB average insertion gain with a maximum gain variation of ±1 dB for a specific frequency across the 64 states in the frequency range from 16 to 23 GHz. The measured total root-mean-square (rms) gain and phase errors are better than 0.51 dB and 2.9° without any extra calibration process, respectively. The VSPS draws 18-mA dc current from 2-V voltage supply with a large input power at 1-dB (IP1dB) up to 3.5 dBm, and the chip occupies an area of $1600\times 900~\mu $ m, including testing pads and serial peripheral interface.


  • A Low-Loss Ultrawideband 3-dB Coupler Using Hybrid Integrated Suspended Line (HISL) With Multiple Inner Boards

    by Lei Chen, Yongqiang Wang, Jianquan Hu, Kaixue Ma

    This letter presents the hybrid integrated suspended line (HISL) platform with multiple inner boards. By employing cutting-out dielectric and multiple-inner board technology, low loss and modal phase velocity balance can be achieved simultaneously. The utilization of HISL platforms helps enhance the mechanical strength of the entire structure. The loss and the modal phase velocity of the structure and the influence of various physical dimensions on the odd-and even-mode impedance are analyzed. Based on the proposed HISL platform with multiple inner boards, a low-loss ultrawideband 2–18-GHz 3-dB coupler utilizing nonuniform technology is designed. The proposed coupler exhibits low measured insertion loss, achieving better than 0.3 dB at the center frequency. Additionally, both measured isolation and return loss are better than 15 dB.


  • Hybrid Irregular Tiled Arrays for Wide-Angle and Low-Sidelobe Scanning With Mixed Integer Linear Programming

    by Yankai Ma, Qiang Sun, Jianquan Hu, Qianyin Xiang, Quanyuan Feng

    The segmentation of phased array apertures into distinct sets of tile modules, referred to as irregular tiled arrays, is highly appealing in scenarios requiring cost efficiency. However, the limited scanning abilities restrict broader applications. To mitigate this limitation, we propose a hybrid subarray architecture that enhances flexibility by utilizing the diverse scanning advantages offered by various subarray sizes and shapes. A mixed integer linear programming model is developed to optimize the tiling configuration to adapt the array design to meet different SLL and maximum scanning angle requirements. Benders decomposition is employed to efficiently decouple and solve both integer and continuous variables. The proposed array structure exhibits network complexity that falls between traditional irregular arrays and nonadjacent arrays. Compared to traditional arrays, it achieves more than 4 dB sidelobe suppression and a 1.1 dB gain improvement. Compared with nonadjacent arrays, the proposed array not only extends the scanning angle but also achieves significantly lower sidelobe levels, offering superior performance for wide-angle scanning applications.


  • A Gain Cell With Unilateralization and Gain-Enhancement Techniques for High-Gain Distributed Amplifier

    by Jianquan Hu, Kaixue Ma, Changzi Xie, Bing Liu, Quanyuan Feng

    This article presents a novel circuit topology of gain cell for high-gain and broad-bandwidth distributed amplifier (DA). To enhance the gain with no deterioration in terms of bandwidth, no additional dc power dissipation and no increment of chip area, the unilateralization, interstage series-resonance, inductive-peaking, and current-reused techniques are incorporated dexterously into the proposed gain cell. The detailed analysis of gain enhancement and bandwidth improvement benefiting by the proposed gain cell is evaluated combined with simulation experiments. Experiments indicate that, by using the same process, the DA using the proposed gain cells achieves a gain improvement in excess of 8 dB larger than the DA using conventional gain cell without sacrificing the upper cutoff frequency, chip size, and dc power dissipation. Based on the theoretical analysis, a design methodology for high-gain DA is developed, and two single-stage DA prototypes, denoted by DA1 and DA2, are designed and implemented by using 0.25- $\mu$ m GaAs pseudomorphic high electron-mobility transistor (pHEMT) process to contrastively verify the proposed techniques. The DA1, using the proposed gain cell without unilateralization technique, provides a high average gain up to 19 dB, 14-dBm OP $_{1\,\textit{dB}}$ , and 2.5-dB typical noise figure across the frequency range from 2.8 to 24 GHz, while the DA2 features an average gain of 18.5 dB and 15-dBm OP $_{1\,\textit{dB}}$ in the frequency range from 2.8 to 27.2 GHz with a chip area of 2.52 mm $^{\text{2}}$ .


