Hana Chaloupecká
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hana Chaloupecká has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
Zbyněk Jaňour
9 shared publicationsKlára Jurčáková
Institute of Thermomechanics, Academy of Sciences of the Czech Republic
6 shared publicationsRadka Kellnerová
6 shared publications- Štěpán Nosek
Institute of Thermomechanics Academy of Sciences of the Czech Republic, v.v.i. Dolejškova 1402/5, Prague 182 00, Czech Republic
5 shared publications - Zbyněk Jaňour
Institute of Thermomechanics
4 shared publications Jan Suchánek
3 shared publications
Latest Publications
- Open Access
- 12 November 2026
- Published by MDPI AG in Atmosphere
- Vol. 17 (11) , 1119
Review on Monitoring and Measurement Strategies for Ammonia Combustion-Related N2O Emissions
While global decarbonization and low-temperature engines curb nitrogen oxides, they risk significant N2O emissions, which is also one of the greenhouse gases. This review evaluates N2O monitoring strategies across maritime and industrial combustion environments. Furthermore, this paper provides a rigorous comparative assessment of analytical monitoring methodologies. We evaluate the adaptability of established agricultural techniques. In parallel, advanced spectroscopic and non-spectroscopic sensor technologies (DAS, NDIR, TDLAS, PAS, CRDS, CEAS, FTIR, GC, and electrochemical/chemiresistive sensors) are critically analyzed regarding their sensitivity, response time, cross-interference vulnerabilities, and suitability for harsh industrial stacks and maritime settings. Finally, the levels of N2O above background from individual sources are estimated using wind-tunnel modeling studies. Emissions from ships, truck lines, and industrial turbines typically cause urban ambient concentrations ranging from hundreds down to tens of ppb, whereas individual trucks and rural ship levels are significantly lower, from below 1 ppb up to about 70 ppb depending on engine optimization. For industrial and combustion sources, real-time N2O analysis can be performed using FTIR, which allows for multi-gas mixture measurement, or TDLAS for targeted N2O detection. For distributed screening and monitoring around industrial plants, NDIR is a technically viable option under specific conditions. For mobile sources, TDLAS, FTIR, and highly sensitive cavity-enhanced methods (CRDS, CEAS) are suitable, provided they are optimized for harsh conditions. NDIR is applicable here only in dense urban areas. In all scenarios, gas chromatography can be used, though it requires physical sample collection and does not offer real-time analysis. As we will show, electrochemical and chemiresistive sensors cannot currently be used. Similarly, PAS is unsuitable for ambient enhancement detection, despite its applicability to stack sampling.
- 12 November 2026
- Published by MDPI AG in Atmosphere
- Vol. 17 (11) , 1119
Open AccessReview on Monitoring and Measurement Strategies for Ammonia Combustion-Related N2O Emissions
While global decarbonization and low-temperature engines curb nitrogen oxides, they risk significant N2O emissions, which is also one of the greenhouse gases. This review evaluates N2O monitoring strategies across maritime and industrial combustion environments. Furthermore, this paper provides a rigorous comparative assessment of analytical monitoring methodologies. We evaluate the adaptability of established agricultural techniques. In parallel, advanced spectroscopic and non-spectroscopic sensor technologies (DAS, NDIR, TDLAS, PAS, CRDS, CEAS, FTIR, GC, and electrochemical/chemiresistive sensors) are critically analyzed regarding their sensitivity, response time, cross-interference vulnerabilities, and suitability for harsh industrial stacks and maritime settings. Finally, the levels of N2O above background from individual sources are estimated using wind-tunnel modeling studies. Emissions from ships, truck lines, and industrial turbines typically cause urban ambient concentrations ranging from hundreds down to tens of ppb, whereas individual trucks and rural ship levels are significantly lower, from below 1 ppb up to about 70 ppb depending on engine optimization. For industrial and combustion sources, real-time N2O analysis can be performed using FTIR, which allows for multi-gas mixture measurement, or TDLAS for targeted N2O detection. For distributed screening and monitoring around industrial plants, NDIR is a technically viable option under specific conditions. For mobile sources, TDLAS, FTIR, and highly sensitive cavity-enhanced methods (CRDS, CEAS) are suitable, provided they are optimized for harsh conditions. NDIR is applicable here only in dense urban areas. In all scenarios, gas chromatography can be used, though it requires physical sample collection and does not offer real-time analysis. As we will show, electrochemical and chemiresistive sensors cannot currently be used. Similarly, PAS is unsuitable for ambient enhancement detection, despite its applicability to stack sampling.
