Ashok Kumar Gupta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ashok Kumar Gupta has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Ashish Raman
Department of Electronics and Communication Engineering, Dr. B.R. Ambedkar National Institute of Technology, Jalandhar, India
7 shared publications - Naveen Kumar
DeepNano Group, James Watt School of Engineering, University of Glasgow, Glasgow, U.K.
4 shared publications - James Minton Cook
Department of Chemistry and Biochemistry, Milwaukee Institute for Drug Discovery, University of Wisconsin-Milwaukee, Milwaukee, WI 53211, USA
3 shared publications X. Fu
Dep. Chem., Univ. Wis., Milwaukee, WI 53201, USA
3 shared publicationsG. Kubiak
Dep. Chem., Univ. Wis., Milwaukee, WI 53201, USA
2 shared publicationsAshish Raman
Dr BR Ambedkar National Institute of Technology, Jalandhar, India
1 shared publication
Latest Publications
- 8 December 2023
- Published by Taylor & Francis
- p. 179-204
Smart Targeted Novel Nanocarriers-Based Treatment of Arthritis
An acute or persistent joint infection is known as arthritis, and it may cause a huge variety of symptoms, along with pain, stiffness, a decrease in the variety of motion, and joint abnormalities. The kinds of arthritis, i.e., rheumatoid arthritis (RA) and osteoarthritis had been mentioned in this article. In RA patients, infection was caused by means of pro-inflammatory cytokines like IL-1, IL-6, IL-8, and IL-10. Nonsteroidal anti-inflammatory medications (NSAIDs), corticosteroids, disease-modifying antirheumatic drugs (DMARDs), and a few biological agents are the most popular RA remedies. However, not one of the remedies available is capable of attaining the final purpose for treating, i.e., drug-free remission. Microemulsions, microspheres, micelles, liposomes, microballoons, co-crystals, nanoemulsions, dendrimers, microsponges, and different strategies had been employed for intrasynovial medicine administration. Because of their size and chemical composition, liposomes have been demonstrated to be specifically effective for maintaining the drugs in the synovial cavity. In contrast to present drugs, novel nanotherapeutic strategies have proven greater selective targeting, extended half-life, subtle bioavailability, and decreased systemic toxicity with the use of nanomaterials and sensible nanomedicines.
- 8 December 2023
- Published by Taylor & Francis
- p. 179-204
Smart Targeted Novel Nanocarriers-Based Treatment of Arthritis
An acute or persistent joint infection is known as arthritis, and it may cause a huge variety of symptoms, along with pain, stiffness, a decrease in the variety of motion, and joint abnormalities. The kinds of arthritis, i.e., rheumatoid arthritis (RA) and osteoarthritis had been mentioned in this article. In RA patients, infection was caused by means of pro-inflammatory cytokines like IL-1, IL-6, IL-8, and IL-10. Nonsteroidal anti-inflammatory medications (NSAIDs), corticosteroids, disease-modifying antirheumatic drugs (DMARDs), and a few biological agents are the most popular RA remedies. However, not one of the remedies available is capable of attaining the final purpose for treating, i.e., drug-free remission. Microemulsions, microspheres, micelles, liposomes, microballoons, co-crystals, nanoemulsions, dendrimers, microsponges, and different strategies had been employed for intrasynovial medicine administration. Because of their size and chemical composition, liposomes have been demonstrated to be specifically effective for maintaining the drugs in the synovial cavity. In contrast to present drugs, novel nanotherapeutic strategies have proven greater selective targeting, extended half-life, subtle bioavailability, and decreased systemic toxicity with the use of nanomaterials and sensible nanomedicines.
- 3 March 2022
- Published by Springer Nature in Silicon
- Vol. 14 (16) , 10357-10373
Design Considerations and Optimization of Electrostatic Doped Ferroelectric Nanotube Tunnel FET: Analog and Noise Analysis
- 3 March 2022
- Published by Springer Nature in Silicon
- Vol. 14 (16) , 10357-10373
Design Considerations and Optimization of Electrostatic Doped Ferroelectric Nanotube Tunnel FET: Analog and Noise Analysis
- 1 December 2021
- Published by Springer Nature in Silicon
- Vol. 13 (12) , 4553-4564
Performance Tuning and Reliability Analysis of the Electrostatically Configured Nanotube Tunnel FET with Impact of Interface Trap Charges
- 1 December 2021
- Published by Springer Nature in Silicon
- Vol. 13 (12) , 4553-4564
Performance Tuning and Reliability Analysis of the Electrostatically Configured Nanotube Tunnel FET with Impact of Interface Trap Charges
- 6 July 2021
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 50 (9) , 5462-5471
Design, Investigation, and Sensitivity Analysis of a Biosensor Based on an Optimized Electrostatically Doped Nanotube TFET
- 6 July 2021
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 50 (9) , 5462-5471
Design, Investigation, and Sensitivity Analysis of a Biosensor Based on an Optimized Electrostatically Doped Nanotube TFET
- 6 January 2021
- Published by Springer Nature in Silicon
- Vol. 14 (3) , 1147-1158
Performance Enhancement and Signal Distortion Analysis of Virtually Doped Nanotube Tunnel FET with Embedded Ferroelectric Gate Oxide
- 6 January 2021
- Published by Springer Nature in Silicon
- Vol. 14 (3) , 1147-1158
Performance Enhancement and Signal Distortion Analysis of Virtually Doped Nanotube Tunnel FET with Embedded Ferroelectric Gate Oxide
- 17 July 2020
- Published by Springer Nature in Silicon
- Vol. 13 (8) , 2401-2413
Electrostatic-Doped Nanotube TFET: Proposal, Design, and Investigation with Linearity Analysis
- 17 July 2020
- Published by Springer Nature in Silicon
- Vol. 13 (8) , 2401-2413
Electrostatic-Doped Nanotube TFET: Proposal, Design, and Investigation with Linearity Analysis
- 30 June 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (7) , 1-10
Performance analysis of electrostatic plasma-based dopingless nanotube TFET
- 30 June 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (7) , 1-10
Performance analysis of electrostatic plasma-based dopingless nanotube TFET
- 1 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 295-300
Design and Implementation of High-Speed Universal Asynchronous Receiver and Transmitter (UART)
In this paper, a universal asynchronous receiver and transmitter (UART) are described, which is basically a serial data transmission protocol used in digital circuit applications. The architecture of the UART transmitter has a baud rate generator, parity generator, transmitter finite state machine (FSM) and parallel in serial out register (PISO). UART receiver has a baud rate generator, negative edge detector, parity checker, receiver finite state machine (FSM) and serial in parallel out (SIPO) register. The baud rate generator of both transmitter and receiver is the same, so the baud rate of transmitter/receiver is the same. Baud rate generator is the same as the frequency divider circuit. The data frame of the UART transmitter is 1 start bit, 8 transmits data bits, 1 parity bit and 1 stop bit. The baud rate of the transmitter and receiver is 4 Mbps using the system clock of 64 MHz’s. Implementation, simulation, and synthesis is done Xilinx Vivado 2016.2 version tool. The design is verified using simulated waveform and synthesized on the FPGA Zed board.