  • A 4.5–7.5 GHz highly integrated transceiver front‐end for UWB application

    by Jianquan Hu, Kaixue Ma

    In this letter, a 4.5–7.5 GHz highly integrated transceiver front‐end, incorporating two single‐pole three‐throw (SP3T) transmit/receive (T/R) switches, a low‐noise amplifier (LNA), a power amplifier (PA), and a bypass path for UWB positioning and communication systems applications, is reported. The mode switches among transmitting, receiving, and bypass are achieved by utilizing two control voltages through integrating a 2–4 decoder. Meanwhile, to ensure low‐power dissipation in different modes, the LNA and PA work in different modes (enable or disable) for transmitting and receiving status while both the LNA and PA are disabled for bypass mode. Fabricated by using 0.5‐μm GaAs pHEMT process, the presented FEM achieves 20‐dB gain, and 2.5‐dB typical noise figure for receiving mode, 8‐dB gain, and 16‐dBm OP1dB for transmitting mode, and 1.8 dB insertion loss for bypass mode, with a compact chip area of 1.5 mm × 1.7 mm. To the best of authors' knowledge, the presented circuits are the highest integrated and smallest chip area transceiver front‐end for UWB application among all previously reported UWB‐related RF front‐end chips.


  • Analysis and design of a 1.7‐ to 27.1‐GHz low‐noise amplifier

    by Jianquan Hu, Kaixue Ma

    This letter illustrates a 1.7‐ to 27.1‐GHz single‐stage cascode low‐noise amplifier (LNA) with high and flat gain response. In the presented LNA, to obtain high and flat gain response in the broad bandwidth, the Micro‐strip type pHEMT is utilized as the common‐source stage so as to alleviate the gain bandwidth degradation caused by parasitic parameters. Meanwhile, multiple inductive‐peaking inductors are employed to enhance the gain. By optimizing the combination of several bandwidth extension techniques, the experimental results indicate that the exhibited LNA achieves high average gain up to 14.6 dB with ±1.5 dB variation, 2.4 dB typical noise figure, and 14‐dBm OP1dB in the frequency range from 1.7 to 27.1 GHz. Fabricated by using 0.15‐μm GaAs pHEMT process, the presented LNA occupies a chip area of 0.96 mm2.


  • Bandpass-Filtering Power Amplifier With Compact Size and Wideband Harmonic Suppression

    by Ting Feng, Kaixue Ma, Yongqiang Wang, Jianquan Hu

    This article proposed a codesign of a power amplifier (PA) and a bandpass filter (BPF) named filtering PA using metal integrated and substrate integrated suspended line (MI-SISL). Two BPFs are designed separately as the input and output matching network to realize bandpass filtering response and good harmonic suppression at the same time. The BPF matching circuits are implemented using SISL-based dual-layer interdigital capacitors for miniaturization and SISL-based dual-layer spiral inductors for low loss. The suspended substrate of the PA is patterned according to the shape of the PA core circuit, which helps to reduce the circuit loss and improve efficiency. Moreover, the metal integrated technique is also proposed by replacing the top and bottom substrates of the conventional SISL structure with metal plates with good electrical and thermal conductivities for heat dissipation. A filtering PA on the MI-SISL platform at 0.9 GHz is fabricated and measured as a demonstration case. An ultrasmall size of $0.12\,\,\lambda _{g} \times 0.07\,\,\lambda _{g}$ is achieved, where $\lambda _{g}$ is the guide wavelength at 0.9 GHz. To the best of our knowledge, this is the most compact filtering PA on the board level to date. In addition, a harmonic suppression level of 40 dBc in up to the fifth-harmonic frequency is achieved.


  • A 2.4–4-GHz Wideband 7-Bit Phase Shifter With Low RMS Phase/Amplitude Error in 0.5-μm GaAs Technology

    by Xuguang Li, Haipeng Fu, Kaixue Ma, Jianquan Hu

    This article presents a 2.4–4-GHz wideband 7-bit switch-type phase shifter (STPS) with a switch driver. Three switch-type phase shifting topologies are employed for the design of the phase shifter (PS), including the switched $L/C$ structure, T-type structure, and high-/low-pass network. For minimizing the phase and amplitude deviations, an improved T-type structure with a switched filter structure has been proposed to boost the performance of the PS. Besides, a phase compensation cell also has been adapted to further decrease the phase error of the STPS. Based on the topology choice of each cell and the amplitude compensation among cells, a systematic design method is developed to extend the bandwidth of the PS. The proposed 7-bit STPS was implemented in the 0.5- $\mu \text{m}$ GaAs pHEMT process. The measured root-mean-square (rms) phase error of the proposed STPS is less than 3.1° from 2.4 to 4 GHz and less than 1.5° at 2.8–3.7 GHz. The average insertion loss (IL) is 4.5–4.9 dB with an rms amplitude error of less than 0.34 dB. IP 1 dB is about 30 dBm. To the best of our knowledge, this PS achieves the highest resolution and the lowest rms amplitude error among the published GaAs/GaN PSs over a similar frequency band. The IL, bandwidth, and rms phase error of the proposed PS also show good performance.