Jaidev Kaushik
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jaidev Kaushik has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
- Sumit Kumar Sonkar
Department of Chemistry, Malaviya National Institute of Technology, Jaipur, Jaipur-302017, India
29 shared publications Nicky Kumar Lamba
Department of Chemistry
10 shared publicationsTwinkle
9 shared publicationsAnjali Kumari Garg
Department of Chemistry, Malaviya National Institute of Technology, Jaipur, Jaipur, 302017, India
7 shared publications- Kumud Malika Tripathi
Center for Emerging Technologies for Sustainable Development (CETSD) Indian Institute of Technology Jodhpur Jodhpur India
7 shared publications Shyam Kumar Choudhary
Graphene Centre, Tata Steel Limited
7 shared publications
Latest Publications
- 8 June 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (6) , 1966-1974
Iron Oxide Dust-Derived Fe 3 O 4 -CuO Nanocomposite for Adsorptive Removal of Congo Red and Benzimidazole
- 8 June 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (6) , 1966-1974
Iron Oxide Dust-Derived Fe 3 O 4 -CuO Nanocomposite for Adsorptive Removal of Congo Red and Benzimidazole
- 16 February 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (8) , 6302-6309
Earthen-Pot Assisted Carbon Aerogel Synthesis for the Adsorption of Multiple Organic Contaminants
Herein, we report a sustainable and indigenous approach for synthesizing a hydrophobic three-dimensional sugar-derived carbon aerogel (SCA) using edible sugar in a traditional Indian clay pot (used as the carbonization vessel). This simple, single-step process produces a lightweight, porous, and hydrophobic aerogel without the need for costly conventional reactors or complex drying steps. The SCA showed its adsorption capabilities towards representative industrial pollutants (benzimidazole (BZI), benzotriazole (BTA)) and pharmaceutical pollutants (paracetamol (PCM), and acetanilide (AN)). To know about the type of adsorption and various stages of adsorption, different kinetic and isotherm analyses were studied. The aerogel demonstrates recyclability with minimal loss of performance up to five cycles. Furthermore, its efficiency in spiked and real wastewater samples highlighted the material's practical scalability and low-cost applicability.
- 16 February 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (8) , 6302-6309
Earthen-Pot Assisted Carbon Aerogel Synthesis for the Adsorption of Multiple Organic Contaminants
Herein, we report a sustainable and indigenous approach for synthesizing a hydrophobic three-dimensional sugar-derived carbon aerogel (SCA) using edible sugar in a traditional Indian clay pot (used as the carbonization vessel). This simple, single-step process produces a lightweight, porous, and hydrophobic aerogel without the need for costly conventional reactors or complex drying steps. The SCA showed its adsorption capabilities towards representative industrial pollutants (benzimidazole (BZI), benzotriazole (BTA)) and pharmaceutical pollutants (paracetamol (PCM), and acetanilide (AN)). To know about the type of adsorption and various stages of adsorption, different kinetic and isotherm analyses were studied. The aerogel demonstrates recyclability with minimal loss of performance up to five cycles. Furthermore, its efficiency in spiked and real wastewater samples highlighted the material's practical scalability and low-cost applicability.
- 10 June 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 13 (25) , 19287-19291
Photocatalytic upcycling of marble waste into acetic acid by copper sulfide nanoparticles
In this study, disk-shaped copper sulfide nanoparticles (CuS-NPs) were synthesized via a simple co-precipitation method and used as a photocatalyst for the reduction of carbonate species derived from marble dust into acetic acid (AcOH). The photocatalytic reaction was carried out under monochromatic light (525 nm) in a hydrogen peroxide–water mixture using CuS-NPs. Key parameters such as solvent composition, light source, catalyst concentration and reaction time were optimized to get the maximum yield of AcOH. The reaction mechanism was investigated using radical scavenging experiments. The practical applicability of the approach was further tested on two additional real-life carbonate waste materials, i.e., chalk dust and carbonate scale.
- 10 June 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 13 (25) , 19287-19291
Photocatalytic upcycling of marble waste into acetic acid by copper sulfide nanoparticles
In this study, disk-shaped copper sulfide nanoparticles (CuS-NPs) were synthesized via a simple co-precipitation method and used as a photocatalyst for the reduction of carbonate species derived from marble dust into acetic acid (AcOH). The photocatalytic reaction was carried out under monochromatic light (525 nm) in a hydrogen peroxide–water mixture using CuS-NPs. Key parameters such as solvent composition, light source, catalyst concentration and reaction time were optimized to get the maximum yield of AcOH. The reaction mechanism was investigated using radical scavenging experiments. The practical applicability of the approach was further tested on two additional real-life carbonate waste materials, i.e., chalk dust and carbonate scale.
