Michele Giunta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Michele Giunta has a total of 192 co-authors. Here are the top co-authors by number of shared publications:
Ronald Holzwarth
Menlo Systems GmbH
24 shared publicationsMarc Fischer
14 shared publicationsMatthias Lezius
Menlo Systems GmbH, Am Klopferspitz 19a, 82152 Martinsried, Germany
12 shared publicationsR. Holzwarth
Max-Planck-Institut für Quantenoptik
9 shared publications- Xiaopeng Xie
State Key Laboratory of Photonics and Communications, School of Electronics, Peking University, Beijing, China
9 shared publications M. Lezius
Menlo Systems GmbH, Martinsried, Germany
8 shared publications
Latest Publications
- Open Access
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 348-355
Cross-Spectrum Phase Noise Measurements of Ultrastable Photonic Microwave Oscillators
Presently, continuous-wave (CW) lasers stabilized by high- $Q$ Fabry–Pérot optical cavities represent the most stable human-engineered frequency oscillators. For optical signals at 194.4 THz (1.5- $\mu $ m wavelength), cutting-edge systems exhibit fractional frequency instabilities as low as $3 \times 10^{-17}$ over a 1-s averaging time. The lowermost phase noise on microwave (MW) signals can be obtained via phase-coherent optical frequency division (OFD) of this class of optical reference signals. Characterizing this level of phase stability with conventional instrumentation is extremely challenging. Digital electronics-based cross correlation techniques allow the inference of MW signals’ phase noise and amplitude noise via downconversion with independent pairs of internal References, generating two independent measurement channels to be cross-correlated. We present in this article the synthesis of ultrastable MW signals via phase-coherent OFD and their characterization by using a commercial cross correlation-based phase noise analyzer and two auxiliary commercial photonic MW oscillators. These X-band frequency sources exhibit a fractional frequency stability of $\lt\!4\times 10^{-15}$ at 1 s, with phase noise as low as $\lt\!-90$ dBc/Hz at 1 Hz and $\lt\!-150$ dBc/Hz at 1 kHz offset from a 10-GHz carrier. Conventional instruments typically do not permit the reveal of this level of fidelity. We show the use of a digital system and two auxiliary independent and free-running ultrastable sources at >1-MHz offset from the DUT to enable cross correlation measurements within minutes for this level of spectral purity and frequency stability.
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 348-355
Open AccessCross-Spectrum Phase Noise Measurements of Ultrastable Photonic Microwave Oscillators
Presently, continuous-wave (CW) lasers stabilized by high- $Q$ Fabry–Pérot optical cavities represent the most stable human-engineered frequency oscillators. For optical signals at 194.4 THz (1.5- $\mu $ m wavelength), cutting-edge systems exhibit fractional frequency instabilities as low as $3 \times 10^{-17}$ over a 1-s averaging time. The lowermost phase noise on microwave (MW) signals can be obtained via phase-coherent optical frequency division (OFD) of this class of optical reference signals. Characterizing this level of phase stability with conventional instrumentation is extremely challenging. Digital electronics-based cross correlation techniques allow the inference of MW signals’ phase noise and amplitude noise via downconversion with independent pairs of internal References, generating two independent measurement channels to be cross-correlated. We present in this article the synthesis of ultrastable MW signals via phase-coherent OFD and their characterization by using a commercial cross correlation-based phase noise analyzer and two auxiliary commercial photonic MW oscillators. These X-band frequency sources exhibit a fractional frequency stability of $\lt\!4\times 10^{-15}$ at 1 s, with phase noise as low as $\lt\!-90$ dBc/Hz at 1 Hz and $\lt\!-150$ dBc/Hz at 1 kHz offset from a 10-GHz carrier. Conventional instruments typically do not permit the reveal of this level of fidelity. We show the use of a digital system and two auxiliary independent and free-running ultrastable sources at >1-MHz offset from the DUT to enable cross correlation measurements within minutes for this level of spectral purity and frequency stability.
