WYWeichao Yao

Weichao Yao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Weichao Yao has a total of 85 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • High-power tunable laser operation of Ho:YScO 3 crystal at 2.1 µm

    by Jian Liu, Xinyu Guo, Chuang Yang, Zhengyuan Jiang, Jiawei Zhang, Longxin Liu, Peng Liu, Weichao Yao, Zebin Wang, Kheirreddine Lebbou, et al.

    We report the Czochralski growth, spectroscopic characterization, and laser performance at 2.1 µm of a Ho:YScO 3 mixed sesquioxide crystal with a doping concentration of 0.4 at.%. Spectroscopic evaluation was performed based on room-temperature absorption and fluorescence measurements. Intensity parameters, radiative lifetime of the 5 I 7 manifold, and spontaneous emission rates were calculated based on Judd–Ofelt theory. For the 5 I 7 → 5 I 8 transition near 2.1 µm, the emission cross-section was derived to be 4.06 × 10 −21 cm 2 , with an exceptionally broad full width at half maximum spectrum of 210.14 nm. In the laser experiment, the laser delivers a maximum continuous-wave output power of 12.1 W with a slope efficiency of 31%. Wavelength tuning over 85 nm (2074–2159 nm) is demonstrated using a Lyot filter. These results establish Ho:YScO 3 crystal as a promising gain medium for high-power, broadly tunable, and potentially ultrafast 2.1 µm lasers.

  • Thermal lensing-induced dynamic beam evolution and damage behaviors in a 1 kHz, 521 mJ nanosecond Ho:YLF MOPA system

    by Yuchun Liu, Enhao Li, Panqiang Kang, Weichao Yao, Yujie Peng, Yuxin Leng, Zhizhan Xu

    A high-power, high-energy 2-µm Ho:YLF MOPA system delivering 521 mJ pulses with a pulse width of 20.3 ns at a repetition rate of 1 kHz was demonstrated using a polarization beam combining technique. To the best of our knowledge, this represents the highest pulse energy reported for a 2-µm laser operating at a high repetition rate. The thermal-lensing-induced beam evolution behavior and potential pulse-induced damage risk during the power-scaling process of the Ho:YLF amplifiers were systematically investigated. Experimental results show that the gradually established negative thermal lens continuously modifies the beam profile, beam size, and laser fluence during power scaling, whereas the pronounced anisotropy of the Ho:YLF further introduces asymmetric beam evolution in multistage amplifiers. Meanwhile, the complex, thermal-lensing-induced evolution of laser fluence may increase the risk of pulse-induced damage, particularly under the relatively low pump intensity used in the multistage amplifier, thereby compromising the safe and stable operation of the system. This study provides useful guidance for the design and optimization of multistage amplifier systems with anisotropic and negative thermal lensing effects.

  • Tm-fiber laser pumped Ho:YAG MOPA system delivering 537 W average output power at a pulse repetition frequency of 10 kHz

    by Panqiang Kang, Yuchun Liu, Enhao Li, Weichao Yao, Yujie Peng, Yuxin Leng

    A pulsed high-power Ho:YAG master-oscillator power amplifier (MOPA) system single-end-pumped by Tm-doped fiber lasers was demonstrated. Through a four-stage amplifier configuration, the maximum average output power of Ho:YAG MOPA system reached 537 W at a pulse repetition frequency of 10 kHz and a pulse width of 52.5 ns, corresponding to the pulse energy of 53.7 mJ and a peak power of 1.017 MW. To the best of our knowledge, this is the maximum average output power for the 2 μm pulsed laser system. Additionally, a polarization-purified laser was obtained by inserting a thin-film polarizer in each amplifier to filter out the depolarized laser. The maximum average output power of the polarization-purified laser was 432 W, and the beam quality M 2 factors were measured to be 1.93 and 1.51 in the x and y directions, respectively.

  • Open Access

    Ho 3+ -doped CALGO crystals for high-power ultrafast 2.1-µm lasers [Invited]

    by Anna Suzuki, Pavel Loiko, Weichao Yao, Parisa Baghery, Martin Hoffmann, Kirill Eremeev, Patrice Camy, Alain Braud, Sergei Tomilov, Yicheng Wang, et al.

    Ho 3+ -doped disordered CaAlGdO 4 (CALGO) crystals have recently emerged as a promising gain material platform for next-generation high-power ultrafast 2.1-µm laser systems. This laser gain material offers a unique combination of high-gain, small quantum defect, inhomogeneously broadened spectra, and good thermal conductivity, enabling ultrashort pulse generation and amplification at high-average power and high pulse energy. Many systems, including mode-locked oscillators and amplifiers with state-of-the-art performance, have been demonstrated in the last few years that promise to meet growing application demands for efficient ultrafast laser technology in this wavelength region. In this review paper, we summarize recent achievements using this gain material both in oscillators and amplifiers and place these results in the state-of-the-art of 2-µm ultrafast laser technology, present detailed spectroscopic characterization of this material, and discuss future perspectives of further performance scaling of Ho:CALGO lasers.