- 16 October 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 500
Hydrogen peroxide mediated thermo-catalytic conversion of carbon dioxide to C1-C2 products over Cu (0)
- 16 October 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 500
Hydrogen peroxide mediated thermo-catalytic conversion of carbon dioxide to C1-C2 products over Cu (0)
- 13 September 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (42) , 15484-15490
Green Light Promoted Photoreduction of Carbonate to Acetic Acid by Zinc Ash-Derived ZCu@ZnO
- 13 September 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (42) , 15484-15490
Green Light Promoted Photoreduction of Carbonate to Acetic Acid by Zinc Ash-Derived ZCu@ZnO
- 28 August 2024
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 40 (36) , 18961-18967
Waste-Derived Copper Flakes for Solvent-Free Reductive Acetamidation of Nitroarenes
Herein, waste-derived copper (Cu) flakes have been used as heterogeneous catalysts for the solvent-free and one-pot reductive acetamidation of nitroarenes. Metallic copper flakes (f-ZCu) were isolated from waste copper Cu scrap/flakes/turnings generated after the grinding and cutting (from the Cu industries). f-ZCu is being used to synthesize acetanilide with a considerable yield (similar to 82%) in one-step and solvent-free conditions within a reaction time of 6 h. Moreover, the same procedure is also being utilized for producing various substrates (9), including the gram-scale synthesis of the well-known important antipyretic drug, i.e., paracetamol. The plausible mechanism for the reaction was also proposed based on the spectroscopic analyses of spent f-ZCu.
- 28 August 2024
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 40 (36) , 18961-18967
Waste-Derived Copper Flakes for Solvent-Free Reductive Acetamidation of Nitroarenes
Herein, waste-derived copper (Cu) flakes have been used as heterogeneous catalysts for the solvent-free and one-pot reductive acetamidation of nitroarenes. Metallic copper flakes (f-ZCu) were isolated from waste copper Cu scrap/flakes/turnings generated after the grinding and cutting (from the Cu industries). f-ZCu is being used to synthesize acetanilide with a considerable yield (similar to 82%) in one-step and solvent-free conditions within a reaction time of 6 h. Moreover, the same procedure is also being utilized for producing various substrates (9), including the gram-scale synthesis of the well-known important antipyretic drug, i.e., paracetamol. The plausible mechanism for the reaction was also proposed based on the spectroscopic analyses of spent f-ZCu.
- 12 August 2024
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 40 (34) , 18028-18038
Graphene Incorporated Sugar Derived Carbon Aerogel for Pyridine Adsorption and Oil–Water Separation
Herein, we have synthesized a three-dimensional and hydrophobic graphene incorporated carbon aerogel (G-SCA) derived from sugar. G-SCA is being used as a multifunctional sorbent material for removing various advanced water-soluble and insoluble pollutants. Initially, G-SCA is being explored for the adsorption of nitroarenes (nitrophenols, 3-nitroaniline), an insecticide (Phoskill), an antibiotic (ciprofloxacin), and a pharmaceutical drug precursor (pyridine). Later, the same G-SCA is also explored in the absorption of various protic and aprotic organic solvents, and oils (including crude oil, waste cooking oil, and waste engine oil), with excellent recyclability checked up to 10 cycles. Moreover, oil-water separation experiments are also being done in various industrial wastewater and seawater samples to support the real-life accessibility of the present approach. Large-scale applicability of G-SCA is also checked by performing crude oil-seawater separation experiments using a laboratory-scale prototype demonstrating the successful continuous recovery of crude oil.
- 12 August 2024
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 40 (34) , 18028-18038
Graphene Incorporated Sugar Derived Carbon Aerogel for Pyridine Adsorption and Oil–Water Separation
Herein, we have synthesized a three-dimensional and hydrophobic graphene incorporated carbon aerogel (G-SCA) derived from sugar. G-SCA is being used as a multifunctional sorbent material for removing various advanced water-soluble and insoluble pollutants. Initially, G-SCA is being explored for the adsorption of nitroarenes (nitrophenols, 3-nitroaniline), an insecticide (Phoskill), an antibiotic (ciprofloxacin), and a pharmaceutical drug precursor (pyridine). Later, the same G-SCA is also explored in the absorption of various protic and aprotic organic solvents, and oils (including crude oil, waste cooking oil, and waste engine oil), with excellent recyclability checked up to 10 cycles. Moreover, oil-water separation experiments are also being done in various industrial wastewater and seawater samples to support the real-life accessibility of the present approach. Large-scale applicability of G-SCA is also checked by performing crude oil-seawater separation experiments using a laboratory-scale prototype demonstrating the successful continuous recovery of crude oil.
- 18 June 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (26) , 11717-11723
Multiphase Reduced Iron Oxide Nanoparticles for Hydrogenation of Mono-, Di-, and Tri-Nitrophenols
- 18 June 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (26) , 11717-11723
Multiphase Reduced Iron Oxide Nanoparticles for Hydrogenation of Mono-, Di-, and Tri-Nitrophenols
- 24 April 2024
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 48 (18) , 8030-8033
Deploying used solid carbon dioxide to assist graphite exfoliation
Herein, we describe the possibility of deploying used solid CO2, also known as dry ice, as an exfoliating agent for thermal-assisted exfoliation of graphite, improving its surface and magnetic properties.
- 24 April 2024
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 48 (18) , 8030-8033
Deploying used solid carbon dioxide to assist graphite exfoliation
Herein, we describe the possibility of deploying used solid CO2, also known as dry ice, as an exfoliating agent for thermal-assisted exfoliation of graphite, improving its surface and magnetic properties.