Zhiteng Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhiteng Gao has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
- Ye Li
Southern University of Science and Technology
7 shared publications Tongguang Wang
5 shared publications- Tongguang Wang
Jiangsu Key Laboratory of Hi-Tech Research for Wind Turbine Design, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China
3 shared publications Lijun Zhang
2 shared publicationsShoutu Li
2 shared publications- Xiaohang Qian
Department of Ocean Science and Engineering, Southern University of Science and Technology, Shenzhen 518055, China
2 shared publications
Latest Publications
- Open Access
- 2 June 2026
- Published by Elsevier in SSRN Electronic Journal
Diameter-dependent wave-field modulation and wave-load response of monopiles under regular and JONSWAP irregular waves
The hydrodynamic response of offshore wind turbine monopiles is strongly affected by structural scale, because increasing diameter enhances wave scattering and diffraction and changes the applicability of engineering load models. This study investigates the diameter-dependent wave-field modulation and horizontal wave-load response of fixed monopiles under regular and JONSWAP irregular waves using an OpenFOAM/waves2Foam numerical wave tank. Two monopile diameters, D5 and D10, are considered, and Morison-based and linear-diffraction-based formulations are used as engineering references. The results show that the JONSWAP irregular-wave case produces broader spectra, stronger short-term envelope modulation, and more non-stationary free-surface and load responses than the regular-wave case. Under both wave conditions, the larger D10 monopile causes stronger near-field wave-height amplification, a broader disturbed region, and more dispersed modal-energy distribution. Load comparisons indicate that D5 agrees better with the Morison-based estimate, whereas D10 is more consistent with the diffraction-based estimate. However, irregular waves lead to visible deviations near local peak loads and strongly modulated wave groups.
- 2 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDiameter-dependent wave-field modulation and wave-load response of monopiles under regular and JONSWAP irregular waves
The hydrodynamic response of offshore wind turbine monopiles is strongly affected by structural scale, because increasing diameter enhances wave scattering and diffraction and changes the applicability of engineering load models. This study investigates the diameter-dependent wave-field modulation and horizontal wave-load response of fixed monopiles under regular and JONSWAP irregular waves using an OpenFOAM/waves2Foam numerical wave tank. Two monopile diameters, D5 and D10, are considered, and Morison-based and linear-diffraction-based formulations are used as engineering references. The results show that the JONSWAP irregular-wave case produces broader spectra, stronger short-term envelope modulation, and more non-stationary free-surface and load responses than the regular-wave case. Under both wave conditions, the larger D10 monopile causes stronger near-field wave-height amplification, a broader disturbed region, and more dispersed modal-energy distribution. Load comparisons indicate that D5 agrees better with the Morison-based estimate, whereas D10 is more consistent with the diffraction-based estimate. However, irregular waves lead to visible deviations near local peak loads and strongly modulated wave groups.
- Open Access
- 6 April 2026
- Published by Elsevier in SSRN Electronic Journal
Yaw-induced aeroelastic response analysis of a 15 MW wind turbine under different extreme conditions
Offshore wind turbines face significant challenges from complex aeroelastic responses and severe structural loads under extreme wind conditions, which constrain the development of offshore wind power. This paper establishes a high-fidelity aeroelastic coupling model suitable for large-scale wind turbines based on the lifting-line free vortex wake method and the co-rotational beam method. Taking the IEA 15 MW wind turbine as the research object, this study validates the accuracy of the model by comparing its results with OpenFAST under various yaw angles and wind speeds. The influence of yaw angles on blade dynamic responses is systematically analyzed under different extreme wind conditions. Furthermore, the aeroelastic response characteristics and load evolutions of blades in the parked condition are investigated across the full range of yaw angles. The results indicate that a 60 degree yaw angle represents a critical threshold for performance adjustment, while a 90 degree yaw angle is the optimal configuration for minimizing structural loads in extreme environments. Under high wind speeds and parked conditions, the hazardous yaw range characterized by severe dynamic oscillations is identified between 20 degree and 60 degree. By maintaining the yaw angle above 70 degree, the overall aeroelastic performance can be effectively optimized while simultaneously mitigating the risks of extreme loads and fatigue damage.
