Anoar Ali Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Anoar Ali Khan has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Gopinath Halder
Department of Chemical Engineering, National Institute of Technology Durgapur, Durgapur-713209, West Bengal, India
9 shared publications Sumalatha Boddu
Technology and Research
6 shared publicationsA.K. Saha
Department of Chemical Engineering, Haldia Institute of Technology, Haldia, India
4 shared publicationsJohn Babu Dulla
Department of Biotechnology, Vignan’s Foundation for Science, Technology and Research, Guntur, India
3 shared publicationsMadhumanti Mondal
Department of Chemical Engineering, National Institute of Technology Durgapur, Durgapur, India
3 shared publicationsIndira Mikkili
Department of Biotechnology, Vignan’s Foundation for Science, Technology and Research, Guntur, India
2 shared publications
Latest Publications
- 18 April 2026
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 106 (13) , 4416-4433
N,S co-doped biochar derived from Eichhornia crassipes for rapid and selective removal of Malachite Green from wastewater
- 18 April 2026
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 106 (13) , 4416-4433
N,S co-doped biochar derived from Eichhornia crassipes for rapid and selective removal of Malachite Green from wastewater
- 10 March 2025
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 236 (4) , 1-18
Green Synthesis of Copper Oxide Nanoparticles (CuONPs) using Ricinus Communis: Efficient Photocatalytic Dye Degradation and Antibacterial Applications
- 10 March 2025
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 236 (4) , 1-18
Green Synthesis of Copper Oxide Nanoparticles (CuONPs) using Ricinus Communis: Efficient Photocatalytic Dye Degradation and Antibacterial Applications
- 20 November 2024
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 15 (10) , 15399-15415
Innovative magnetic biochar for textile wastewater treatment: a sustainable solution for methylene blue and Congo Red dye removal
- 20 November 2024
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 15 (10) , 15399-15415
Innovative magnetic biochar for textile wastewater treatment: a sustainable solution for methylene blue and Congo Red dye removal
- 1 January 2022
- Published by Elsevier in Materials Today: Proceedings
- Vol. 57, 1585-1592
Sustainable removal of Cr(VI) from wastewater by Peltophorum pterocarpum leaf powder
- 1 January 2022
- Published by Elsevier in Materials Today: Proceedings
- Vol. 57, 1585-1592
Sustainable removal of Cr(VI) from wastewater by Peltophorum pterocarpum leaf powder
- 25 August 2021
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (41) , 61856-61869
Assessment of algal biomass towards removal of Cr(VI) from tannery effluent: a sustainable approach
The current investigation focuses on a systematic study of application of two dried algal biomass (i.e., Nostoc sp. and Turbinaria vulgaris) in removal of Cr(VI) from synthetic solution as well as tannery industrial wastewater. The optimized conditions for Cr(VI) removal are nearly same for the both the biosorbents (i.e., pH 2.8, initial Cr(VI) concentration 100 mg L−1, biomass dosage of 1.2g L−1, contact time 120 and 110 min). Nostoc sp. (qmax=23.94mg g−1) was observed to possess a superior removal capability when compared to Turbinaria vulgaris (qmax=21.8mg g−1). Desorption studies were performed with four different desorbing agents. Application study was conducted using tannery wastewater with Nostoc sp. and 94.20% removal of Cr(VI) was obtained. Hence, this study revealed that Nostoc sp. and T. vulgaris both have great potential to be an environment friendly and economic biosorbent for removal of Cr(VI) containing industrial effluent. Graphical abstract
- 25 August 2021
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (41) , 61856-61869
Assessment of algal biomass towards removal of Cr(VI) from tannery effluent: a sustainable approach
The current investigation focuses on a systematic study of application of two dried algal biomass (i.e., Nostoc sp. and Turbinaria vulgaris) in removal of Cr(VI) from synthetic solution as well as tannery industrial wastewater. The optimized conditions for Cr(VI) removal are nearly same for the both the biosorbents (i.e., pH 2.8, initial Cr(VI) concentration 100 mg L−1, biomass dosage of 1.2g L−1, contact time 120 and 110 min). Nostoc sp. (qmax=23.94mg g−1) was observed to possess a superior removal capability when compared to Turbinaria vulgaris (qmax=21.8mg g−1). Desorption studies were performed with four different desorbing agents. Application study was conducted using tannery wastewater with Nostoc sp. and 94.20% removal of Cr(VI) was obtained. Hence, this study revealed that Nostoc sp. and T. vulgaris both have great potential to be an environment friendly and economic biosorbent for removal of Cr(VI) containing industrial effluent. Graphical abstract
- 1 January 2021
- Published by Elsevier
- p. 313-340
Hybrid membrane technique: a technological advancement of textile waste effluent treatment
- 1 January 2021
- Published by Elsevier
- p. 313-340
Hybrid membrane technique: a technological advancement of textile waste effluent treatment
- 1 January 2021
- Published by Elsevier
- p. 257-277
Hybrid membrane process: an emerging and promising technique toward industrial wastewater treatment
- 1 January 2021
- Published by Elsevier
- p. 257-277
Hybrid membrane process: an emerging and promising technique toward industrial wastewater treatment
- 7 July 2020
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 102 (16) , 4842-4861
Estimation of biosorption characteristics of chromium (VI) from aqueous and real tannery effluents by treated T. vulgaris: experimental assessment and statistical modelling
