David W. Watkins
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
David W. Watkins has a total of 145 co-authors. Here are the top co-authors by number of shared publications:
- Ali Mirchi
Department of Civil Engineering and Center for Environmental Resource Management, University of Texas at El Paso, 500 W University Ave., El Paso, TX 79968, USA
5 shared publications - Alex Mayer
Michigan Technological University
3 shared publications - Ali Mirchi
Department of Civil and Environmental Engineering Michigan Technological University Houghton Michigan USA
3 shared publications Azad Heidari
Department of Civil and Environmental Engineering Michigan Technological University Houghton USA
3 shared publications- Brian D. Barkdoll
Department of Civil, Environmental, and Geospatial Engineering, Michigan Technological University, Houghton, MI 49931, USA
3 shared publications Diego de Abelleyra
INTA Buenos Aires Argentina
3 shared publications
Latest Publications
- 1 August 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 152 (8)
Advancing Asset Management in Water Infrastructure Systems
- 1 August 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 152 (8)
Advancing Asset Management in Water Infrastructure Systems
- Top Cited Papers
- 5 February 2025
- Published by Elsevier in Urban Forestry & Urban Greening
- Vol. 105
Geospatial analysis for promoting urban green space equity: Case study of Detroit, Michigan, USA
- 5 February 2025
- Published by Elsevier in Urban Forestry & Urban Greening
- Vol. 105
Top Cited PapersGeospatial analysis for promoting urban green space equity: Case study of Detroit, Michigan, USA
- Open Access
- 13 August 2024
- Published by IWA Publishing in Journal of Hydroinformatics
- Vol. 26 (9) , 2104-2123
Verifying an improved intermittent water distribution network analysis method based on EPA-SWMM
Modelling Intermittent Water Supply (IWS) presents challenges, as traditional hydraulic methods based on EPANET are often inadequate due to their inability to simulate the network filling process. While EPA-SWMM (EPA's Storm Water Management Model)-based methods enhance IWS analysis, they remain network-specific and lack universal applicability. This study aims to calibrate and verify an improved EPA-SWMM-based model on a 6 m × 5 m laboratory-scale IWS. Experiments were conducted to capture flow rate data from demand nodes under various conditions. The EPA-SWMM model, based on uncontrolled outlets with flow rate varying by pressure, was calibrated using, an automated procedure that integrated the Genetic Algorithm (GA) into the SWMM-toolkit for optimizing minor loss and pipe roughness coefficients. Comparing model results with experimental data demonstrated the model's capability to simulate the laboratory-scale IWS system behaviour. The model was also applied to a real case study, with results closely aligning with field data, affirming its reliability. The proposed IWS modelling method offers a versatile tool for applications, such as design and scenario analysis for tackling IWS challenges and managing IWS systems. Future research should focus on a large-scale laboratory experiment with pressure and flow sensors, considering air presence in the network to mitigate errors.
- 13 August 2024
- Published by IWA Publishing in Journal of Hydroinformatics
- Vol. 26 (9) , 2104-2123
Open AccessVerifying an improved intermittent water distribution network analysis method based on EPA-SWMM
Modelling Intermittent Water Supply (IWS) presents challenges, as traditional hydraulic methods based on EPANET are often inadequate due to their inability to simulate the network filling process. While EPA-SWMM (EPA's Storm Water Management Model)-based methods enhance IWS analysis, they remain network-specific and lack universal applicability. This study aims to calibrate and verify an improved EPA-SWMM-based model on a 6 m × 5 m laboratory-scale IWS. Experiments were conducted to capture flow rate data from demand nodes under various conditions. The EPA-SWMM model, based on uncontrolled outlets with flow rate varying by pressure, was calibrated using, an automated procedure that integrated the Genetic Algorithm (GA) into the SWMM-toolkit for optimizing minor loss and pipe roughness coefficients. Comparing model results with experimental data demonstrated the model's capability to simulate the laboratory-scale IWS system behaviour. The model was also applied to a real case study, with results closely aligning with field data, affirming its reliability. The proposed IWS modelling method offers a versatile tool for applications, such as design and scenario analysis for tackling IWS challenges and managing IWS systems. Future research should focus on a large-scale laboratory experiment with pressure and flow sensors, considering air presence in the network to mitigate errors.
