Chul Han Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Chul Han Kim has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Min Sung Tak
Plastic and Reconstructive Surgery Department, Soonchunhyang University Hospital, Seoul 04401, Republic of Korea
2 shared publications - Sang Gue Kang
Department of Plastic and Reconstructive Surgery Soonchunhyang University Seoul Hospital Soonchunhyang University College of Medicine 59 Daesagwan-ro Yongsan-gu 04401 Seoul Korea
2 shared publications - Wang Seok Lee
Department of Plastic and Reconstructive Surgery, Soonchunhyang University Hospital, Seoul, Korea
2 shared publications - Eun Soo Park
Department of Plastic and Reconstructive Surgery, Soonchunhyang University Bucheon Hospital, Bucheon, Republic of Korea
1 shared publication - Sang Won Lee1 shared publication
- Si-Hyun Park
Department of Electronic Engineering, Yeungnam University, Gyeongsan-si, South Korea
1 shared publication
Latest Publications
- 16 August 2026
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 68 (8)
Impact of Feedback Amplified Spontaneous Emission Peak Power on the Performance of an All‐Optical Automatic Gain‐Controlled Erbium‐Doped Fiber Amplifier in Terrestrial Free‐Space Optical Communication Systems
An all‐optical automatic gain‐controlled (AGC) erbium‐doped fiber amplifier (EDFA) is proposed and experimentally demonstrated for suppressing optical signal power fluctuations in terrestrial free‐space optical communication (FSOC) systems. The proposed AGC EDFA employs a simple optical feedback loop consisting of two optical couplers, an optical bandpass filter and a conventional EDFA, eliminating the need for electronic feedback circuitry. The operating characteristics of the amplifier were investigated by measuring the gain and amplified spontaneous emission (ASE) spectra under different feedback ASE peak power levels. Stable AGC operation with gain saturation was achieved when the feedback ASE peak power exceeded approximately −15 dBm, whereas excessive ASE feedback resulted in pump power depletion and reduced amplifier gain. Optical signal fluctuations emulating atmospheric turbulence were generated using an acousto‐optic modulator (AOM), and the fluctuation suppression performance was evaluated under sinusoidal, randomly varying, and square‐wave driving conditions. The proposed AGC EDFA effectively suppressed optical signal fluctuations over an AOM driving frequency range from 1 Hz to 10 kHz and reduced both the peak‐to‐peak signal variation and the scintillation index under randomly varying input conditions. Dynamic response measurements further revealed that the transient response depends strongly on the magnitude of the input optical power fluctuation because of the ASE lasing buildup dynamics and pump power depletion. These results demonstrate that the proposed all‐optical AGC EDFA provides a simple, cost‐effective, and practical approach for mitigating turbulence‐induced optical power fluctuations while offering useful design guidelines for optimizing the dynamic performance of AGC EDFAs in terrestrial FSOC systems.
- 16 August 2026
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 68 (8)
Impact of Feedback Amplified Spontaneous Emission Peak Power on the Performance of an All‐Optical Automatic Gain‐Controlled Erbium‐Doped Fiber Amplifier in Terrestrial Free‐Space Optical Communication Systems
An all‐optical automatic gain‐controlled (AGC) erbium‐doped fiber amplifier (EDFA) is proposed and experimentally demonstrated for suppressing optical signal power fluctuations in terrestrial free‐space optical communication (FSOC) systems. The proposed AGC EDFA employs a simple optical feedback loop consisting of two optical couplers, an optical bandpass filter and a conventional EDFA, eliminating the need for electronic feedback circuitry. The operating characteristics of the amplifier were investigated by measuring the gain and amplified spontaneous emission (ASE) spectra under different feedback ASE peak power levels. Stable AGC operation with gain saturation was achieved when the feedback ASE peak power exceeded approximately −15 dBm, whereas excessive ASE feedback resulted in pump power depletion and reduced amplifier gain. Optical signal fluctuations emulating atmospheric turbulence were generated using an acousto‐optic modulator (AOM), and the fluctuation suppression performance was evaluated under sinusoidal, randomly varying, and square‐wave driving conditions. The proposed AGC EDFA effectively suppressed optical signal fluctuations over an AOM driving frequency range from 1 Hz to 10 kHz and reduced both the peak‐to‐peak signal variation and the scintillation index under randomly varying input conditions. Dynamic response measurements further revealed that the transient response depends strongly on the magnitude of the input optical power fluctuation because of the ASE lasing buildup dynamics and pump power depletion. These results demonstrate that the proposed all‐optical AGC EDFA provides a simple, cost‐effective, and practical approach for mitigating turbulence‐induced optical power fluctuations while offering useful design guidelines for optimizing the dynamic performance of AGC EDFAs in terrestrial FSOC systems.
- Open Access
- 30 July 2019
- Published by Korean Society for Aesthetic Plastic Surgery in Archives of Aesthetic Plastic Surgery
- Vol. 25 (3) , 108-114
Emergency room visits for severe complications after cosmetic surgery
- 30 July 2019
- Published by Korean Society for Aesthetic Plastic Surgery in Archives of Aesthetic Plastic Surgery
- Vol. 25 (3) , 108-114
Open AccessEmergency room visits for severe complications after cosmetic surgery
- Open Access
- 20 June 2019
- Published by Korean Cleft Palate-Craniofacial Association in Archives of Craniofacial Surgery
- Vol. 20 (3) , 195-198
A 30-year neglected foreign body mimicking a maxillary fracture
A-50-year-old male patient presented with complaint of tenderness on the left malar area after traffic accident. Our first impression on him was zygomatic fracture, we did radiologic work-up and physical examination on him. But, on the computed tomography scan, there was no fracture or discontinuity on his facial bone. The computed tomography scan was revealed a 4-cm long foreign body in left maxillary sinus with a large amount of fluid collection. After thorough history taking from him, we reveal the patient had a history of trauma 30 years back on the left zygomatic area with a chopstick. The foreign body was removed via transoral approach with the endoscopic assist. There was no complication after operation.
- 20 June 2019
- Published by Korean Cleft Palate-Craniofacial Association in Archives of Craniofacial Surgery
- Vol. 20 (3) , 195-198
Open AccessA 30-year neglected foreign body mimicking a maxillary fracture
A-50-year-old male patient presented with complaint of tenderness on the left malar area after traffic accident. Our first impression on him was zygomatic fracture, we did radiologic work-up and physical examination on him. But, on the computed tomography scan, there was no fracture or discontinuity on his facial bone. The computed tomography scan was revealed a 4-cm long foreign body in left maxillary sinus with a large amount of fluid collection. After thorough history taking from him, we reveal the patient had a history of trauma 30 years back on the left zygomatic area with a chopstick. The foreign body was removed via transoral approach with the endoscopic assist. There was no complication after operation.