Rakesh Singh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Rakesh Singh has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Dinesh Kumar
Department of Electronic Science, Kurukshetra University, Kurukshetra, India
7 shared publications- Mukesh Kumar
Electronic Science Department, Kurukshetra University, Kurukshetra, India
5 shared publications - Ravi Kumar
ELECTRONIC SCIENCE DEPARTMENT, Kurukshetra University, ELECTRONIC SCIENCE DEPARTMENT, KUK, ELECTRONIC SCIENCE DEPARTMENT, KUK, Kurukshetra, 136119, INDIA
5 shared publications Anil Kumar
Department of Electronic Science, Kurukshetra University, Kurukshetra, India
4 shared publications- Anil Kumar
Electronic Science Department, Kurukshetra University,Kurukshetra, 136119, India
3 shared publications Mukesh Kumar
Kurukshetra University, Kurukshetra, Haryana, India
2 shared publications
Latest Publications
- 12 November 2021
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 36 (12) , 125019
Electroforming free enhanced resistive switching in reduced graphene oxide films embedded with silver nanoparticles for nonvolatile memory applications
In this paper, the reduced graphene oxide (rGO)-based resistive random access memory (RRAM), embedded with Ag NPs, for nonvolatile memory applications has been investigated. The device exhibited enhanced I on / I off current ratio at lower switching voltage. The rGO-Ag thin film was deposited by spin-coating technique on an indium tin oxide coated glass substrate. Top contacts of aluminum (Al) were deposited by thermal evaporation technique for electrical measurements. The morphology of thin film has been characterized by scanning electron microscopy, and elemental quantification has been done using energy-dispersive x-ray spectroscopy. The structural and chemical analysis of thin film has been performed using x-ray diffraction (XRD) characterization and x-ray photoelectron spectroscopy, respectively. During applied potential, the device switches between two resistance states; low resistance state (LRS) and high resistance state (HRS). Initially when potential is applied across the device, the deposited thin film (rGO-Ag) was found in LRS which did not require initial forming voltage to activate the device. The requirement of this forming voltage may induce severe mechanical and electrical stress in the device and degrades the device performance. The rGO-Ag-based RRAM devices required (60 cycles, which did not exhibit too much degradation. In rGO-Ag thin film-based RRAM devices, Ag NPs act as charge trapping sites, which results in enhanced switching characteristics. The trapping and detrapping mechanism of charges by Ag NPs is responsible for the enhanced switching characteristics in these films.
- 12 November 2021
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 36 (12) , 125019
Electroforming free enhanced resistive switching in reduced graphene oxide films embedded with silver nanoparticles for nonvolatile memory applications
In this paper, the reduced graphene oxide (rGO)-based resistive random access memory (RRAM), embedded with Ag NPs, for nonvolatile memory applications has been investigated. The device exhibited enhanced I on / I off current ratio at lower switching voltage. The rGO-Ag thin film was deposited by spin-coating technique on an indium tin oxide coated glass substrate. Top contacts of aluminum (Al) were deposited by thermal evaporation technique for electrical measurements. The morphology of thin film has been characterized by scanning electron microscopy, and elemental quantification has been done using energy-dispersive x-ray spectroscopy. The structural and chemical analysis of thin film has been performed using x-ray diffraction (XRD) characterization and x-ray photoelectron spectroscopy, respectively. During applied potential, the device switches between two resistance states; low resistance state (LRS) and high resistance state (HRS). Initially when potential is applied across the device, the deposited thin film (rGO-Ag) was found in LRS which did not require initial forming voltage to activate the device. The requirement of this forming voltage may induce severe mechanical and electrical stress in the device and degrades the device performance. The rGO-Ag-based RRAM devices required (60 cycles, which did not exhibit too much degradation. In rGO-Ag thin film-based RRAM devices, Ag NPs act as charge trapping sites, which results in enhanced switching characteristics. The trapping and detrapping mechanism of charges by Ag NPs is responsible for the enhanced switching characteristics in these films.
