Parvaneh Iranmanesh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Parvaneh Iranmanesh has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
S. Saeednia
Department of Chemistry, Faculty of Sciences, Vali-e-Asr University of Rafsanjan, Rafsanjan, Iran
5 shared publicationsN. Khorasanipour
Department of Physics, Faculty of Sciences, Vali-e-Asr University of Rafsanjan, Rafsanjan, Iran
3 shared publications- Samira Saeednia
Department of Chemistry, Faculty of Sciences Vali‐e‐Asr University of Rafsanjan Rafsanjan Iran
2 shared publications Sh. Tabatabai Yazdi
2 shared publicationsF. Amiri
Department of Physics, Faculty of Sciences, Vali-e-Asr University of Rafsanjan, Rafsanjan, Iran
1 shared publication- Farzad Farahmandzadeh
Department of Physics, Faculty of Science, Vali-E-Asr University of Rafsanjan, Rafsanjan, Iran
1 shared publication
Latest Publications
- Open Access
- 27 August 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Synergistic photocatalysis of magnetic Fe3O4/CdS/ZnO nanocomposite for efficient and recyclable removal of tetracycline and Eosin Y
The increasing global threat posed by persistent organic pollutants, including pharmaceutical residues and hazardous dyes, requires efficient, recyclable, and durable photocatalysts. To address this challenge, we successfully developed a novel magnetic ternary Fe 3 O 4 /CdS/ZnO nanocomposite via a simple chemical co-precipitation method. The structure and photocatalytic activity were rigorously characterized using XRD, TEM, FTIR, Raman, FE-SEM, PL, BET, VSM, and DRS. XRD confirmed a multi-phase structure including cubic spinel Fe 3 O 4 , hexagonal CdS and ZnO, with particle size of approximately 35 nm as measured by TEM .Importantly, photoluminescence studies revealed substantial quenching of electron-hole recombination in Fe 3 O 4 /CdS/ZnO compared to Fe 3 O 4 /CdS. Furthermore, the ternary nanocomposite exhibited superparamagnetic behavior (M s ≈ 22 emu/g) and a significantly large specific surface area (approximately 69.55 m 2 /g), essential for facile magnetic recovery and high photocatalytic efficiency. Zeta potential analysis gave a value of approximately − 40 mV, confirming a negatively charged surface. This negative charge is expected to facilitate strong interaction between the nanocomposite and the dye molecules. The photocatalytic performance of Fe 3 O 4 /CdS/ZnO was evaluated through degradation of tetracycline (TC) under UV light and Eosin Y dye under visible light, achieving 88% degradation (90 min) and 92% degradation (150 min), respectively. These findings confirm that the optimized nanostructure enhances charge carrier separation and transfer. Compared with previously reported binary or ternary systems, this novel composite offers competitive or superior multifunctional performance under both UV and visible light. Overall, the magnetic Fe 3 O 4 /CdS/ZnO nanocomposite represents a highly effective, recyclable, and sustainable material for the neutralization of organic pollutants.
- 27 August 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessSynergistic photocatalysis of magnetic Fe3O4/CdS/ZnO nanocomposite for efficient and recyclable removal of tetracycline and Eosin Y
The increasing global threat posed by persistent organic pollutants, including pharmaceutical residues and hazardous dyes, requires efficient, recyclable, and durable photocatalysts. To address this challenge, we successfully developed a novel magnetic ternary Fe 3 O 4 /CdS/ZnO nanocomposite via a simple chemical co-precipitation method. The structure and photocatalytic activity were rigorously characterized using XRD, TEM, FTIR, Raman, FE-SEM, PL, BET, VSM, and DRS. XRD confirmed a multi-phase structure including cubic spinel Fe 3 O 4 , hexagonal CdS and ZnO, with particle size of approximately 35 nm as measured by TEM .Importantly, photoluminescence studies revealed substantial quenching of electron-hole recombination in Fe 3 O 4 /CdS/ZnO compared to Fe 3 O 4 /CdS. Furthermore, the ternary nanocomposite exhibited superparamagnetic behavior (M s ≈ 22 emu/g) and a significantly large specific surface area (approximately 69.55 m 2 /g), essential for facile magnetic recovery and high photocatalytic efficiency. Zeta potential analysis gave a value of approximately − 40 mV, confirming a negatively charged surface. This negative charge is expected to facilitate strong interaction between the nanocomposite and the dye molecules. The photocatalytic performance of Fe 3 O 4 /CdS/ZnO was evaluated through degradation of tetracycline (TC) under UV light and Eosin Y dye under visible light, achieving 88% degradation (90 min) and 92% degradation (150 min), respectively. These findings confirm that the optimized nanostructure enhances charge carrier separation and transfer. Compared with previously reported binary or ternary systems, this novel composite offers competitive or superior multifunctional performance under both UV and visible light. Overall, the magnetic Fe 3 O 4 /CdS/ZnO nanocomposite represents a highly effective, recyclable, and sustainable material for the neutralization of organic pollutants.
