Ellie Bennett
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ellie Bennett has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Jonathan Scharle Owen
Columbia Univ., New York, NY (United States)
5 shared publications - Jonathan De Roo
University of Basel
3 shared publications - Abraham J. Jordan
Department of Chemistry, Columbia University, New York, New York 10027, United States
2 shared publications - Benjamin Abécassis
Université de Lyon, CNRS, Ecole Normale Supérieure de Lyon, Laboratoire de Chimie UMR 5182
2 shared publications - Brandon M. McMurtry
Department of Chemistry, Columbia University, New York, New York 10027, USA
2 shared publications - Isabel Van Driessche
Ghent University
2 shared publications
Latest Publications
- 19 December 2024
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (1) , 993-998
One Pot Synthesis of Cyan Emitting CdZnSSe Quantum Dots for Human Centric Lighting
- 19 December 2024
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (1) , 993-998
One Pot Synthesis of Cyan Emitting CdZnSSe Quantum Dots for Human Centric Lighting
- Open Access
- 30 March 2022
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 13 (17) , 4977-4983
Persistent nucleation and size dependent attachment kinetics produce monodisperse PbS nanocrystals
In situ X-ray scattering kinetics and population balance modeling of crystal nucleation and growth.
- 30 March 2022
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 13 (17) , 4977-4983
Open AccessPersistent nucleation and size dependent attachment kinetics produce monodisperse PbS nanocrystals
In situ X-ray scattering kinetics and population balance modeling of crystal nucleation and growth.
- Open Access
- 17 March 2022
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 13 (16) , 4555-4565
Growth kinetics determine the polydispersity and size of PbS and PbSe nanocrystals
A library of thio- and selenourea derivatives is used to adjust the kinetics of PbE (E = S, Se) nanocrystal formation across a 1000-fold range (kr = 10−1 to 10−4 s−1), at several temperatures (80–120 °C), under a standard set of conditions (Pb : E = 1.2 : 1, [Pb(oleate)2] = 10.8 mM, [chalcogenourea] = 9.0 mM). An induction delay (tind) is observed prior to the onset of nanocrystal absorption during which PbE solute is observed using in situ X-ray total scattering. Density functional theory models fit to the X-ray pair distribution function (PDF) support a Pb2(μ2-S)2(Pb(O2CR)2)2 structure. Absorption spectra of aliquots reveal a continuous increase in the number of nanocrystals over more than half of the total reaction time at low temperatures. A strong correlation between the width of the nucleation phase and reaction temperature is observed that does not correlate with the polydispersity. These findings are antithetical to the critical concentration dependence of nucleation that underpins the La Mer hypothesis and demonstrates that the duration of the nucleation period has a minor influence on the size distribution. The results can be explained by growth kinetics that are size dependent, more rapid at high temperature, and self limiting at low temperatures.
- 17 March 2022
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 13 (16) , 4555-4565
Open AccessGrowth kinetics determine the polydispersity and size of PbS and PbSe nanocrystals
A library of thio- and selenourea derivatives is used to adjust the kinetics of PbE (E = S, Se) nanocrystal formation across a 1000-fold range (kr = 10−1 to 10−4 s−1), at several temperatures (80–120 °C), under a standard set of conditions (Pb : E = 1.2 : 1, [Pb(oleate)2] = 10.8 mM, [chalcogenourea] = 9.0 mM). An induction delay (tind) is observed prior to the onset of nanocrystal absorption during which PbE solute is observed using in situ X-ray total scattering. Density functional theory models fit to the X-ray pair distribution function (PDF) support a Pb2(μ2-S)2(Pb(O2CR)2)2 structure. Absorption spectra of aliquots reveal a continuous increase in the number of nanocrystals over more than half of the total reaction time at low temperatures. A strong correlation between the width of the nucleation phase and reaction temperature is observed that does not correlate with the polydispersity. These findings are antithetical to the critical concentration dependence of nucleation that underpins the La Mer hypothesis and demonstrates that the duration of the nucleation period has a minor influence on the size distribution. The results can be explained by growth kinetics that are size dependent, more rapid at high temperature, and self limiting at low temperatures.
- 6 January 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (2) , 706-717
Size Dependent Optical Properties and Structure of ZnS Nanocrystals Prepared from a Library of Thioureas
- 6 January 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (2) , 706-717
Size Dependent Optical Properties and Structure of ZnS Nanocrystals Prepared from a Library of Thioureas
- 4 March 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (10) , 11793-11804
Au/TiO2-Catalyzed Benzyl Alcohol Oxidation on Morphologically Precise Anatase Nanoparticles
Au nanoparticles (NP) on TiO2 have been shown to be effective catalysts for selective oxidation reactions by using molecular oxygen. In this work, we have studied the influence of support morphology on the catalytic activity of Au/TiO2 catalysts. Two TiO2 anatase supports, a nanoplatelet-shaped material with predominantly the {001} facet exposed and a truncated bipyramidal-shaped nanoparticle with predominantly the {101} facet exposed, were prepared by using a nonaqueous solvothermal method and characterized by using DRIFTS, XPS, and TEM. Au nanoparticles were deposited on the supports by using the deposition–precipitation method, and particle sizes were determined by using STEM. Au nanoparticles were smaller on the support with the majority of the {101} facet exposed. The resulting materials were used to catalyze the aerobic oxidation of benzyl alcohol and trifluoromethylbenzyl alcohol. Support morphology impacts the catalytic activity of Au/TiO2; reaction rates for reactions catalyzed by the predominantly {101} material were higher. Much of the increased reactivity can be explained by the presence of smaller Au particles on the predominantly {101} material, providing more Au/TiO2 interface area, which is where catalysis occurs. The remaining modest differences between the two catalysts are likely due to geometric effects as Hammett slopes show no evidence for electronic differences between the Au particles on the different materials.
