CRCamille Raillon

Camille Raillon

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Camille Raillon has a total of 63 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Characterization of a uranium-tolerant green microalga of the genus Coelastrella with high potential for the remediation of metal-polluted waters

    by Camille Beaulier, Marie Dannay, Fabienne Devime, Célia Baggio, Nabila El Sakkout, Camille Raillon, Olivier Courson, Jacques Bourguignon, Claude Alban, Stéphane Ravanel

    Uranium (U) pollution of terrestrial and aquatic ecosystems poses a significant threat to the environment and human health because this radionuclide is chemotoxic. Characterization of organisms that tolerate and accumulate U is critical to decipher the mechanisms evolved to cope with the radionuclide and to propose new effective strategies for bioremediation of U-contaminated environments. Here, we isolated a unicellular green microalga of the genus Coelastrella from U-contaminated wastewater. We showed that Coelastrella sp. PCV is much more tolerant to U than Chlamydomonas reinhardtii and Chlorella vulgaris . Coelastrella is able to accumulate U very rapidly, then gradually release it into the medium, behaving as an excluder to limit the toxic effects of U. The ability of Coelastrella to accumulate U is remarkably high, with up to 600 mg U sorbed per g dry biomass. Coelastrella is able to grow and maintain high photosynthesis in natural metal-contaminated waters from a wetland near a reclaimed U mine. Over a single one-week growth cycle, Coelastrella is able to capture 25-55% of U from contaminated waters and demonstrates lipid droplet accumulation. Coelastrella sp. PCV is a very promising microalga for the remediation of polluted waters with valorization of algal biomass that accumulates lipids. Graphical


  • Discrimination of α-Thrombin and γ-Thrombin Using Aptamer-Functionalized Nanopore Sensing

    by Lucile Reynaud, Aurélie Bouchet-Spinelli, Jean-Marc Janot, Arnaud Buhot, Sébastien Balme, Camille Raillon

    Protein detection and identification at the single-molecule level are major challenges in many biotechnological fields. Solid-state nanopores have raised attention as label-free biosensors with high sensitivity. Here, we use solid-state nanopore sensing to discriminate two closely related proteins, α-thrombin and γ-thrombin. We show that aptamer functionalization improves protein discrimination thanks to a significant difference in the relative current blockade amplitude. To enhance discrimination, we postprocessed the signals using machine learning and training algorithms and we were able to reach an accuracy of 98.8% using seven features and ensemble methods.


  • Open Access

    Sensing with Nanopores and Aptamers: A Way Forward

    by Lucile Reynaud, Aurélie Bouchet-Spinelli, Camille Raillon, Arnaud Buhot

    In the 90s, the development of a novel single molecule technique based on nanopore sensing emerged. Preliminary improvements were based on the molecular or biological engineering of protein nanopores along with the use of nanotechnologies developed in the context of microelectronics. Since the last decade, the convergence between those two worlds has allowed for biomimetic approaches. In this respect, the combination of nanopores with aptamers, single-stranded oligonucleotides specifically selected towards molecular or cellular targets from an in vitro method, gained a lot of interest with potential applications for the single molecule detection and recognition in various domains like health, environment or security. The recent developments performed by combining nanopores and aptamers are highlighted in this review and some perspectives are drawn.


  • Biosensing extracellular vesicles: contribution of biomolecules in affinity-based methods for detection and isolation

    by M. Gaillard, A. Thuaire, G. Nonglaton, V. Agache, Y. Roupioz, C. Raillon

    This Minireview focuses on the contribution of biomolecules used as ligands in affinity-based biosensors for the detection and isolation of Extracellular Vesicles (EVs).


  • Open Access

    Polarization Induced Electro-Functionalization of Pore Walls: A Contactless Technology

    by Aurélie Bouchet-Spinelli, Emeline Descamps, Jie Liu, Abdulghani Ismail, Pascale Pham, François Chatelain, Thierry Leïchlé, Loïc Leroy, Patrice Noël Marche, Camille Raillon, et al.

    This review summarizes recent advances in micro- and nanopore technologies with a focus on the functionalization of pores using a promising method named contactless electro-functionalization (CLEF). CLEF enables the localized grafting of electroactive entities onto the inner wall of a micro- or nano-sized pore in a solid-state silicon/silicon oxide membrane. A voltage or electrical current applied across the pore induces the surface functionalization by electroactive entities exclusively on the inside pore wall, which is a significant improvement over existing methods. CLEF’s mechanism is based on the polarization of a sandwich-like silicon/silicon oxide membrane, creating electronic pathways between the core silicon and the electrolyte. Correlation between numerical simulations and experiments have validated this hypothesis. CLEF-induced micro- and nanopores functionalized with antibodies or oligonucleotides were successfully used for the detection and identification of cells and are promising sensitive biosensors. This technology could soon be successfully applied to planar configurations of pores, such as restrictions in microfluidic channels.