- Top Cited Papers
- 14 January 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (2) , 646-649
Deployment of a transportable Yb optical lattice clock
We report on the first deployment of a ytterbium (Yb) transportable optical lattice clock (TOLC), commercially shipping the clock 3000 km from Boulder, Colorado, to Washington DC. The system, composed of a rigidly mounted optical reference cavity, an atomic physics package, and an optical frequency comb, fully realizes an independent frequency standard for comparisons in the optical and microwave domains. The shipped Yb TOLC was fully operational within 2 days of arrival, enabling frequency comparison with a rubidium (Rb) fountain at the United States Naval Observatory (USNO). To the best of our knowledge, this represents the first deployment of a fully independent TOLC, including the frequency comb, coherently uniting the optical stability of the Yb TOLC to the microwave output of the Rb fountain.
- 14 January 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (2) , 646-649
Top Cited PapersDeployment of a transportable Yb optical lattice clock
We report on the first deployment of a ytterbium (Yb) transportable optical lattice clock (TOLC), commercially shipping the clock 3000 km from Boulder, Colorado, to Washington DC. The system, composed of a rigidly mounted optical reference cavity, an atomic physics package, and an optical frequency comb, fully realizes an independent frequency standard for comparisons in the optical and microwave domains. The shipped Yb TOLC was fully operational within 2 days of arrival, enabling frequency comparison with a rubidium (Rb) fountain at the United States Naval Observatory (USNO). To the best of our knowledge, this represents the first deployment of a fully independent TOLC, including the frequency comb, coherently uniting the optical stability of the Yb TOLC to the microwave output of the Rb fountain.
- Top Cited PapersOpen Access
- 3 June 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 21 (6) , L061001
Long-distance chronometric leveling with a portable optical clock
We have measured the geopotential difference between two locations separated by 457 km by comparison of two optical lattice clocks via an interferometric fiber link, utilizing the gravitational redshift of the clock transition frequency. The clocks have been compared side-by-side before and after one of the clocks was moved to the remote location. The chronometrically measured geopotential difference of agrees with an independent geodetic determination of . The uncertainty of the chronometric geopotential difference is equivalent to an uncertainty of in height.- 3 June 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 21 (6) , L061001
Top Cited PapersOpen AccessLong-distance chronometric leveling with a portable optical clock
We have measured the geopotential difference between two locations separated by 457 km by comparison of two optical lattice clocks via an interferometric fiber link, utilizing the gravitational redshift of the clock transition frequency. The clocks have been compared side-by-side before and after one of the clocks was moved to the remote location. The chronometrically measured geopotential difference of agrees with an independent geodetic determination of . The uncertainty of the chronometric geopotential difference is equivalent to an uncertainty of in height. - 1 January 2024
- Published by Optica Publishing Group
- p. SF3N.6
Optical-to-microwave phase coherent link at 19th digit accuracy
We present a transportable clockwork system capable of porting the optical spectral purity down to the microwave domain at the level of a few parts in 10−19.
- 1 January 2024
- Published by Optica Publishing Group
- p. SF3N.6
Optical-to-microwave phase coherent link at 19th digit accuracy
We present a transportable clockwork system capable of porting the optical spectral purity down to the microwave domain at the level of a few parts in 10−19.
- 1 January 2024
- Published by Optica Publishing Group
- p. SM2G.5
>1.5 Octave-broad Optical Frequency Comb for Multi-clock Comparisons and Wide-band Spectral Purity Transfer
We present a system composed of an Er:laser-based ultra-low-noise frequency comb seeding a custom-designed photonic-crystal fiber with 2nJ pulse energies. A super-continuum is obtained spanning from 650nm to 2µm. System qualifications will be presented.
- 1 January 2024
- Published by Optica Publishing Group
- p. SM2G.5
>1.5 Octave-broad Optical Frequency Comb for Multi-clock Comparisons and Wide-band Spectral Purity Transfer
We present a system composed of an Er:laser-based ultra-low-noise frequency comb seeding a custom-designed photonic-crystal fiber with 2nJ pulse energies. A super-continuum is obtained spanning from 650nm to 2µm. System qualifications will be presented.
- 1 January 2022
- Published by Optica Publishing Group
- p. STu5O.7
Rack-Mounted Ultrastable Laser System for Sr Lattice Clock Operation
We present a rack-mounted ultra-low-noise laser system for Sr lattice clocks, with spectral purity transfer stability of 4×10−18@1s and 2×10−19@100s. We realize a system stability of 5×10-16@1s, representing state-of-the-art performance for rack-mounted commercial systems.