  • Open Access

    1 kHz, 280 mJ, 14.5 ns high-power and high-energy 2.05 μm laser generation via a three-stage Ho:YLF rod amplifier

    by Yuchun Liu, Panqiang Kang, Enhao Li, Weichao Yao, Yujie Peng, Yuxin Leng, Zhizhan Xu

    A 2.05 μm holmium-doped yttrium lithium fluoride (Ho:YLF) master oscillator power amplifier system with both high average power and high pulse energy operating at a 1 kHz repetition rate is demonstrated, achieving a maximum output power of 280 W with a pulse width of 14.5 ns. The system comprises three-stage amplifiers, boosting a 20 W seed laser to output powers of 110, 205 and 280 W, corresponding to extraction efficiencies of 46.1%, 45.0% and 34.9%, respectively. At maximum output, the system exhibits excellent beam quality ( M x 2 = 1.22 and M y 2 = 1.23) and power stability (root mean square = 0.5% over 30 min). To the best of our knowledge, this work reports the highest pulse energy (280 mJ) achieved for a 2 μm laser operating at a kHz repetition rate. In addition, a slice model of an end-pumped quasi-three-level laser amplifier was developed to analyze the output limitations of multi-stage Ho:YLF amplifiers based on rod geometry, providing theoretical support for the experimental results.


  • Diode-pumped Tm:YLF MOPA system delivering 713 mJ pulse energy with near-diffraction-limited beam quality

    by Yan Xu, Yunjie Zhang, Nan Lin, Weichao Yao, Weibiao Chen

    We present a diode-pumped high-energy Tm:YLF nanosecond MOPA system at 1880nm wavelength. Using a simplified laser amplification process, we analyze the distribution of the upper-level population in the gain medium under different pump durations and beam sizes and discuss the dependence of amplifier gain on pump intensity. A cavity-dumped Tm:YLF oscillator was used as a seed source, delivering 5.5 mJ pulse energy with 15 ns pulse duration at a 1 Hz repetition rate. The pulse energy was boosted to 713 mJ using a four-pass Tm:YLF pre-amplifier followed by a double-pass dual-crystal Tm:YLF power amplifier. The system exhibits a good beam quality with M2 of 1.27 and 1.13 in the horizontal and vertical directions, respectively.


  • Investigation on repetition-rate division dynamics in a high-power high-repetition-rate 2-μm Q-switched Ho:YLF laser

    by Yuchun Liu, Panqiang Kang, Enhao Li, Yujie Peng, Jing Wang, Weichao Yao, Yuxin Leng, Zhizhan Xu

    We demonstrated a high-power, high-efficiency 2-μm Ho:YLF laser and investigated the repetition-rate division phenomenon in high-repetition-rate Q-switched mode of operation. The Ho:YLF laser produced 135 W of output power with an optical conversion efficiency of 68.3% in CW regime and over 55 W of average power in Q-switched regime, which, to the best of our knowledge, represent the highest power values achieved for both CW and Q-switched regimes of Ho:YLF lasers. Notably, a regular repetition-rate division phenomenon was observed when operating at high repetition rate of 10-30 kHz, i.e., the pulse repetition frequency shows an integer division of the set frequency, which is attributed to the insufficient energy storage during individual Q-switched cycles. To elucidate the underlying dynamics, we proposed a Q-switched laser model based on quasi-three-level rate equations, specifically tailored to the Ho:YLF gain medium. Theoretical analysis demonstrates that increasing the pump intensity is an effective approach to overcome the frequency division phenomenon. This study could provide practical design guidelines for achieving stable pulsed outputs in high-repetition-rate quasi-three-level Q-switched lasers.


  • Kerr-lens mode-locked Ho:CALYO laser at 2.1 μm

    by Jing Wang, Weichao Yao, Jian Liu, Xiaodong Xu, Jun Xu, Yuxin Leng

    We report on a Kerr-lens mode-locked Ho laser operating at 2.1 μm, based on a disordered structure crystal Ho:CALYO. The laser-generated ultrashort pulses with a pulse duration of 177 fs and an average output power of 0.81 W at a repetition rate of 90 MHz, with an optical-to-optical efficiency of 11%. By optimizing the system for shorter pulse durations, we achieved pulses as short as 166 fs, though at a reduced output power of 0.18 W. The pulse duration and output power limitations were analyzed and discussed.


  • GHz repetition rate, sub-100-fs Ho:CALGO laser at 2.1 µm with watt-level average power

    by Weichao Yao, Mohsen Khalili, Yicheng Wang, Martin Hoffmann, Marcel van Delden, Thomas Musch, Clara J. Saraceno, Martin Saraceno

    We report on a GHz fundamental repetition rate Kerr-lens mode-locked Ho:CALGO laser emitting at 2.1 µm. The laser employs a ring cavity to increase the fundamental repetition rate to 1.179 GHz and can be made to oscillate in both directions stably with nearly identical performance: for the counterclockwise oscillation, it generates 93-fs pulses at 1.68 W of average power, whereas 92 fs and 1.69 W were measured for the clockwise operation. Our current results represent the highest average power from a 2-µm GHz oscillator and, to our knowledge, the first sub-100-fs pulse duration from a Ho-based oscillator.