Eveline Rigo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Eveline Rigo has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Lorenzo Pavesi
Nanoscience Laboratory, Department of Physics, University of Trento , 38123 Povo
7 shared publications - Paolo Bettotti
University of Trento
4 shared publications - Mher Ghulinyan
Fondazione Bruno Kessler
3 shared publications - Alessandro Pitanti
Dipartimento di Fisica “E. Fermi” Università di Pisa and Istituto Nanoscienze ‐ CNR Pisa Italy
2 shared publications - Francisco Javier Aparicio
Nanotechnology on Surfaces and Plasma Laboratory, Materials Science Institute of Seville (CSIC-US), C/Américo Vespucio 49, 41092 Seville, Spain
2 shared publications R. Guider
Università di Trento
2 shared publications
Latest Publications
- Open Access
- 30 May 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-13
Measurements of the size and correlations between ions using an electrolytic point contact
The size of an ion affects everything from the structure of water to life itself. In this report, to gauge their size, ions dissolved in water are forced electrically through a sub-nanometer-diameter pore spanning a thin membrane and the current is measured. The measurements reveal an ion-selective conductance that vanishes in pores +, Mg2+, Na+ and K+-ions extrapolates to pore diameters of 0.13 ± 0.11 nm, 0.16 ± 0.11 nm, 0.22 ± 0.11 nm and 0.25 ± 0.11 nm, respectively—consonant with diameters at which the conductance vanishes and consistent with ions moving through the sub-nanopore with distorted hydration shells in a correlated way.
- 30 May 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-13
Open AccessMeasurements of the size and correlations between ions using an electrolytic point contact
The size of an ion affects everything from the structure of water to life itself. In this report, to gauge their size, ions dissolved in water are forced electrically through a sub-nanometer-diameter pore spanning a thin membrane and the current is measured. The measurements reveal an ion-selective conductance that vanishes in pores +, Mg2+, Na+ and K+-ions extrapolates to pore diameters of 0.13 ± 0.11 nm, 0.16 ± 0.11 nm, 0.22 ± 0.11 nm and 0.25 ± 0.11 nm, respectively—consonant with diameters at which the conductance vanishes and consistent with ions moving through the sub-nanopore with distorted hydration shells in a correlated way.
- 5 September 2014
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 47 (40)
Silicon oxynitride waveguides as evanescent-field-based fluorescent biosensors
- 5 September 2014
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 47 (40)
Silicon oxynitride waveguides as evanescent-field-based fluorescent biosensors
- 5 July 2013
- Published by Springer Nature in Applied Physics B
- Vol. 114 (4) , 537-544
Evanescent-field excitation and collection approach for waveguide based photonic luminescent biosensors
- 5 July 2013
- Published by Springer Nature in Applied Physics B
- Vol. 114 (4) , 537-544
Evanescent-field excitation and collection approach for waveguide based photonic luminescent biosensors
- Open Access
Modeling of Slot Waveguide Sensors Based on Polymeric Materials
Slot waveguides are very promising for optical sensing applications because of their peculiar spatial mode profile. In this paper we have carried out a detailed analysis of mode confinement properties in slot waveguides realized in very low refractive index materials. We show that the sensitivity of a slot waveguide is not directly related to the refractive index contrast of high and low materials forming the waveguide. Thus, a careful design of the structures allows the realization of high sensitivity devices even in very low refractive index materials (e.g., polymers) to be achieved. Advantages of low index dielectrics in terms of cost, functionalization and ease of fabrication are discussed while keeping both CMOS compatibility and integrable design schemes. Finally, applications of low index slot waveguides as substitute of bulky fiber capillary sensors or in ring resonator architectures are addressed. Theoretical results of this work are relevant to well established polymer technologies.
Open AccessModeling of Slot Waveguide Sensors Based on Polymeric Materials
Slot waveguides are very promising for optical sensing applications because of their peculiar spatial mode profile. In this paper we have carried out a detailed analysis of mode confinement properties in slot waveguides realized in very low refractive index materials. We show that the sensitivity of a slot waveguide is not directly related to the refractive index contrast of high and low materials forming the waveguide. Thus, a careful design of the structures allows the realization of high sensitivity devices even in very low refractive index materials (e.g., polymers) to be achieved. Advantages of low index dielectrics in terms of cost, functionalization and ease of fabrication are discussed while keeping both CMOS compatibility and integrable design schemes. Finally, applications of low index slot waveguides as substitute of bulky fiber capillary sensors or in ring resonator architectures are addressed. Theoretical results of this work are relevant to well established polymer technologies.