- 1 January 2022
- Published by Optica Publishing Group
- p. STu5O.7
Rack-Mounted Ultrastable Laser System for Sr Lattice Clock Operation
We present a rack-mounted ultra-low-noise laser system for Sr lattice clocks, with spectral purity transfer stability of 4×10−18@1s and 2×10−19@100s. We realize a system stability of 5×10-16@1s, representing state-of-the-art performance for rack-mounted commercial systems.
- 1 January 2021
- Published by Optica Publishing Group
- p. STh2Q.5
Ultra-stable Laser System for Next-generation Light-pulse Atom Interferometry MAGIS-100
We present a fully phase-locked comb-disciplined-laser system, conceived to operate the Matter-wave Atomic Gradiometer Interferometric Sensor (MAGIS-100). Via phase-locking to the comb, four ECDLs and a Ti:Sapphire laser inherit the stability of an ultra-stable laser.
- 1 January 2021
- Published by Optica Publishing Group
- p. STh2Q.5
Ultra-stable Laser System for Next-generation Light-pulse Atom Interferometry MAGIS-100
We present a fully phase-locked comb-disciplined-laser system, conceived to operate the Matter-wave Atomic Gradiometer Interferometric Sensor (MAGIS-100). Via phase-locking to the comb, four ECDLs and a Ti:Sapphire laser inherit the stability of an ultra-stable laser.
- 19 February 2020
- Published by Optica Publishing Group in Optics Letters
- Vol. 45 (5) , 1140-1143
Compact and ultrastable photonic microwave oscillator
Frequency comb synthesized microwaves have been so far realized with tabletop systems, operated in well-controlled environments. Here, we demonstrate state-of-the-art ultrastable microwave synthesis with a compact rack-mountable apparatus. We present absolute phase noise characterization of a 12 GHz signal using an ultrastable laser at ∼ 194 T H z and an Er:fiber comb divider, obtaining − 83 d B c / H z at 1 Hz and < − 166 d B c / H z for offsets greater than 5 kHz. Employing semiconductor coating mirrors for the same type of transportable optical frequency reference, we show that − 105 d B c / H z at 1 Hz is supported by demonstrating a residual noise limit of division and detection process of − 115 d B c / H z at 1 Hz. This level of fidelity paves the way for the deployment of ultrastable photonic microwave oscillators and for operating transportable optical clocks.
- 19 February 2020
- Published by Optica Publishing Group in Optics Letters
- Vol. 45 (5) , 1140-1143
Compact and ultrastable photonic microwave oscillator
Frequency comb synthesized microwaves have been so far realized with tabletop systems, operated in well-controlled environments. Here, we demonstrate state-of-the-art ultrastable microwave synthesis with a compact rack-mountable apparatus. We present absolute phase noise characterization of a 12 GHz signal using an ultrastable laser at ∼ 194 T H z and an Er:fiber comb divider, obtaining − 83 d B c / H z at 1 Hz and < − 166 d B c / H z for offsets greater than 5 kHz. Employing semiconductor coating mirrors for the same type of transportable optical frequency reference, we show that − 105 d B c / H z at 1 Hz is supported by demonstrating a residual noise limit of division and detection process of − 115 d B c / H z at 1 Hz. This level of fidelity paves the way for the deployment of ultrastable photonic microwave oscillators and for operating transportable optical clocks.
- 1 January 2020
- Published by Optica Publishing Group
- p. FTh5B.1
Complete Laser System for Strontium Lattice Clock Based on Frequency Comb
We report the development of a complete turn-key 5 × 10-16 ultra-stable laser system for operating neutral strontium atoms for optical lattice clocks or for quantum computing.
- 1 January 2020
- Published by Optica Publishing Group
- p. FTh5B.1
Complete Laser System for Strontium Lattice Clock Based on Frequency Comb
We report the development of a complete turn-key 5 × 10-16 ultra-stable laser system for operating neutral strontium atoms for optical lattice clocks or for quantum computing.