Jason Tam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jason Tam has a total of 77 co-authors. Here are the top co-authors by number of shared publications:
Uwe Erb
9 shared publications- Gisele Azimi
Laboratory for Strategic Materials, Department of Chemical Engineering and Applied Chemistry, University of Toronto, 200 College Street, Toronto, ON M5S 3E5, Canada
5 shared publications - Uwe Erb
Department of Materials Science and Engineering, University of Toronto, Toronto, Canada
5 shared publications Bosco Yu
3 shared publicationsJason D. Giallonardo
3 shared publicationsWeiwei Li
3 shared publications
Latest Publications
- Open Access
- 3 January 2025
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 11 (1) , eads6137
High-performance solid-state electrochemical thermal switches with earth-abundant cerium oxide
Thermal switches, which electrically turn heat flow on and off, have attracted attention as thermal management devices. Electrochemical reduction/oxidation switches the thermal conductivity (κ) of active metal oxide films. The performance of the previously proposed electrochemical thermal switches is low; the on/off κ-ratio is mostly less than 5, and the κ-switching width is less than 5 watts per meter kelvin. We used a CeO 2 thin film as the active layer deposited on a solid electrolyte YSZ substrate. When the CeO 2 thin film was reduced once (off-state) and then oxidized (on-state), κ was about 2.2 watts per meter kelvin in the most reduced state, and κ increased with oxidation to 12.5 watts per meter kelvin (on-state). This reduction (off-state)/oxidation (on-state) cycle was repeated 100 times, and the on/off κ-ratio was 5.8, and the κ-switching width was 10.3 watts per meter kelvin. The CeO 2 -based solid-state electrochemical thermal switches would be potential devices for thermal shutters and thermal displays.
- 3 January 2025
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 11 (1) , eads6137
Open AccessHigh-performance solid-state electrochemical thermal switches with earth-abundant cerium oxide
Thermal switches, which electrically turn heat flow on and off, have attracted attention as thermal management devices. Electrochemical reduction/oxidation switches the thermal conductivity (κ) of active metal oxide films. The performance of the previously proposed electrochemical thermal switches is low; the on/off κ-ratio is mostly less than 5, and the κ-switching width is less than 5 watts per meter kelvin. We used a CeO 2 thin film as the active layer deposited on a solid electrolyte YSZ substrate. When the CeO 2 thin film was reduced once (off-state) and then oxidized (on-state), κ was about 2.2 watts per meter kelvin in the most reduced state, and κ increased with oxidation to 12.5 watts per meter kelvin (on-state). This reduction (off-state)/oxidation (on-state) cycle was repeated 100 times, and the on/off κ-ratio was 5.8, and the κ-switching width was 10.3 watts per meter kelvin. The CeO 2 -based solid-state electrochemical thermal switches would be potential devices for thermal shutters and thermal displays.
- 20 February 2023
- Published by Elsevier in Plant Science
- Vol. 330, 111659
Superhydrophobicity mechanism of refoliated quaking aspen leaves after complete defoliation by LDD (gypsy, spongy) moth caterpillars
- 20 February 2023
- Published by Elsevier in Plant Science
- Vol. 330, 111659
Superhydrophobicity mechanism of refoliated quaking aspen leaves after complete defoliation by LDD (gypsy, spongy) moth caterpillars
- 19 December 2022
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 659
Contamination of rare earth oxide surfaces stored in vacuum environment
- 19 December 2022
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 659
Contamination of rare earth oxide surfaces stored in vacuum environment
- 1 February 2022
- Published by Elsevier in Scripta Materialia
- Vol. 208
The effect of annealing on trapped copper oxides in particle-particle interfaces of cold-sprayed Cu coatings
- 1 February 2022
- Published by Elsevier in Scripta Materialia
- Vol. 208
The effect of annealing on trapped copper oxides in particle-particle interfaces of cold-sprayed Cu coatings
- 1 December 2020
- Published by Elsevier in Surface and Coatings Technology
- Vol. 404
Reducing complex microstructural heterogeneity in electrodeposited and cold sprayed copper coating junctions
- 1 December 2020
- Published by Elsevier in Surface and Coatings Technology
- Vol. 404
Reducing complex microstructural heterogeneity in electrodeposited and cold sprayed copper coating junctions
- 30 September 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (40) , 18730-18738
Nanomechanical elasticity and fracture studies of lithium phosphate (LPO) and lithium tantalate (LTO) solid-state electrolytes
Nanomechanical behavior of ALD prepared solid-state electrolytes studied by an AFM deflection technique to emulate mechanical deformation at the nanoscale.