- 6 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessYaw-induced aeroelastic response analysis of a 15 MW wind turbine under different extreme conditions
Offshore wind turbines face significant challenges from complex aeroelastic responses and severe structural loads under extreme wind conditions, which constrain the development of offshore wind power. This paper establishes a high-fidelity aeroelastic coupling model suitable for large-scale wind turbines based on the lifting-line free vortex wake method and the co-rotational beam method. Taking the IEA 15 MW wind turbine as the research object, this study validates the accuracy of the model by comparing its results with OpenFAST under various yaw angles and wind speeds. The influence of yaw angles on blade dynamic responses is systematically analyzed under different extreme wind conditions. Furthermore, the aeroelastic response characteristics and load evolutions of blades in the parked condition are investigated across the full range of yaw angles. The results indicate that a 60 degree yaw angle represents a critical threshold for performance adjustment, while a 90 degree yaw angle is the optimal configuration for minimizing structural loads in extreme environments. Under high wind speeds and parked conditions, the hazardous yaw range characterized by severe dynamic oscillations is identified between 20 degree and 60 degree. By maintaining the yaw angle above 70 degree, the overall aeroelastic performance can be effectively optimized while simultaneously mitigating the risks of extreme loads and fatigue damage.
- 14 June 2025
- Published by Elsevier in Renewable Energy
- Vol. 255
Dynamic response analysis and blade stiffness sensitivity study of large floating offshore wind turbine with coupling effect
- 14 June 2025
- Published by Elsevier in Renewable Energy
- Vol. 255
Dynamic response analysis and blade stiffness sensitivity study of large floating offshore wind turbine with coupling effect
- 27 September 2024
- Published by Elsevier in Renewable Energy
- Vol. 237
Performance analysis of a novel hybrid device with floating breakwater and wave energy converter integrated
- 27 September 2024
- Published by Elsevier in Renewable Energy
- Vol. 237
Performance analysis of a novel hybrid device with floating breakwater and wave energy converter integrated
- 10 July 2024
- Published by Elsevier in Ocean Engineering
- Vol. 310
Flutter limit optimization of offshore wind turbine blades considering different control and structural parameters
- 10 July 2024
- Published by Elsevier in Ocean Engineering
- Vol. 310
Flutter limit optimization of offshore wind turbine blades considering different control and structural parameters
- 20 February 2023
- Published by Elsevier in Applied Energy
- Vol. 336
Wind power performance assessment at high plateau region: A case study of the wind farm field test on the Qinghai-Tibet plateau
- 20 February 2023
- Published by Elsevier in Applied Energy
- Vol. 336
Wind power performance assessment at high plateau region: A case study of the wind farm field test on the Qinghai-Tibet plateau
- 25 February 2022
- Published by Springer Nature in Journal of Hydrodynamics
- Vol. 34 (1) , 15-30
A brief discussion on offshore wind turbine hydrodynamics problem
- 25 February 2022
- Published by Springer Nature in Journal of Hydrodynamics
- Vol. 34 (1) , 15-30
A brief discussion on offshore wind turbine hydrodynamics problem
- 1 December 2021
- Published by Elsevier in Applied Energy
- Vol. 303
Nacelle and tower effect on a stand-alone wind turbine energy output—A discussion on field measurements of a small wind turbine
- 1 December 2021
- Published by Elsevier in Applied Energy
- Vol. 303
Nacelle and tower effect on a stand-alone wind turbine energy output—A discussion on field measurements of a small wind turbine
- Open Access
- 1 March 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 463 (1)
Experimental validation and improvement of actuator line model in the large-eddy simulation of wind-turbine wakes
Wind-turbine wakes significantly affect the power output of downstream wind turbines. In order to improve the calculation accuracy of wind-turbine wakes in the atmospheric boundary layer, a new improved actuator line - large-eddy simulation (AL-LES) method is proposed and verified by experiments. The traditional AL-LES method is improved in three aspects. Firstly, the atmospheric turbulence is generated by a dynamic k-equation LES with a wall shear stress model and a buoyancy effect model. Secondly, the nacelle and tower are modelled based on the static actuator line method. Finally, the distribution of blade body force is improved by using an anisotropic 3D Gaussian function. Based on the results of three wind tunnel experiments conducted by Norwegian University of Science and Technology (NTNU), China Aerodynamics Research and Development Centre (CARDC) and Von Karman Institute for Fluid Dynamics (VKI), the improved AL-LES method is validated from the aspects of wind-turbine power performance, the generation of tip vortex, and the distribution of wake velocity under typical offshore and onshore conditions. In addition, a full-scale wind turbine installed in Gansu is used for the experimental and numerical research. The main conclusion is that compared with the traditional method, the new AL-LES method improves the numerical accuracy by nearly 22%, and can more accurately simulate the interaction between atmospheric turbulence and wind-turbine wakes. The results can help the research of wind-turbine wakes and the micro-location selection of wind farm.
