Jiandang Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jiandang Liu has a total of 104 co-authors. Here are the top co-authors by number of shared publications:
- Hongjun Zhang
State Key Laboratory of Particle Detection and Electronics, University of Science and Technology of China, Hefei, China
7 shared publications - Bang-Jiao Ye
Department of Modern Physics, University of Science and Technology of China, Hefei 230026, P. R. China
6 shared publications - Lu Liu
Tianjin Key Laboratory of Environmental Remediation and Pollution Control, College of Environmental Science and Engineering, Nankai University, Tianjin 300350, China
4 shared publications Bangjiao Ye
3 shared publicationsJingyu Sun
Tianjin Key Laboratory of Environmental Remediation and Pollution Control, College of Environmental Science and Engineering, Nankai University, Tianjin 300350, China; College of Chemistry and Materials Engineering, Quzhou University, Quzhou 324000, China
3 shared publicationsWei Xu
3 shared publications
Latest Publications
- Open Access
- 15 April 2026
- Published by Elsevier in SSRN Electronic Journal
Physical aging of ZIF-8@PIM-1 mixed matrix membranes investigated by positron annihilation lifetime spectroscopy
Physical aging of polymer-based gas separation membranes poses a critical barrier to their industrial applications, yet the evolution of the pore structure during long-term aging remains poorly understood. In this work, the physical aging of zeolitic imidazolate framework-8 (ZIF-8)@polymer of intrinsic microporosity-1 (PIM-1) mixed matrix membranes (MMMs) is systematically investigated by simultaneously monitoring microstructural evolution (via positron annihilation lifetime spectroscopy) and gas transport properties of the pure PIM-1 membrane and ZIF-8@PIM-1 MMMs with 5 and 20 wt% filler loadings over a timescale exceeding 100 days. As aging proceeds, both the gas permeabilities and the fractional free volume (FFV) values of these membranes decrease, with the dependence of permeabilities on FFV generally following the Cohen–Turnbull equation. For the pure PIM-1 membrane, the reduction in CO2 permeability is primarily attributed to the FFV-induced reduction in diffusion coefficient. However, the CO2 permeability decline of the two MMMs arises from the FFV-induced reductions in both solubility coefficient and diffusion coefficient, with the influence of solubility coefficient becoming more pronounced in the MMM with higher filler loading. In the early stage of aging, the sharp drop in permeabilities of the MMMs is considered to arise from the collapse of interfacial voids and the associated accompanying effects. High-temperature accelerated aging is likely to cause the matrix polymer surrounding the fillers to shrink away from their surfaces. This work provides valuable insights into the design of aging-resistant MMMs in the future.
- 15 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessPhysical aging of ZIF-8@PIM-1 mixed matrix membranes investigated by positron annihilation lifetime spectroscopy
Physical aging of polymer-based gas separation membranes poses a critical barrier to their industrial applications, yet the evolution of the pore structure during long-term aging remains poorly understood. In this work, the physical aging of zeolitic imidazolate framework-8 (ZIF-8)@polymer of intrinsic microporosity-1 (PIM-1) mixed matrix membranes (MMMs) is systematically investigated by simultaneously monitoring microstructural evolution (via positron annihilation lifetime spectroscopy) and gas transport properties of the pure PIM-1 membrane and ZIF-8@PIM-1 MMMs with 5 and 20 wt% filler loadings over a timescale exceeding 100 days. As aging proceeds, both the gas permeabilities and the fractional free volume (FFV) values of these membranes decrease, with the dependence of permeabilities on FFV generally following the Cohen–Turnbull equation. For the pure PIM-1 membrane, the reduction in CO2 permeability is primarily attributed to the FFV-induced reduction in diffusion coefficient. However, the CO2 permeability decline of the two MMMs arises from the FFV-induced reductions in both solubility coefficient and diffusion coefficient, with the influence of solubility coefficient becoming more pronounced in the MMM with higher filler loading. In the early stage of aging, the sharp drop in permeabilities of the MMMs is considered to arise from the collapse of interfacial voids and the associated accompanying effects. High-temperature accelerated aging is likely to cause the matrix polymer surrounding the fillers to shrink away from their surfaces. This work provides valuable insights into the design of aging-resistant MMMs in the future.
