Eduardo Paniguel Oliveira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Eduardo Paniguel Oliveira has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Rafael Brito de Moura
Poços de Caldas, Federal University of Alfenas, Poços de Caldas, Brazil
2 shared publications Caio Pompeu Cavalieri
Institute for Technological Research (IPT), Avenida Prof. Almeida Prado, nº 532, Cidade Universitária, 05508-901, São Paulo, SP, Brazil
1 shared publication- Camila Ferreira Alves1 shared publication
- Carla Beatriz Casagrande Bortoluci1 shared publication
- Dagoberto Yukio Okada
Universidade Estadual de Campinas (UNICAMP)
1 shared publication - Leonardo Henrique Soares Damasceno
Centro de Estudos e Aplicação de Materiais Para Remediação Ambiental (CEMARA), Instituto de Ciência e Tecnologia (ICT), Campus Avançado de Poços de Caldas, Universidade Federal de Alfenas (UNIFAL-MG), Poços de Caldas, Brazil
1 shared publication
Latest Publications
- 4 March 2021
- Published by Taylor & Francis in Environmental Technology
- Vol. 43 (16) , 2540-2552
Optimization of airflow and aeration cycles in a new structured bed reactor configuration for carbon and nitrogen removal
The Structured Bed Reactor with Recirculation and Intermittent Aeration (SBRRIA) is a reactor configuration that presents high efficiency of organic matter and nitrogen removal, besides low sludge production. However, operational parameters, as the recirculation rate, aeration time, and airflow, are not fully established. A bench-scale structured bed reactor with intermittent aeration was fed with synthetic effluent simulating the characteristics of sanitary sewage. The reactor was operated for 280 days with an operational hydraulic retention time (HRT) of 10 h. The reactor was operated without effluent recirculation for the first time since this approach was not yet reported, and was named Structured Bed Reactor with Intermittent Aeration (SBRIA). The COD removal was higher than 81% for all operational conditions, and the total nitrogen removal ranged from 10 to 80%. The highest efficiencies were obtained with an aeration time of 1 h 45 min (total cycle of 3 h) and an airflow rate of 4.5 L.min−1. Different nitrification and denitrification behaviours were observed, resulting in nitrification efficiencies over 90% when the reactor was submitted to higher aeration times and denitrification efficiencies above 90% when the reactor was submitted to low aeration times. The airflow ranges tested in this study affected the nitrification and the total nitrogen efficiencies. Even without effluent recirculation, the temporal profile showed that there were no peaks in the concentration of the nitrogen forms in the reactor effluent, saving electrical energy up to 75% due to pumping. GRAPHICAL ABSTRACT
- 4 March 2021
- Published by Taylor & Francis in Environmental Technology
- Vol. 43 (16) , 2540-2552
Optimization of airflow and aeration cycles in a new structured bed reactor configuration for carbon and nitrogen removal
The Structured Bed Reactor with Recirculation and Intermittent Aeration (SBRRIA) is a reactor configuration that presents high efficiency of organic matter and nitrogen removal, besides low sludge production. However, operational parameters, as the recirculation rate, aeration time, and airflow, are not fully established. A bench-scale structured bed reactor with intermittent aeration was fed with synthetic effluent simulating the characteristics of sanitary sewage. The reactor was operated for 280 days with an operational hydraulic retention time (HRT) of 10 h. The reactor was operated without effluent recirculation for the first time since this approach was not yet reported, and was named Structured Bed Reactor with Intermittent Aeration (SBRIA). The COD removal was higher than 81% for all operational conditions, and the total nitrogen removal ranged from 10 to 80%. The highest efficiencies were obtained with an aeration time of 1 h 45 min (total cycle of 3 h) and an airflow rate of 4.5 L.min−1. Different nitrification and denitrification behaviours were observed, resulting in nitrification efficiencies over 90% when the reactor was submitted to higher aeration times and denitrification efficiencies above 90% when the reactor was submitted to low aeration times. The airflow ranges tested in this study affected the nitrification and the total nitrogen efficiencies. Even without effluent recirculation, the temporal profile showed that there were no peaks in the concentration of the nitrogen forms in the reactor effluent, saving electrical energy up to 75% due to pumping. GRAPHICAL ABSTRACT