- Open Access
- 3 November 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (11) , 1326
Varying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
Air pollution monitoring in industrial regions like Moravia-Silesia faces challenges due to complex environmental conditions. Low-cost sensors offer a promising, cost-effective alternative for supplementing data from regulatory-grade air quality monitoring stations. This study evaluates the accuracy and reliability of a prototype node containing low-cost sensors for carbon monoxide (CO) and particulate matter (PM), specifically tailored for the local conditions of the Moravian-Silesian Region during winter and spring periods. An analysis of the reference data observed during the winter evaluation period showed a strong positive correlation between PM, CO, and concentrations, attributable to common pollution sources under low ambient temperature conditions and increased local heating activity. The Sensirion SPS30 sensor exhibited high linearity during the winter period but showed a systematic positive bias in readings during Polish smog episodes, likely due to fine particles from domestic heating. Conversely, during Saharan dust storm episodes, the sensor showed a negative bias, underestimating levels due to the prevalence of coarse particles. Calibration adjustments, based on the ratio derived from Alphasense OPC-N3 data, were initially explored to reduce these biases. For the first time, this study quantifies the influence of particle size distribution on the SPS30 sensor’s response during smog episodes of varying origin, under the given local and seasonal conditions. In addition to sensor evaluation, we analyzed the potential use of data from the Copernicus Atmospheric Monitoring Service (CAMS) as an alternative to increasing sensor complexity. Our findings suggest that, with appropriate calibration, selected low-cost sensors can provide reliable data for monitoring air pollution episodes in the Moravian-Silesian Region and may also be used for future adjustments of CAMS model predictions.- 3 November 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (11) , 1326
Open AccessVarying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
Air pollution monitoring in industrial regions like Moravia-Silesia faces challenges due to complex environmental conditions. Low-cost sensors offer a promising, cost-effective alternative for supplementing data from regulatory-grade air quality monitoring stations. This study evaluates the accuracy and reliability of a prototype node containing low-cost sensors for carbon monoxide (CO) and particulate matter (PM), specifically tailored for the local conditions of the Moravian-Silesian Region during winter and spring periods. An analysis of the reference data observed during the winter evaluation period showed a strong positive correlation between PM, CO, and concentrations, attributable to common pollution sources under low ambient temperature conditions and increased local heating activity. The Sensirion SPS30 sensor exhibited high linearity during the winter period but showed a systematic positive bias in readings during Polish smog episodes, likely due to fine particles from domestic heating. Conversely, during Saharan dust storm episodes, the sensor showed a negative bias, underestimating levels due to the prevalence of coarse particles. Calibration adjustments, based on the ratio derived from Alphasense OPC-N3 data, were initially explored to reduce these biases. For the first time, this study quantifies the influence of particle size distribution on the SPS30 sensor’s response during smog episodes of varying origin, under the given local and seasonal conditions. In addition to sensor evaluation, we analyzed the potential use of data from the Copernicus Atmospheric Monitoring Service (CAMS) as an alternative to increasing sensor complexity. Our findings suggest that, with appropriate calibration, selected low-cost sensors can provide reliable data for monitoring air pollution episodes in the Moravian-Silesian Region and may also be used for future adjustments of CAMS model predictions. - Open Access
- 3 October 2024
- Published by MDPI AG in Preprints.org
Varying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
This study examines the varying performance of low-cost sensors during seasonal smog events, particularly those resulting from solid fuel combustion linked to residential or industrial heating and other pollution sources. A prototype low-cost sensor node developed within this work was collocated for several months with reference equipment at an air quality monitoring station in the city of Ostrava (Moravian-Silesian region, Czech Republic). Deterioration of air quality during a pair of smog alert events, namely wintertime "Polish smog" episode and springtime "Saharan dust storm", which occurred through the extended period of co-location, was characterized quantitatively based on particulate matter and carbon monoxide concentrations measured by the low-cost sensors. These datasets were compared with reference data and model predictions provided by the Copernicus Atmospheric Monitoring Service. Selected low-cost sensors demonstrated linear response during Polish smog episode with highly correlated time series of carbon monoxide and particulate matter concentrations. However, when compared to reference data, the Sensirion SPS30 sensor is found to overestimate coarse particle (PM10) concentrations by the factor of two during winter evaluation period. On the other hand, oppositely biased PM10 response (underestimation by the factor of five) was determined from co-location measurement during Saharan dust storm event. This observation was attributed to combination of specific detection efficiency of the given low-cost sensor and shifts in particle size distribution due to seasonal change of ambient conditions.
