Boyang Zou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Boyang Zou has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Binjian Nie
Department of Engineering Science, University of Oxford, Oxford OX1 3PJ, UK
6 shared publications Yulong Ding
6 shared publications- Yulong Ding
Birmingham Centre for Energy Storage and School of Chemical Engineering, University of Birmingham, Birmingham, UK
5 shared publications Binjian Nie
3 shared publicationsTongtong Zhang
3 shared publications- Yanqi Zhao
School of Mechanical Engineering & Institute of Intelligent Flexible Mechatronics, Jiangsu University, Zhenjiang 212013, People’s Republic of China
3 shared publications
Latest Publications
- 1 October 2025
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 295
Low-cost MgCl2·6H2O-based composite thermochemical material for low-to-medium temperature heat storage
- 1 October 2025
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 295
Low-cost MgCl2·6H2O-based composite thermochemical material for low-to-medium temperature heat storage
- Open Access
- 14 August 2023
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 23 (9) , 6263-6274
Novel Application of an In Situ Raman Technique for a Co-Crystal Ternary Phase Diagram Determination
- 14 August 2023
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 23 (9) , 6263-6274
Open AccessNovel Application of an In Situ Raman Technique for a Co-Crystal Ternary Phase Diagram Determination
- 23 February 2023
- Published by Elsevier in Renewable Energy
- Vol. 206, 1212-1227
Numerical investigation of a shell-and-tube thermochemical reactor with thermal bridges: Structurale optimization and performance evaluation
- 23 February 2023
- Published by Elsevier in Renewable Energy
- Vol. 206, 1212-1227
Numerical investigation of a shell-and-tube thermochemical reactor with thermal bridges: Structurale optimization and performance evaluation
- Open Access
Discharging Behavior of a Fixed-Bed Thermochemical Reactor under Different Charging Conditions: Modelling and Experimental Validation
Thermochemical heat storage has attracted significant attention in recent years due to potential advantages associated with very high-energy density at the material scale and its suitability for long-duration energy storage because of almost zero loss during storage. Despite the potential, thermochemical heat storage technologies are still in the early stage of development and little has been reported on thermochemical reactors. In this paper, our recent work on the charging and discharging behavior of a fixed-bed thermochemical reactor is reported. Silica gels were used as the sorbent for the experimental work. An effective model was established to numerically study the effect of different charging conditions on the discharging behavior of the reactor, which was found to have a maximum deviation of 10.08% in terms of the root mean square error compared with the experimental results. The experimentally validated modelling also showed that the discharging temperature lift increased by 5.84 times by changing the flow direction of the air in the discharging process when the charging level was at 20%. At a charging termination temperature of 51.25 °C, the maximum discharging temperature was increased by 2.35 °C by reducing the charging flow velocity from 0.64 m/s to 0.21 m/s. An increase in the charging temperature and a decrease in the air humidity increased the maximum discharging outlet temperature lift by 3.37 and 1.89 times, respectively.
Open AccessDischarging Behavior of a Fixed-Bed Thermochemical Reactor under Different Charging Conditions: Modelling and Experimental Validation
Thermochemical heat storage has attracted significant attention in recent years due to potential advantages associated with very high-energy density at the material scale and its suitability for long-duration energy storage because of almost zero loss during storage. Despite the potential, thermochemical heat storage technologies are still in the early stage of development and little has been reported on thermochemical reactors. In this paper, our recent work on the charging and discharging behavior of a fixed-bed thermochemical reactor is reported. Silica gels were used as the sorbent for the experimental work. An effective model was established to numerically study the effect of different charging conditions on the discharging behavior of the reactor, which was found to have a maximum deviation of 10.08% in terms of the root mean square error compared with the experimental results. The experimentally validated modelling also showed that the discharging temperature lift increased by 5.84 times by changing the flow direction of the air in the discharging process when the charging level was at 20%. At a charging termination temperature of 51.25 °C, the maximum discharging temperature was increased by 2.35 °C by reducing the charging flow velocity from 0.64 m/s to 0.21 m/s. An increase in the charging temperature and a decrease in the air humidity increased the maximum discharging outlet temperature lift by 3.37 and 1.89 times, respectively.
- Top Cited Papers
- 15 June 2022
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 167
A comprehensive review of composite phase change material based thermal management system for lithium-ion batteries
- 15 June 2022
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 167
Top Cited PapersA comprehensive review of composite phase change material based thermal management system for lithium-ion batteries
- 11 June 2021
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (11) , 16565-16575
Performance enhancement of cold energy storage using phase change materials with fumed silica for air‐conditioning applications
- 11 June 2021
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (11) , 16565-16575
Performance enhancement of cold energy storage using phase change materials with fumed silica for air‐conditioning applications
- Top Cited Papers
- 1 December 2020
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 134
Review on phase change materials for cold thermal energy storage applications
- 1 December 2020
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 134
Top Cited PapersReview on phase change materials for cold thermal energy storage applications