Ayaz Ali Memon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ayaz Ali Memon has a total of 174 co-authors. Here are the top co-authors by number of shared publications:
- Khalid Hussain Thebo
Department of Chemistry, Mirpur University of Science and Technology, Mirpur Azad, Jammu and Kashmir, Pakistan
20 shared publications Ali Hyder
Departamento de Química Fundamental, Instituto de Química, Universidade de São Paulo
14 shared publicationsShahabuddin Memon
University of Sindh
9 shared publications- Ali Hyder
Department of Chemistry, Faculty of Sciences, Erciyes University, Kayseri, Türkiye
7 shared publications - Roomia Memon
National Centre of Excellence in Analytical Chemistry, University of Sindh, Jamshoro, Pakistan
7 shared publications - Aamna Balouch
University of Sindh
6 shared publications
Latest Publications
- 20 October 2026
- Published by Taylor & Francis in Critical Reviews in Analytical Chemistry
- p. 1-35
Recent Progress in g-C 3 N 4 Functionalized Nanocomposites for Electrochemical Sensors: A Comprehensive Review
The rapid industrialization of recent years has seen an estimated 80% of global wastewater ending up in water bodies without treatment (UNEP, 2021)[1] leading to environmental pollution and increas...
- 20 October 2026
- Published by Taylor & Francis in Critical Reviews in Analytical Chemistry
- p. 1-35
Recent Progress in g-C 3 N 4 Functionalized Nanocomposites for Electrochemical Sensors: A Comprehensive Review
The rapid industrialization of recent years has seen an estimated 80% of global wastewater ending up in water bodies without treatment (UNEP, 2021)[1] leading to environmental pollution and increas...
- 21 September 2026
- Published by Springer Nature in Ionics
- p. 1-14
Development of MIL-53(Fe)-based electrochemical sensor for detection of 4-aminophenol in wastewater
- 21 September 2026
- Published by Springer Nature in Ionics
- p. 1-14
Development of MIL-53(Fe)-based electrochemical sensor for detection of 4-aminophenol in wastewater
- 9 September 2026
- Published by Springer Nature in Food Analytical Methods
- Vol. 19 (11) , 338
A High-Performance GNP@Fe3O4 Nanohybrid-Based Electrochemical Sensor for Trace-Level Detection of Gallic Acid in Food Products
- 9 September 2026
- Published by Springer Nature in Food Analytical Methods
- Vol. 19 (11) , 338
A High-Performance GNP@Fe3O4 Nanohybrid-Based Electrochemical Sensor for Trace-Level Detection of Gallic Acid in Food Products
- 27 August 2026
- Published by Springer Nature in Journal of Food Measurement and Characterization
- Vol. 20 (10) , 18555-18567
Ni-glycerolate modified screen-printed carbon electrode for sensitive voltammetric detection of mancozeb fungicide in food samples
- 27 August 2026
- Published by Springer Nature in Journal of Food Measurement and Characterization
- Vol. 20 (10) , 18555-18567
Ni-glycerolate modified screen-printed carbon electrode for sensitive voltammetric detection of mancozeb fungicide in food samples
- Top Cited Papers
- 16 March 2026
- Published by Elsevier in Food Chemistry
- Vol. 512, 148902
Trace detection of carbaryl pesticide in food samples via a highly efficient and novel g-C3N4/MXene-based electrochemical sensor
- 16 March 2026
- Published by Elsevier in Food Chemistry
- Vol. 512, 148902
Top Cited PapersTrace detection of carbaryl pesticide in food samples via a highly efficient and novel g-C3N4/MXene-based electrochemical sensor
- Open Access
- 19 January 2026
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 18 (6) , 1248-1258
A sensitive electrochemical platform for paracetamol monitoring in real matrices via a supramolecular calix[6]arene-CuO hybrid nanocomposite
A p -HSC6–CuO-modified glassy carbon electrode was fabricated for sensitive, selective electrochemical detection of paracetamol, delivering a wide linear range, low detection limit, and reliable results in biomedical and environmental samples.
- 19 January 2026
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 18 (6) , 1248-1258
Open AccessA sensitive electrochemical platform for paracetamol monitoring in real matrices via a supramolecular calix[6]arene-CuO hybrid nanocomposite
A p -HSC6–CuO-modified glassy carbon electrode was fabricated for sensitive, selective electrochemical detection of paracetamol, delivering a wide linear range, low detection limit, and reliable results in biomedical and environmental samples.
