RTRana Faisal Tufail

Rana Faisal Tufail

*This is an algorithmically generated author record based on publicly available information.

Rana Faisal Tufail has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Experimental investigation and strength model of RC deep beams externally bonded by CFRP

    by Saeed Ahmad, Ayub Elahi, Rana Faisal Tufail, Muhammad Zahid, Saad Bin Tariq

    This paper presents an experimental study on shear strengthening of reinforced concrete (RC) deep beams using externally applied carbon fiber reinforced polymer (CFRP) jackets. A total of 18 RC deep beams were tested using a four-point bending load. The examined parameter included span to depth ratio with or without CFRP strengthening. CFRP strips were applied perpendicular to the probable crack pattern as observed during testing for un-strengthened beams. The properties that is cracking behavior, ultimate strength, deflection, and energy dissipation capacity of beams were evaluated and discussed. The test results showed enhancement in shear strength up to 17% with CFRP. An increase in depth of RC deep beams caused a decrease in the rate of enhancement in shear strength for CFRP strengthened beams as compared to that observed in their counterparts. The experimental test results were compared with the existing design guidelines to assess their application for RC deep beams strengthened with CFRP. A strength equation based on regression analysis was developed to predict the experimental shear strength of RC deep beams strengthened with CFRP. This study showed that the RC deep beams strengthened with CFRP can effectively be used in structural engineering applications with enhanced shear strength and energy absorption capacity.


  • Statistical modeling of rubberized concrete beams confined by FRP using RSM technique

    by Rana Faisal Tufail, Xiong Feng, Muhammad Zahid, Nodir Utashev, Tahir Mehmood, Adnan Nawaz, Ahsen Maqsoom, Hammad Salahuddin


  • Open Access

    Effects of Modified Metakaolin Using Nano-Silica on the Mechanical Properties and Durability of Concrete

    by Nasir Shafiq, Rabinder Kumar, Muhammad Zahid, Rana Faisal Tufail

    This paper discussed the effects of modified metakaolin (MK) with nano-silica (NS) on the mechanical properties and durability of concrete. In the first phase, trial mixes of concrete were prepared for achieving the desired value of the 28 days compressive strength, and the charge passed in rapid chloride permeability test (RCPT). In the second phase, statistical analysis was performed on the experimental results using the response surface method (RSM). The RSM was applied for optimizing the mix proportions for the required performance by exploiting the relationship between the mix characteristics and the corresponding test results. A blend of 10% MK + 1% NS as part of cement replacement exhibited the highest mechanical properties and durability characteristics of concrete; concrete mix showed that the 28-days compressive strength (CS) was 103 MPa, which was 15% greater than the CS of the control mix without MK or NS. The same mix showed more than 40% higher flexural and split-tensile strength than the control mix; also it resulted in a reduction of 73% in the rapid chloride permeability value. ANOVA technique was used for optimizing the nano-silica and metakaolin content for achieving maximum compressive strength and minimum RCPT value. Statistical analysis using ANOVA technique showed that the maximum compressive strength and lowest RCPT value could be achieved with a blend of 10% MK and 1.55% NS.


  • Open Access

    Experimental Investigation and Statistical Modeling of FRP Confined RuC Using Response Surface Methodology

    by Xiong Feng, Rana Faisal Tufail, Muhammad Zahid

    Scrap tires that are dumped to landfill is a serious problem in China and rest of the world. The use of rubber in concrete is an effective environmental approach to reduce the amount of scrap tires around the world. However, the loss in compressive strength of concrete is a major drawback of rubberized concrete. In this paper, the fiber reinforced polymer (FRP) confinement technique is used to overcome the drawbacks of rubberized concrete (RuC). A total of sixty six RuC cylinders were tested in axial compression. The cylinders were cast using recycled rubber to replace, a) 0-50 percent fine aggregate volume, b) 0-50 percent coarse aggregate volume, and c) 40-50 percent fine and coarse aggregate volume. Twenty seven cylinders of the latter mix were then confined with one, two and three layers of CFRP jackets. Concrete suffered a substantial reduction in compressive strength up to 80 percent by fine and coarse aggregate replacement with rubber content. However, CFRP jackets recovered and further enhanced the axial compressive strength of RuC up to 600% over unconfined RuC. SEM was performed to investigate the microstructural properties of RuC. Statistical models were developed on the basis of experimental tests for FRP confined RuC cylinders using response surface method. The effect of variable factors; unconfined concrete strength, rubber replacement type and number of FRP layers on confined compressive concrete strength was investigated. The regression analysis was performed to develop the response equations based on quadratic models. The predicted and experimental test results were found in good agreement as the variation between experimental and predicted values were less than 5%. Furthermore, the difference between predicted and adjusted R2 was found to be less than 0.2 which shows the significance of the statistical models. These proposed statistical models can provide a better understanding to design the experiments and the parameters affecting FRP-confined RuC cylinders.