Yu Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yu Li has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
Chao Yong
School of Metallurgical Engineering, Anhui University of Technology, Ma’anshan 243032, P. R. China
14 shared publicationsYing Lei
11 shared publications- Ying Lei
School of Mechanical Engineering, Tongling University, Tongling 244000, P. R. China
8 shared publications Fan Ye
School of Metallurgical Engineering, Anhui University of Technology, Ma’anshan 243032, P. R. China
7 shared publicationsFeng Gao
Anhui Univ Technol, Sch Met Engn, Maanshan 243032, Peoples R China
7 shared publicationsJin Qiu
7 shared publications
Latest Publications
- 7 November 2025
- Published by World Scientific Pub Co Pte Ltd in Nano
Research on the Microwave Hydrothermal Synthesis of Water Hyacinth-Based CDs and Their Potential Application in LEDs
Biomass is widely used for the synthesis of high-performance carbon dots (CDs) because of its environmentally friendly and recyclable properties. In this study, long-wavelength luminescent CDs were synthesized by a green and simple microwave hydrothermal method using water hyacinth as a carbon source. The fluorescence emission of CDs will be significantly red-shifted to 678 nm after the introduction of dimethylformamide (DMF). It was demonstrated that the red light of CDs is caused by the increase of sp 2 conjugated structural domains and graphite N. The fluorescence emission of long-wavelength luminescent CDs is significantly shifted to 678[ ]nm after the introduction of DMF. Subsequently, the resulting CDs were initially used in fluorescent films and light-emitting diodes (LEDs). This provides a new approach to utilizing water hyacinth resources and has the potential to integrate biomass CDs into light-emitting diodes on a large scale.
- 7 November 2025
- Published by World Scientific Pub Co Pte Ltd in Nano
Research on the Microwave Hydrothermal Synthesis of Water Hyacinth-Based CDs and Their Potential Application in LEDs
Biomass is widely used for the synthesis of high-performance carbon dots (CDs) because of its environmentally friendly and recyclable properties. In this study, long-wavelength luminescent CDs were synthesized by a green and simple microwave hydrothermal method using water hyacinth as a carbon source. The fluorescence emission of CDs will be significantly red-shifted to 678 nm after the introduction of dimethylformamide (DMF). It was demonstrated that the red light of CDs is caused by the increase of sp 2 conjugated structural domains and graphite N. The fluorescence emission of long-wavelength luminescent CDs is significantly shifted to 678[ ]nm after the introduction of DMF. Subsequently, the resulting CDs were initially used in fluorescent films and light-emitting diodes (LEDs). This provides a new approach to utilizing water hyacinth resources and has the potential to integrate biomass CDs into light-emitting diodes on a large scale.
- 29 May 2025
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 25 (23) , 9262-9269
Multiscale Microstructures and Carrier–Phonon Decoupling in BiCuSeO-CDs Composites
Owing to the carrier-phonon coupling, the majority of thermoelectric materials such as BiCuSeO adopt the strategy of sacrificing carrier mobility and thermal properties to improve the electrical performance so as to enhance the zT value. In response, we innovatively introduce carbon dots (CDs) as a nanophase and efficiently synthesize Bi0.88Ca0.06Pb0.06CuSeO-CDs composites, attenuating the carrier-phonon coupling while realizing the structure optimization on the multiscale. The addition of CDs improves the electrical performance (PFmax = 883.99 μW m-1 K-2), and CDs introduce multiscale defects that strongly scatter phonons across multiple frequencies, drastically reducing the lattice thermal conductivity to 0.14 W m-1 K-1. The BCPCSO-0.15 wt % CDs achieve a record zT value of 1.82 at 873 K, representing a 61.97% enhancement of the BCPCSO matrix, with an average zT value reaching 1.11. This research offers an economical, efficient, and scalable approach to improve thermoelectric performance of BiCuSeO, offering a novel pathway for performance optimization of other structurally similar thermoelectric materials.
