Ming Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ming Li has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Xiaohan Chen
Shandong University
4 shared publications Bin Zhang
Center for Optics Research and Engineering, and Key Laboratory of Laser & Infrared System, Ministry of Education, Shandong University, Binhai Road No.72, Qingdao, Shandong, 266237, CHINA
2 shared publicationsJing Liu
School of Information Science and Engineering, Shandong University, Binhai Road No.72, Qingdao, Shandong, 266237, CHINA
2 shared publicationsPing Li
Center for Optics Research and Engineering, and Key Laboratory of Laser & Infrared System, Ministry of Education, Shandong University, Qingdao, Shandong 266237, People’s Republic of China
2 shared publications- Ping Li
Xi'an Jiaotong University
2 shared publications Qiongyu Hu
Center for Optics Research and Engineering, and Key Laboratory of Laser & Infrared System, Ministry of Education, Shandong University, Qingdao, Shandong 266237, People’s Republic of China
2 shared publications
Latest Publications
- 14 April 2026
- Published by Springer Nature in Journal of Russian Laser Research
- Vol. 47 (2) , 168-173
Research on 0.9 µm Nd-doped mode-locked fiber laser with dispersion compensation based on reflective grating pairs
- 14 April 2026
- Published by Springer Nature in Journal of Russian Laser Research
- Vol. 47 (2) , 168-173
Research on 0.9 µm Nd-doped mode-locked fiber laser with dispersion compensation based on reflective grating pairs
- 23 June 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 34 (36) , 365203
Multi-pulse dynamic patterns in a mode-locked erbium-doped fiber laser based on an Sb2S3-PVA saturable absorber
Multi-pulse dynamic patterns have been experimentally documented in a passively mode-locked (PML) erbium-doped fiber (EDF) laser using an Sb2S3-PVA saturable absorber (SA). The fundamental mode-locking operation, with a repetition rate of ∼3.22 MHz, a pulse width of ∼2.5 ps, a signal-to-noise ratio (SNR) of ∼50 dB and a peak power over 200 W, was achieved under a pump power from 280 to 360 mW with appropriate polarization states introduced by the polarization controllers (PCs). By rotating the orientation of the intra-cavity PCs carefully and slowly at a pump power of 350 mW, it was found that a multi-pulse bunch was transformed gradually from a single-pulse to a twelve-pulse bunch, with several intermediate transition states of multi-pulse bunches being observed. In addition, other characteristic modes including disordered multi-pulses and soliton rains have been experimentally observed by meticulously adjusting the polarization states of PCs at a pump power of 350 mW. Our systematic study clearly demonstrates that Sb2S3 has potential as an effective SA for generating different operation states of multi-pulses in PML anomalous-dispersion EDF lasers.
- 23 June 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 34 (36) , 365203
Multi-pulse dynamic patterns in a mode-locked erbium-doped fiber laser based on an Sb2S3-PVA saturable absorber
Multi-pulse dynamic patterns have been experimentally documented in a passively mode-locked (PML) erbium-doped fiber (EDF) laser using an Sb2S3-PVA saturable absorber (SA). The fundamental mode-locking operation, with a repetition rate of ∼3.22 MHz, a pulse width of ∼2.5 ps, a signal-to-noise ratio (SNR) of ∼50 dB and a peak power over 200 W, was achieved under a pump power from 280 to 360 mW with appropriate polarization states introduced by the polarization controllers (PCs). By rotating the orientation of the intra-cavity PCs carefully and slowly at a pump power of 350 mW, it was found that a multi-pulse bunch was transformed gradually from a single-pulse to a twelve-pulse bunch, with several intermediate transition states of multi-pulse bunches being observed. In addition, other characteristic modes including disordered multi-pulses and soliton rains have been experimentally observed by meticulously adjusting the polarization states of PCs at a pump power of 350 mW. Our systematic study clearly demonstrates that Sb2S3 has potential as an effective SA for generating different operation states of multi-pulses in PML anomalous-dispersion EDF lasers.
- Open Access
Passively Mode-Locked Er-Doped Fiber Laser Based on Sb2S3-PVA Saturable Absorber
In this paper, antimony trisulfide (Sb2S3) was successfully prepared with the liquid phase exfoliation method and embedded into polyvinyl alcohol (PVA) as a saturable absorber (SA) in a passively mode-locked Er-doped fiber laser for the first time. Based on Sb2S3-PVA SA with a modulation depth of 4.0% and a saturable intensity of 1.545 GW/cm2, a maximum average output power of 3.04 mW and maximum peak power of 325.6 W for the stable mode-locked pulses was achieved with slope a efficiency of 0.87% and maximum single pulse energy of 0.81 nJ at a repetition rate of 3.47 MHz under a pump power of 369 mW. A minimum pulse width value of 2.4 ps with a variation range less than 0.1 ps, and a maximum signal to noise ratio (SNR) of 54.3 dB indicated reliable stability of mode-locking, revealing promising potentials of Sb2S3 as a saturable absorber in ultrafast all-fiber lasers.
