Darryl Y. Sasaki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Darryl Y. Sasaki has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
- Tonya Lynn Kuhl
University of California Davis
2 shared publications - Achraf Noureddine
University of New Mexico
1 shared publication Amanda Tuyet Yi Dang
Chemical Engineering Department , University of California, Davis , Davis , California 95616 , United States
1 shared publicationAmir Berman
Department of Biotechnology Engineering, Ben-Gurion University of the Negev, Beersheba 8410501, Israel
1 shared publicationAndrew Gomez
Department of Active Ceramics Value Stream, Sandia National Laboratories, Albuquerque, USA
1 shared publicationAnnette E. LaBauve
Department of Biotechnology and Bioengineering, Sandia National Laboratories, Livermore, USA
1 shared publication
Latest Publications
- Open Access
- 27 April 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-13
Lipid-coated mesoporous silica nanoparticles for anti-viral applications via delivery of CRISPR-Cas9 ribonucleoproteins
Emerging and re-emerging viral pathogens present a unique challenge for anti-viral therapeutic development. Anti-viral approaches with high flexibility and rapid production times are essential for combating these high-pandemic risk viruses. CRISPR-Cas technologies have been extensively repurposed to treat a variety of diseases, with recent work expanding into potential applications against viral infections. However, delivery still presents a major challenge for these technologies. Lipid-coated mesoporous silica nanoparticles (LCMSNs) offer an attractive delivery vehicle for a variety of cargos due to their high biocompatibility, tractable synthesis, and amenability to chemical functionalization. Here, we report the use of LCMSNs to deliver CRISPR-Cas9 ribonucleoproteins (RNPs) that target the Niemann–Pick disease type C1 gene, an essential host factor required for entry of the high-pandemic risk pathogen Ebola virus, demonstrating an efficient reduction in viral infection. We further highlight successful in vivo delivery of the RNP-LCMSN platform to the mouse liver via systemic administration.
- 27 April 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-13
Open AccessLipid-coated mesoporous silica nanoparticles for anti-viral applications via delivery of CRISPR-Cas9 ribonucleoproteins
Emerging and re-emerging viral pathogens present a unique challenge for anti-viral therapeutic development. Anti-viral approaches with high flexibility and rapid production times are essential for combating these high-pandemic risk viruses. CRISPR-Cas technologies have been extensively repurposed to treat a variety of diseases, with recent work expanding into potential applications against viral infections. However, delivery still presents a major challenge for these technologies. Lipid-coated mesoporous silica nanoparticles (LCMSNs) offer an attractive delivery vehicle for a variety of cargos due to their high biocompatibility, tractable synthesis, and amenability to chemical functionalization. Here, we report the use of LCMSNs to deliver CRISPR-Cas9 ribonucleoproteins (RNPs) that target the Niemann–Pick disease type C1 gene, an essential host factor required for entry of the high-pandemic risk pathogen Ebola virus, demonstrating an efficient reduction in viral infection. We further highlight successful in vivo delivery of the RNP-LCMSN platform to the mouse liver via systemic administration.
- 26 October 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (44) , 12940-12951
Characterizing and Tuning the Properties of Polydiacetylene Films for Sensing Applications
Self-assembled, polymerized diacetylene (DA) nanostructures and two-dimensional films have been studied over the past two decades for sensor applications because of their straightforward visual readout. DA monomers, when exposed to UV light, polymerize to produce a visibly blue polymer. Blue phase polydiacetylenes (PDAs) when exposed to an external stimuli, such as temperature or UV light, undergo a chromatic phase transition to a fluorescent, visibly red phase. The tunability of the monomer to blue to red chromatic phase transitions by choice of diacetylene monomer in the presence of metal cations is systematically and comprehensively investigated to determine their effects on the properties of PDA Langmuir films. The polymerization kinetics and domain morphology of the PDA films were characterized using polarized fluorescent microscopy, UV–vis–fluorescent spectroscopy, and Fourier transform infrared spectroscopy (FTIR). Increasing the monomer alkyl tail length was found to strongly increase the UV dose necessary to produce optimally blue films and fully red films. A decrease in the polymer domain size was also correlated with longer-tailed DA molecules. Metal cations have a diverse effect on the film behavior. Alkaline-earth metals such as Mg, Ca, and Ba have a negligible effect on the phase transition kinetics but can be used to tune PDA polymer domain sizes. The Ni and Fe cations increase the UV dose necessary to produce red phase PDA films and significantly decrease the polymer domain sizes. The Zn, Cd, and Cu ions exhibit strong directed interactions with the PDA carboxylic acid headgroups, resulting in quenched fluorescence and a unique film morphology. FTIR analysis provides insight into the metal–PDA binding mechanisms and demonstrates that the coordination between the PDA film headgroups and the metal cations can be correlated with changes in the film morphology and kinetics. The findings from these studies will have broad utility for tuning PDA-based sensors for different applications and sensitivity ranges.