- 29 May 2025
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 25 (23) , 9262-9269
Multiscale Microstructures and Carrier–Phonon Decoupling in BiCuSeO-CDs Composites
Owing to the carrier-phonon coupling, the majority of thermoelectric materials such as BiCuSeO adopt the strategy of sacrificing carrier mobility and thermal properties to improve the electrical performance so as to enhance the zT value. In response, we innovatively introduce carbon dots (CDs) as a nanophase and efficiently synthesize Bi0.88Ca0.06Pb0.06CuSeO-CDs composites, attenuating the carrier-phonon coupling while realizing the structure optimization on the multiscale. The addition of CDs improves the electrical performance (PFmax = 883.99 μW m-1 K-2), and CDs introduce multiscale defects that strongly scatter phonons across multiple frequencies, drastically reducing the lattice thermal conductivity to 0.14 W m-1 K-1. The BCPCSO-0.15 wt % CDs achieve a record zT value of 1.82 at 873 K, representing a 61.97% enhancement of the BCPCSO matrix, with an average zT value reaching 1.11. This research offers an economical, efficient, and scalable approach to improve thermoelectric performance of BiCuSeO, offering a novel pathway for performance optimization of other structurally similar thermoelectric materials.
- 19 March 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
Enhanced Thermoelectric Properties of AgSb1–xPbxBiySe2 Achieved via Microwave Smelting Combined with Spark Plasma Sintering
In this study, two series of thermoelectric (TE) materials, AgSb1-xPbxSe2 (x = 0.00, 0.035, 0.04, 0.045, and 0.05) and AgSb0.955Pb0.045BiySe2 (y = 0.01, 0.015, 0.02, and 0.025), were fabricated that are achieved via microwave smelting (MS) combined with spark plasma sintering (SPS). Although Pb doping effectively increased the carrier concentration (n) of the AgSb1-xPbxSe2 materials, it substantially restricted the improvement in carrier mobility (μH), leading to a nonsignificant enhancement in the dimensionless figure of merit (ZT). To address this issue, AgSb1-xPbxSe2 was doped with Bi to optimize n and μH. The phase composition, microstructure, and electrical and thermal transport properties of the materials were characterized in the temperature range of 300-723 K. The AgSb0.955Pb0.045Bi0.025Se2 material exhibited a maximum power factor of 720 μWK-2 m-1 at 723 K and a reduced lattice thermal conductivity of 0.36 Wm1- K-1. Consequently, a ZT value as high as 1.23 was obtained at 723 K. This study demonstrates that microwave smelting - SPS is an efficient and environmentally friendly method for the synthesis of Pb- and Bi-doped AgSbSe2 materials with excellent TE transport properties.
- 19 March 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
Enhanced Thermoelectric Properties of AgSb1–xPbxBiySe2 Achieved via Microwave Smelting Combined with Spark Plasma Sintering
In this study, two series of thermoelectric (TE) materials, AgSb1-xPbxSe2 (x = 0.00, 0.035, 0.04, 0.045, and 0.05) and AgSb0.955Pb0.045BiySe2 (y = 0.01, 0.015, 0.02, and 0.025), were fabricated that are achieved via microwave smelting (MS) combined with spark plasma sintering (SPS). Although Pb doping effectively increased the carrier concentration (n) of the AgSb1-xPbxSe2 materials, it substantially restricted the improvement in carrier mobility (μH), leading to a nonsignificant enhancement in the dimensionless figure of merit (ZT). To address this issue, AgSb1-xPbxSe2 was doped with Bi to optimize n and μH. The phase composition, microstructure, and electrical and thermal transport properties of the materials were characterized in the temperature range of 300-723 K. The AgSb0.955Pb0.045Bi0.025Se2 material exhibited a maximum power factor of 720 μWK-2 m-1 at 723 K and a reduced lattice thermal conductivity of 0.36 Wm1- K-1. Consequently, a ZT value as high as 1.23 was obtained at 723 K. This study demonstrates that microwave smelting - SPS is an efficient and environmentally friendly method for the synthesis of Pb- and Bi-doped AgSbSe2 materials with excellent TE transport properties.