Open AccessPassively Mode-Locked Er-Doped Fiber Laser Based on Sb2S3-PVA Saturable Absorber
In this paper, antimony trisulfide (Sb2S3) was successfully prepared with the liquid phase exfoliation method and embedded into polyvinyl alcohol (PVA) as a saturable absorber (SA) in a passively mode-locked Er-doped fiber laser for the first time. Based on Sb2S3-PVA SA with a modulation depth of 4.0% and a saturable intensity of 1.545 GW/cm2, a maximum average output power of 3.04 mW and maximum peak power of 325.6 W for the stable mode-locked pulses was achieved with slope a efficiency of 0.87% and maximum single pulse energy of 0.81 nJ at a repetition rate of 3.47 MHz under a pump power of 369 mW. A minimum pulse width value of 2.4 ps with a variation range less than 0.1 ps, and a maximum signal to noise ratio (SNR) of 54.3 dB indicated reliable stability of mode-locking, revealing promising potentials of Sb2S3 as a saturable absorber in ultrafast all-fiber lasers.
- 12 January 2022
- Published by IOP Publishing in Laser Physics
- Vol. 32 (2) , 025102
All-fiber all-normal-dispersion passively mode-locked neodymium-doped fiber laser operation at 1064 nm
In this work, we report an all-fiber Nd-doped passively mode-locked fiber laser based on nonlinear polarization rotation mechanism operating in the 1.06 μ m region. When the pump power was 300 mW, a pulse with a maximum average output power of 0.63 mW, a narrowest pulse duration of 1.22 ps and a pulse repetition rate of 14.25 MHz was obtained.
- 12 January 2022
- Published by IOP Publishing in Laser Physics
- Vol. 32 (2) , 025102
All-fiber all-normal-dispersion passively mode-locked neodymium-doped fiber laser operation at 1064 nm
In this work, we report an all-fiber Nd-doped passively mode-locked fiber laser based on nonlinear polarization rotation mechanism operating in the 1.06 μ m region. When the pump power was 300 mW, a pulse with a maximum average output power of 0.63 mW, a narrowest pulse duration of 1.22 ps and a pulse repetition rate of 14.25 MHz was obtained.
- Open Access
- 13 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 11 (4) , 1-13
Dual-Wavelength Passively Mode-Locked Yb-Doped Fiber Laser Based on a SnSe2-PVA Saturable Absorber
In this paper, tin diselenide ( $\text{SnSe}_2$ ) was successfully prepared with liquid phase exfoliation method and embedded into polyvinyl alcohol (PVA) as a saturable absorber (SA) in a dual-wavelength passively mode-locked Yb-doped fiber laser. Stable mode-locked pulses with a maximum average output power of 2.55 mW and a slope efficiency of 1.3% at the fundamental repetition rate of 333 kHz were achieved. By properly adjusting polarization state, four kinds of dual-wavelength fundamental frequency mode-locked pulses with peak wavelength intervals of 0.4, 1.0, 1.5 and 1.9 nm were obtained, and corresponding waveforms with different single pulse shapes were investigated in our work. A maximum signal to noise ratio (SNR) of 71.04 dB indicates that $\text{SnSe}_2$ is promising to serve as SA in passively mode-locked fiber lasers.- 13 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 11 (4) , 1-13
Open AccessDual-Wavelength Passively Mode-Locked Yb-Doped Fiber Laser Based on a SnSe2-PVA Saturable Absorber
In this paper, tin diselenide ( $\text{SnSe}_2$ ) was successfully prepared with liquid phase exfoliation method and embedded into polyvinyl alcohol (PVA) as a saturable absorber (SA) in a dual-wavelength passively mode-locked Yb-doped fiber laser. Stable mode-locked pulses with a maximum average output power of 2.55 mW and a slope efficiency of 1.3% at the fundamental repetition rate of 333 kHz were achieved. By properly adjusting polarization state, four kinds of dual-wavelength fundamental frequency mode-locked pulses with peak wavelength intervals of 0.4, 1.0, 1.5 and 1.9 nm were obtained, and corresponding waveforms with different single pulse shapes were investigated in our work. A maximum signal to noise ratio (SNR) of 71.04 dB indicates that $\text{SnSe}_2$ is promising to serve as SA in passively mode-locked fiber lasers.