- Open Access
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Physical aging of ZIF-8@PIM-1 mixed matrix membranes investigated by positron annihilation lifetime spectroscopy
Physical aging of polymer-based gas separation membranes poses a critical barrier to their industrial applications, yet the evolution of the pore structure during long-term aging remains poorly understood. In this work, the physical aging of zeolitic imidazolate framework-8 (ZIF-8)@polymer of intrinsic microporosity-1 (PIM-1) mixed matrix membranes (MMMs) is systematically investigated by simultaneously monitoring microstructural evolution (via positron annihilation lifetime spectroscopy) and gas transport properties of the pure PIM-1 membrane and ZIF-8@PIM-1 MMMs with 5 and 20 wt% filler loadings over a timescale exceeding 100 days. As aging proceeds, both the gas permeabilities and the fractional free volume (FFV) values of these membranes decrease, with the dependence of permeabilities on FFV generally following the Cohen–Turnbull equation. For the pure PIM-1 membrane, the reduction in CO2 permeability is primarily attributed to the FFV-induced reduction in diffusion coefficient. However, the CO2 permeability decline of the two MMMs arises from the FFV-induced reductions in both solubility coefficient and diffusion coefficient, with the influence of solubility coefficient becoming more pronounced in the MMM with higher filler loading. In the early stage of aging, the sharp drop in permeabilities of the MMMs is considered to arise from the collapse of interfacial voids and the concurrent reduction in the flexibility of filler framework. High-temperature accelerated aging is likely to cause the polymer matrix surrounding the fillers to shrink away from their surfaces. This work provides valuable insights into the design of aging-resistant MMMs in the future.
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessPhysical aging of ZIF-8@PIM-1 mixed matrix membranes investigated by positron annihilation lifetime spectroscopy
Physical aging of polymer-based gas separation membranes poses a critical barrier to their industrial applications, yet the evolution of the pore structure during long-term aging remains poorly understood. In this work, the physical aging of zeolitic imidazolate framework-8 (ZIF-8)@polymer of intrinsic microporosity-1 (PIM-1) mixed matrix membranes (MMMs) is systematically investigated by simultaneously monitoring microstructural evolution (via positron annihilation lifetime spectroscopy) and gas transport properties of the pure PIM-1 membrane and ZIF-8@PIM-1 MMMs with 5 and 20 wt% filler loadings over a timescale exceeding 100 days. As aging proceeds, both the gas permeabilities and the fractional free volume (FFV) values of these membranes decrease, with the dependence of permeabilities on FFV generally following the Cohen–Turnbull equation. For the pure PIM-1 membrane, the reduction in CO2 permeability is primarily attributed to the FFV-induced reduction in diffusion coefficient. However, the CO2 permeability decline of the two MMMs arises from the FFV-induced reductions in both solubility coefficient and diffusion coefficient, with the influence of solubility coefficient becoming more pronounced in the MMM with higher filler loading. In the early stage of aging, the sharp drop in permeabilities of the MMMs is considered to arise from the collapse of interfacial voids and the concurrent reduction in the flexibility of filler framework. High-temperature accelerated aging is likely to cause the polymer matrix surrounding the fillers to shrink away from their surfaces. This work provides valuable insights into the design of aging-resistant MMMs in the future.
- Open Access
- 6 January 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (1)
Optimizing the upconversion photoluminescence of Er–Nb co-doped Bi4Ti3O12 ceramics by Ti divacancy defects
To optimize the upconversion photoluminescence (UCPL) performance of rare-earth doped Bi4Ti3O12 Aurivillius-phase ceramics, it is critical to reveal the microstructure-property relationship. In this work, Er and Nb co-doped Bi3.7Er0.3NbyTi3−yO12 (y=0,0.01,0.02,0.04,0.06) ceramics were synthesized via a solid-state reaction. The x-ray diffraction analysis confirmed their phase-pure orthorhombic without a secondary phase. Compared to Bi3.7Er0.3Ti3O12, the intensities of 528 and 661 nm emission peaks of UCPL spectra for Bi3.7Er0.3Nb0.02Ti2.98O12 are 2.5 and 2.2 times increased, respectively. Experimental and theoretical calculation results of positron annihilation lifetime spectroscopy and coincidence Doppler broadening revealed the presence of VTi monovacancy and VTi–Ti divacancy defects within these ceramics. As demonstrated by the UCPL and the positron annihilation results, the enhancement of UCPL performance of Er–Nb co-doped Bi4Ti3O12 ceramics is predominantly determined by the VTi–Ti divacancy defects.