- 1 March 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 463 (1)
Open AccessExperimental validation and improvement of actuator line model in the large-eddy simulation of wind-turbine wakes
Wind-turbine wakes significantly affect the power output of downstream wind turbines. In order to improve the calculation accuracy of wind-turbine wakes in the atmospheric boundary layer, a new improved actuator line - large-eddy simulation (AL-LES) method is proposed and verified by experiments. The traditional AL-LES method is improved in three aspects. Firstly, the atmospheric turbulence is generated by a dynamic k-equation LES with a wall shear stress model and a buoyancy effect model. Secondly, the nacelle and tower are modelled based on the static actuator line method. Finally, the distribution of blade body force is improved by using an anisotropic 3D Gaussian function. Based on the results of three wind tunnel experiments conducted by Norwegian University of Science and Technology (NTNU), China Aerodynamics Research and Development Centre (CARDC) and Von Karman Institute for Fluid Dynamics (VKI), the improved AL-LES method is validated from the aspects of wind-turbine power performance, the generation of tip vortex, and the distribution of wake velocity under typical offshore and onshore conditions. In addition, a full-scale wind turbine installed in Gansu is used for the experimental and numerical research. The main conclusion is that compared with the traditional method, the new AL-LES method improves the numerical accuracy by nearly 22%, and can more accurately simulate the interaction between atmospheric turbulence and wind-turbine wakes. The results can help the research of wind-turbine wakes and the micro-location selection of wind farm.
- Open Access
- 12 June 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (12) , 2392
Study of Dynamic Response Characteristics of the Wind Turbine Based on Measured Power Spectrum in the Eyewall Region of Typhoons
The present research envisages a method for calculating the dynamic responses of the wind turbines under typhoon. The measured power spectrum and inverse Fourier transform are used to generate the fluctuating wind field in the eyewall of the typhoon. Based on the beam theory, the unsteady aerodynamic model and the wind turbine dynamic model are coupled to calculate the dynamic response. Furthermore, using this method, the aeroelastic responses of a 6 MW wind turbine at different yaw angles are studied, and a 2 MW wind turbine are also calculated to verify the applicability of the results for different sizes of wind turbines. The results show that the turbulence characteristics of the fluctuating wind simulated by the proposed method is in good agreement with the actual measurement. Compared with the results simulated by the recommended power spectrum like the Kaimal spectrum, the energy distribution and variation characteristics simulated by the proposed method represent the real typhoon in a superior manner. It is found that the blade vibrates most violently at the inflow yaw angle of 30 degrees under the coupled effect of the aerodynamic, inertial and structural loads. In addition, the load on the tower exceeds the design limit values at the yaw angles of both 30 degrees and 120 degrees.
- 12 June 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (12) , 2392
Open AccessStudy of Dynamic Response Characteristics of the Wind Turbine Based on Measured Power Spectrum in the Eyewall Region of Typhoons
The present research envisages a method for calculating the dynamic responses of the wind turbines under typhoon. The measured power spectrum and inverse Fourier transform are used to generate the fluctuating wind field in the eyewall of the typhoon. Based on the beam theory, the unsteady aerodynamic model and the wind turbine dynamic model are coupled to calculate the dynamic response. Furthermore, using this method, the aeroelastic responses of a 6 MW wind turbine at different yaw angles are studied, and a 2 MW wind turbine are also calculated to verify the applicability of the results for different sizes of wind turbines. The results show that the turbulence characteristics of the fluctuating wind simulated by the proposed method is in good agreement with the actual measurement. Compared with the results simulated by the recommended power spectrum like the Kaimal spectrum, the energy distribution and variation characteristics simulated by the proposed method represent the real typhoon in a superior manner. It is found that the blade vibrates most violently at the inflow yaw angle of 30 degrees under the coupled effect of the aerodynamic, inertial and structural loads. In addition, the load on the tower exceeds the design limit values at the yaw angles of both 30 degrees and 120 degrees.