- 26 October 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (44) , 12940-12951
Characterizing and Tuning the Properties of Polydiacetylene Films for Sensing Applications
Self-assembled, polymerized diacetylene (DA) nanostructures and two-dimensional films have been studied over the past two decades for sensor applications because of their straightforward visual readout. DA monomers, when exposed to UV light, polymerize to produce a visibly blue polymer. Blue phase polydiacetylenes (PDAs) when exposed to an external stimuli, such as temperature or UV light, undergo a chromatic phase transition to a fluorescent, visibly red phase. The tunability of the monomer to blue to red chromatic phase transitions by choice of diacetylene monomer in the presence of metal cations is systematically and comprehensively investigated to determine their effects on the properties of PDA Langmuir films. The polymerization kinetics and domain morphology of the PDA films were characterized using polarized fluorescent microscopy, UV–vis–fluorescent spectroscopy, and Fourier transform infrared spectroscopy (FTIR). Increasing the monomer alkyl tail length was found to strongly increase the UV dose necessary to produce optimally blue films and fully red films. A decrease in the polymer domain size was also correlated with longer-tailed DA molecules. Metal cations have a diverse effect on the film behavior. Alkaline-earth metals such as Mg, Ca, and Ba have a negligible effect on the phase transition kinetics but can be used to tune PDA polymer domain sizes. The Ni and Fe cations increase the UV dose necessary to produce red phase PDA films and significantly decrease the polymer domain sizes. The Zn, Cd, and Cu ions exhibit strong directed interactions with the PDA carboxylic acid headgroups, resulting in quenched fluorescence and a unique film morphology. FTIR analysis provides insight into the metal–PDA binding mechanisms and demonstrates that the coordination between the PDA film headgroups and the metal cations can be correlated with changes in the film morphology and kinetics. The findings from these studies will have broad utility for tuning PDA-based sensors for different applications and sensitivity ranges.
- 6 July 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (32) , 10276-10285
Mechanism of Acid-Triggered Cargo Release from Lipid Bilayer-Coated Mesoporous Silica Particles
Lipid bilayer-coated mesoporous silica nanoparticles are unique core-shell nanomaterials currently being developed as drug delivery vehicles. To improve cargo loading and biocirculation the particle’s pore structure and surface chemistry have been modified and well characterized. However, an understanding of cargo release mechanisms from cellular uptake pathways remain largely unexplored. Here, we present a study of the release mechanism of lipid bilayer-coated silica particles induced by endosomal-like pH change from 7.4 to 5.0. We found that this relatively small pH change produces rapid deformation of the supported lipid bilayer that ultimately results in holes in the membrane. Using a combination of dye release studies, wide-field and 3D confocal fluorescence microscopies, and surface area modeling analysis we determined that small blister-like structures form which leads to lateral membrane displacement and hole formation. Possible mechanisms for the blister formation, which include curvature effects and interfacial interactions, are discussed.
- 6 July 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (32) , 10276-10285
Mechanism of Acid-Triggered Cargo Release from Lipid Bilayer-Coated Mesoporous Silica Particles
Lipid bilayer-coated mesoporous silica nanoparticles are unique core-shell nanomaterials currently being developed as drug delivery vehicles. To improve cargo loading and biocirculation the particle’s pore structure and surface chemistry have been modified and well characterized. However, an understanding of cargo release mechanisms from cellular uptake pathways remain largely unexplored. Here, we present a study of the release mechanism of lipid bilayer-coated silica particles induced by endosomal-like pH change from 7.4 to 5.0. We found that this relatively small pH change produces rapid deformation of the supported lipid bilayer that ultimately results in holes in the membrane. Using a combination of dye release studies, wide-field and 3D confocal fluorescence microscopies, and surface area modeling analysis we determined that small blister-like structures form which leads to lateral membrane displacement and hole formation. Possible mechanisms for the blister formation, which include curvature effects and interfacial interactions, are discussed.
- 1 July 2012
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 18 (S2) , 1132-1133
Progress Towards In Situ TEM Observation of Biofouling
- 1 July 2012
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 18 (S2) , 1132-1133
Progress Towards In Situ TEM Observation of Biofouling
- Open Access
- 16 May 2006
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 96 (19) , 198101
Rearrangement of Lipid Ordered Phases Upon Protein Adsorption Due to Multiple Site Binding
This study involves the interactions of proteins with Langmuir monolayers of a metal-chelating lipid, where adsorption is driven by a strong specific interaction between histidines on the proteins and divalent metal ions loaded into the lipid headgroups. A comparison of the structural rearrangement of the lipid film upon adsorption of myoglobin and a synthetic peptide, each of which have multiple histidines, with that upon the adsorption of lysozyme, which has only one histidine, suggests that the lipid rearrangement in the former case is due to the multiplicity of binding sites. The kinetics and manner of rearrangement change with the binding energy and film pressure.
- 16 May 2006
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 96 (19) , 198101
Open AccessRearrangement of Lipid Ordered Phases Upon Protein Adsorption Due to Multiple Site Binding
This study involves the interactions of proteins with Langmuir monolayers of a metal-chelating lipid, where adsorption is driven by a strong specific interaction between histidines on the proteins and divalent metal ions loaded into the lipid headgroups. A comparison of the structural rearrangement of the lipid film upon adsorption of myoglobin and a synthetic peptide, each of which have multiple histidines, with that upon the adsorption of lysozyme, which has only one histidine, suggests that the lipid rearrangement in the former case is due to the multiplicity of binding sites. The kinetics and manner of rearrangement change with the binding energy and film pressure.
- 1 March 2004
- Published by Elsevier in Applied Surface Science
- Vol. 224 (1-4) , 270-273
Proposal of a multi-layer channel MOSFET: the application of selective etching for Si/SiGe stacked layers
- 1 March 2004
- Published by Elsevier in Applied Surface Science
- Vol. 224 (1-4) , 270-273
Proposal of a multi-layer channel MOSFET: the application of selective etching for Si/SiGe stacked layers
- Open Access
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 991-996
Gas phase chemical detection with an integrated chemical analysis system
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 991-996
Open AccessGas phase chemical detection with an integrated chemical analysis system
- 1 December 1992
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 25 (25) , 6961-6969
Structural study of polyethers on graphite by scanning tunneling microscopy. Polymerization-induced epitaxy
- 1 December 1992
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 25 (25) , 6961-6969
Structural study of polyethers on graphite by scanning tunneling microscopy. Polymerization-induced epitaxy