- 1 December 2020
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 48 (6) , 983-988
Evaluation of silt curtain in the reduction of suspended solids
- 1 December 2020
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 48 (6) , 983-988
Evaluation of silt curtain in the reduction of suspended solids
- Open Access
- 23 May 2018
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 9 (3) , 174-187
Remoção biológica de nitrogênio em águas residuárias: uma revisão dos processos convencionais aos processos modernos
O lançamento de efluentes em corpos receptores ou em redes de esgoto deve ser monitorado e atender a legislação vigente. As máximas concentrações permitidas para o lançamento de nutrientes, especialmente o nitrogênio, se tornaram mais restritivas após 2005. O nitrogênio é um nutriente que está presente em diferentes tipos de águas residuárias, como chorume, efluentes industriais e esgotamento sanitário. O descarte deste tipo de efluente sem redução da carga de nitrogênio resulta em impactos sobre a fauna e flora de ecossistemas em geral. A remoção de nitrogênio está baseada na conversão de amônia a nitrito e nitrato (nitrificação) e posterior redução destes à nitrogênio gasoso (desnitrificação). Diversos métodos biológicos foram e têm sido desenvolvidos para remover nitrogênio de efluentes baseados em configurações complexas de reatores em série ou em sistemas unicompartimentados. Recentemente, novas rotas metabólicas envolvendo processos mais eficientes e econômicos têm sido apresentadas. Este trabalho apresenta uma revisão da literatura para os processos de nitrificação e desnitrificação convencional, nitrificação e desnitrificação simultânea, Sharon (Single Reactor System for High Activity Ammonia Removal Over Nitrite), Anammox (Anaerobic Ammonium Oxidation) e Canon (Completely Autotrophic Nitrogen Removal Over Nitrite). As principais características de cada processo foram abordadas, destacando-se as principais reações envolvidas, crescimento biológico, inibidores, requisitos e aplicações.
- 23 May 2018
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 9 (3) , 174-187
Open AccessRemoção biológica de nitrogênio em águas residuárias: uma revisão dos processos convencionais aos processos modernos
O lançamento de efluentes em corpos receptores ou em redes de esgoto deve ser monitorado e atender a legislação vigente. As máximas concentrações permitidas para o lançamento de nutrientes, especialmente o nitrogênio, se tornaram mais restritivas após 2005. O nitrogênio é um nutriente que está presente em diferentes tipos de águas residuárias, como chorume, efluentes industriais e esgotamento sanitário. O descarte deste tipo de efluente sem redução da carga de nitrogênio resulta em impactos sobre a fauna e flora de ecossistemas em geral. A remoção de nitrogênio está baseada na conversão de amônia a nitrito e nitrato (nitrificação) e posterior redução destes à nitrogênio gasoso (desnitrificação). Diversos métodos biológicos foram e têm sido desenvolvidos para remover nitrogênio de efluentes baseados em configurações complexas de reatores em série ou em sistemas unicompartimentados. Recentemente, novas rotas metabólicas envolvendo processos mais eficientes e econômicos têm sido apresentadas. Este trabalho apresenta uma revisão da literatura para os processos de nitrificação e desnitrificação convencional, nitrificação e desnitrificação simultânea, Sharon (Single Reactor System for High Activity Ammonia Removal Over Nitrite), Anammox (Anaerobic Ammonium Oxidation) e Canon (Completely Autotrophic Nitrogen Removal Over Nitrite). As principais características de cada processo foram abordadas, destacando-se as principais reações envolvidas, crescimento biológico, inibidores, requisitos e aplicações.