Um-E-Salma Amjad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Um-E-Salma Amjad has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Murid Hussain
Faculty of Engineering and Technology Muscat University Muscat Oman
7 shared publications Parveen Akhter
5 shared publications- Maria Mustafa
Nanofabrication and Green Energy Research Laboratory Department of Chemical Engineering COMSATS University Islamabad Lahore Campus Lahore Punjab 54000 Pakistan
4 shared publications Nasir Shehzad
4 shared publications- Fahad Rehman
Department of Chemical Engineering, COMSATS University Islamabad, Lahore Campus, Pakistan
3 shared publications Ibrahim M. Maafa
3 shared publications
Latest Publications
- 6 March 2025
- Published by Wiley in Energy Technology
MOF‐808 Enhanced MXene Tribopositive Layer for High‐Performance Triboelectric Nanogenerators
Smart electronic devices require an energy harvester that is a durable, portable, miniature, and long‐lasting power source. As an energy harvester, triboelectric nanogenerator (TENG) is a promising state‐of‐the‐art technology that can provide power on demand. The choice of triboactive materials greatly influences TENG performance, and recently, great attention has been given to composite materials. Herein, it is shown that the MOF‐808@MXene/PVDF TENG fabricated from a composite of MOF‐808 with MXene produces a synergistic effect, thus generating higher triboelectric output than MOF‐808/PVDF TENG and MXene/PVDF TENG, respectively. The optimized MOF‐808@MXene/PVDF TENG delivers an output of 296.22 V, 30.7 μA, and 67.4 mW m−2. The figure‐of‐merit performance indicates a thirteen times increase in improvement from MOF‐808/PVDF TENG and the improvement doubles for MXene/PVDF TENG, respectively. Moreover, all the optimized TENGs are found to be stable for up to 5000 repeated cycles and are also tested toward endurance of up to 10 weeks. The results also depict that among all TENG, the composite MOF‐808@MXene/PVDF TENG shows only a 34% reduction in output voltage after 10 weeks of endurance and, therefore, can be used as a durable, long‐lasting power source for micro‐based circuit device applications.
- 6 March 2025
- Published by Wiley in Energy Technology
MOF‐808 Enhanced MXene Tribopositive Layer for High‐Performance Triboelectric Nanogenerators
Smart electronic devices require an energy harvester that is a durable, portable, miniature, and long‐lasting power source. As an energy harvester, triboelectric nanogenerator (TENG) is a promising state‐of‐the‐art technology that can provide power on demand. The choice of triboactive materials greatly influences TENG performance, and recently, great attention has been given to composite materials. Herein, it is shown that the MOF‐808@MXene/PVDF TENG fabricated from a composite of MOF‐808 with MXene produces a synergistic effect, thus generating higher triboelectric output than MOF‐808/PVDF TENG and MXene/PVDF TENG, respectively. The optimized MOF‐808@MXene/PVDF TENG delivers an output of 296.22 V, 30.7 μA, and 67.4 mW m−2. The figure‐of‐merit performance indicates a thirteen times increase in improvement from MOF‐808/PVDF TENG and the improvement doubles for MXene/PVDF TENG, respectively. Moreover, all the optimized TENGs are found to be stable for up to 5000 repeated cycles and are also tested toward endurance of up to 10 weeks. The results also depict that among all TENG, the composite MOF‐808@MXene/PVDF TENG shows only a 34% reduction in output voltage after 10 weeks of endurance and, therefore, can be used as a durable, long‐lasting power source for micro‐based circuit device applications.
