Xuejun Shao

In this study, the coupled effects of sediment inertia and stratification on the pattern of secondary currents in bend-flows are evaluated using a 3D numerical model. The sediment inertia effect, as well as the stratification effect induced by the non-uniform distribution of suspended sediment, is accounted for by adopting the hydrodynamic equations without the Boussinesq approximation. The 3D model is validated by existing laboratory experimental results. Simulation results of a simplified meandering channel indicate that sediment stratification effect enhances the intensity of secondary flow via reducing eddy viscosity, while sediment inertia effect suppresses it. The integrated effects result in an increase and a reduction in the secondary flow, respectively, at lower and higher concentrations (near-bed volumetric concentrations of 0.015 and 0.1 are, respectively, considered in this study). This suggests that the dominance of the suspended sediment effect depends on the sediment concentration profile. With the increase of concentration under a specific sediment size, the secondary flow rises to reach a maximum, and then decreases. Moreover, as the sediment concentration increases, an exponentially decaying rate has been found for the secondary flow. It is concluded that in the numerical simulation of flow in meandering channels, when concentration is high, the variable-density hydrodynamic equations without the Boussinesq approximation should be considered.

This paper is focused on the sedimentation processes of fine-grained particles in a 14-km-long section upstream of the Three Gorges Dam, referred to as the dam area, during the period from March 2003 to October 2006. Field measurements indicated that sediment deposits in the dam area were mostly found at the bottom of the main channel, where a new river bed was formed with a flat, nearly horizontal surface. In contrast, very little deposits could be found on the bank slopes of the channel. The observations disagree with the previous predictions based on numerical models, which suggested more evenly distribution of deposits over the cross section. This paper explains the discrepancy by identifying the motion of muddy deposits by gravity as a key process in the dam area. A three-dimensional (3D) full Reynolds-Averaged Navier-Stokes (RANS) model is applied to calculate the flow and sediment transport processes. A critical slope method (CSM) is used to estimate the downslope movement of muddy deposits in the bottom by gravity. The formation of bottom deposits is successfully simulated using this approach. The simulated sedimentation patterns agree well with field observations.

This paper presents a two-dimensional morphological model for unsteady flow and both suspended-load and bed-load transport of multiple grain size to simulate transport of graded sediments downstream from the Three Gorges Reservoir. The model system includes a hydrodynamic module and a sediment module. The hydrodynamic module is based on the depth-averaged shallow water equations in orthogonal curvilinear coordinates. The sediment module describing nonuniform sediment transport is developed to include nonequilibrium transport processes, bed deformation, and bed material sorting. The model was calibrated using field observations through application to a 63-km-long alluvial river channel on the middle Yangtze River in China. A total of 16 size groups and a loose layer method of three sublayers were considered for the transport of the nonuniform bed materials in a long-term simulation. Predictions are compared with preliminary results of field observations and factors affecting the reliability of the simulate...