Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Barry K. Lavine has a total of 94 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Artificial Neural Networks for Discrimination of Automotive Clear Coats by Vehicle Manufacturer

    by Barry K. Lavine, Collin G. White, Douglas R. Heisterkamp

    Modern automotive paints have a thin undercoat and color coat layer protected by a thick clear coat layer. All too often, only the clear coat layer of the automotive paint is recovered at the crime scene of a vehicle-related fatality. Searches for motor vehicle paint databases of clear coats using commercial software typically generate large hitlists that are difficult for a forensic paint examiner to work through unless additional information is provided for the search. To address this problem, deep learning has been applied to the infrared spectra of automotive clear coats to identify patterns in their spectra indicative of the motor vehicle manufacturer. An in-house automotive paint library of 2796 clear coat infrared spectra from six automotive manufacturers and 100 assembly plants was partitioned into training, validation, and prediction sets. Each spectrum has 1880 measurements over the spectral range of 4000 cm−1 to 376 cm−1. Several multilayer perceptron neural network models, each with three hidden layers, were developed that achieved high classification success rates for the training, validation, and prediction sets. The addition of convolutional layers to the deep learning neural network models did not improve the performance of these models.

  • Open Access

    Determination of Acidity of Edible Oils for Renewable Fuels Using Experimental and Digitally Blended Mid-Infrared Spectra

    by Collin G. White, Ayuba Fasasi, Chanda Swalley, Barry K. Lavine

    Renewable fuels produced from animal- and plant-based edible oils have emerged as an alternative to oil and natural gas. Burgeoning interest in renewables can be attributed to the rapid depletion of fossil fuels caused by the global energy demand and the environmental advantages of renewables, specifically reduced emissions of greenhouse gases. An important property of the feedstock that is crucial for the conversion of edible oils to renewable fuels is the total acid number (TAN), as even a small increase in TAN for the feedstock can lead to corrosion of the catalyst in the refining process. Currently, the TAN is determined by potentiometric titration, which is time-consuming, expensive, and requires the preparation of reagents. As part of an effort to promote the use of renewable fuels, a partial least squares regression method with orthogonal signal correction to remove spectral information related to the sample background was developed to determine the TAN from the mid-infrared (IR) spectra of the feedstock. Digitally blended mid-IR spectral data were generated to fill in regions of the PLS calibration where there were very few samples. By combining experimental and digitally blended mid-IR spectral data to ensure adequate sample representation in all regions of the spectra–property calibration and better understand the spectra–property relationship through the identification of sample outliers in the original data that can be difficult to detect because of swamping, a PLS regression model for TAN (R2 = 0.992, cross-validated root mean square error = 0.468, and bias = 0.0036) has been developed from 118 experimental and digitally blended mid-IR spectra of commercial feedstock. Thus, feedstock whose TAN value is too high for refining can be flagged using the proposed mid-IR method, which is faster and easier to use than the current titrimetric method.

  • Open Access

    Classification and Peroxide Value Prediction of Naturally Aged Edible Oils Using Raman and Infrared Spectral Analysis

    by William E. Gilbraith, J. Chance Carter, Kristl Adams, Isio Sota-Uba, Barry K. Lavine, Karl S. Booksh, Joshua M. Ottaway

    Developing global classification and calibration models for identifying edible oil type and predicting peroxide value, a measure of the degree of oxidation directly related to oil freshness is predicated on capturing variance differences within and between growing seasons across a large set of 19 naturally aged (5–7 years) oil types. Our approach utilizes a larger sample set and longer aging period than reported studies (typically 2–5 years), includes multiple growing seasons, and is based on natural rather than accelerated thermal aging of oil samples. We provide spectroscopic data (Raman scattering, near- and mid-infrared absorption) for 19 edible oil types, which represent the most diverse and only naturally aged sample set reported to date. The data, which consist of three data collection campaigns acquired using different analytical methods at different times during the aging process, provide opportunities to investigate and validate new machine learning approaches for classification, calibration, and data fusion. In the supplemental material, vibrational spectroscopy data from all samples are included along with the R programming language code for preprocessing data and building basic classification and calibration models.