- 28 March 2022
- Published by Elsevier in Chemical Engineering Journal
- Vol. 441
Effect of active species scavengers in photocatalytic desulfurization of hydrocracker diesel using mesoporous Ag3VO4
- 28 March 2022
- Published by Elsevier in Chemical Engineering Journal
- Vol. 441
Effect of active species scavengers in photocatalytic desulfurization of hydrocracker diesel using mesoporous Ag3VO4
- 9 February 2022
- Published by Elsevier in Waste Management
- Vol. 141, 240-250
Catalytic cracking of polystyrene pyrolysis oil: Effect of Nb2O5 and NiO/Nb2O5 catalyst on the liquid product composition
- 9 February 2022
- Published by Elsevier in Waste Management
- Vol. 141, 240-250
Catalytic cracking of polystyrene pyrolysis oil: Effect of Nb2O5 and NiO/Nb2O5 catalyst on the liquid product composition
- 21 July 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 40 (2)
Diesel and gasoline like fuel production with minimum styrene content from catalytic pyrolysis of polystyrene
Pyrolysis of waste polystyrene to generate fuel was carried out to yield pyrolysis oil. For the first time, NiO deposited over ZrO2 carrier as catalyst, was deployed and evaluated in the catalytic pyrolysis. Catalysts based on different loading (2, 5, 10, and 15%) of NiO deposited over ZrO2 carrier were prepared by solution combustion synthesis and tested toward screening of catalytic pyrolysis of PS in semi batch reactor. Based on conversion, yield of oil and low styrene monomer content, the catalytic performance with different loadings was evaluated and optimized. Furthermore, the oil obtained from the best catalysts were analyzed using GC–MS for carbon number distribution, depolymerization reactions, and diesel fuel generation. These catalysts were also characterized using X‐ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), pyridine FTIR, and scanning electron microscopy (SEM) techniques. As compared to thermal pyrolysis, the catalytic pyrolysis process was found to be highly selective toward diesel like fuel generation with minimum styrene monomer formation. Also, 2 and 10% NiO catalyst showed the best catalytic performance in pyrolysis process that could be ascribed to the presence of Lewis and Brönsted acid sites resulting in selectivity for C16 carbon number, diesel fuel generation, and depolymerization reactions.
- 21 July 2020
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 40 (2)
Diesel and gasoline like fuel production with minimum styrene content from catalytic pyrolysis of polystyrene
Pyrolysis of waste polystyrene to generate fuel was carried out to yield pyrolysis oil. For the first time, NiO deposited over ZrO2 carrier as catalyst, was deployed and evaluated in the catalytic pyrolysis. Catalysts based on different loading (2, 5, 10, and 15%) of NiO deposited over ZrO2 carrier were prepared by solution combustion synthesis and tested toward screening of catalytic pyrolysis of PS in semi batch reactor. Based on conversion, yield of oil and low styrene monomer content, the catalytic performance with different loadings was evaluated and optimized. Furthermore, the oil obtained from the best catalysts were analyzed using GC–MS for carbon number distribution, depolymerization reactions, and diesel fuel generation. These catalysts were also characterized using X‐ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), pyridine FTIR, and scanning electron microscopy (SEM) techniques. As compared to thermal pyrolysis, the catalytic pyrolysis process was found to be highly selective toward diesel like fuel generation with minimum styrene monomer formation. Also, 2 and 10% NiO catalyst showed the best catalytic performance in pyrolysis process that could be ascribed to the presence of Lewis and Brönsted acid sites resulting in selectivity for C16 carbon number, diesel fuel generation, and depolymerization reactions.
- 1 May 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 390, 121623
Integrating adsorption and photocatalysis: A cost effective strategy for textile wastewater treatment using hybrid biochar-TiO2 composite
- 1 May 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 390, 121623
Integrating adsorption and photocatalysis: A cost effective strategy for textile wastewater treatment using hybrid biochar-TiO2 composite
- 12 August 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (36) , 16395-16406
Methane Steam Reforming on the Pt/CeO2 Catalyst: Effect of Daily Start-Up and Shut-Down on Long-Term Stability of the Catalyst
- 12 August 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (36) , 16395-16406
Methane Steam Reforming on the Pt/CeO2 Catalyst: Effect of Daily Start-Up and Shut-Down on Long-Term Stability of the Catalyst