- 9 June 2021
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 32 (13) , 17545-17557
Low power and stable resistive switching in graphene oxide-based RRAM embedded with ZnO nanoparticles for nonvolatile memory applications
- 9 June 2021
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 32 (13) , 17545-17557
Low power and stable resistive switching in graphene oxide-based RRAM embedded with ZnO nanoparticles for nonvolatile memory applications
- 25 May 2020
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 49 (8) , 4872-4881
Enhanced Resistive Switching Effect in Ag Nanoparticles Embedded in Graphene Oxide Thin Film
- 25 May 2020
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 49 (8) , 4872-4881
Enhanced Resistive Switching Effect in Ag Nanoparticles Embedded in Graphene Oxide Thin Film
- Open Access
- 1 April 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (4) , 045003
Numerical modelling of the potential inside the cylindrical shaped nanocrystallite metal oxide semiconductors and its effect on gas sensor response
The surface of metal oxide semiconductors exhibits great gas sensing response when the size of the grains becomes much smaller, i.e. in the range of the Debye length. In the presented work, the gas sensing properties of nanocrystalline cylindrical shaped metal oxide semiconductors have been studied. The effect of crystal size and surface states on gas sensor response has been investigated. The electric potential inside the grains has been calculated by solving the Poisson’s equation coupled with electroneutrality condition. The relationship between the electric potential and the size of the nanograins has been established as a function of available surface states, surface temperature and occupied surface states. It has been found that the critical value of available surface state density increases with an increase in the size of nanograins. Total carrier concentration inside the grain volume has been simulated as a function of available surface state density and grain size. Eventually, the sensitivity of the gas sensor has been simulated and compared for different sizes of nanocrystals. From the simulated studies, it is clear that the smaller cylindrical-shaped nanostructured grains could result in better gas sensing performances. Presented model has universal application for all metal oxides (both n-type and p-type) based semiconductors and can be extended for both oxidising and reducing gases with essential modifications.
- 1 April 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (4) , 045003
Open AccessNumerical modelling of the potential inside the cylindrical shaped nanocrystallite metal oxide semiconductors and its effect on gas sensor response
The surface of metal oxide semiconductors exhibits great gas sensing response when the size of the grains becomes much smaller, i.e. in the range of the Debye length. In the presented work, the gas sensing properties of nanocrystalline cylindrical shaped metal oxide semiconductors have been studied. The effect of crystal size and surface states on gas sensor response has been investigated. The electric potential inside the grains has been calculated by solving the Poisson’s equation coupled with electroneutrality condition. The relationship between the electric potential and the size of the nanograins has been established as a function of available surface states, surface temperature and occupied surface states. It has been found that the critical value of available surface state density increases with an increase in the size of nanograins. Total carrier concentration inside the grain volume has been simulated as a function of available surface state density and grain size. Eventually, the sensitivity of the gas sensor has been simulated and compared for different sizes of nanocrystals. From the simulated studies, it is clear that the smaller cylindrical-shaped nanostructured grains could result in better gas sensing performances. Presented model has universal application for all metal oxides (both n-type and p-type) based semiconductors and can be extended for both oxidising and reducing gases with essential modifications.
- Open Access
- 1 January 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 015612
Chemically functionalized graphene oxide thin films for selective ammonia Gas sensing
In this work graphene oxide has been functionalized using Para chloro benzoic acid (PCBA). Three different concentrations of PCBA were used for functionalization on the GO surface. Functionalization was confirmed by the study of X-ray diffraction (XRD) and Fourier transform infra-red spectroscopy (FTIR) characterization. Raman characterization was used for the study of defects on the functionalized GO surface. Langmuir–Blodgett technique was used for the deposition of a thin film. This deposited layer was used as a sensing layer for the detection of ammonia gas. Aluminum contacts were made for electrical measurement using thermal evaporation technique and annealed to obtain a good quality of contacts. The sensor behavior was observed for all three concentrations of PCBA and it has been observed that increase in PCBA concentration leads to the high sensor response and the maximum response was observed for the higher concentration of PCBA i.e. 75 mM. The senor was tested for different gas concentrations varied from 100 ppm to 1200 ppm. Also the selectivity and long term stability of prepared devices has been investigated.
- 1 January 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 015612
Open AccessChemically functionalized graphene oxide thin films for selective ammonia Gas sensing
In this work graphene oxide has been functionalized using Para chloro benzoic acid (PCBA). Three different concentrations of PCBA were used for functionalization on the GO surface. Functionalization was confirmed by the study of X-ray diffraction (XRD) and Fourier transform infra-red spectroscopy (FTIR) characterization. Raman characterization was used for the study of defects on the functionalized GO surface. Langmuir–Blodgett technique was used for the deposition of a thin film. This deposited layer was used as a sensing layer for the detection of ammonia gas. Aluminum contacts were made for electrical measurement using thermal evaporation technique and annealed to obtain a good quality of contacts. The sensor behavior was observed for all three concentrations of PCBA and it has been observed that increase in PCBA concentration leads to the high sensor response and the maximum response was observed for the higher concentration of PCBA i.e. 75 mM. The senor was tested for different gas concentrations varied from 100 ppm to 1200 ppm. Also the selectivity and long term stability of prepared devices has been investigated.
- 4 September 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (10) , 105621
Enhanced resistive switching in graphene oxide based composite thin film for nonvolatile memory applications
- 4 September 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (10) , 105621
Enhanced resistive switching in graphene oxide based composite thin film for nonvolatile memory applications
- 24 July 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (9) , 095618
Room temperature ammonia gas sensor using ester functionalization of graphene oxide
- 24 July 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (9) , 095618
Room temperature ammonia gas sensor using ester functionalization of graphene oxide