Joel Olayide Amosun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Joel Olayide Amosun has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Oluseun Adetola Sanuade
Boone Pickens School of Geology, Oklahoma State University, Stillwater, USA
5 shared publications - Tokunbo Sanmi Fagbemigun
Department of Geophysics, Federal University, Oye-Ekiti, Nigeria
4 shared publications Jane Idowu Faloyo
Department of Applied Geophysics, Federal University of Technology Akure, Nigeria
3 shared publicationsKehinde David Oyeyemi
Department of Industrial Physics, Covenant University, Ota, Ogun State, Nigeria
3 shared publications- Abayomi Adesola Olaojo
Department of Earth Sciences, Ajayi Crowther University, Oyo, Nigeria
2 shared publications Julius O. Fatoba
Department of Geophysics, Federal University Oye Ekiti, Oye-Ekiti, Nigeria
2 shared publications
Latest Publications
- 26 February 2021
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 14 (5) , 1-10
Integration of electrical resistivity and soil analysis for Agricultural soil characterization—a case study
- 26 February 2021
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 14 (5) , 1-10
Integration of electrical resistivity and soil analysis for Agricultural soil characterization—a case study
- 20 November 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (12) , 1-14
Imaging lateritic bauxite bearing zones in Ekiti, Southwestern Nigeria, using magnetic and electrical resistivity tomography techniques
- 20 November 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (12) , 1-14
Imaging lateritic bauxite bearing zones in Ekiti, Southwestern Nigeria, using magnetic and electrical resistivity tomography techniques
- 17 October 2020
- Published by Springer Nature in Modeling Earth Systems and Environment
- Vol. 7 (2) , 695-701
Geophysical and geochemical assessments of the environmental impact of Abule-Egba landfill, southwestern Nigeria
- 17 October 2020
- Published by Springer Nature in Modeling Earth Systems and Environment
- Vol. 7 (2) , 695-701
Geophysical and geochemical assessments of the environmental impact of Abule-Egba landfill, southwestern Nigeria
- Open Access
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012066
Statistical comparison of Schlumberger arrays using randomized complete block design
In this study, statistical comparison of the resistivity data acquired using vertical electrical sounding (VES) technique with three arrays (conventional Schlumberger array, Hummel array and half-Hummel array) was performed. The objective is to assess the efficacy of the Hummel and half-Hummel arrays of VES as alternative arrays to the conventional Schlumberger array at areas with limited space for acquisition during groundwater exploration activities. A total of fifteen (15) VES data were acquired for the three arrays at five locations within Phase II of Federal University Oye-Ekiti, southwestern, Nigeria. The electrode spacing (AB/2) varies from 1 to 65 m during the acquisition. The raw VES data were subjected to statistical analysis to compare the three arrays. Randomized complete block design (RCBD) was used to establish if one array could be a perfect or near perfect substitution for other arrays. The responses obtained for all the arrays analysed are statistically the same at some locations which means measurements could either be taken using any of the three arrays. However, responses for the three arrays are different at a location which shows the three arrays are independent in this location. Pairwise comparison analysis at this location shows the difference in the three arrays. We therefore generated acceptance and rejection map of the study area which could be used as a guide prior to any geophysical data acquisition.
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012066
Open AccessStatistical comparison of Schlumberger arrays using randomized complete block design
In this study, statistical comparison of the resistivity data acquired using vertical electrical sounding (VES) technique with three arrays (conventional Schlumberger array, Hummel array and half-Hummel array) was performed. The objective is to assess the efficacy of the Hummel and half-Hummel arrays of VES as alternative arrays to the conventional Schlumberger array at areas with limited space for acquisition during groundwater exploration activities. A total of fifteen (15) VES data were acquired for the three arrays at five locations within Phase II of Federal University Oye-Ekiti, southwestern, Nigeria. The electrode spacing (AB/2) varies from 1 to 65 m during the acquisition. The raw VES data were subjected to statistical analysis to compare the three arrays. Randomized complete block design (RCBD) was used to establish if one array could be a perfect or near perfect substitution for other arrays. The responses obtained for all the arrays analysed are statistically the same at some locations which means measurements could either be taken using any of the three arrays. However, responses for the three arrays are different at a location which shows the three arrays are independent in this location. Pairwise comparison analysis at this location shows the difference in the three arrays. We therefore generated acceptance and rejection map of the study area which could be used as a guide prior to any geophysical data acquisition.
