Martina Cerreti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Martina Cerreti has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Ilaria Benucci
Department of Agriculture and Forestry Science (DAFNE), Tuscia University, via S. Camillo de Lellis snc, 01100 Viterbo, Italy
3 shared publications Felicia Del Franco
Department of Agriculture and Forestry Science (DAFNE), Tuscia University, Viterbo, Italy
2 shared publicationsMarco Esti
Department of Agriculture and Forestry Science (DAFNE), Tuscia University, via S. Camillo de Lellis snc, 01100 Viterbo, Italy
2 shared publications- Marco Esti
Department of Agriculture and Forest Sciences (DAFNE), Tuscia University, Via S. Camillo de Lellis snc, 01100 Viterbo, Italy
2 shared publications - Caterina Mazzocchi
Department of Agriculture and Forest Sciences (DAFNE), Tuscia University, Via S. Camillo de Lellis snc, 01100 Viterbo, Italy
1 shared publication - Claudio Lombardelli
Department of Agriculture and Forestry Science (DAFNE) Tuscia University Viterbo Italy
1 shared publication
Latest Publications
- 18 October 2022
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 39 (12) , 1942-1952
Inclusion of curcumin in b-cyclodextrin: a promising prospective as food ingredient
In the present work, the inclusion complexes between curcumin (CC) and β-cyclodextrin (β-CD) were obtained through co-precipitation at different times of magnetic stirring and simple mixing. The stoichiometric ratio between CC and β-CD was ascertained to be 1:2. The samples prepared by co-precipitation (24 h magnetic stirring and 24 h cold static precipitation) and by simple mixing, showed the best performance in terms of powder recovery (72 and 97%, respectively), encapsulation efficiency (72 and 95%, respectively) and tinting power, while no significant differences were revealed in terms of loading capacity (about 14%). Using either inclusion method, the complexation of CC into β-CD make the colorant 20-fold more water soluble than pure CC. The pigment stability was also enhanced under different storage conditions (high temperature and light exposure), either when applied in liquid or gel state. However, after 30 days under natural light exposure, an appreciable colour change from yellow to orange was revealed to an extent probably perceptible by an inexperienced observer.
- 18 October 2022
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 39 (12) , 1942-1952
Inclusion of curcumin in b-cyclodextrin: a promising prospective as food ingredient
In the present work, the inclusion complexes between curcumin (CC) and β-cyclodextrin (β-CD) were obtained through co-precipitation at different times of magnetic stirring and simple mixing. The stoichiometric ratio between CC and β-CD was ascertained to be 1:2. The samples prepared by co-precipitation (24 h magnetic stirring and 24 h cold static precipitation) and by simple mixing, showed the best performance in terms of powder recovery (72 and 97%, respectively), encapsulation efficiency (72 and 95%, respectively) and tinting power, while no significant differences were revealed in terms of loading capacity (about 14%). Using either inclusion method, the complexation of CC into β-CD make the colorant 20-fold more water soluble than pure CC. The pigment stability was also enhanced under different storage conditions (high temperature and light exposure), either when applied in liquid or gel state. However, after 30 days under natural light exposure, an appreciable colour change from yellow to orange was revealed to an extent probably perceptible by an inexperienced observer.
- 26 April 2020
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 37 (6) , 905-915
Heat and light stability of natural yellow colourants in model beverage systems
The performance of 10 natural yellow colourants at different concentrations (0.001–0.3% w/v) was investigated in a model beverage system at various pH levels (3.5, 5.5 and 7.5) containing 10% w/v of sucrose, with or without ethanol (15% v/v) to simulate both alcoholic and non-alcoholic lemon-like beverages. Thus, the incidence of pH, ethanol and colourant concentration on spectral properties as well as turbidity were evaluated. The λmax was found to be independent from concentration in the tested range (0.001– 0.3% w/v), whereas the specific absorbance at λmax increased linearly. Moreover, the absorption spectrum and λmax of yellow pigments were found to be independent of pH and ethanol. Gardenia, safflower, and curcumin had the highest colour intensity and the lowest turbidity level. Heat and light stability were studied for these as well. Safflower was found to be the most stable colourant against heat (25, 40, 60, 80°C) and light (550 W/m2, 30°C).