- 1 February 2025
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1345, 343763
Regulation mechanisms of tea residue-based carbon dots in water-induced full-color emission and applications of visual ratio water sensors in organic solvents and WLEDs
- 1 February 2025
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1345, 343763
Regulation mechanisms of tea residue-based carbon dots in water-induced full-color emission and applications of visual ratio water sensors in organic solvents and WLEDs
- 1 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (9) , 11331-11337
Optimization of thermoelectric performance in BiCuSeO-based materials by constructing Cu2Se composite interface
- 1 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (9) , 11331-11337
Optimization of thermoelectric performance in BiCuSeO-based materials by constructing Cu2Se composite interface
- 6 July 2024
- Published by Elsevier in Materials Today Communications
- Vol. 40
Introduction of interstitial Cu atoms is beneficial to improving the thermoelectric performance of TiNiSn
- 6 July 2024
- Published by Elsevier in Materials Today Communications
- Vol. 40
Introduction of interstitial Cu atoms is beneficial to improving the thermoelectric performance of TiNiSn
- Open Access
- 24 January 2024
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 160 (4)
Composite of carbon dots and TiNiSn thermoelectric materials: Initial investigation on the electrical and thermal transport properties
TiNiCu0.025Sn0.99Sb0.01 is prepared using microwaves. However, an ultra-high electrical conductivity and electronic thermal conductivity are obtained by interstitial Cu and Sb doping, which could not effectively improve the ZT value. We introduce carbon dots (CDs) as a nano-second phase by ball milling to simultaneously optimize the thermoelectric properties. To our best knowledge, this is the first report on half-Heusler/CDs composites. Experimental results show that the introduction of nano-CDs optimizes the carrier concentration and mobility and dramatically improves the Seebeck coefficient through the energy filtering effect. The nano-CDs introduce more point defects, inhibit the grains growth, and form a specific carbon solid solution second phase in the matrix. The lattice thermal conductivity is reduced to the same level as TiNiSn at 1.96 W m−1 K−1 through the synergistic effect of point defects and phase and grain boundaries scattering, and the ZT value reaches a maximum of 0.63 at 873 K.
- 24 January 2024
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 160 (4)
Open AccessComposite of carbon dots and TiNiSn thermoelectric materials: Initial investigation on the electrical and thermal transport properties
TiNiCu0.025Sn0.99Sb0.01 is prepared using microwaves. However, an ultra-high electrical conductivity and electronic thermal conductivity are obtained by interstitial Cu and Sb doping, which could not effectively improve the ZT value. We introduce carbon dots (CDs) as a nano-second phase by ball milling to simultaneously optimize the thermoelectric properties. To our best knowledge, this is the first report on half-Heusler/CDs composites. Experimental results show that the introduction of nano-CDs optimizes the carrier concentration and mobility and dramatically improves the Seebeck coefficient through the energy filtering effect. The nano-CDs introduce more point defects, inhibit the grains growth, and form a specific carbon solid solution second phase in the matrix. The lattice thermal conductivity is reduced to the same level as TiNiSn at 1.96 W m−1 K−1 through the synergistic effect of point defects and phase and grain boundaries scattering, and the ZT value reaches a maximum of 0.63 at 873 K.
- 15 April 2023
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 323
Enhancement of thermoelectric performance in TiNiSbxSn1-x half-Heusler alloys
- 15 April 2023
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 323
Enhancement of thermoelectric performance in TiNiSbxSn1-x half-Heusler alloys
- 1 March 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (5) , 2913-2918
Microstructure and High-Temperature Thermoelectric Performance of InxCo4Sb12 Fabricated via Microwave Synthesis Combined with Spark Plasma Sintering
- 1 March 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (5) , 2913-2918
Microstructure and High-Temperature Thermoelectric Performance of InxCo4Sb12 Fabricated via Microwave Synthesis Combined with Spark Plasma Sintering