- 3 October 2024
- Published by MDPI AG in Preprints.org
Open AccessVarying Performance of Low-Cost Sensors During Seasonal Smog Events in Moravian-Silesian Region
This study examines the varying performance of low-cost sensors during seasonal smog events, particularly those resulting from solid fuel combustion linked to residential or industrial heating and other pollution sources. A prototype low-cost sensor node developed within this work was collocated for several months with reference equipment at an air quality monitoring station in the city of Ostrava (Moravian-Silesian region, Czech Republic). Deterioration of air quality during a pair of smog alert events, namely wintertime "Polish smog" episode and springtime "Saharan dust storm", which occurred through the extended period of co-location, was characterized quantitatively based on particulate matter and carbon monoxide concentrations measured by the low-cost sensors. These datasets were compared with reference data and model predictions provided by the Copernicus Atmospheric Monitoring Service. Selected low-cost sensors demonstrated linear response during Polish smog episode with highly correlated time series of carbon monoxide and particulate matter concentrations. However, when compared to reference data, the Sensirion SPS30 sensor is found to overestimate coarse particle (PM10) concentrations by the factor of two during winter evaluation period. On the other hand, oppositely biased PM10 response (underestimation by the factor of five) was determined from co-location measurement during Saharan dust storm event. This observation was attributed to combination of specific detection efficiency of the given low-cost sensor and shifts in particle size distribution due to seasonal change of ambient conditions.
- 9 February 2024
- Published by Elsevier in Journal of Molecular Spectroscopy
- Vol. 400
Chemometrics approach to Cantilever enhanced photoacoustic spectroscopy with Quantum Cascade lasers
- 9 February 2024
- Published by Elsevier in Journal of Molecular Spectroscopy
- Vol. 400
Chemometrics approach to Cantilever enhanced photoacoustic spectroscopy with Quantum Cascade lasers
- 14 November 2021
- Published by Springer Nature
- p. 295-299
Emergency Local-Scale Dispersion (ELSI) Software
- 14 November 2021
- Published by Springer Nature
- p. 295-299
Emergency Local-Scale Dispersion (ELSI) Software
- Open Access
- 8 January 2021
- Published by MDPI AG in Atmosphere
- Vol. 12 (1) , 88
Characteristics of Toxic Gas Leakages with Change in Duration
One of the emergencies rescue crews have to face is toxic gas leakages. The characteristics of the gas leakages differ with regard to their leakage duration. Long-term releases have plume-like behaviors that can be described by utilizing mean concentrations at individual exposed locations. In contrast, ensemble statistics of individual cloud characteristics are needed for short-term releases with puff-like behaviors to ensure fully aware risk assessment. The reason is that the time evolution of the concentration of short-term gas releases can differ wildly under the same mean ambient and leakage conditions. The duration from which the release can be classified as plume-like can be found only by studying the releases of different durations, which is the main aim of this paper. To investigate gas releases of different durations, wind tunnel experiments of gas releases in an idealized urban area were conducted. The results present a new method by which concentration signals of releases can be divided into three cloud phases: the arrival, the central and the departure cloud phase. The characteristics (e.g., lengths, mean concentrations) of the individual cloud phases are explored. The results indicate that the finite-duration releases for which the central cloud phase exists have the plume-like behavior for this cloud part.
- 8 January 2021
- Published by MDPI AG in Atmosphere
- Vol. 12 (1) , 88
Open AccessCharacteristics of Toxic Gas Leakages with Change in Duration
One of the emergencies rescue crews have to face is toxic gas leakages. The characteristics of the gas leakages differ with regard to their leakage duration. Long-term releases have plume-like behaviors that can be described by utilizing mean concentrations at individual exposed locations. In contrast, ensemble statistics of individual cloud characteristics are needed for short-term releases with puff-like behaviors to ensure fully aware risk assessment. The reason is that the time evolution of the concentration of short-term gas releases can differ wildly under the same mean ambient and leakage conditions. The duration from which the release can be classified as plume-like can be found only by studying the releases of different durations, which is the main aim of this paper. To investigate gas releases of different durations, wind tunnel experiments of gas releases in an idealized urban area were conducted. The results present a new method by which concentration signals of releases can be divided into three cloud phases: the arrival, the central and the departure cloud phase. The characteristics (e.g., lengths, mean concentrations) of the individual cloud phases are explored. The results indicate that the finite-duration releases for which the central cloud phase exists have the plume-like behavior for this cloud part.
- 24 November 2019
- Published by Springer Nature in Springer Proceedings in Complexity
- p. 363-368
Model of Arrival Time for Gas Clouds in Urban Canopy
- 24 November 2019
- Published by Springer Nature in Springer Proceedings in Complexity
- p. 363-368
Model of Arrival Time for Gas Clouds in Urban Canopy