Ming Ye
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ming Ye has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Jiaqiang Yang
Zhejiang University
2 shared publications - Hui Li
Dalian University of Technology
1 shared publication - Jiahao Chen
School of Information Science and Technology, ShanghaiTech University, Shanghai, China
1 shared publication - Jian Zhang
Zhejiang University
1 shared publication Jin Huang
Department of Electrical Engineering, Zhejiang University, Hangzhou 310027, China
1 shared publicationMin Kang
School of Automation and Electrical Engineering, Zhejiang University of Science and Technology, Hangzhou, China
1 shared publication
Latest Publications
- 9 October 2023
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 35 (1) , 015112
Bearing fault diagnosis under non-stationary conditions based on a speed signal resonance component demodulation algorithm
This paper proposes a novel bearing fault diagnosis indicator, the resonance component, for motor speed signals. The speed signal was modulated into a higher-frequency band using a double-inertia system, and the bearing fault information was carried and reserved in this high-frequency resonance component. Variational mode decomposition was then used to separate the components unrelated to the resonance based on the parameters optimized using the artificial bee colony algorithm. After envelope demodulation and angular resampling, the multipoint optimal minimum entropy deconvolution adjusted algorithm was utilized to enhance the amplitude of the order spectrum at the corresponding faulty order. Additionally, experiments were successfully conducted on both the outer and inner raceway bearing faults under time-varying conditions using the proposed method. The results indicate that the ordinary diagnosis method using the basic bearing fault characteristic frequency as an indicator is less effective.
- 9 October 2023
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 35 (1) , 015112
Bearing fault diagnosis under non-stationary conditions based on a speed signal resonance component demodulation algorithm
This paper proposes a novel bearing fault diagnosis indicator, the resonance component, for motor speed signals. The speed signal was modulated into a higher-frequency band using a double-inertia system, and the bearing fault information was carried and reserved in this high-frequency resonance component. Variational mode decomposition was then used to separate the components unrelated to the resonance based on the parameters optimized using the artificial bee colony algorithm. After envelope demodulation and angular resampling, the multipoint optimal minimum entropy deconvolution adjusted algorithm was utilized to enhance the amplitude of the order spectrum at the corresponding faulty order. Additionally, experiments were successfully conducted on both the outer and inner raceway bearing faults under time-varying conditions using the proposed method. The results indicate that the ordinary diagnosis method using the basic bearing fault characteristic frequency as an indicator is less effective.
- Open Access
Bearing Fault Diagnosis under Time-Varying Speed and Load Conditions via Observer-Based Load Torque Analysis
Bearing fault is the most common failure in rotating machines, and bearing fault diagnosis (BFD) has been investigated using vibration, current, or acoustic signals. However, there are still challenges in some existing approaches. This study proposes a novel BFD method based on natural observer. Based on the analysis of the effects on the load torque signal caused by bearing faults in the permanent magnetic synchronous machine (PMSM), a modified natural observer was designed to reconstruct the load torque signal from electrical signals, acquiring a novel indicator without the additional sensor installed. Angular resampling was implemented to convert the non-stationary load torque signal into a stationary one to reduce the computational complexity. For full-auto diagnosis without human involvement, a threshold determination algorithm was also modified. Experimental validations were carried out under speed-varying and torque-varying conditions and were compared with phase current and q-axis current signals. The average signal-to-noise ratio (SNR) of the estimated load torque is about 8.65 times compared with the SNR of the traditional q-axis current. The effectiveness of the proposed method prior to the traditional PMSM bearing fault indicators is demonstrated by the order spectrum results.
Open AccessBearing Fault Diagnosis under Time-Varying Speed and Load Conditions via Observer-Based Load Torque Analysis
Bearing fault is the most common failure in rotating machines, and bearing fault diagnosis (BFD) has been investigated using vibration, current, or acoustic signals. However, there are still challenges in some existing approaches. This study proposes a novel BFD method based on natural observer. Based on the analysis of the effects on the load torque signal caused by bearing faults in the permanent magnetic synchronous machine (PMSM), a modified natural observer was designed to reconstruct the load torque signal from electrical signals, acquiring a novel indicator without the additional sensor installed. Angular resampling was implemented to convert the non-stationary load torque signal into a stationary one to reduce the computational complexity. For full-auto diagnosis without human involvement, a threshold determination algorithm was also modified. Experimental validations were carried out under speed-varying and torque-varying conditions and were compared with phase current and q-axis current signals. The average signal-to-noise ratio (SNR) of the estimated load torque is about 8.65 times compared with the SNR of the traditional q-axis current. The effectiveness of the proposed method prior to the traditional PMSM bearing fault indicators is demonstrated by the order spectrum results.
- 4 May 2019
- Published by Springer Nature
- p. 983-991
Multiuser MIMO Relay System Model and Performance Evaluation Under Hardware Impairment
- 4 May 2019
- Published by Springer Nature
- p. 983-991
Multiuser MIMO Relay System Model and Performance Evaluation Under Hardware Impairment
- 16 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 7 (3) , 1899-1913
An EMF Observer for PMSM Sensorless Drives Adaptive to Stator Resistance and Rotor Flux Linkage
The electromotive force (EMF) observer based sensorless algorithms are sensitive to temperature rise because it requires the stator resistance (Rs) or the rotor flux-linkage ( Ψr). The temperature measuring of an operating motor can be difficult, therefore adaptive sensorless algorithms with online Rs and Ψr estimation are appreciated. However, existing methods require extra signal injections, transient operations or estimate Rs and Ψr one at a time to overcome the rank-deficient problem. In this paper, an adaptive EMF observer which is able to estimate both Rs and Ψr simultaneously without requiring any signal injections or transient operations is proposed. The method exploits the harmonic back-EMFs (HBEMF) to serve as a novel reference model and regulates the Rs value in the EMF observer accordingly. The rank deficient problem is solved with the extra information provided by the HBEMFs. To make use of the HBEMFs, a parameter insensitive extraction method and an algorithm to calculate the rotor position from them are proposed. With the proposed reference model, an adaptive scheme to regulate Rs is proposed. To obtain the rotor flux-linkage, a Ψr estimator is also developed. The effectiveness of these proposed methods are all verified with experiments and simulations.
- 16 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 7 (3) , 1899-1913
An EMF Observer for PMSM Sensorless Drives Adaptive to Stator Resistance and Rotor Flux Linkage
The electromotive force (EMF) observer based sensorless algorithms are sensitive to temperature rise because it requires the stator resistance (Rs) or the rotor flux-linkage ( Ψr). The temperature measuring of an operating motor can be difficult, therefore adaptive sensorless algorithms with online Rs and Ψr estimation are appreciated. However, existing methods require extra signal injections, transient operations or estimate Rs and Ψr one at a time to overcome the rank-deficient problem. In this paper, an adaptive EMF observer which is able to estimate both Rs and Ψr simultaneously without requiring any signal injections or transient operations is proposed. The method exploits the harmonic back-EMFs (HBEMF) to serve as a novel reference model and regulates the Rs value in the EMF observer accordingly. The rank deficient problem is solved with the extra information provided by the HBEMFs. To make use of the HBEMFs, a parameter insensitive extraction method and an algorithm to calculate the rotor position from them are proposed. With the proposed reference model, an adaptive scheme to regulate Rs is proposed. To obtain the rotor flux-linkage, a Ψr estimator is also developed. The effectiveness of these proposed methods are all verified with experiments and simulations.