- 1 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 295-300
Design and Implementation of High-Speed Universal Asynchronous Receiver and Transmitter (UART)
In this paper, a universal asynchronous receiver and transmitter (UART) are described, which is basically a serial data transmission protocol used in digital circuit applications. The architecture of the UART transmitter has a baud rate generator, parity generator, transmitter finite state machine (FSM) and parallel in serial out register (PISO). UART receiver has a baud rate generator, negative edge detector, parity checker, receiver finite state machine (FSM) and serial in parallel out (SIPO) register. The baud rate generator of both transmitter and receiver is the same, so the baud rate of transmitter/receiver is the same. Baud rate generator is the same as the frequency divider circuit. The data frame of the UART transmitter is 1 start bit, 8 transmits data bits, 1 parity bit and 1 stop bit. The baud rate of the transmitter and receiver is 4 Mbps using the system clock of 64 MHz’s. Implementation, simulation, and synthesis is done Xilinx Vivado 2016.2 version tool. The design is verified using simulated waveform and synthesized on the FPGA Zed board.
- 9 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3506-3512
Design and Investigation of a Novel Charge Plasma-Based Core-Shell Ring-TFET: Analog and Linearity Analysis
A novel device architecture charge plasma-based Ring-TFET (CP-RingTFET) has been described in this work. The ring structure of the proposed device uses a core-shell architecture with a drain at the center covered with the channel and followed by the source. The ring structure has the advantage of ultrascaling and mechanical strength as compared to the nanowire structure. The performance characteristics of the Ring-TFET are much better as compared to nanowire-TFET with similar physical dimensions. To investigate the impact of charge plasma on RingTFET architecture, various analog and linearity parameters have been studied; such as off-state current (Ioff), on-state current (Ion), Ion/Ioff, subthreshold slope (SS), gate-to-gate capacitance, transconductance (gm), transconductance gain factor (TGF), threshold voltage (VTH), higher-order transconductances, higher-order harmonic distortions, third-order current intercept point (IIP3), third-order intermodulation distortions (IMD3), and higher-order voltage intercept points. The ability of the CP-RingTFET to enhance the performance of the proposed device is confirmed with the reduction of Ioff, improving Ion/Ioff, lower SS including the benefits of threshold voltage reduction.
- 9 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3506-3512
Design and Investigation of a Novel Charge Plasma-Based Core-Shell Ring-TFET: Analog and Linearity Analysis
A novel device architecture charge plasma-based Ring-TFET (CP-RingTFET) has been described in this work. The ring structure of the proposed device uses a core-shell architecture with a drain at the center covered with the channel and followed by the source. The ring structure has the advantage of ultrascaling and mechanical strength as compared to the nanowire structure. The performance characteristics of the Ring-TFET are much better as compared to nanowire-TFET with similar physical dimensions. To investigate the impact of charge plasma on RingTFET architecture, various analog and linearity parameters have been studied; such as off-state current (Ioff), on-state current (Ion), Ion/Ioff, subthreshold slope (SS), gate-to-gate capacitance, transconductance (gm), transconductance gain factor (TGF), threshold voltage (VTH), higher-order transconductances, higher-order harmonic distortions, third-order current intercept point (IIP3), third-order intermodulation distortions (IMD3), and higher-order voltage intercept points. The ability of the CP-RingTFET to enhance the performance of the proposed device is confirmed with the reduction of Ioff, improving Ion/Ioff, lower SS including the benefits of threshold voltage reduction.
- 1 May 2002
- Published by American Chemical Society (ACS) in Organic Process Research & Development
- Vol. 6 (3) , 329-335
The Development of a Large-Scale Synthesis of Matrix Metalloproteinase Inhibitor, ABT-518
- 1 May 2002
- Published by American Chemical Society (ACS) in Organic Process Research & Development
- Vol. 6 (3) , 329-335
The Development of a Large-Scale Synthesis of Matrix Metalloproteinase Inhibitor, ABT-518