Asghar Lashanizadegan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Asghar Lashanizadegan has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Parviz Darvishi
Chemical Engineering Department, School of Engineering, Yasouj University, Yasouj, Iran
2 shared publications Abdolhamid Zare
Department of Chemical Engineering, School of Engineering, Yasouj University, Yasuj, Iran
1 shared publicationHakimeh Sharififard
Chemical Engineering Department, School of Engineering, Yasouj University, Yasouj, Iran
1 shared publication- Hakimeh Sharififard
Chemical Engineering Department, Yasouj University, Yasouj, Iran
1 shared publication Hamed Tahmouresinejad
Chemical Engineering Department, School of Engineering, Yasouj University, Yasouj, Iran
1 shared publicationKeyvan Eghtedari
Chemical Engineering Department, School of Engineering, Yasouj University, Yasouj, Iran
1 shared publication
Latest Publications
- Open Access
- 13 May 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Comprehensive experimental study to compare the effects of flue gases and CO2 injection on enhancing oil recovery and asphaltene deposition
Non-hydrocarbon injection gases such as carbon dioxide and flue gas offer low-cost, green substitutes for traditional hydrocarbon gases to be used in enhanced oil recovery. However, issues such as asphaltene precipitation and formation damage raise doubts about their use in tight carbonate reservoirs. While CO2 injection has been extensively studied, few experimental results are available for flue gas. The present paper presents a systematic experimental comparison between synthetic flue gas and CO2 in eight middle flooding experiments with recombined live oil and two low-permeability carbonate cores. The effects of gas type, pressure, volume of gas injected, and temperature on oil recovery, asphaltene deposition, and permeability damage were evaluated. CO2 injection resulted in about 15% more oil recovery than was obtained with flue gas at equal pressure. Equal oil recovery was achieved by the injection of flue gas at 20 to 30% higher pressure and 10 to 15% lower volume of gas. CO2 even caused up to 18.6% higher asphaltene deposition and 67% more formation damage than flue gas under identical conditions. The influence of injection pressure and temperature on the formation damage behavior has also been discussed in this study. The results confirm that flue gas injection is an applicable alternative to CO2 for EOR in carbonate reservoirs.
- 13 May 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessComprehensive experimental study to compare the effects of flue gases and CO2 injection on enhancing oil recovery and asphaltene deposition
Non-hydrocarbon injection gases such as carbon dioxide and flue gas offer low-cost, green substitutes for traditional hydrocarbon gases to be used in enhanced oil recovery. However, issues such as asphaltene precipitation and formation damage raise doubts about their use in tight carbonate reservoirs. While CO2 injection has been extensively studied, few experimental results are available for flue gas. The present paper presents a systematic experimental comparison between synthetic flue gas and CO2 in eight middle flooding experiments with recombined live oil and two low-permeability carbonate cores. The effects of gas type, pressure, volume of gas injected, and temperature on oil recovery, asphaltene deposition, and permeability damage were evaluated. CO2 injection resulted in about 15% more oil recovery than was obtained with flue gas at equal pressure. Equal oil recovery was achieved by the injection of flue gas at 20 to 30% higher pressure and 10 to 15% lower volume of gas. CO2 even caused up to 18.6% higher asphaltene deposition and 67% more formation damage than flue gas under identical conditions. The influence of injection pressure and temperature on the formation damage behavior has also been discussed in this study. The results confirm that flue gas injection is an applicable alternative to CO2 for EOR in carbonate reservoirs.
- 4 January 2022
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 103 (20) , 9761-9784
Investigating the experimental and theoretical treatment of spent caustic effluent from an industrial Olefin plant by combining Fenton-like and foam fractionation methods on the bench scale
In the present study, the treatment of a typical spent Merox caustic waste (SMC) was investigated by three methods of Fenton-like process, foam fractionation and combination of both methods. Immobilised TiO2/Fe0 nanoparticles on modified silica nanoparticles were used as heterogeneous Fenton-like catalyst. The characterisation of catalyst was carried out using Fourier transform infrared (FT-IR), X‐ray diffraction (XRD), diffuse reflectance spectra (DRS) analysis, thermal gravimetric analysis (TGA), differential scanning calorimeter (DSC) and transmission electron microscopy (TEM). The performance of the combined method was evaluated in terms of chemical oxygen demand (COD) residual parameter. The parameters including pH, gas flow rate to the separator column, concentrations of hydrogen peroxide/catalyst/surfactant/chelate agent, surfactant type, and chelate agent type were investigated to obtain the optimum conditions of the process by response surface methodology (RSM) based on eight-factors central composite design (CCD). Under optimum conditions of combining Fenton-like and foam fractionation methods, the minimum residue of COD was 10.98 ppm, corresponding to a COD removal of 99.7%. However, the measured values for the Fenton-like or foam fractionation methods alone did not exceed 88.9% and 58.4%, respectively. In addition, hydrogen peroxide consumption decreased by 63% compared to the Fenton-like method. Also, another important result shows that the use of cationic surfactants is more effective than anionic and amphoteric for wastewater treatment.
- 4 January 2022
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 103 (20) , 9761-9784
Investigating the experimental and theoretical treatment of spent caustic effluent from an industrial Olefin plant by combining Fenton-like and foam fractionation methods on the bench scale
In the present study, the treatment of a typical spent Merox caustic waste (SMC) was investigated by three methods of Fenton-like process, foam fractionation and combination of both methods. Immobilised TiO2/Fe0 nanoparticles on modified silica nanoparticles were used as heterogeneous Fenton-like catalyst. The characterisation of catalyst was carried out using Fourier transform infrared (FT-IR), X‐ray diffraction (XRD), diffuse reflectance spectra (DRS) analysis, thermal gravimetric analysis (TGA), differential scanning calorimeter (DSC) and transmission electron microscopy (TEM). The performance of the combined method was evaluated in terms of chemical oxygen demand (COD) residual parameter. The parameters including pH, gas flow rate to the separator column, concentrations of hydrogen peroxide/catalyst/surfactant/chelate agent, surfactant type, and chelate agent type were investigated to obtain the optimum conditions of the process by response surface methodology (RSM) based on eight-factors central composite design (CCD). Under optimum conditions of combining Fenton-like and foam fractionation methods, the minimum residue of COD was 10.98 ppm, corresponding to a COD removal of 99.7%. However, the measured values for the Fenton-like or foam fractionation methods alone did not exceed 88.9% and 58.4%, respectively. In addition, hydrogen peroxide consumption decreased by 63% compared to the Fenton-like method. Also, another important result shows that the use of cationic surfactants is more effective than anionic and amphoteric for wastewater treatment.
- 23 January 2020
- Published by Springer Nature in Chemical Papers
- Vol. 74 (7) , 2163-2174
Synthesis and characterization of NaP zeolite nanocrystals using [C12mim][Cl] ionic liquid
- 23 January 2020
- Published by Springer Nature in Chemical Papers
- Vol. 74 (7) , 2163-2174
Synthesis and characterization of NaP zeolite nanocrystals using [C12mim][Cl] ionic liquid
- 21 May 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (8) , 085621
Walnut shell activated carbon: optimization of synthesis process, characterization and application for Zn (II) removal in batch and continuous process
- 21 May 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (8) , 085621
Walnut shell activated carbon: optimization of synthesis process, characterization and application for Zn (II) removal in batch and continuous process