- 15 April 2026
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (6) , 3681-3698
High-performance Fe3O4/activated carbon/ZnS nanocomposite for simple and fast degradation of pollutant dyes from water
- 15 April 2026
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (6) , 3681-3698
High-performance Fe3O4/activated carbon/ZnS nanocomposite for simple and fast degradation of pollutant dyes from water
- 25 October 2024
- Published by Springer Nature in Applied Physics A
- Vol. 130 (11) , 1-13
Biocompatible synthesis of MoS2/Ag nanocomposite for enhanced photocatalytic activity via surface plasmon effects
- 25 October 2024
- Published by Springer Nature in Applied Physics A
- Vol. 130 (11) , 1-13
Biocompatible synthesis of MoS2/Ag nanocomposite for enhanced photocatalytic activity via surface plasmon effects
- 22 September 2024
- Published by Springer Nature in Journal of Inorganic and Organometallic Polymers and Materials
- Vol. 35 (3) , 1779-1794
Synergetic Photocatalytic Performance of Reusable Ag2S/ZnS/Fe3O4 Magnetic Nanocomposite for Impressive Degradation of Methyl Orange over Visible Light
- 22 September 2024
- Published by Springer Nature in Journal of Inorganic and Organometallic Polymers and Materials
- Vol. 35 (3) , 1779-1794
Synergetic Photocatalytic Performance of Reusable Ag2S/ZnS/Fe3O4 Magnetic Nanocomposite for Impressive Degradation of Methyl Orange over Visible Light
- Open Access
- 1 July 2024
- Published by Apex Publishing in Iranian Journal of Crystallography and Mineralogy
- Vol. 32 (2) , 379-392
Synthesis and characterization of recyclable Ag2S/ZnS nanophotocatalyst coated with Fe3O4 nanoparticles in methyl red dye degradation
Iranian Journal of Crystallography and Mineralogy مجله بلورشناسی و کانی شناسی ایران
- 1 July 2024
- Published by Apex Publishing in Iranian Journal of Crystallography and Mineralogy
- Vol. 32 (2) , 379-392
Open AccessSynthesis and characterization of recyclable Ag2S/ZnS nanophotocatalyst coated with Fe3O4 nanoparticles in methyl red dye degradation
Iranian Journal of Crystallography and Mineralogy مجله بلورشناسی و کانی شناسی ایران
- 27 December 2022
- Published by Elsevier in Surfaces and Interfaces
- Vol. 36
Photocatalytic degradation of Naphthol Green in aqueous solution through the reusable ZnS/MoS2/Fe3O4 magnetic nanocomposite
- 27 December 2022
- Published by Elsevier in Surfaces and Interfaces
- Vol. 36
Photocatalytic degradation of Naphthol Green in aqueous solution through the reusable ZnS/MoS2/Fe3O4 magnetic nanocomposite
- 16 August 2020
- Published by Wiley in Luminescence
- Vol. 36 (1) , 180-191
Influence of synthesis parameters on the optical and photocatalytic properties of solvo/hydrothermal CuS and ZnS nanoparticles
Copper sulfide and zinc sulfide nanostructures were synthesized using a solvo/hydrothermal method and a thio Schiff base ligand, N‐benzylidene ethanethioamide, as a source of sulfide ions. The effects of different synthesis parameters including the type of solvent, temperature, and duration of reactions on the morphology of the CuS and ZnS products were investigated using field emission scanning microscopy and transmission electron microscopy, respectively. The structural aspects of the samples were characterized using powder X‐ray diffraction, Fourier transform infrared spectroscopy, and energy dispersive X‐ray analysis. The optical properties of the samples were studied through their optical absorption and photoluminescence spectra. The photocatalytic ability of the as‐synthesized sulfides was explored by studying the colour removal of methylene blue under ultraviolet light irradiation.
