AZAbdullah Muhammad Zakaria

Abdullah Muhammad Zakaria

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Abdullah Muhammad Zakaria has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Yield of the Fricke dosimeter irradiated with the recoil α and Li ions of the 10B(n,α)7Li nuclear reaction: effects of multiple ionization and temperature

    by Abdullah Muhammad Zakaria, Phantira Lertnaisat, Muhammad Mainul Islam, Jintana Meesungnoen, Yosuke Katsumura, Jean-Paul Jay-Gerin

    Monte Carlo track chemistry simulations were used to investigate the effects of multiple ionization (MI) of water on the yields (G values) of the ferrous sulfate (Fricke) dosimeter, which was irradiated with low-energy α and lithium ion recoils from the 10B(n,α)7Li nuclear reaction as a function of temperature from 25 to 350 °C. Calculations were performed individually for 1.47 MeV α-particles and 0.84 MeV lithium nuclei with dose-average linear energy transfer (LET) values of ∼196 and 225 keV/µm at 25 °C, respectively. The total yields were obtained by summing the G values for each recoil α and Li ion weighted with its fraction of the total energy absorbed. At room temperature, our G(Fe3+) values calculated under aerated and deaerated conditions only agreed well with the experimental results, provided the MI of water was incorporated in the simulations. This strongly supports the importance of the role of MI of water in the high-LET radiolysis of water. We also simulated the effects of MI of water on G-values for the primary species of the radiolysis of deaerated 0.4 M H2SO4 aqueous solutions by 10B(n,α)7Li recoils. As with the Fricke dosimeter, the best agreement between experiment and simulation was found at 25 °C when the MI of water was included in the simulations. It was also shown that G(Fe3+) decreases slightly as a function of temperature over the range of 25–350 °C. However, at elevated temperatures, no experimental data were available with which to compare our results.


  • Open Access

    Fabrication of Nanostructured Kaolinite Doped Composite Films from Silicone Rubber with Enhanced Properties

    by Abdullah Muhammad Zakaria, Shaikat Chandra Dey, Muhammad Mominur Rahman, Mithun Sarker, Ashaduzzaman, Sayed Md. Shamsuddin

    Naturally occurring nanomaterials are finding growing interests in tailoring properties of engineering polymers for advanced applications. The objective of this study was to develop environment-friendly nanocomposite films by reinforcing kaolinite nanofillers (1–10 wt%) in silicone rubber (SR) matrix using a simple solvent casting technique. Kaolinite-reinforced films showed substantial improvement in mechanical (tensile strength, Young’s modulus, and elongation at break) and thermal properties at very low filler loading (5 wt%). The improvement of solvent resistance nature of the fabricated films was another critical aspect of this study. Unfilled SR film showed ~19% weight loss when immersed in toluene for 4 h at 25 °C, whereas only ~4% weight loss was recorded in the case of 5% (w/w) kaolinite loaded film. Therefore, kaolinite has the potential to bring significant improvement in the properties of SR. This study indicates that there is plenty of room at the bottom for proper utilization of the potential of kaolinite for developing SR-based composite materials for potential applications in many industries, such as textile, household cleaning, construction, electronics, automotive, medical, etc.