Jed Costanza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jed Costanza has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Kurt D. Pennell
Brown University
4 shared publications - Linda M. Abriola
Brown University
3 shared publications - Masoud Arshadi
Department of Civil and Environmental Engineering, Tufts University, Medford, Massachusetts 02155, United States
2 shared publications Charles D. Clabaugh
U.S. Environmental Protection Agency
1 shared publicationChrista Leibli
U.S. Environmental Protection Agency
1 shared publicationJames Ferreira
U.S. Environmental Protection Agency
1 shared publication
Latest Publications
- 27 February 2025
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 59 (9) , 4215-4229
Using Suction Lysimeters for Determining the Potential of Per- and Polyfluoroalkyl Substances to Leach from Soil to Groundwater: A Review
In-situ porewater samples were proposed to best represent the fraction of perfluoroalkyl and polyfluoroalkyl substances (PFAS) with the potential to migrate to groundwater. While there are many techniques for collecting porewater samples, suction lysimeters are frequently being used for PFAS investigations. Suction lysimeters use vacuum to extract porewater from vadose zone soils, typically fine to medium sands, which retain and release enough porewater for analysis. Importantly, determining the rate of PFAS migration to groundwater requires an independent measure of water percolation. This review covers the installation and sampling methods for suction lysimeters and provides suggestions to improve the utility and reduce the variability of the results. Because the volume of soil represented by the porewater sample varies significantly depending on the soil-water content, which is spatially and temporally variable, many suction lysimeters may be required to accurately represent soil heterogeneity. A similar limitation applies to soil or leaching protocol samples. Suction lysimeters may not provide a representative sample for all PFAS due to interactions with lysimeter materials, air-water interfaces, and the use of vacuum. Consequently, lysimeter data are best applied in combination with soil-leaching protocols, groundwater transects, and soil analysis when making remedial decisions.
- 27 February 2025
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 59 (9) , 4215-4229
Using Suction Lysimeters for Determining the Potential of Per- and Polyfluoroalkyl Substances to Leach from Soil to Groundwater: A Review
In-situ porewater samples were proposed to best represent the fraction of perfluoroalkyl and polyfluoroalkyl substances (PFAS) with the potential to migrate to groundwater. While there are many techniques for collecting porewater samples, suction lysimeters are frequently being used for PFAS investigations. Suction lysimeters use vacuum to extract porewater from vadose zone soils, typically fine to medium sands, which retain and release enough porewater for analysis. Importantly, determining the rate of PFAS migration to groundwater requires an independent measure of water percolation. This review covers the installation and sampling methods for suction lysimeters and provides suggestions to improve the utility and reduce the variability of the results. Because the volume of soil represented by the porewater sample varies significantly depending on the soil-water content, which is spatially and temporally variable, many suction lysimeters may be required to accurately represent soil heterogeneity. A similar limitation applies to soil or leaching protocol samples. Suction lysimeters may not provide a representative sample for all PFAS due to interactions with lysimeter materials, air-water interfaces, and the use of vacuum. Consequently, lysimeter data are best applied in combination with soil-leaching protocols, groundwater transects, and soil analysis when making remedial decisions.
- 23 September 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 54 (21) , 13590-13597
Aqueous Film-Forming Foams Exhibit Greater Interfacial Activity than PFOA, PFOS, or FOSA
Perfluoroalkyl acids spontaneously concentrate at air-water and non-aqueous phase liquid (NAPL)-water interfaces, which can influence their retention during subsurface transport. This work presents measurements of air- and NAPL-water interfacial tension for synthetic groundwater containing perfluorooctanoic acid (PFOA), perfluorooctanesulfonic acid (PFOS), perfluorooctanesulfonamide (FOSA), or aqueous film forming foam (AFFF) formulations at concentrations ranging from 0.1 to greater than 1,000 mg/L. The NAPLs tested included dodecane, tetrachloroethylene (PCE), or jet fuel. AFFF formulations were less efficient at lowering interfacial tension than PFOA, FPOS, or FOSA substances below 100 mg/L, while above 100 mg/L, these formulations were more effective, achieving tensions of less than 3 mN/m. Infiltration of solutions with such low tension could lead to mobilization of residual NAPL. Equations based on interfacial tension measurements show that concentrations of PFOA, PFOS, and FOSA at the air-water interface were from 2 to 16 times greater than at the NAPL-water interface below 100 mg/L, and were 10 to 50 times greater for AFFF below 20 mg/L. Calculations for unsaturated soil estimate that up to 87% of PFOS mass was at the air-water interface and less than 4% at the dodecane-water interface for bulk-water concentrations below 1 mg/L.
- 23 September 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 54 (21) , 13590-13597
Aqueous Film-Forming Foams Exhibit Greater Interfacial Activity than PFOA, PFOS, or FOSA
Perfluoroalkyl acids spontaneously concentrate at air-water and non-aqueous phase liquid (NAPL)-water interfaces, which can influence their retention during subsurface transport. This work presents measurements of air- and NAPL-water interfacial tension for synthetic groundwater containing perfluorooctanoic acid (PFOA), perfluorooctanesulfonic acid (PFOS), perfluorooctanesulfonamide (FOSA), or aqueous film forming foam (AFFF) formulations at concentrations ranging from 0.1 to greater than 1,000 mg/L. The NAPLs tested included dodecane, tetrachloroethylene (PCE), or jet fuel. AFFF formulations were less efficient at lowering interfacial tension than PFOA, FPOS, or FOSA substances below 100 mg/L, while above 100 mg/L, these formulations were more effective, achieving tensions of less than 3 mN/m. Infiltration of solutions with such low tension could lead to mobilization of residual NAPL. Equations based on interfacial tension measurements show that concentrations of PFOA, PFOS, and FOSA at the air-water interface were from 2 to 16 times greater than at the NAPL-water interface below 100 mg/L, and were 10 to 50 times greater for AFFF below 20 mg/L. Calculations for unsaturated soil estimate that up to 87% of PFOS mass was at the air-water interface and less than 4% at the dodecane-water interface for bulk-water concentrations below 1 mg/L.
- 12 May 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 54 (11) , 7019-7020
Comment on “Uptake of Poly- and Perfluoroalkyl Substances at the Air–Water Interface”
- 12 May 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 54 (11) , 7019-7020
Comment on “Uptake of Poly- and Perfluoroalkyl Substances at the Air–Water Interface”
- 8 May 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 7 (6) , 446
Correction to “Accumulation of PFOA and PFOS at the Air–Water Interface”
- 8 May 2020
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 7 (6) , 446
Correction to “Accumulation of PFOA and PFOS at the Air–Water Interface”
- Top Cited Papers
- 24 July 2019
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 6 (8) , 487-491
Accumulation of PFOA and PFOS at the Air–Water Interface
- 24 July 2019
- Published by American Chemical Society (ACS) in Environmental Science & Technology Letters
- Vol. 6 (8) , 487-491
Top Cited PapersAccumulation of PFOA and PFOS at the Air–Water Interface