FMFouad Maroun

Fouad Maroun

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Fouad Maroun has a total of 57 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Role of Defects in Reversible Surface Restructuring and Activity of Co 3 O 4 Oxygen Evolution Electrocatalysts

    by Carl Hendric Scharf, Alex Chandraraj, Konrad Dyk, Felix Stebner, Sören Lepin, Jing Tian, Laila El Bergmi Byaz, Jochim Stettner, Christian Leppin, Anastasiia Kotova, et al.


  • Open Access

    Role of defects in reversible surface restructuring and activity of Co3O4 oxygen evolution electrocatalysts

    by Carl Hendric Scharf, Alex Chandraraj, Konrad Dyk, Felix Stebner, Sören Lepin, Jing Tian, Laila El Bergmi Byaz, Jochim Stettner, Christian Leppin, Anastasiia Kotova, et al.

    Overcoming the slow kinetics of the oxygen evolution reaction at the anode is a key challenge for the sustainable production of hydrogen via electrolysis. This reaction operates at very positive potentials where the electrocatalyst is exposed to highly oxidative conditions and prone to potential-dependent surface structural transformations. While substantial evidence for such surface restructuring exists, its extent and relevance for the catalysts’ activity is unclear. We address this topic for the case of Co3O4, one of the best known electrocatalysts exhibiting surface transformations, by studies of epitaxial (111)-ordered electrodeposited films with combined operando surface X-ray diffraction, electrochemical impedance spectroscopy, and electrochemical measurements on rotating disk electrodes. Comparison of the as-prepared and the annealed state of the same samples, which both are stable even under long-term oxygen evolution conditions, provides clear insight into the role of surface defects. Our results show that defect-free annealed Co3O4(111) surfaces are structurally stable over a wide potential range and hydroxylate via adsorption at surface oxygen and Co sites. Potential-induced surface restructuring of the Co3O4 lattice only occurs in the presence of surface defects, leading to the formation of the well-known nanometer-thick oxyhydroxide skin layer. The presence of this skin layer promotes oxygen evolution at low overpotentials, but results in higher Tafel slopes. As a result, highly ordered Co3O4(111) surfaces are more active at high current densities than defective Co3O4 surfaces that undergo surface transformation. These results highlight that strategies for catalyst surface defect engineering need to be application-oriented.

  • Growth of Ultrathin Well-Defined and Crystalline Films of Co3O4 and CoOOH by Electrodeposition

    by I. Pacheco, M. Bouvier, O. M. Magnussen, P. Allongue, F. Maroun

    Cobalt oxides are among the best noble metal free catalysts for the oxygen evolution reaction in alkaline electrolyte. To elucidate the origin of their catalytic properties, crystalline films with well-defined orientation and surface quality are needed. In this work, we study the growth of ultrathin crystalline films of cobalt oxides layers on Au(111). The films are grown by electrodeposition at reflux temperature in cobalt nitrate alkaline solutions in the presence of tartrate. The film structure and morphology is studied by X-ray diffraction, atomic force microscopy and scanning electron microscopy, as a function of the deposition parameters (solution composition, potential). Single phase Co3O4(111) and CoOOH(001) films in epitaxy with the Au(111) substrate could be obtained by choosing the conditions of deposition. The CoOOH films present a smooth morphology with several 100 nm wide pyramidal islands with stepped facets. The morphology of Co3O4 films consists of three-dimensional densely packed triangular islands with flat tops. Finally, we investigate the influence of the substrate on the morphology of Co3O4 films by depositing them on Au(100) and a CoOOH buffer layer. The nucleation and growth modes as well as the reaction mechanisms are discussed.


  • Open Access

    OperandoIdentification of the Reversible Skin Layer on Co3O4as a Three-Dimensional Reaction Zone for Oxygen Evolution

    by Tim Wiegmann, Ivan Pacheco, Finn Reikowski, Jochim Stettner, Canrong Qiu, Mathilde Bouvier, Manon Bertram, Firas Faisal, Olaf Brummel, Jörg Libuda, et al.

