Yasuo Takahashi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yasuo Takahashi has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Masakatsu Maeda
Osaka University
2 shared publications- Akihisa Inoue
Institute for Materials Research, Tohoku University, Sendai 980-8577, Japan
1 shared publication - Edmund Soji Otabe
Department of Physics and Information Technology, Kyushu Institute of Technology, Iizuka, Japan
1 shared publication F. Matsutani
Department of Computer Science and Electronics, Kyushu Institute of Technology, 680-4 Kawazu, Iizuka, Fukuoka 820-8502, Japan
1 shared publication- Kentaro Uesugi
Japan Synchrotron Radiation Research Institute, Sayo-gun, JAPAN
1 shared publication Kouichi Hamada
Graduate School of Information Science and Technology
1 shared publication
Latest Publications
- 23 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (6) , 2227-2237
Dispersion-Free and Tunable Nonreciprocities in Composite Right-/Left-Handed Metamaterials and Their Applications to Beam Squint Reduction in Leaky-Wave Antennas
In this paper, the enhancement of bandwidth for beam squint reduction in leaky-wave antennas has been numerically and experimentally demonstrated based on the pseudo-traveling-wave resonance by using nonreciprocal composite right-/left-handed metamaterial lines with almost dispersion-free phase-shifting nonreciprocities. We consider two different types of metamaterials governed by the edge-guided mode propagation in normally magnetized ferrite microstrip lines and operating at frequencies far above or below the magnetic resonance. Both metamaterials are separately designed and implemented in leaky-wave antennas based on the pseudo-traveling-wave resonance. The numerical simulation and measurement results verify the beam squint reduction for both cases with the enhanced bandwidths of 6%-10%.
- 23 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (6) , 2227-2237
Dispersion-Free and Tunable Nonreciprocities in Composite Right-/Left-Handed Metamaterials and Their Applications to Beam Squint Reduction in Leaky-Wave Antennas
In this paper, the enhancement of bandwidth for beam squint reduction in leaky-wave antennas has been numerically and experimentally demonstrated based on the pseudo-traveling-wave resonance by using nonreciprocal composite right-/left-handed metamaterial lines with almost dispersion-free phase-shifting nonreciprocities. We consider two different types of metamaterials governed by the edge-guided mode propagation in normally magnetized ferrite microstrip lines and operating at frequencies far above or below the magnetic resonance. Both metamaterials are separately designed and implemented in leaky-wave antennas based on the pseudo-traveling-wave resonance. The numerical simulation and measurement results verify the beam squint reduction for both cases with the enhanced bandwidths of 6%-10%.
- Open Access
- 1 August 2014
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 61, 012001
Influence of surface asperities on interfacial extension during solid state pressure welding
- 1 August 2014
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 61, 012001
Open AccessInfluence of surface asperities on interfacial extension during solid state pressure welding
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Real-time resistive switching of Cu/MoOx ReRAM observed in transmission electron microscope
Inner-structural changes of a Cu/MoOx ReRAM was observed by in-situ TEM during the resistive switching. We succeeded for the first time to observe the structure changes in the continuous multiple resistive switching cycles. Cu-rich filament was formed in the MoOx layer during the SET process with positive voltage to the Cu electrode, and disappeared by negative voltage in the RESET process. It was also confirmed that thick filaments were generated when the current compliance for the SET process was increased. The most meaningful phenomenon is that the position of the filament changed at each SET process.
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Real-time resistive switching of Cu/MoOx ReRAM observed in transmission electron microscope
Inner-structural changes of a Cu/MoOx ReRAM was observed by in-situ TEM during the resistive switching. We succeeded for the first time to observe the structure changes in the continuous multiple resistive switching cycles. Cu-rich filament was formed in the MoOx layer during the SET process with positive voltage to the Cu electrode, and disappeared by negative voltage in the RESET process. It was also confirmed that thick filaments were generated when the current compliance for the SET process was increased. The most meaningful phenomenon is that the position of the filament changed at each SET process.
- 16 May 2010
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 470 (20) , 1411-1414
Influence of nanoparticles on flux pinning properties in TFA-MOD processed YGdBCO coated conductor
- 16 May 2010
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 470 (20) , 1411-1414
Influence of nanoparticles on flux pinning properties in TFA-MOD processed YGdBCO coated conductor
- Open Access
- 1 January 2009
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 50 (6) , 1263-1268
Interfacial Microstructure and Thermal Stability of Zr55Cu30Ni5Al10 Metallic Glass Joints Formed by Ultrasonic Bonding
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 January 2009
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 50 (6) , 1263-1268
Open AccessInterfacial Microstructure and Thermal Stability of Zr55Cu30Ni5Al10 Metallic Glass Joints Formed by Ultrasonic Bonding
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 May 2003
- Published by Elsevier in Acta Materialia
- Vol. 51 (8) , 2219-2234
Stress induced diffusion along adhesional contact interfaces
- 1 May 2003
- Published by Elsevier in Acta Materialia
- Vol. 51 (8) , 2219-2234
Stress induced diffusion along adhesional contact interfaces