- 6 January 2026
- Published by Optica Publishing Group in Optical Materials Express
- Vol. 16 (2) , 222
Design and application of a ZnO/rGO nanocomposite opto-catalyst as a wide-bandgap optical material for solar-driven dye degradation
In this study, a ZnO/rGO nanocomposite opto-catalyst was successfully designed and applied for sunlight-driven photocatalytic degradation of Rhodamine B dye. The structural, morphological, elemental, and optical properties of the nanocomposite were comprehensively characterized using Raman spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), X-ray photoelectron (XPS), and photoluminescence (PL) spectroscopy. The XRD confirmed the formation of crystalline ZnO with an average crystallite size of 47.6 nm, while the disappearance of the GO (001) peak and the emergence of the rGO (002) peak signaled the successful reduction of graphene oxide. SEM analysis revealed a well-exfoliated layered morphology, and EDX verified the expected elemental composition as (45.0% Zn, 34.7% O, and 20.3% C). The optical band gap was estimated by the Tauc plot method. The photocatalytic performance was systematically optimized by varying key operational parameters, including catalyst dose, NaBH 4 concentration, and sunlight irradiation time. The optimal conditions, as 7 mg of ZnO/rGO, 15 µL of NaBH 4 (0.01 M), and 12 min solar irradiation yielded the highest degradation efficiency of 98%. Besides, the composite showed strong reproducibility over multiple cycles, confirming the reliability of the optimized conditions. The results highlight the strong synergistic interaction between the ZnO and rGO, enhanced charge separation, and light absorption; thus, the composite ZnO/rGO demonstrated to be an efficient, sunlight-activated, and environmentally friendly photocatalyst for wastewater treatment.
- 6 January 2026
- Published by Optica Publishing Group in Optical Materials Express
- Vol. 16 (2) , 222
Design and application of a ZnO/rGO nanocomposite opto-catalyst as a wide-bandgap optical material for solar-driven dye degradation
In this study, a ZnO/rGO nanocomposite opto-catalyst was successfully designed and applied for sunlight-driven photocatalytic degradation of Rhodamine B dye. The structural, morphological, elemental, and optical properties of the nanocomposite were comprehensively characterized using Raman spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), X-ray photoelectron (XPS), and photoluminescence (PL) spectroscopy. The XRD confirmed the formation of crystalline ZnO with an average crystallite size of 47.6 nm, while the disappearance of the GO (001) peak and the emergence of the rGO (002) peak signaled the successful reduction of graphene oxide. SEM analysis revealed a well-exfoliated layered morphology, and EDX verified the expected elemental composition as (45.0% Zn, 34.7% O, and 20.3% C). The optical band gap was estimated by the Tauc plot method. The photocatalytic performance was systematically optimized by varying key operational parameters, including catalyst dose, NaBH 4 concentration, and sunlight irradiation time. The optimal conditions, as 7 mg of ZnO/rGO, 15 µL of NaBH 4 (0.01 M), and 12 min solar irradiation yielded the highest degradation efficiency of 98%. Besides, the composite showed strong reproducibility over multiple cycles, confirming the reliability of the optimized conditions. The results highlight the strong synergistic interaction between the ZnO and rGO, enhanced charge separation, and light absorption; thus, the composite ZnO/rGO demonstrated to be an efficient, sunlight-activated, and environmentally friendly photocatalyst for wastewater treatment.
- 2 January 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 12 (3) , 896-907
Eco-friendly ascorbic acid-integrated graphene oxide composite membranes for high performance ionic and molecular sieving in wastewater treatment
The AA/GO lamellar membrane prepared by a simple method shows excellent water permeability, improved separation of dyes, salts, and heavy metals, and greater structural stability compared to a pristine GO membrane.
- 2 January 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 12 (3) , 896-907
Eco-friendly ascorbic acid-integrated graphene oxide composite membranes for high performance ionic and molecular sieving in wastewater treatment
The AA/GO lamellar membrane prepared by a simple method shows excellent water permeability, improved separation of dyes, salts, and heavy metals, and greater structural stability compared to a pristine GO membrane.
- 28 October 2025
- Published by Springer Nature
- p. 207-221
Development of Pectin-Based Nanobiohybrids for Removal of Heavy Metals
- 28 October 2025
- Published by Springer Nature
- p. 207-221
Development of Pectin-Based Nanobiohybrids for Removal of Heavy Metals
- Open Access
- 2 April 2025
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 3 (5) , 2160-2184
MXene-based nanocomposites: a new horizon for electrochemical monitoring of environmental pollutants
The review focuses on current synthesis methods and various electrochemical sensing applications of MXene-based nanocomposites.
- 2 April 2025
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 3 (5) , 2160-2184
Open AccessMXene-based nanocomposites: a new horizon for electrochemical monitoring of environmental pollutants
The review focuses on current synthesis methods and various electrochemical sensing applications of MXene-based nanocomposites.