    Co oxides and oxyhydroxides have been studied extensively in the past as promising electrocatalysts for the oxygen evolution reaction (OER) in neutral to alkaline media. Earlier studies showed the formation of an ultrathin CoOx(OH)y skin layer on Co3O4 at potentials above 1.15 V vs reversible hydrogen electrode (RHE), but the precise influence of this skin layer on the OER reactivity is still under debate. We present here a systematic study of epitaxial spinel-type Co3O4 films with defined (111) orientation, prepared on different substrates by electrodeposition or physical vapor deposition. The OER overpotential of these samples may vary up to 120 mV, corresponding to two orders of magnitude differences in current density, which cannot be accounted for by differences in the electrochemically active surface area. We demonstrate by a careful analysis of operando surface X-ray diffraction measurements that these differences are clearly correlated with the average thickness of the skin layer. The OER reactivity increases with the amount of formed skin layer, indicating that the entire three-dimensional skin layer is an OER-active interphase. Furthermore, a scaling relationship between the reaction centers in the skin layer and the OER activity is established. It suggests that two lattice sites are involved in the OER mechanism.


  • Operando Surface X-Ray Diffraction Studies of Structurally-Defined Oxygen Evolution Electrocatalysts Based on Electrodeposited Epitaxial Transition Metal Oxide Films

    by Finn Reikowski, Canrong Qiu, Fouad Maroun, Philippe Allongue, Iwan Pacheco, Mathilde Bouvier, Tim Wiegmann, Jochim Stettner, Olaf M. Magnussen

    Iron-group oxides are among the best precious-metal-free catalyst for the oxygen evolution reaction (OER) in alkaline media [1] and thus of great interest for large-scale electrochemical water splitting into O2 and H2. A wide variety of different catalysts, based on oxides of Co, Fe, and Ni, have been synthesized and studied, exhibiting rather diverse nanoscale morphologies and usually an unknown surface structure. This makes it difficult to compare their reactivity and correlate it with ab initio theoretical studies, which hinders the development of clear structure-reactivity relationships and unambiguous determination of the OER reaction mechanism. In this work we report in situ and operando surface x-ray diffraction (SXRD) studies of well-defined Co3O4 and b-CoOOH electrocatalysts [2]. Ultrathin epitaxial films (10-20 nm thickness) of these materials were electrodeposited on Au single crystals from a dilute Co(II) tartrate solution of pH 14, using a modified version of the procedure described in Ref. [3]. Characterization by SXRD and AFM revealed that epitaxial Co3O4(111) and β-CoOOH(001) deposits were obtained in 2 M and 5 M NaOH, respectively. The film orientation is independent of the substrate and in the surface plane aligned with the Au(111) and Au(001) substrate lattice. The β-CoOOH(001) film deposits were found to be smooth with clearly visible atomic steps. The Co3O4 films exhibits a more island-like morphology, which can be controlled by the deposition parameters. The potential-dependent structure of these model oxide electrocatalysts during cyclic voltammograms was studied at pH values between 7 and 13 over a wide potential range up to OER current densities of 150 mA/cm2. For this, a custom designed electrochemical cell was used that allows high-resolution SXRD characterization together with electrochemical and optical reflectivity measurements while gas evolution proceeds. The two oxide materials show very different behavior. The CoOOH(001) samples were perfectly stable over a wide potential range. In the case of Co3O4(111), fast and fully reversible structural changes are observed, in good agreement with a previous operando study of polycrystalline Co3O4 catalysts [4]. Specifically, the near surface region of Co3O4(111) is converted to a new phase, which is assigned to highly disordered CoOOH. This restructuring starts at potentials 300 mV negative of the onset of the OER, indicating that the process is related to the thermodynamically predicted Co3O4 / β-CoOOH(001) transition rather than to the catalytic reaction. The formed skin layer is of defined thickness, which changes linearly with applied potential. In addition, continuous changes of the Co3O4 unit cell volume are found over a wide potential range, which are assigned to changes in the oxide bulk, related to the pseudo-capacitive charging current in the pre-OER potential range. The kinetics of these structural changes is fast and highly reversible. Furthermore, systematic studies of Co3O4(111) films with different morphology show a smaller skin layer thickness and lower magnitude of the bulk oxide changes for smoother deposits, suggesting an important role of more open oxide facets for the structural conversion. Surprisingly, the catalytic activity of the skin layer covered Co3O4(111) and that of the smooth β-CoOOH(001) are almost identical, if the true microscopic surface area is taken into account. This indicates that the number of OER active sites on the two oxides is similar, despite the very different defect density, and is at variance with previous suggestions that di-µ-oxo bridged Co cations are exclusively responsible for the OER activity of Co oxides. For the smooth β-CoOOH(001) a turnover frequency of 4.2 s-1 per surface atom is determined at an overpotential of 400 mV, which exceeds that estimated in most studies of polycrystalline Co oxide electrocatalysts. [1] C. C. L. McCrory et al., Journal of the American Chemical Society 2015, 137, 4347. [2] F. Reikowski, et al., ACS Catalysis, 2019, 9, 3811 [3] J. A. Koza et al., Chem. Mat. 2012, 24, 3567. [4] A. Bergmann, et al., Nature Communications, 2015, 6, 8625. Figure 1