- Open Access
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012065
Analysis of principles of equivalence and suppression in resistivity sounding technique
The principles of equivalence and suppression in resistivity sounding technique are phenomena where different resistivity models may produce resistivity curves that are essentially the same. The understanding of these phenomena could be of great importance in using resistivity sounding technique for citing boreholes in places underlain by Basement Complex rocks. In such areas, it would be difficult to identify the fractured/weathered bedrock from the sounding interpretation. This is because the resistivity of the weathered layer is usually intermediate between those of the adjacent layers (i.e. residual overburden) on top and the fresh bedrock below. Therefore, it is important to analyse the problems of suppression and equivalence in resistivity sounding data for estimating thickness and resistivity of the subsurface layers. Several resistivity models were generated ranging from two-layer to five-layer models to investigate these phenomena. The apparent resistivity curves were plotted for these models. The results show that the problems of suppression and equivalence exist in resistivity sounding data. Hence, geophysicists should not make any a priori quantitative inferences using the shape of the resistivity sounding curve.
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012065
Open AccessAnalysis of principles of equivalence and suppression in resistivity sounding technique
The principles of equivalence and suppression in resistivity sounding technique are phenomena where different resistivity models may produce resistivity curves that are essentially the same. The understanding of these phenomena could be of great importance in using resistivity sounding technique for citing boreholes in places underlain by Basement Complex rocks. In such areas, it would be difficult to identify the fractured/weathered bedrock from the sounding interpretation. This is because the resistivity of the weathered layer is usually intermediate between those of the adjacent layers (i.e. residual overburden) on top and the fresh bedrock below. Therefore, it is important to analyse the problems of suppression and equivalence in resistivity sounding data for estimating thickness and resistivity of the subsurface layers. Several resistivity models were generated ranging from two-layer to five-layer models to investigate these phenomena. The apparent resistivity curves were plotted for these models. The results show that the problems of suppression and equivalence exist in resistivity sounding data. Hence, geophysicists should not make any a priori quantitative inferences using the shape of the resistivity sounding curve.
- Open Access
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012067
Understanding the interrelationship between electrical anisotropy and groundwater yield in a typical Basement Complex area
The rocks in the Basement Complexof southwestern Nigeria exhibit electrical anisotropy as a result of their heterogeneous nature caused by weathering, near-surface effects or presence of fractures. It is known that groundwater yield (Y) in a typical Basement Complex aquifers is related to its coefficient of anisotropy (λ). Therefore, it is essential to study the correlation between Y and λ in the basement complex. Ten (10) vertical electrical sounding (VES) points using Schlumberger array were studied in areas underlain by migmatite gneiss and quartzite rocks. The current electrode spacing (AB/2) varies from 1 m to a maximum spread length of 100 m. The quantitative interpretation of VES curves was done by using partial curve matching and computer assisted program called WinResist version 1.0 software. Dar Zarrouk parameters were estimated from the interpreted VES curves and thus coefficient of anisotropy (λ) was calculated from these parameters. Data on the groundwater yield at the VES points were also obtained. The results show that as λ increases, Y also increases with coefficient of correlation (R2) of 0.86 and 0.79 for migmatite gneiss and quartzite rocks respectively. To further investigate the relationship between Y andλ, a regression analysis was performed. The regression analysis that was performed on the dataset shows that λ contributes significantly to the regression models of the two rocks. The relationship between Y and λ reveals that groundwater yield could be predicted from the values of λ in a given locality.
