XYXufeng Yang

Xufeng Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xufeng Yang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of Laser Shock Peening on Fretting Fatigue Life of TC11 Titanium Alloy

    by Xufeng Yang, Hongjian Zhang, Haitao Cui, Changlong Wen

    The purpose of this paper is to investigate the performance of laser shock peening (LSP) subjected to fretting fatigue with TC11 titanium alloy specimens and pads. Three laser power densities (3.2 GW/cm2, 4.8 GW/cm2 and 6.4 GW/cm2) of LSP were chosen and tested using manufactured fretting fatigue apparatus. The experimental results show that the LSP surface treatment significantly improves the fretting fatigue lives of the fretting specimens, and the fretting fatigue life increases most when the laser power density is 4.8 GW/cm2. It is also found that with the increase of the laser power density, the fatigue crack initiation location tends to move from the surface to the interior of the specimen.


  • Open Access

    Study on the Effect of Laser Quenching on Fretting Fatigue Life

    by Hongjian Zhang, Xufeng Yang, Haitao Cui, Weidong Wen

    Laser quenching hardening is one of the most used surface treated technologies. In order to study the effect of laser quenching on the fretting fatigue life, fretting fatigue experiments of TC11 (Ti-6.5Al-1.5Zr-3.5Mo-0.3Si) titanium alloy specimens with different surface conditions were carried out on a special hydraulic servo fatigue test system. The experimental results showed that laser quenching hardening has a good performance in increasing the fretting fatigue lives of the TC11 alloy. However, the effects of laser quenching on fretting fatigue are more obviously at low stress level than at high stress level, the fretting fatigue life was increased by 110.78% at low stress level and 17.56% at high stress level, respectively. Based on the critical plane approach, the traditional SWT (Smith–Watson–Topper) parameter was modified and used to describe the fretting fatigue life of the TC11 alloy after hardening by the consideration of the variations of the hardening layer’s elastic modulus. Compared with the experimental results, all the errors of the predicted results lied in the error band of two.