  • Electrochemical Growth and OER Catalytic Activityof Ultrathin Epitaxial Cobalt Oxide Films

    by Ivan Pacheco, Mathilde Bouvier, Tim Wiegmann, Canrong Qiu, Finn Reikowski, Jochim Stettner, Olaf M. Magnussen, Philippe Allongue, Fouad Maroun

    Iron-group oxides are among the best earth abundant catalysts for the oxygen evolution reaction (OER) in alkaline and neutral electrolytes [1],[2]. Such oxides have been prepared with an amorphous or a crystalline structure, using thermal salt decomposition [3], autoclave synthesis [4], photochemical reactions [5], sol-gel synthesis [6], metal electrodeposition and subsequent oxidation, [7] and direct oxide electrodeposition [1], [8]. This work focuses on well-defined epitaxial CoOx [9] electrocatalysts grown by direct electrodeposition on Au(111) according to an approach similar to that introduced by Switzer [8]. The growth modes of catalysts and the mechanisms of deposition will be discussed based on electrochemical characterizations, XRD characterizations and microscopic observations. In particular to explain that CoOOH may be obtained at a potential of +1V/RHE by oxidation of a Co(II) complex diluted in an alkaline solution while thermodynamics predicts that Co3O4 should be formed. The electrochemical properties in pre-OER and within OER will be discussed as a function of the surface structure and morphology of layers. In particular to show that the large pseudocapacitance measured at the electrode is not related to its ECSA but to electrical charging within the bulk of the electrode. [1] M. W. Kanan and D. G. Nocera, Science 321, 1072 (2008). [2] C. C. L. McCrory, S. Jung, I. M. Ferrer et al., Journal of the American Chemical Society 137, 4347 (2015). [3] C. Pirovano and S. Trasatti, Journal of Electroanalytical Chemistry and Interfacial Electrochemistry 180, 171 (1984). [4] D. Yuming, H. Kun, Y. Lin et al., Nanotechnology 18, 435602 (2007). [5] S. R. Alvarado, Y. Guo, T. P. A. Ruberu et al., The Journal of Physical Chemistry C 116, 10382 (2012). [6] A. Bergmann, E. Martinez-Moreno, D. Teschner et al., Nature Communications 6, 8625 (2015). [7] M. W. Louie and A. T. Bell, Journal of the American Chemical Society 135, 12329 (2013). [8] J. A. Koza, Z. He, A. S. Miller et al., Chem. Mat. 24, 3567 (2012). [9] F. Reikowski, F. Maroun, I. Pacheco et al., ACS Catalysis 9, 3811 (2019).

  • In situ monitoring of electric field effect on domain wall motion in Co ultrathin films in direct contact with an electrolyte

    by A. D. Lamirand, J.-P. Adam, D. Ravelosona, P. Allongue, F. Maroun

    We present experimental data on the electric field effect on the magnetic domain wall dynamics in Co ultrathin films in direct contact with an aqueous electrolyte and in the absence of any oxide layer. We use a three electrode electrochemical setup to apply a large and uniform electric field and to precisely separate chemical effects induced by hydrogen from pure electric field effects. We show that in the case of the pure electric field effect, the domain wall velocity varies exponentially with the electric field and that these variations are larger than those observed previously on similar systems due to a larger magnetoelectric coefficient in our case.


  • Transmission Surface Diffraction for Operando Studies of Heterogeneous Interfaces

    by Finn Reikowski, Tim Wiegmann, Jochim Stettner, Jakub Drnec, Veijo Honkimäki, Fouad Maroun, Philippe Allongue, Olaf M. Magnussen

    Processes at material interfaces to liquids or to high-pressure gases often involve structural changes that are heterogeneous on the micrometer scale. We present a novel in situ X-ray scattering technique that uses high-energy photons and a transmission geometry for atomic-scale studies under these conditions. Transmission surface diffraction gives access to a large fraction of reciprocal space in a single acquisition, allowing direct imaging of the in-plane atomic arrangement at the interface. Experiments with focused X-ray beams enable mapping of these structural properties with micrometer spatial resolution. The potential of this new technique is illustrated by in situ studies of electrochemical surface phase transitions and deposition processes.