- 1 August 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1299 (1) , 012067
Open AccessUnderstanding the interrelationship between electrical anisotropy and groundwater yield in a typical Basement Complex area
The rocks in the Basement Complexof southwestern Nigeria exhibit electrical anisotropy as a result of their heterogeneous nature caused by weathering, near-surface effects or presence of fractures. It is known that groundwater yield (Y) in a typical Basement Complex aquifers is related to its coefficient of anisotropy (λ). Therefore, it is essential to study the correlation between Y and λ in the basement complex. Ten (10) vertical electrical sounding (VES) points using Schlumberger array were studied in areas underlain by migmatite gneiss and quartzite rocks. The current electrode spacing (AB/2) varies from 1 m to a maximum spread length of 100 m. The quantitative interpretation of VES curves was done by using partial curve matching and computer assisted program called WinResist version 1.0 software. Dar Zarrouk parameters were estimated from the interpreted VES curves and thus coefficient of anisotropy (λ) was calculated from these parameters. Data on the groundwater yield at the VES points were also obtained. The results show that as λ increases, Y also increases with coefficient of correlation (R2) of 0.86 and 0.79 for migmatite gneiss and quartzite rocks respectively. To further investigate the relationship between Y andλ, a regression analysis was performed. The regression analysis that was performed on the dataset shows that λ contributes significantly to the regression models of the two rocks. The relationship between Y and λ reveals that groundwater yield could be predicted from the values of λ in a given locality.
- Open Access
- 1 December 2018
- Published by University of Ljubljana in Materials and Geoenvironment
- Vol. 65 (4) , 199-206
Preliminary geophysical investigation for road construction using integrated methods
Integrated geophysical methods have been used to investigate the competency of the subsoil. The geophysical surveys conducted involve very low-frequency electromagnetic (VLF-EM) and electrical resistivity (ER) methods (dipole-dipole). ABEM Wadi and Ohmega resistivity meter were used to acquire VLF-EM and ER data, respectively, along two traverses. Station interval of 5 m was used for the VLF-EM survey, while inter-electrode spacing for dipole–dipole was 10 m; the inter-dipole expansion factor (n) ranged from 1 to 5. KHFFILT software was used to generate VLF-EM profiles and pseudosection, while DIPRO software was used for ER. Results from the ER method revealed the pattern of resistivity variations within the study area. The low resistivity values (11–25 Ohm-m) observed at the southern part of the study area could be attributed to changes in clay contents and degree of weathering in the subsurface. The results from the VLF-EM investigation revealed the presence of near-surface linear geologic structures of varying lengths, depths and attitudes, which suggest probable conductive zones that are inimical to the foundation of the road subgrade.
- 1 December 2018
- Published by University of Ljubljana in Materials and Geoenvironment
- Vol. 65 (4) , 199-206
Open AccessPreliminary geophysical investigation for road construction using integrated methods
Integrated geophysical methods have been used to investigate the competency of the subsoil. The geophysical surveys conducted involve very low-frequency electromagnetic (VLF-EM) and electrical resistivity (ER) methods (dipole-dipole). ABEM Wadi and Ohmega resistivity meter were used to acquire VLF-EM and ER data, respectively, along two traverses. Station interval of 5 m was used for the VLF-EM survey, while inter-electrode spacing for dipole–dipole was 10 m; the inter-dipole expansion factor (n) ranged from 1 to 5. KHFFILT software was used to generate VLF-EM profiles and pseudosection, while DIPRO software was used for ER. Results from the ER method revealed the pattern of resistivity variations within the study area. The low resistivity values (11–25 Ohm-m) observed at the southern part of the study area could be attributed to changes in clay contents and degree of weathering in the subsurface. The results from the VLF-EM investigation revealed the presence of near-surface linear geologic structures of varying lengths, depths and attitudes, which suggest probable conductive zones that are inimical to the foundation of the road subgrade.
- Open Access
- 17 July 2018
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 173 (1) , 012025
Prediction of transmissivity of aquifer from geoelectric data using artificial neural network
- 17 July 2018
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 173 (1) , 012025
Open AccessPrediction of transmissivity of aquifer from geoelectric data using artificial neural network