The current study has focused on the removal proficiency of acid-treated brown marine algae Turbinaria vulgaris (T. vulgaris) for the removal of Cr (VI) from laboratory grade solution along with real tannery effluent. Surface morphology, elemental configuration, structural parameters and functional group identification of the acid-treated T. vulgaris were done through appropriate analysis. The optimized ranges of significant components for biosorption study were initial Cr (VI) ion concentration (20–100 mg.l−1), pH (1–3), biosorbent concentration (0.1–0.5 g.l−1) and temperature (283–323 K). The maximum removal percentage (90.08%) of Cr (VI) through biosorption by T. vulgaris is achieved at optimum conditions: pH 2.39, initial metal ion strength-19.85 mg.l−1, biosorbent quantity-0.26 g.l−1 and temperature-299.44 K. Characterisation of T. vulgaris was done before and after sorption study. The removal characteristics were validated through different isotherms and kinetic models towards the estimation of solute interaction and biosorption nature. The entire experimental results concluded that biosorption of Cr (VI) obeys pseudo second-order kinetics. Biosorption of Cr (VI) onto T. vulgaris follows Freundlich isotherm (R2 = 0.999), with maximum removal capability of 21.25 mg.g−1. Thus, acid-treated T. vulgaris could be an efficient biosorbent towards the removal of Cr (VI) from chromium containing waste effluent. Graphical Abstract
- 7 July 2020
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 102 (16) , 4842-4861
Estimation of biosorption characteristics of chromium (VI) from aqueous and real tannery effluents by treated T. vulgaris: experimental assessment and statistical modelling
The current study has focused on the removal proficiency of acid-treated brown marine algae Turbinaria vulgaris (T. vulgaris) for the removal of Cr (VI) from laboratory grade solution along with real tannery effluent. Surface morphology, elemental configuration, structural parameters and functional group identification of the acid-treated T. vulgaris were done through appropriate analysis. The optimized ranges of significant components for biosorption study were initial Cr (VI) ion concentration (20–100 mg.l−1), pH (1–3), biosorbent concentration (0.1–0.5 g.l−1) and temperature (283–323 K). The maximum removal percentage (90.08%) of Cr (VI) through biosorption by T. vulgaris is achieved at optimum conditions: pH 2.39, initial metal ion strength-19.85 mg.l−1, biosorbent quantity-0.26 g.l−1 and temperature-299.44 K. Characterisation of T. vulgaris was done before and after sorption study. The removal characteristics were validated through different isotherms and kinetic models towards the estimation of solute interaction and biosorption nature. The entire experimental results concluded that biosorption of Cr (VI) obeys pseudo second-order kinetics. Biosorption of Cr (VI) onto T. vulgaris follows Freundlich isotherm (R2 = 0.999), with maximum removal capability of 21.25 mg.g−1. Thus, acid-treated T. vulgaris could be an efficient biosorbent towards the removal of Cr (VI) from chromium containing waste effluent. Graphical Abstract
- 7 June 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 39 (6)
Experimental study of biosorption of fluoride by immobilized beads of zeolite NaA and Nostoc sp. (BTA394) using a continuous flow system
The current experiment investigated the fluoride sorptive efficacies of immobilized beads of zeolite NaA and Nostoc sp. (BTA394) from simulated wastewater in column reactor. Influence of crucial kinetic parameters viz. initial concentration (10, 15, and 20 mg/L), bed height (4, 6, and 8 cm) and flow rate (2, 4, and 6 ml/min) on F− uptake was examined. Influence of these parameters on breakthrough curves was also determined. These breakthrough curves were further estimated by Adams–Bohart's and Thomas models. Spent column was eluted with 0.01 M NaCl, Ca(OH)2, Na2SO4, or NaOH solution to assess column regeneration efficacy. The Thomas model satisfactorily explained the sorption dynamics but Adams–Bohart model could only explicate preliminary portion of the column sorption mechanism. The exhaustion and breakthrough time shortened with increased flow rate, decreased bed height and increased F− concentration. Safe disposal of spent biosorbents were also performed. From the results obtained, it can be said that these biosorbents could be used effectively in treatment of simulated wastewater in continuous flow, although further experiments are being carried out to assess their defluoridation capabilities for real wastewater in large‐scale operations.
- 7 June 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 39 (6)
Experimental study of biosorption of fluoride by immobilized beads of zeolite NaA and Nostoc sp. (BTA394) using a continuous flow system
The current experiment investigated the fluoride sorptive efficacies of immobilized beads of zeolite NaA and Nostoc sp. (BTA394) from simulated wastewater in column reactor. Influence of crucial kinetic parameters viz. initial concentration (10, 15, and 20 mg/L), bed height (4, 6, and 8 cm) and flow rate (2, 4, and 6 ml/min) on F− uptake was examined. Influence of these parameters on breakthrough curves was also determined. These breakthrough curves were further estimated by Adams–Bohart's and Thomas models. Spent column was eluted with 0.01 M NaCl, Ca(OH)2, Na2SO4, or NaOH solution to assess column regeneration efficacy. The Thomas model satisfactorily explained the sorption dynamics but Adams–Bohart model could only explicate preliminary portion of the column sorption mechanism. The exhaustion and breakthrough time shortened with increased flow rate, decreased bed height and increased F− concentration. Safe disposal of spent biosorbents were also performed. From the results obtained, it can be said that these biosorbents could be used effectively in treatment of simulated wastewater in continuous flow, although further experiments are being carried out to assess their defluoridation capabilities for real wastewater in large‐scale operations.