- 4 May 2011
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8069, 80690K
Development and optical characterization of vertical tapers in SiON waveguides using gray-scale lithography
We describe the development of optical waveguides and adiabatic tapers based on SiON-glasses for a lab-on-chip device with fluorescence optical detection. Sensing is based on evanescent near-field excitation of biomolecules captured on the surface of a thin waveguide. First, the composition of SiON waveguides was optimized to reduce losses for visible light. Waveguides with refractive index of ~1.63 showed propagation losses of ~0.8-0.9 dB/cm at 633 nm. A low loss adiabatic taper was developed to convert efficiently the light from a multi mode waveguide into a thin mono-modal one. Design of the taper was done by calculating numerically the transmission efficiency using a finite-difference time-domain method (FDTD). Simulation results show that losses lower than ~1 dB are obtained for taper lengths of 100 to 300 micron, which indicates an efficient mode conversion. Based on this, tapers of different lengths were realized by grayscale lithography and by reactive ion etching. Their optical testing shows best insertion losses of ~1 dB at 633 nm for multimode to monomode waveguide transitions.
- 4 May 2011
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8069, 80690K
Development and optical characterization of vertical tapers in SiON waveguides using gray-scale lithography
We describe the development of optical waveguides and adiabatic tapers based on SiON-glasses for a lab-on-chip device with fluorescence optical detection. Sensing is based on evanescent near-field excitation of biomolecules captured on the surface of a thin waveguide. First, the composition of SiON waveguides was optimized to reduce losses for visible light. Waveguides with refractive index of ~1.63 showed propagation losses of ~0.8-0.9 dB/cm at 633 nm. A low loss adiabatic taper was developed to convert efficiently the light from a multi mode waveguide into a thin mono-modal one. Design of the taper was done by calculating numerically the transmission efficiency using a finite-difference time-domain method (FDTD). Simulation results show that losses lower than ~1 dB are obtained for taper lengths of 100 to 300 micron, which indicates an efficient mode conversion. Based on this, tapers of different lengths were realized by grayscale lithography and by reactive ion etching. Their optical testing shows best insertion losses of ~1 dB at 633 nm for multimode to monomode waveguide transitions.
- 1 April 2011
- Published by Elsevier in Thin Solid Films
- Vol. 519 (12) , 4110-4113
Role of kinetic energy of impinging molecules in the α-sexithiophene growth
- 1 April 2011
- Published by Elsevier in Thin Solid Films
- Vol. 519 (12) , 4110-4113
Role of kinetic energy of impinging molecules in the α-sexithiophene growth
- 18 March 2009
- Published by Elsevier in Optical Materials
- Vol. 31 (10) , 1488-1491
Polymeric waveguides using oxidized porous silicon cladding for optical amplification
- 18 March 2009
- Published by Elsevier in Optical Materials
- Vol. 31 (10) , 1488-1491
Polymeric waveguides using oxidized porous silicon cladding for optical amplification
- 10 November 2008
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 40 (4) , 453-458
Vibrational properties of ibuprofen–cyclodextrin inclusion complexes investigated by Raman scattering and numerical simulation
The modifications to the vibrational spectra produced by inclusion into cyclodextrins on the vibrational spectra of of the non‐steroidal anti–inflammatory drug ibuprofen, by inclusion into cyclodextrins have been investigated by means of Raman scattering and numerical simulation. These changes are discussed and explained by comparison with the theoretical vibrational wavenumbersfrequencies and Raman intensities obtained by quantum and classical numerical simulations, disentangling the effects directly related to the complexation process, from those to be ascribed to non‐covalent dimerization of ibuprofen due to hydrogen bonding. Copyright © 2008 John Wiley & Sons, Ltd.
- 10 November 2008
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 40 (4) , 453-458
Vibrational properties of ibuprofen–cyclodextrin inclusion complexes investigated by Raman scattering and numerical simulation
The modifications to the vibrational spectra produced by inclusion into cyclodextrins on the vibrational spectra of of the non‐steroidal anti–inflammatory drug ibuprofen, by inclusion into cyclodextrins have been investigated by means of Raman scattering and numerical simulation. These changes are discussed and explained by comparison with the theoretical vibrational wavenumbersfrequencies and Raman intensities obtained by quantum and classical numerical simulations, disentangling the effects directly related to the complexation process, from those to be ascribed to non‐covalent dimerization of ibuprofen due to hydrogen bonding. Copyright © 2008 John Wiley & Sons, Ltd.
- 1 January 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19492081,p. 353-355
Couapled cavities in one-dimensional photonic crystal based on horizontal slot waveguide structure with Si-nc
One-dimensional photonic crystal structure is used for a slow light effect in a coupled resonators optical horizontal slot waveguide with Si-nc. We report on design, simulations and preliminary optical transmission characterization around 1.55 mum.
- 1 January 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19492081,p. 353-355
Couapled cavities in one-dimensional photonic crystal based on horizontal slot waveguide structure with Si-nc
One-dimensional photonic crystal structure is used for a slow light effect in a coupled resonators optical horizontal slot waveguide with Si-nc. We report on design, simulations and preliminary optical transmission characterization around 1.55 mum.