Ankit Soni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ankit Soni has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Raksha Upadhyay
Room No D106, D-Block, Department of Electronics & Telecommunication, Institute of Engineering & Technology (IET-DAVV), Devi Ahilya Vishwavidyalaya, Indore, India
6 shared publications- Abhay Kumar
School of Electronics, Devi Ahilya University, Indore, India
4 shared publications Anjana Jain
Shri Govindram Seksaria Institute of Technology and Science
1 shared publication- Atul Gupta
Santerno India Design Center
1 shared publication Purvi Panse
Institute of Engineering and Technology, Devi Ahilya University
1 shared publication- Raksha Upadhyay
DAVV
1 shared publication
Latest Publications
- 25 April 2022
- Published by Springer Nature in Wireless Personal Communications
- Vol. 125 (3) , 2865-2888
Low Complexity Preprocessing Approach for Wireless Physical Layer Secret Key Extraction Based on PCA
- 25 April 2022
- Published by Springer Nature in Wireless Personal Communications
- Vol. 125 (3) , 2865-2888
Low Complexity Preprocessing Approach for Wireless Physical Layer Secret Key Extraction Based on PCA
- 14 July 2021
- Published by Taylor & Francis
- p. 169-184
Lightweight Security Solutions for IoT using Physical-Layer Key Generation
Modern networking technologies involve the interconnection of smart and intelligent physical objects to provide advanced services. These physical objects may be part of various network technologies like WLAN, wireless sensor network (WSN), Internet of Things (IoT), etc., and share data in wireless mode, which should be secured from threats. These physical devices possess many constraints like power, computational complexity and storage, and are required to have lightweight security algorithms. Traditionally, security is achieved by the higher layers of the communication model, which has high computational complexity and consumes more power. In this chapter, a secure-key-generation scheme from physical layer characteristics is introduced as a possible lightweight security alternative to traditional upper-layer security approaches. The proposed scheme is based on the wiretap-channel model and security is achieved by generating keys at both communicating ends independently, based on inherent common-channel characteristics like randomness. It is mainly based on the principle of spatial decorrelation and channel reciprocity for identical carrier frequency. There is no provision for sharing keys as in public-key cryptography, so physical-layer key generation is not vulnerable to threats like key leakage. The generated key at the transmitter encrypts plain text; the generated cipher is transmitted on the common channel and is decrypted at the receiver end using the key generated by the receiver. Key generation consists of fundamental blocks like channel probing and quantization followed by information reconciliation and privacy amplification. The physical-layer key generation is already a power-efficient security solution; this chapter aims to enhance this capacity further. This is done by introducing low-end signal conditioning in the channel-probing step using moving-window averaging. This solution not only improves system performance but also makes it suitable for limited- power applications. The performance of the key-generation system is characterised in terms of the bit-disagreement rate between the generated key sequences of communicating parties and the key randomness by means of the NIST statistical test suite.
- 14 July 2021
- Published by Taylor & Francis
- p. 169-184
Lightweight Security Solutions for IoT using Physical-Layer Key Generation
Modern networking technologies involve the interconnection of smart and intelligent physical objects to provide advanced services. These physical objects may be part of various network technologies like WLAN, wireless sensor network (WSN), Internet of Things (IoT), etc., and share data in wireless mode, which should be secured from threats. These physical devices possess many constraints like power, computational complexity and storage, and are required to have lightweight security algorithms. Traditionally, security is achieved by the higher layers of the communication model, which has high computational complexity and consumes more power. In this chapter, a secure-key-generation scheme from physical layer characteristics is introduced as a possible lightweight security alternative to traditional upper-layer security approaches. The proposed scheme is based on the wiretap-channel model and security is achieved by generating keys at both communicating ends independently, based on inherent common-channel characteristics like randomness. It is mainly based on the principle of spatial decorrelation and channel reciprocity for identical carrier frequency. There is no provision for sharing keys as in public-key cryptography, so physical-layer key generation is not vulnerable to threats like key leakage. The generated key at the transmitter encrypts plain text; the generated cipher is transmitted on the common channel and is decrypted at the receiver end using the key generated by the receiver. Key generation consists of fundamental blocks like channel probing and quantization followed by information reconciliation and privacy amplification. The physical-layer key generation is already a power-efficient security solution; this chapter aims to enhance this capacity further. This is done by introducing low-end signal conditioning in the channel-probing step using moving-window averaging. This solution not only improves system performance but also makes it suitable for limited- power applications. The performance of the key-generation system is characterised in terms of the bit-disagreement rate between the generated key sequences of communicating parties and the key randomness by means of the NIST statistical test suite.
