Pierre Perichon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Pierre Perichon has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- B. Schwartzmann
CEA LETI/LITEN, Minatec, Grenoble, France
1 shared publication - David Frey
Universite Grenoble Alpes, 27015 Saint-Martin-d'Heres, Rhone-Alpes France
1 shared publication J. Dahmani
Grenoble INP, GIPSA-lab, St Martin d’Hères, France
1 shared publication- Jia Zhuang
Department of Electrical Engineering, Stanford University, Stanford, CA, USA
1 shared publication - Pierre-Olivier Jeannin
Universite Grenoble Alpes, 27015 Saint-Martin-d'Heres, Rhone-Alpes France
1 shared publication - Rawad Makhoul
LITEN, CEA Grenoble, 70610 Grenoble France 38000
1 shared publication
Latest Publications
- 13 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (9) , 8289-8292
A Very High Frequency Self-Oscillating Inverter Based on a Novel Free-Running Oscillator
This paper introduces a self oscillating very high frequency (VHF) class $\phi 2$ inverter based on a free-running oscillator. The class $\phi 2$ is a low voltage semiconductor stress, fast transient, single transistor inverter topology suitable for very high frequency applications. With new advancements in GaN technology, the tendency to increase the switching frequency in power converters is on the rise. Switching at very high frequency (VHF: 30MHz-300MHz) allows for smaller passive components and more compact power converters. However, although GaN components are able to switch at 100 MHz and beyond, gate drivers available in the market struggle to provide the adequate switching signal at very high frequency. Hence, there is a need for an alternative to VHF converters using those gate drivers : self-oscillating topologies. To that end, a self-oscillating class $\phi 2$ inverter switching at 30 MHz is presented and a design methodology is provided. A 30MHz prototype with 30V input voltage using a GaN Systems GS61004B is also built and tested, showing good matching between the simulation and experimental results.- 13 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (9) , 8289-8292
A Very High Frequency Self-Oscillating Inverter Based on a Novel Free-Running Oscillator
This paper introduces a self oscillating very high frequency (VHF) class $\phi 2$ inverter based on a free-running oscillator. The class $\phi 2$ is a low voltage semiconductor stress, fast transient, single transistor inverter topology suitable for very high frequency applications. With new advancements in GaN technology, the tendency to increase the switching frequency in power converters is on the rise. Switching at very high frequency (VHF: 30MHz-300MHz) allows for smaller passive components and more compact power converters. However, although GaN components are able to switch at 100 MHz and beyond, gate drivers available in the market struggle to provide the adequate switching signal at very high frequency. Hence, there is a need for an alternative to VHF converters using those gate drivers : self-oscillating topologies. To that end, a self-oscillating class $\phi 2$ inverter switching at 30 MHz is presented and a design methodology is provided. A 30MHz prototype with 30V input voltage using a GaN Systems GS61004B is also built and tested, showing good matching between the simulation and experimental results.- Open Access
- 27 September 2013
- Published by MDPI AG in World Electric Vehicle Journal
- Vol. 6 (3) , 762-770
Detection of Electric Arcs in Large Batteries
This paper addresses the precocious detection of electric arcs in an electric vehicle battery generated by a connector fault. The detection principle is based on the acoustic emission of the arc. First, the identification of the electric arc acoustic signature as well as disturbances in the environment of detection has been realized. Subsequently, we have been focused on the propagation of acoustic waves emitted by the arc in the confined environment of the battery. We proposed a detection method based on correlation whose performance was evaluated. Finally, a localization system based on signal time-difference-of-arrival estimation and triangulation is described and assessed. A demonstrator has been developed and validates the detection performance.
- 27 September 2013
- Published by MDPI AG in World Electric Vehicle Journal
- Vol. 6 (3) , 762-770
Open AccessDetection of Electric Arcs in Large Batteries
This paper addresses the precocious detection of electric arcs in an electric vehicle battery generated by a connector fault. The detection principle is based on the acoustic emission of the arc. First, the identification of the electric arc acoustic signature as well as disturbances in the environment of detection has been realized. Subsequently, we have been focused on the propagation of acoustic waves emitted by the arc in the confined environment of the battery. We proposed a detection method based on correlation whose performance was evaluated. Finally, a localization system based on signal time-difference-of-arrival estimation and triangulation is described and assessed. A demonstrator has been developed and validates the detection performance.