- 26 April 2020
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 37 (6) , 905-915
Heat and light stability of natural yellow colourants in model beverage systems
The performance of 10 natural yellow colourants at different concentrations (0.001–0.3% w/v) was investigated in a model beverage system at various pH levels (3.5, 5.5 and 7.5) containing 10% w/v of sucrose, with or without ethanol (15% v/v) to simulate both alcoholic and non-alcoholic lemon-like beverages. Thus, the incidence of pH, ethanol and colourant concentration on spectral properties as well as turbidity were evaluated. The λmax was found to be independent from concentration in the tested range (0.001– 0.3% w/v), whereas the specific absorbance at λmax increased linearly. Moreover, the absorption spectrum and λmax of yellow pigments were found to be independent of pH and ethanol. Gardenia, safflower, and curcumin had the highest colour intensity and the lowest turbidity level. Heat and light stability were studied for these as well. Safflower was found to be the most stable colourant against heat (25, 40, 60, 80°C) and light (550 W/m2, 30°C).
- 1 December 2019
- Published by Elsevier in Food Chemistry
- Vol. 300, 125174
Yeast cells in double layer calcium alginate–chitosan microcapsules for sparkling wine production
- 1 December 2019
- Published by Elsevier in Food Chemistry
- Vol. 300, 125174
Yeast cells in double layer calcium alginate–chitosan microcapsules for sparkling wine production
- 4 July 2016
- Published by Wiley in Journal of Food Science
- Vol. 81 (8) , M2015-20
Characterization of Active Dry Wine Yeast During Starter Culture ( Pied de Cuve ) Preparation for Sparkling Wine Production
The preparation of yeast starter culture ( Pied de Cuve ) for producing sparkling wine with the traditional method is a key factor for manufacturing a good Prise de mousse . In this paper, the evolution of total yeast population, its viability during Pied de Cuve preparation, and the pressure profile during the 2nd fermentation in 2 different base wines made from Bombino bianco and Chardonnay grapes were investigated using 4 different commercial active dried yeasts. The study proves that despite the initial differences observed throughout the acclimatization phase, all the tested strains showed similar results on either the total population (from 8.2 × 10 7 cells/mL to 1.3 × 10 8 cells/mL) or cellular viability (from 70% to 84%). Independently from the base wine tested, the kinetic of sugar consumption was faster during the gradual acclimatization to the alcoholic medium (phase II) and slower during the preparation of starter culture in active growth phase (phase III). During both of these phases Saccharomyces cerevisiae bayanus Vitilevure DV10 ® (Station œnotechnique de Champagne) proved to have a higher sugar consumption rate than the other strains. During the Prise de mousse , S. cerevisiae bayanus Lalvin EC‐1118 ® (Lallemand) reached the maximum pressure increase within time in both base wines.
- 4 July 2016
- Published by Wiley in Journal of Food Science
- Vol. 81 (8) , M2015-20
Characterization of Active Dry Wine Yeast During Starter Culture ( Pied de Cuve ) Preparation for Sparkling Wine Production
The preparation of yeast starter culture ( Pied de Cuve ) for producing sparkling wine with the traditional method is a key factor for manufacturing a good Prise de mousse . In this paper, the evolution of total yeast population, its viability during Pied de Cuve preparation, and the pressure profile during the 2nd fermentation in 2 different base wines made from Bombino bianco and Chardonnay grapes were investigated using 4 different commercial active dried yeasts. The study proves that despite the initial differences observed throughout the acclimatization phase, all the tested strains showed similar results on either the total population (from 8.2 × 10 7 cells/mL to 1.3 × 10 8 cells/mL) or cellular viability (from 70% to 84%). Independently from the base wine tested, the kinetic of sugar consumption was faster during the gradual acclimatization to the alcoholic medium (phase II) and slower during the preparation of starter culture in active growth phase (phase III). During both of these phases Saccharomyces cerevisiae bayanus Vitilevure DV10 ® (Station œnotechnique de Champagne) proved to have a higher sugar consumption rate than the other strains. During the Prise de mousse , S. cerevisiae bayanus Lalvin EC‐1118 ® (Lallemand) reached the maximum pressure increase within time in both base wines.