- 6 January 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (1)
Open AccessOptimizing the upconversion photoluminescence of Er–Nb co-doped Bi4Ti3O12 ceramics by Ti divacancy defects
To optimize the upconversion photoluminescence (UCPL) performance of rare-earth doped Bi4Ti3O12 Aurivillius-phase ceramics, it is critical to reveal the microstructure-property relationship. In this work, Er and Nb co-doped Bi3.7Er0.3NbyTi3−yO12 (y=0,0.01,0.02,0.04,0.06) ceramics were synthesized via a solid-state reaction. The x-ray diffraction analysis confirmed their phase-pure orthorhombic without a secondary phase. Compared to Bi3.7Er0.3Ti3O12, the intensities of 528 and 661 nm emission peaks of UCPL spectra for Bi3.7Er0.3Nb0.02Ti2.98O12 are 2.5 and 2.2 times increased, respectively. Experimental and theoretical calculation results of positron annihilation lifetime spectroscopy and coincidence Doppler broadening revealed the presence of VTi monovacancy and VTi–Ti divacancy defects within these ceramics. As demonstrated by the UCPL and the positron annihilation results, the enhancement of UCPL performance of Er–Nb co-doped Bi4Ti3O12 ceramics is predominantly determined by the VTi–Ti divacancy defects.
- 13 December 2025
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 621
Poisitron annihilation study on corrosion-incudced defects in UNS N10003 alloy exposed to tellurium-containing FLiNaK salt
- 13 December 2025
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 621
Poisitron annihilation study on corrosion-incudced defects in UNS N10003 alloy exposed to tellurium-containing FLiNaK salt
- 26 August 2025
- Published by Elsevier in Water Research
- Vol. 287 (Pt B) , 124465
Efficient and low-cost removal of dissolved organic phosphorus by visible light-enhanced Ti electrocoagulation with self-generated rutile photocatalysts
- 26 August 2025
- Published by Elsevier in Water Research
- Vol. 287 (Pt B) , 124465
Efficient and low-cost removal of dissolved organic phosphorus by visible light-enhanced Ti electrocoagulation with self-generated rutile photocatalysts
- Open Access
- 12 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (6)
A simulation comparison of 3D reconstruction techniques of muography for blast furnace
To monitor industrial processes within blast furnaces (BFs) using muography, this study focuses on resolving the internal cohesive zone-dead man boundary (CDB). This boundary, which separates the furnace’s semi-plastic melting region (cohesive zone) from its stable coke core (dead man), is a key indicator of operational health. To this end, the effectiveness of various reconstruction algorithms and voxel parameters are systematically evaluated. Theoretical results demonstrate that the Limited-memory Broyden–Fletcher–Goldfarb–Shanno method with a voxel size of 0.2 m achieves the best performance in CDB reconstruction. Furthermore, as disclosed in the investigation of the detector placement configuration, at least four detectors are required to clearly visualize CDB. Eventually, discernible CDB is successfully reconstructed from simulated data for both symmetric and asymmetric BF scenarios without image filtering, which validates the potential of muography to monitor BFs.
- 12 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (6)
Open AccessA simulation comparison of 3D reconstruction techniques of muography for blast furnace
To monitor industrial processes within blast furnaces (BFs) using muography, this study focuses on resolving the internal cohesive zone-dead man boundary (CDB). This boundary, which separates the furnace’s semi-plastic melting region (cohesive zone) from its stable coke core (dead man), is a key indicator of operational health. To this end, the effectiveness of various reconstruction algorithms and voxel parameters are systematically evaluated. Theoretical results demonstrate that the Limited-memory Broyden–Fletcher–Goldfarb–Shanno method with a voxel size of 0.2 m achieves the best performance in CDB reconstruction. Furthermore, as disclosed in the investigation of the detector placement configuration, at least four detectors are required to clearly visualize CDB. Eventually, discernible CDB is successfully reconstructed from simulated data for both symmetric and asymmetric BF scenarios without image filtering, which validates the potential of muography to monitor BFs.
- Open Access
- 18 April 2025
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (6) , 1
Correction: Positron annihilation study of defect formation and evolution in matrix graphite under He ion irradiation
- 18 April 2025
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (6) , 1
Open AccessCorrection: Positron annihilation study of defect formation and evolution in matrix graphite under He ion irradiation
- 16 December 2024
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (1) , 1-9
Positron annihilation study of defect formation and evolution in matrix graphite under He ion irradiation
- 16 December 2024
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (1) , 1-9
Positron annihilation study of defect formation and evolution in matrix graphite under He ion irradiation