  • Open Access

    Thermodynamic and Kinetic Characterization of Colloidal Polymers of N-Isopropylacrylamide and Alkyl Acrylic Acids for Optical pH Sensing

    by James T. Moulton, David Bruce, Richard A. Bunce, Mariya Kim, Leah Oxenford Snyder, W. Rudolf Seitz, Barry K. Lavine

    Copolymers of N-isopropylacrylamide (NIPA) and alkyl acrylic acids that swell and shrink in response to pH were prepared by dispersion polymerization at 35 °C using N-isopropylacrylamide (transduction monomer), methylenebisacrylamide (crosslinker), 2-dimethoxy-2-phenyl-acetophenone (initiator), N-tert-butylacrylamide (transition temperature modifier), and acrylic acid, methacrylic acid, ethacrylic acid, and propacrylic acid (functional comonomer). The diameter of the microspheres of the copolymer varied between 0.5 µm and 1.0 µm. These microspheres were cast into hydrogel membranes prepared by mixing the pH-sensitive swellable polymer particles with aqueous polyvinyl alcohol solutions followed by crosslinking the polyvinyl alcohol with glutaric dialdehyde for use as pH sensors. Large changes in the turbidity of the polyvinyl alcohol membrane monitored using a Cary 6000 UV–visible absorbance spectrometer were observed as the pH of the buffer solution in contact with the membrane was varied. Polymer swelling was reversible for many of these NIPA-based copolymers. The buffer capacity, ionic strength, pH, and temperature of the buffer solution in contact with the membrane were systematically varied to provide an in-depth pH profile of each copolymer. A unique aspect of this study was the investigation of the response of the NIPA-based polymers to changes in the pH of the solution in contact with the membrane at low buffer concentrations (0.5 mM). The response rate and the reversibility of polymer swelling even at low buffer capacity suggest that NIPA-based copolymers can be coupled to an optical fiber for pH sensing in the environment. We envision using these polymers to monitor rising acidity levels in the ocean due to water that has become enriched in carbon dioxide that endangers shell-building organisms by reducing the amount of carbonate available to them.


  • Alternating and Modified Alternating Least Squares Applied to Raman Spectra of Finished Gasolines

    by Collin G. White, Thomas M. Hancewicz, Ayuba Fasasi, Junior Wright, Barry K. Lavine

    Extraction of components from individual refinery streams (e.g., reformates and alkylates) in finished gasoline was undertaken using Raman spectroscopy to characterize the chemical content of the finished product. Modified alternating least squares (MALS) was used for separating Raman spectroscopic data sets of the finished product into its pure individual components. The advantages of MALS over alternating least squares (ALS) for multicomponent resolution are highlighted in this study using three Raman spectroscopic data sets which provide a suitable benchmark for comparing the performance of these two methods. MALS is superior to ALS in terms of accuracy and can better resolve components than ALS, and it is also more robust toward collinear data. Finally, components near the noise level usually cannot be extracted by ALS because of instability when inverting the covariance structure which inflates the noise present in the data. However, these same components can be extracted by MALS due to the stabilization of the least squares regression with respect to the matrix inversion using modified techniques from ridge regression.

  • Open Access

    Transductive and Transfer Learning

    by Barry K. Lavine, Karl S. Booksh, Sharon L. Neal

    For most of the twentieth century, chemistry has been a data-poor discipline relying on well-thought-out hypotheses and carefully planned experiments to develop solutions to real-world problems

  • Supervised discretization for decluttering classification models

    by James A. Jordan, Caelin P. Celani, Michael Ketterer, Barry K. Lavine, K. S. Booksh

    Supervised discretization ‘declutters’ chemical sensor data to sharpen the observed differences between classes and improve multivariate classification models.


