IBI. V. Bogdanov

I. V. Bogdanov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


I. V. Bogdanov has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Experience in HTS-2 Annular Field Coils for a High-Power Synchronous Generator

    by A. I. Ageev, I. V. Bogdanov, S. S. Kozub, V. M. Smirnov, I. S. Tersky, L. M. Tkachenko, V. I. Shuvalov, D. S. Dezhin, R. I. Ilyasov, K. L. Kovalev, et al.

    The Institute for High Energy Physics of National Research Centre “Kurchatov Institute” has developed a technology for manufacturing annular co

  • Experience in Development of HTS-2 Annular Field Coils for a High-Power Synchronous Generator

    by Анатолий Иванович Агеев, Игорь Викторович Богданов, Сергей Сергеевич Козуб, Владимир Михайлович Смирнов, Ivan Terskiy, Леонид Михайлович Ткаченко, Виктор Иванович Шувалов, Dmitriy Dezhin, Roman Il’yAsov, Константин Львович Ковалев, et al.

    NRC Kurchatov Institute - IHEP has developed a technology for the manufacture of annular coils from a second generation high-temperature superconductor (HTS-2 tape). Jointly with the Moscow Aviation Institute, two excitation coils were developed and manufactured from HTS-2 tape in their own cryostats for the synchronous generator model. In doing so, a method was developed for applying to the HTS-2 tape an electric insulation consisting of polyimide film layers with a total thickness of 26 μm. Such insulation provides sufficient electrical strength at a 2500 V voltage with a pressure of up to 5 kg/cm2. At the intermediate stage of manufacture, after the coils had been wound and the shroud applied, the coils manufacturing quality was checked by measuring the coils critical current when immersing them into a liquid nitrogen bath. At the final stage, the coils residing in their own cryostats were cooled with liquid nitrogen in the forced circulation mode. When cooling the coils to the operating temperature, the pressure drop across the cryogenic agent flow was 0.02 MPa, and the cooling time took about 1 h. A limit current value at which stable coil operation will be retained has been found. This current is 116 A and 126 A for the first and second coils, respectively, which is higher than the design operating current when using these coils in the synchronous generator model. An experimental model of a synchronous generator with these HTS-2 coils used as axial field windings was manufactured and tested. During the tests, the generator no-load characteristics, as well as its loading and adjustment characteristics were measured. The test results correspond to the calculated ones. НИЦ «Курчатовский институт» – ИФВЭ разработал технологию изготовления круглых обмоток из высокотемпературного сверхпроводника второго поколения (ВТСП-2 ленты). Совместно с МАИ были разработаны и изготовлены две обмотки возбуждения для модели синхронного генератора из ВТСП-2 ленты в собственных криостатах. При этом был разработан метод нанесения на ВТСП-2 ленту электрической изоляции, состоящей из слоев полиимидной пленки суммарной толщиной 26 мкм. Изоляция обеспечивает достаточную электрическую прочность при напряжении 2500 В и давлении до 5 кг/см2 включительно. На промежуточном этапе изготовления после намотки катушек и нанесения бандажа качество изготовления обмоток было проконтролировано путем измерения критического тока обмоток при погружении в ванну с жидким азотом. На заключительном этапе обмотки, находящиеся в собственных криостатах, охлаждались жидким азотом в прокачном режиме. При охлаждении обмоток до рабочей температуры перепад давления потока криагента составлял 0,02 МПа, при этом время охлаждения заняло около 1 ч. Найдено граничное значение тока, при котором будет сохраняться устойчивая работа обмоток. Этот ток составляет 116 и 126 А для первой и второй обмотки соответственно, что превышает расчетный рабочий ток при использовании этих обмоток в модели генератора. Изготовлена и испытана экспериментальная модель синхронного генератора с этими ВТСП-2 обмотками, применяемыми в качестве обмоток осевого возбуждения. При испытаниях измерены характеристика холостого хода генератора, а также его нагрузочная и регулировочная характеристики. Результаты испытаний соответствуют расчетным.