- 4 March 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (10) , 11793-11804
Au/TiO2-Catalyzed Benzyl Alcohol Oxidation on Morphologically Precise Anatase Nanoparticles
Au nanoparticles (NP) on TiO2 have been shown to be effective catalysts for selective oxidation reactions by using molecular oxygen. In this work, we have studied the influence of support morphology on the catalytic activity of Au/TiO2 catalysts. Two TiO2 anatase supports, a nanoplatelet-shaped material with predominantly the {001} facet exposed and a truncated bipyramidal-shaped nanoparticle with predominantly the {101} facet exposed, were prepared by using a nonaqueous solvothermal method and characterized by using DRIFTS, XPS, and TEM. Au nanoparticles were deposited on the supports by using the deposition–precipitation method, and particle sizes were determined by using STEM. Au nanoparticles were smaller on the support with the majority of the {101} facet exposed. The resulting materials were used to catalyze the aerobic oxidation of benzyl alcohol and trifluoromethylbenzyl alcohol. Support morphology impacts the catalytic activity of Au/TiO2; reaction rates for reactions catalyzed by the predominantly {101} material were higher. Much of the increased reactivity can be explained by the presence of smaller Au particles on the predominantly {101} material, providing more Au/TiO2 interface area, which is where catalysis occurs. The remaining modest differences between the two catalysts are likely due to geometric effects as Hammett slopes show no evidence for electronic differences between the Au particles on the different materials.
- 16 September 2019
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 19 (10) , 7411-7417
The Trouble with ODE: Polymerization during Nanocrystal Synthesis
1-Octadecene is a widely used solvent for high-temperature nanocrystal synthesis (120–320 °C). Here, we show that 1-octadecene spontaneously polymerizes under these conditions, and the resulting poly(1-octadecene) has a comparable solubility and size to nanocrystals stabilized by hydrophobic ligands. Typical purification procedures (precipitation/redispersion cycles or size exclusion chromatography) fail to separate the poly(1-octadecene) impurity from the nanocrystal product. To avoid formation of poly(1-octadecene), we replace 1-octadecene with saturated, aliphatic solvents. Alternatively, the nanocrystals’ native ligands are exchanged for polar ligands, leading to significant solubility differences between nanocrystals and poly(1-octadecene), therefore allowing isolation of pure nanocrystals, free from polymer impurities. These results will help design superior syntheses and improve nanocrystal purity, an important factor in many applications.
- 16 September 2019
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 19 (10) , 7411-7417
The Trouble with ODE: Polymerization during Nanocrystal Synthesis
1-Octadecene is a widely used solvent for high-temperature nanocrystal synthesis (120–320 °C). Here, we show that 1-octadecene spontaneously polymerizes under these conditions, and the resulting poly(1-octadecene) has a comparable solubility and size to nanocrystals stabilized by hydrophobic ligands. Typical purification procedures (precipitation/redispersion cycles or size exclusion chromatography) fail to separate the poly(1-octadecene) impurity from the nanocrystal product. To avoid formation of poly(1-octadecene), we replace 1-octadecene with saturated, aliphatic solvents. Alternatively, the nanocrystals’ native ligands are exchanged for polar ligands, leading to significant solubility differences between nanocrystals and poly(1-octadecene), therefore allowing isolation of pure nanocrystals, free from polymer impurities. These results will help design superior syntheses and improve nanocrystal purity, an important factor in many applications.
- Open Access
- 9 July 2019
- Published by American Chemical Society (ACS) in ChemRxiv
The Trouble with 1-Octadecene; Polymerization During Nanocrystal Synthesis
1-octadecene is a widely used solvent for high temperature nanocrystal synthesis (120 – 320 °C). Here, we show that 1-octadecene spontaneously polymerizes under these conditions and the resulting poly(1-octadecene) has a comparable solubility and size to nanocrystals stabilized by hydrophobic ligands. Typical purification procedures (precipitation/redispersion cycles or size exclusion chromatography) fail to separate the poly(1-octadecene) impurity from the nanocrystal product. To avoid formation of poly(1-octadecene), we replaced 1-octadecene with saturated, aliphatic solvents. Alternatively, the native ligands are exchanged for polar ligands, leading to significant solubility differences between nanocrystals and poly(1-octadecene), therefore allowing isolation of pure nanocrystals, free from polymer impurities. These results will help design superior syntheses and improve nanocrystal purity, an important factor in many applications.
- 9 July 2019
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessThe Trouble with 1-Octadecene; Polymerization During Nanocrystal Synthesis
1-octadecene is a widely used solvent for high temperature nanocrystal synthesis (120 – 320 °C). Here, we show that 1-octadecene spontaneously polymerizes under these conditions and the resulting poly(1-octadecene) has a comparable solubility and size to nanocrystals stabilized by hydrophobic ligands. Typical purification procedures (precipitation/redispersion cycles or size exclusion chromatography) fail to separate the poly(1-octadecene) impurity from the nanocrystal product. To avoid formation of poly(1-octadecene), we replaced 1-octadecene with saturated, aliphatic solvents. Alternatively, the native ligands are exchanged for polar ligands, leading to significant solubility differences between nanocrystals and poly(1-octadecene), therefore allowing isolation of pure nanocrystals, free from polymer impurities. These results will help design superior syntheses and improve nanocrystal purity, an important factor in many applications.