PBPatrick Bottke

Patrick Bottke

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Patrick Bottke has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Sustainable Synergistic Engineering of Co–Fe Borate/Exfoliated Graphite Composites for Efficient Alkaline Water Splitting: A Response Surface Approach

    by Ali Afruz, Mandana Amiri, Abolfazl Bezaatpour, Patrick Bottke, Alexander Simon, Michael Wark

    Electrochemical water splitting is a promising route for energy conversion and chemical energy storage, yet its large-scale implementation is limited by sluggish reaction kinetics and the insufficient stability and activity of earth-abundant electrocatalysts. In this work, we report an amorphous bimetallic borate composite integrated with exfoliated graphite (Fe–CoBOx/EG) as a bifunctional, binder-free electrocatalyst deposited on commercial nickel foam. A central composite design approach was employed to systematically evaluate compositional effects and synergistic interactions between the metal borate constituents and to identify an optimal formulation. Under optimized conditions, the Fe–CoBOx/EG prepared by controlled mechanical pressing on a nickel foam electrode delivers high activity toward both the hydrogen evolution reaction (HER) and oxygen evolution reaction (OER) in 0.1 M KOH. The overpotentials of 57 mV at 10 mA cm–2 for HER and 240 mV at 10 mA cm–2 for OER were obtained with corresponding Tafel slopes of 79 and 42 mV dec–1, respectively. Structural and morphological analyses by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and energy-dispersive X-ray spectroscopy (EDX) confirm the amorphous character, homogeneous dispersion of active species, and postelectrolysis structural integrity of the composite. The enhanced performance is attributed to the disordered borate framework, which provides abundantly accessible active sites, and the intimate electrical contact among the catalyst layers, exfoliated graphite, and nickel foam substrate, which facilitates rapid charge transport. These features provide a binder-free Fe–CoBOx/EG–Ni electrode with durable bifunctional activity for alkaline water splitting.


  • Dual-function nickel bio-MOF as a non-enzymatic glucose sensor and efficient supercapacitor

    by Ali Afruz, Mandana Amiri, Maryam Kaffash-Jamshid, Abolfazl Bezaatpour, Patrick Bottke, Michael Wark


  • Open Access

    Enhanced Breaking of Lignin and Mesopore Formation in Zinc Chloride Assisted Hydrothermal Carbonization of Waste Biomasses

    by Hendrik Multhaupt, Patrick Bottke, Michael Wark

    Hydrochars from hydrothermal carbonization of different biowaste materials (dried dandelion, sawdust, coconut shell powder) formed in the presence of aqueous salt solutions were compared to those obtained by the common method in pure water. Hydrochars with increased carbon contents, pore volume and surface areas were specifically obtained from coconut shell powder in the presence of zinc chloride. Compositional and structural changes within the hydrochar products caused by the process conditions and/or the additive were characterized by solid state 13C NMR spectroscopy, proving that cellulose and, in particular, lignin units in the biomass are more easily attacked in the presence of the salt. Under saline conditions, a distinct particle break-up led to the creation of mesoporosity, as observable from hysteresis loops in nitrogen adsorption isotherms, which were indicative of the presence of pores with diameters of about 3 to 10 nm. The obtained hydrochars were still rich in functional groups which, together with the mesoporosity, indicates the compounds have a high potential for pollutant removal. This was documented by adsorption capacities for the methylene blue and methyl orange dyes, which exceeded the values obtained for other hydrochar-based adsorbers. A subsequent physical activation of the mesoporous hydrochars in steam at different temperatures and times resulted in a further drastic increase in the surface areas, of up to about 750 m2/g; however, this increase is mainly due to micropore formation coupled with a loss of surface functionality. Consequently, the adsorption capacity for the quite large dyes does not provide any further benefit, but the uptake of smaller gas molecules is favored.


  • Open Access

    Study of Polarization Characteristics of Corrosion Films on Magnesium in Sulfate-Containing Electrolytes

    by Ainaz K. Abildina, Akmaral M. Argimbayeva, Andrey Kurbatov, Yeldana Bakhytzhan, Gulmira Rakhymbay, Michael Wark, Patrick Bottke

    In this article, the results of studying the polarization characteristics of magnesium covered with corrosion film in aqueous solutions of MgSO4 and Na2SO4 are presented. The absence of a corrosion-free magnesium surface was shown; in this connection, it was proposed to interpret the larger values of Tafel’s coefficients obtained in the experiment from the point of view of limiting the electrochemical process by charge transfer in the film phase. Charge transfer in corrosion films obeys the regularities of particle movement in high electric fields, and it is not only cationic. According to the impedance measurements, the resistance of the oxide and hydroxide layer of the magnesium-based corrosion film in the studied solutions was calculated. The largest contribution to the restriction of charge transfer in the initial stages of corrosion is made by a dense primary film defining the polarization resistance. Correlation of transfer parameters in high electric fields with thickness and resistance of corrosion film was demonstrated.


  • Open Access

    Converting bimetallic M (M = Ni, Co, or Fe)–Sn nanoparticles into phosphides: a general strategy for the synthesis of ternary metal phosphide nanocrystals

    by Anke Düttmann, Patrick Bottke, Thorsten Plaggenborg, Christian Gutsche, Jürgen Parisi, Martin Knipper, Joanna Kolny-Olesiak

    Ternary metal tin phosphides are promising candidates for electrochemical or catalytic applications. Nevertheless, their synthesis, neither as bulk nor nanomaterials is well investigated in the literature. Here, we describe a general synthetic strategy to convert bimetallic M–Sn (M = Ni, Co, and Fe) nanoparticles to ternary metal phosphides by decomposition of tributylphosphine at 300 °C. At high phosphorus concentrations, Ni3Sn4 nanoparticles convert to hybrid structured Ni2SnP and β-Sn. The CoSn2 and FeSn2 nanoparticles undergo a phosphorization, too and form hybrid nanocrystals reported here for the first time, containing ternary or binary phosphides. We identified the crystal structure of the nanoparticles via XRD and HRTEM measurements using the diffraction data given for Ni2SnP in literature. We were able to locate the Ni2SnP and β-Sn crystal structure within the nanoparticles to demonstrate the phase composition of the nanoparticles. By transferring the synthesis to cobalt and iron, we obtained nanoparticles exhibiting similar hybrid structures and ternary element compositions for Co–Sn–P and binary Fe–P and FeSn2 compositions. In the last step, we used the given information to propose a conversion mechanism from the binary M–Sn nanoparticles through phosphorization.


  • Open Access

    Low‐Temperature Synthesis, Characterization, and Stability of Spinel‐Type Li2NiF4 and Solid‐Solutions Li2Ni1–xCoxF4

    by Julia Kohl, Suliman Nakhal, Noel Ferro, Patrick Bottke, Martin Wilkening, Thomas Bredow, Paul Heitjans, Martin Lerch

    A new synthesis route to Li2NiF4 based on a fluorolytic process using Ni(acac)2 or Ni(OAc)2·4H2O as precursor is presented. Variation of the synthesis conditions allows crystallite size control of the obtained powders. 6Li and 7Li MAS NMR experiments were carried out to study local environments of the lithium ions. Several attempts were made to synthesize Li2CoF4, which are, unfortunately, hitherto not successful. Nevertheless, our studies clearly reveal that solid solutions Li2NiF4–Li2CoF4 are stable up to ca. 30 % cobalt. High‐temperature X‐ray diffraction measurements also show no evidence for the existence of pure Li2CoF4. These findings are supported by quantum chemical calculations.