- 8 August 2019
- Published by World Scientific Pub Co Pte Ltd in Fluctuation and Noise Letters
- Vol. 19 (01)
AvDR-Based Wireless Secure Key Generation with Colored Noise for IoT
Physical layer key generation exploiting inherent channel randomness is an open research area in securing the networks with resource constraint nodes; therefore reduction of numerical computation is desirable to save battery power. However, the correlated components due to colored noise also affect the system performance. In this work, we consider the correlated colored noise components along with the additive white Gaussian noise (AWGN) in the wireless channel and analyze the effect of these correlated components on the system performance. We further propose a hybrid averaging and dimensionality reduction (AvDR), based received signal strength (RSS) preprocessing which is the combination of moving window averaging (Av) and principal component analysis (PCA) as dimensionality reduction technique (DR) to improve the system performance. Further, the system performance was evaluated by numerical simulations, and it is observed that the same improvement in system performance is achieved by generating keys from a fewer number of points selected after PCA as compared to processing all the points. Picking a few of the points in the data sequence instead of all reduces the total number of numerical calculations and saves system power, which is the primary requirement of resource constraint networks like the IoT.
- 8 August 2019
- Published by World Scientific Pub Co Pte Ltd in Fluctuation and Noise Letters
- Vol. 19 (01)
AvDR-Based Wireless Secure Key Generation with Colored Noise for IoT
Physical layer key generation exploiting inherent channel randomness is an open research area in securing the networks with resource constraint nodes; therefore reduction of numerical computation is desirable to save battery power. However, the correlated components due to colored noise also affect the system performance. In this work, we consider the correlated colored noise components along with the additive white Gaussian noise (AWGN) in the wireless channel and analyze the effect of these correlated components on the system performance. We further propose a hybrid averaging and dimensionality reduction (AvDR), based received signal strength (RSS) preprocessing which is the combination of moving window averaging (Av) and principal component analysis (PCA) as dimensionality reduction technique (DR) to improve the system performance. Further, the system performance was evaluated by numerical simulations, and it is observed that the same improvement in system performance is achieved by generating keys from a fewer number of points selected after PCA as compared to processing all the points. Picking a few of the points in the data sequence instead of all reduces the total number of numerical calculations and saves system power, which is the primary requirement of resource constraint networks like the IoT.
- 26 July 2019
- Published by Wiley in International Journal of Communication Systems
- Vol. 32 (16) , e4124
Performance improvement of wireless secret key generation with colored noise for IoT
Summary: Achieving security in the Internet of things (IoT) networks by generating symmetric keys from the wireless channel parameters like received signal strength (RSS) is a promising approach. Despite the easy acquisition of the RSS signal, RSS‐based security is less explored for IoT. In this work, we analyze the performance of RSS‐based wireless physical layer key generation with correlated colored noise components and proposed a low complexity filtering approach to improve the performance for the IoT network. We started with providing a survey of various recent researches related to RSS‐based key generation and also discussed correlated colored noise components with a few of the recent works considering them. Further, we analyze various colored noise components in the time domain by the Allan variance and Ljung‐Box test. Furthermore, we develop a key generation model and proposed a moving window averaging‐based filtering followed by Lloyd max quantization to improve the BDR performance, degraded due to the presence of correlated colored noise components. The simulation results show that the proposed preprocessing technique has a considerable improvement in the BDR performance, and the keys generated have sufficient randomness, which is verified by NIST test.