  • Raman Spectroscopy to Enhance Investigative Lead Information in Automotive Clearcoats

    by George P. Affadu-Danful, Haoran Zhong, Kaushalya Sharma Dahal, Kaan Kalkan, Linqi Zhang, Barry K. Lavine

    A new method to determine the make and model of a vehicle from an automotive paint sample recovered at the crime scene of a vehicle-related fatality such as a hit-and-run using Raman microscopy has been developed. Raman spectra were collected from 118 automotive paint samples from six General Motors (GM) vehicle assembly plants to investigate the discrimination power of Raman spectroscopy for automotive clearcoats using a genetic algorithm for pattern recognition that incorporates model inference and sample error in the variable selection process. Each vehicle assembly plant pertained to a specific vehicle model. The spectral region between 1802 and 697 cm –1 was found to be supportive of the discrimination of these six GM assembly plants. By comparison, only one of the six automotive assembly plants could be differentiated from the other five assembly plants using Fourier transform infrared spectroscopy (FT-IR), which is the most widely used analytical method for the examination of automotive paint) and the genetic algorithm for pattern recognition. The results of this study indicate that Raman spectroscopy in combination with pattern recognition methods offers distinct advantages over FT-IR for the identification and discrimination of automotive clearcoats.


  • Application of ultramicrotomy and infrared imaging to the forensic examination of automotive paint

    by Haoran Zhong, Elizabeth Donkor, Lisa Whitworth, Collin G. White, Kaushalya Sharma Dahal, Ayuba Fasasi, Thomas M. Hancewicz, Franklin Uba, Barry K. Lavine

    In several previously published studies, Lavine and coworkers have demonstrated that infrared (IR) spectra from all layers of an intact multilayered automotive paint chip can be collected in a single analysis by scanning across each layer of a cross sectioned paint chip using a Fourier transform IR imaging microscope. Applying alternating least squares to the spectral data, the IR spectrum of each layer of an original equipment manufacturer paint chip can be extracted from a line map of the spectral image. To further develop this imaging technique for automotive paint analysis, the capability to cross section “small” paint chips (1 mm or less) using an ultramicrotome has been incorporated into our current imaging methodology. An ultramicrotome does not require epoxy or other embedding media for the paint chip and will simplify the analysis. However, extracting the IR spectra for each layer of an original equipment manufacturer paint chip by alternating least squares can be problematic for thin peels (less than one micron thickness), necessitating the use of target testing factor analysis to determine whether a specific layer is present in the line map and modified alternating least squares to recover the IR spectrum of the layer. Using a new sample preparation technique and the appropriate multivariate curve resolution methods, high quality IR spectra of the layers of a modern automotive paint system can be obtained from paint fragments that are smaller than what is practical to analyze by conventional Fourier transform IR spectroscopy.


  • Authentication of edible oils using an infrared spectral library and digital sample sets: A feasibility study

    by Isio Sota‐Uba, Collin G. White, Karl Booksh, Barry K. Lavine

    A potential method to determine whether two varieties of edible oils can be differentiated by Fourier transform infrared (FTIR) spectroscopy is proposed using digitally generated data of adulterated edible oils from an infrared (IR) spectral library. The first step is the evaluation of digitally blended data sets. Specifically, IR spectra of adulterated edible oils are computed from digitally blending experimental data of the IR spectra of an edible oil and the corresponding adulterant using the appropriate mixing coefficients to achieve the desired level of adulteration. To determine whether two edible oils can be differentiated by FTIR spectroscopy, pure IR spectra of the two edible oils are compared with IR spectra of two edible oils digitally mixed using a genetic algorithm for pattern recognition to solve a ternary classification problem. If the IR spectra of the two edible oils and their binary mixtures are differentiable from principal component plots of the spectral data, then differences between the IR spectra of these two edible oils are of sufficient magnitude to ensure that a reliable classification by FTIR spectroscopy can be obtained. Using this approach, the feasibility of authenticating edible oils such as extra virgin olive oil (EVOO) directly from library spectra is demonstrated. For this study, both digital and experimental data are combined to generate training and validation data sets to assess detection limits in FTIR spectroscopy for the adulterants.