- 16 August 2020
- Published by Wiley in Luminescence
- Vol. 36 (1) , 180-191
Influence of synthesis parameters on the optical and photocatalytic properties of solvo/hydrothermal CuS and ZnS nanoparticles
Copper sulfide and zinc sulfide nanostructures were synthesized using a solvo/hydrothermal method and a thio Schiff base ligand, N‐benzylidene ethanethioamide, as a source of sulfide ions. The effects of different synthesis parameters including the type of solvent, temperature, and duration of reactions on the morphology of the CuS and ZnS products were investigated using field emission scanning microscopy and transmission electron microscopy, respectively. The structural aspects of the samples were characterized using powder X‐ray diffraction, Fourier transform infrared spectroscopy, and energy dispersive X‐ray analysis. The optical properties of the samples were studied through their optical absorption and photoluminescence spectra. The photocatalytic ability of the as‐synthesized sulfides was explored by studying the colour removal of methylene blue under ultraviolet light irradiation.
- 1 March 2020
- Published by Elsevier in Journal of Luminescence
- Vol. 219
Synthesis and characterization of EDTA-assisted ZnS:Hg nanoparticles
- 1 March 2020
- Published by Elsevier in Journal of Luminescence
- Vol. 219
Synthesis and characterization of EDTA-assisted ZnS:Hg nanoparticles
- 3 June 2019
- Published by Wiley in Luminescence
- Vol. 34 (7) , 689-698
Effect of synthesis method and chemical reagents on the structural parameters, particle size, and optical and photoluminescence properties of ZnS nanostructures
In this experimental study, ZnS nanostructures were synthesized using two hydrothermal and co‐precipitation methods with different precursors. Different reagents and precursors were changed to obtain the best product size and morphology. The structure and crystal phase of the products were studied using X‐ray diffraction (XRD) patterns. Some structural parameters were calculated using the XRD results and a product composition was obtained by energy dispersive X‐ray (EDX) analysis and Fourier transform infrared (FT‐IR) spectra to study the chemical composition. The size and morphology of ZnS nanostructures were obtained by scanning electron microscopy (SEM). The optical properties of the synthesized ZnS nanostructures were examined using ultraviolet–visible (UV–Vis) spectra to estimate the optical band gap. Band gap energies were higher than those in the ZnS bulk sample, mainly due to quantum size effects. The photoluminescence (PL) properties of the products were investigated using PL spectra. The results showed the effect of two factors, namely synthesis method and chemical reagents, on the structure parameters, crystallite size, product size and morphology, and optical and PL properties.
- 3 June 2019
- Published by Wiley in Luminescence
- Vol. 34 (7) , 689-698
Effect of synthesis method and chemical reagents on the structural parameters, particle size, and optical and photoluminescence properties of ZnS nanostructures
In this experimental study, ZnS nanostructures were synthesized using two hydrothermal and co‐precipitation methods with different precursors. Different reagents and precursors were changed to obtain the best product size and morphology. The structure and crystal phase of the products were studied using X‐ray diffraction (XRD) patterns. Some structural parameters were calculated using the XRD results and a product composition was obtained by energy dispersive X‐ray (EDX) analysis and Fourier transform infrared (FT‐IR) spectra to study the chemical composition. The size and morphology of ZnS nanostructures were obtained by scanning electron microscopy (SEM). The optical properties of the synthesized ZnS nanostructures were examined using ultraviolet–visible (UV–Vis) spectra to estimate the optical band gap. Band gap energies were higher than those in the ZnS bulk sample, mainly due to quantum size effects. The photoluminescence (PL) properties of the products were investigated using PL spectra. The results showed the effect of two factors, namely synthesis method and chemical reagents, on the structure parameters, crystallite size, product size and morphology, and optical and PL properties.