- 14 March 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 1 (3) , 493-503
Liquid Fed Pyrolysis of Polyethylene Films: Environmental and Economic Assessments of Co-located and Remotely-Located U.S. Facilities
- 14 March 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 1 (3) , 493-503
Liquid Fed Pyrolysis of Polyethylene Films: Environmental and Economic Assessments of Co-located and Remotely-Located U.S. Facilities
- 31 December 2023
- Published by Elsevier in Journal of Environmental Management
- Vol. 351, 119948
Effectiveness of conservation messages to reduce households' GHG emissions: A serious-gaming experiment
- 31 December 2023
- Published by Elsevier in Journal of Environmental Management
- Vol. 351, 119948
Effectiveness of conservation messages to reduce households' GHG emissions: A serious-gaming experiment
- 1 January 2023
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 149 (1) , 01622001
Editor’s Note
Sponsored by the Environmental & Water Resources Institute (EWRI)
- 1 January 2023
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 149 (1) , 01622001
Editor’s Note
Sponsored by the Environmental & Water Resources Institute (EWRI)
- 1 January 2023
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 149 (1) , 01622001
Editor’s Note
Sponsored by the Environmental & Water Resources Institute (EWRI)
- 1 January 2023
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 149 (1) , 01622001
Editor’s Note
Sponsored by the Environmental & Water Resources Institute (EWRI)
- 22 September 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 10 (39) , 13145-13155
Material Flow Analysis and Life Cycle Assessment of Polyethylene Terephthalate and Polyolefin Plastics Supply Chains in the United States
- 22 September 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 10 (39) , 13145-13155
Material Flow Analysis and Life Cycle Assessment of Polyethylene Terephthalate and Polyolefin Plastics Supply Chains in the United States
- Open Access
- 8 November 2021
- Published by American Chemical Society (ACS) in ACS ES&T Engineering
- Vol. 2 (3) , 409-422
Water- and Energy-Efficient Appliances for Circular Water Economy: Conceptual Framework Development and Analysis of Greenhouse Gas Emissions and Water Consumption
- 8 November 2021
- Published by American Chemical Society (ACS) in ACS ES&T Engineering
- Vol. 2 (3) , 409-422
Open AccessWater- and Energy-Efficient Appliances for Circular Water Economy: Conceptual Framework Development and Analysis of Greenhouse Gas Emissions and Water Consumption
- Open Access
- 14 February 2021
- Published by Wiley in GCB Bioenergy
- Vol. 13 (5) , 823-837
Spatially variable hydrologic impact and biomass production tradeoffs associated with Eucalyptus (E. grandis) cultivation for biofuel production in Entre Rios, Argentina
Climate change and energy security promote using renewable sources of energy such as biofuels. High woody biomass production achieved from short‐rotation intensive plantations is a strategy that is increasing in many parts of the world. However, broad expansion of bioenergy feedstock production may have significant environmental consequences. This study investigates the watershed‐scale hydrological impacts of Eucalyptus (E. grandis) plantations for energy production in a humid subtropical watershed in Entre Rios province, Argentina. A Soil and Water Assessment Tool (SWAT) model was calibrated and validated for streamflow, leaf area index (LAI), and biomass production cycles. The model was used to simulate various Eucalyptus plantation scenarios that followed physically based rules for land use conversion (in various extents and locations in the watershed) to study hydrological effects, biomass production, and the green water footprint of energy production. SWAT simulations indicated that the most limiting factor for plant growth was shallow soils causing seasonal water stress. This resulted in a wide range of biomass productivity throughout the watershed. An optimization algorithm was developed to find the best location for Eucalyptus development regarding highest productivity with least water impact. E. grandis plantations had higher evapotranspiration rates compared to existing terrestrial land cover classes; therefore, intensive land use conversion to E. grandis caused a decline in streamflow, with January through March being the most affected months. October was the least‐affected month hydrologically, since high rainfall rates overcame the canopy interception and higher ET rates of E. grandis in this month. Results indicate that, on average, producing 1 kg of biomass in this region uses 0.8 m3 of water, and the green water footprint of producing 1 m3 fuel is approximately 2150 m3 water, or 57 m3 water per GJ of energy, which is lower than reported values for wood‐based ethanol, sugar cane ethanol, and soybean biodiesel.
- 14 February 2021
- Published by Wiley in GCB Bioenergy
- Vol. 13 (5) , 823-837
Open AccessSpatially variable hydrologic impact and biomass production tradeoffs associated with Eucalyptus (E. grandis) cultivation for biofuel production in Entre Rios, Argentina
Climate change and energy security promote using renewable sources of energy such as biofuels. High woody biomass production achieved from short‐rotation intensive plantations is a strategy that is increasing in many parts of the world. However, broad expansion of bioenergy feedstock production may have significant environmental consequences. This study investigates the watershed‐scale hydrological impacts of Eucalyptus (E. grandis) plantations for energy production in a humid subtropical watershed in Entre Rios province, Argentina. A Soil and Water Assessment Tool (SWAT) model was calibrated and validated for streamflow, leaf area index (LAI), and biomass production cycles. The model was used to simulate various Eucalyptus plantation scenarios that followed physically based rules for land use conversion (in various extents and locations in the watershed) to study hydrological effects, biomass production, and the green water footprint of energy production. SWAT simulations indicated that the most limiting factor for plant growth was shallow soils causing seasonal water stress. This resulted in a wide range of biomass productivity throughout the watershed. An optimization algorithm was developed to find the best location for Eucalyptus development regarding highest productivity with least water impact. E. grandis plantations had higher evapotranspiration rates compared to existing terrestrial land cover classes; therefore, intensive land use conversion to E. grandis caused a decline in streamflow, with January through March being the most affected months. October was the least‐affected month hydrologically, since high rainfall rates overcame the canopy interception and higher ET rates of E. grandis in this month. Results indicate that, on average, producing 1 kg of biomass in this region uses 0.8 m3 of water, and the green water footprint of producing 1 m3 fuel is approximately 2150 m3 water, or 57 m3 water per GJ of energy, which is lower than reported values for wood‐based ethanol, sugar cane ethanol, and soybean biodiesel.