- 26 July 2019
- Published by Wiley in International Journal of Communication Systems
- Vol. 32 (16) , e4124
Performance improvement of wireless secret key generation with colored noise for IoT
Summary: Achieving security in the Internet of things (IoT) networks by generating symmetric keys from the wireless channel parameters like received signal strength (RSS) is a promising approach. Despite the easy acquisition of the RSS signal, RSS‐based security is less explored for IoT. In this work, we analyze the performance of RSS‐based wireless physical layer key generation with correlated colored noise components and proposed a low complexity filtering approach to improve the performance for the IoT network. We started with providing a survey of various recent researches related to RSS‐based key generation and also discussed correlated colored noise components with a few of the recent works considering them. Further, we analyze various colored noise components in the time domain by the Allan variance and Ljung‐Box test. Furthermore, we develop a key generation model and proposed a moving window averaging‐based filtering followed by Lloyd max quantization to improve the BDR performance, degraded due to the presence of correlated colored noise components. The simulation results show that the proposed preprocessing technique has a considerable improvement in the BDR performance, and the keys generated have sufficient randomness, which is verified by NIST test.
- Open Access
- 2 April 2019
- Published by Elsevier in SSRN Electronic Journal
Principal Component Analysis as a Dimensionality Reduction and Data Preprocessing Technique
Nowadays, dealing with high dimension data has become common in many fields such as network security, image processing, medical diagnosis, biometric systems, e-commerce, etc. In data base with higher dimension the direct use of data is costlier in terms of its storage, processing, mathematical computations etc. Moreover, in many applications with wireless networks, Received Signal Strength (RSS) needs to be processed to remove the redundant readings. In this paper, we discussed Principal Component Analysis (PCA) as a dimensionality reduction technique. PCA can be done either by calculating the covariance matrix or by Singular Value Decomposition (SVD). We used covariance matrix calculation due to its less complexity. Simulation results verify that the correlated input data sequence is sorted to uncorrelated principal components (PC’s) with decreasing variation and some of first PC’s can represent nearly all data sets.
- 2 April 2019
- Published by Elsevier in SSRN Electronic Journal
Open AccessPrincipal Component Analysis as a Dimensionality Reduction and Data Preprocessing Technique
Nowadays, dealing with high dimension data has become common in many fields such as network security, image processing, medical diagnosis, biometric systems, e-commerce, etc. In data base with higher dimension the direct use of data is costlier in terms of its storage, processing, mathematical computations etc. Moreover, in many applications with wireless networks, Received Signal Strength (RSS) needs to be processed to remove the redundant readings. In this paper, we discussed Principal Component Analysis (PCA) as a dimensionality reduction technique. PCA can be done either by calculating the covariance matrix or by Singular Value Decomposition (SVD). We used covariance matrix calculation due to its less complexity. Simulation results verify that the correlated input data sequence is sorted to uncorrelated principal components (PC’s) with decreasing variation and some of first PC’s can represent nearly all data sets.
- 1 April 2019
- Published by Elsevier in Physical Communication
- Vol. 33, 249-258
Wireless physical layer key generation with improved bit disagreement for the internet of things using moving window averaging
- 1 April 2019
- Published by Elsevier in Physical Communication
- Vol. 33, 249-258
Wireless physical layer key generation with improved bit disagreement for the internet of things using moving window averaging
- 4 May 2017
- Published by Springer Nature
- p. 115-123
Internet of Things and Wireless Physical Layer Security: A Survey
- 4 May 2017
- Published by Springer Nature
- p. 115-123
Internet of Things and Wireless Physical Layer Security: A Survey
- 11 September 2012
- Published by Springer Nature
- p. 275-282
Experimental Validation and Performance Comparison of Multi-Loop MPPT Controlled PV Systems on Low to High End Controllers
- 11 September 2012
- Published by Springer Nature
- p. 275-282
Experimental Validation and Performance Comparison of Multi-Loop MPPT Controlled PV Systems on Low to High End Controllers