  • Open Access

    Toward Microfluidic Label‐Free Isolation and Enumeration of Circulating Tumor Cells from Blood Samples

    by Camille Raillon, James Che, Sandy Thill, Margaux Duchamp, Benoît X. E. Desbiolles, Arnaud Millet, Elodie Sollier, Philippe Renaud

    The isolation, analysis, and enumeration of circulating tumor cells (CTCs) from cancer patient blood samples are a paradigm shift for cancer patient diagnosis, prognosis, and treatment monitoring. Most methods used to isolate and enumerate these target cells rely on the expression of cell surface markers, which varies between patients, cancer types, tumors, and stages. Here, we propose a label‐free high‐throughput platform to isolate, enumerate, and size CTCs on two coupled microfluidic devices. Cancer cells were purified through a Vortex chip and subsequently flowed in‐line to an impedance chip, where a pair of electrodes measured fluctuations of an applied electric field generated by cells passing through. A proof‐of‐concept of the coupling of those two devices was demonstrated with beads and cells. First, the impedance chip was tested as a stand‐alone device: (1) with beads (mean counting error of 1.0%, sizing information clearly separated three clusters for 8, 15, and 20 um beads, respectively) as well as (2) with cancer cells (mean counting error of 3.5%). Second, the combined setup was tested with beads, then with cells in phosphate‐buffered saline, and finally with cancer cells spiked in healthy blood. Experiments demonstrated that the Vortex HT chip enriched the cancer cells, which then could be counted and differentiated from smaller blood cells by the impedance chip based on size information. Further discrimination was shown with dual high‐frequency measurements using electric opacity, highlighting the potential application of this combined setup for a fully integrated label‐free isolation and enumeration of CTCs from cancer patient samples. © 2019 International Society for Advancement of Cytometry


  • DNA Translocation through Low-Noise Glass Nanopores

    by Lorenz J. Steinbock, Roman D. Bulushev, Swati Krishnan, Camille Raillon, Aleksandra Radenovic

    The effect of electron irradiation-induced shrinking on glass nanocapillaries with diameters ranging from 75 to 14 nm was analyzed by measuring the conductance characteristics with and without DNA translocation. We have investigated nanocapillary shrinking with a scanning electron microscope from several perspectives to understand the geometry of the shrunken nanocapillary. On the basis of this observation, the conductance was modeled with respect to the nanocapillary diameter, which allowed reproducing the experimental results. We then translocated DNA through the shrunken nanocapillaries and measured higher conductance drops for smaller diameters, reaching 1.7 nS for the 14 nm diameter nanocapillary. A model taking into account the conical shape of the shrunken nanocapillaries also supported this dependence. Next, we calculated the noise in the form of the standard deviation of the ionic conductance (between 0.04 and 0.15 nS) to calculate a signal-to-noise ratio (SNR) and compared it with nanopores embedded in 20 nm thick silicon nitride membranes. This shows that although nanocapillaries have smaller signal amplitudes due to their conical shape, they benefit from a lower noise. The glass nanocapillaries have a good SNR of about 25 compared with the SNR of 15 for smaller sized nanopores in silicon nitride membranes. The ability to use a modified model of nanopores to mimic the block conductance by DNA translocation provides a theoretical framework to support experimental results from translocating polymers such as DNA.


  • Top Cited Papers

    Detecting the translocation of DNA through a nanopore using graphene nanoribbons

    by F. Traversi, C. Raillon, S. M. Benameur, K. Liu, S. Khlybov, M. Tosun, D. Krasnozhon, A. Kis, A. Radenovic

    Solid-state nanopores can act as single-molecule sensors and could potentially be used to rapidly sequence DNA molecules. However, nanopores are typically fabricated in insulating membranes that are as thick as 15 bases, which makes it difficult for the devices to read individual bases. Graphene is only 0.335 nm thick (equivalent to the spacing between two bases in a DNA chain) and could therefore provide a suitable membrane for sequencing applications. Here, we show that a solid-state nanopore can be integrated with a graphene nanoribbon transistor to create a sensor for DNA translocation. As DNA molecules move through the pore, the device can simultaneously measure drops in ionic current and changes in local voltage in the transistor, which can both be used to detect the molecules. We examine the correlation between these two signals and use the ionic current measurements as a real-time control of the graphene-based sensing device.


  • Detection of RNAP-DNA complexes using solid state nanopores

    by C. Raillon, P. Granjon, M. Graf, A. Radenovic

    Transcription is the first step in gene expression where DNA is copied into RNA. It is extensively studied at the bulk level especially the regulation mechanism, which in cancerous cells is impaired. We were interested in studying E. coli RNAP enzyme at the single-molecule level for its functional as well as molecular motor properties. With nanopore sensing, we were able to observe RNA polymerase-DNA complexes translocate through nanopores and able to distinguish between individual complexes and bare RNA polymerase. We were also able to observe orientation of RNA polymerase in the nanopore whether flow or electric field predominates. The complexity of the signals from the protein-DNA complexes experiment motivated us to develop level detection software. This software is based on a change detection method called the CUSUM algorithm. OpenNanpore software was designed to analyze in details current blockages in nanopore signals with very little prior knowledge on the signal. With this work one can separate events according to their number of levels and study those sub-populations separately.


  • Fast and automatic processing of multi-level events in nanopore translocation experiments

    by C. Raillon, P. Granjon, M. Graf, L. J. Steinbock, A. Radenovic

    We have developed a method to analyze in detail, translocation events providing a novel and flexible tool for data analysis of nanopore experiments. Our program, called OpenNanopore, is based on the cumulative sums algorithm (CUSUM algorithm). This algorithm is an abrupt change detection algorithm that provides fitting of current blockages, allowing the user to easily identify the different levels in each event. Our method detects events using adaptive thresholds that adapt to low-frequency variations in the baseline. After event identification, our method uses the CUSUM algorithm to fit the levels inside every event and automatically extracts their time and amplitude information. This facilitates the statistical analysis of an event population with a given number of levels. The obtained information improves the interpretation of interactions between the molecule and nanopore. Since our program does not require any prior information about the analyzed molecules, novel molecule–nanopore interactions can be characterized. In addition our program is very fast and stable. With the progress in fabrication and control of the translocation speed, in the near future, our program could be useful in identification of the different bases of DNA.