- 30 September 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (40) , 18730-18738
Nanomechanical elasticity and fracture studies of lithium phosphate (LPO) and lithium tantalate (LTO) solid-state electrolytes
Nanomechanical behavior of ALD prepared solid-state electrolytes studied by an AFM deflection technique to emulate mechanical deformation at the nanoscale.
- 29 July 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (32) , 17880-17892
ZSM-5 decrystallization and dealumination in hot liquid water
Zeolites have recently attracted attention for upgrading renewable resources in the presence of liquid water phases; however, the stability of zeolites in the presence of liquid-phase water is not completely understood. Accordingly, the stability of the ZSM-5 framework and its acid sites was studied in the presence of water at temperatures ranging from 250 to 450 °C and at pressures sufficient to maintain a liquid or liquid-like state (25 MPa). Treated samples were analyzed for framework degradation and Al content and coordination using a variety of complementary techniques, including X-ray diffraction, electron microscopy, N2 sorption, 27Al and 29Si NMR spectroscopy, and several different types of infrared spectroscopy. These analyses indicate that the ZSM-5 framework retains >80% crystallinity at all conditions, and that 300–400 °C are the most aggressive. Decrystallization appears to initiate primarily at crystal surfaces and share many characteristics in common with alkali promoted desilication. Liquid water treatment promotes ZSM-5 dealumination, following a mechanism analogous to that observed under steaming conditions: initiation by Al–O hydrolysis, Al migration to the surface, and finally deposition as extra framework Al or possibly complete dissolution under some conditions. As with the framework, dealumination is most aggressive at 300–400 °C. Several models were evaluated to capture the non-Arrhenius effect of temperature on decrystallization and dealumination, the most successful of which included temperature dependent values of the water auto-ionization constant. These results can help interpretation of previous studies on ZSM-5 catalysis in hot liquid water and suggest future approaches to extend catalyst lifetime.
- 29 July 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (32) , 17880-17892
ZSM-5 decrystallization and dealumination in hot liquid water
Zeolites have recently attracted attention for upgrading renewable resources in the presence of liquid water phases; however, the stability of zeolites in the presence of liquid-phase water is not completely understood. Accordingly, the stability of the ZSM-5 framework and its acid sites was studied in the presence of water at temperatures ranging from 250 to 450 °C and at pressures sufficient to maintain a liquid or liquid-like state (25 MPa). Treated samples were analyzed for framework degradation and Al content and coordination using a variety of complementary techniques, including X-ray diffraction, electron microscopy, N2 sorption, 27Al and 29Si NMR spectroscopy, and several different types of infrared spectroscopy. These analyses indicate that the ZSM-5 framework retains >80% crystallinity at all conditions, and that 300–400 °C are the most aggressive. Decrystallization appears to initiate primarily at crystal surfaces and share many characteristics in common with alkali promoted desilication. Liquid water treatment promotes ZSM-5 dealumination, following a mechanism analogous to that observed under steaming conditions: initiation by Al–O hydrolysis, Al migration to the surface, and finally deposition as extra framework Al or possibly complete dissolution under some conditions. As with the framework, dealumination is most aggressive at 300–400 °C. Several models were evaluated to capture the non-Arrhenius effect of temperature on decrystallization and dealumination, the most successful of which included temperature dependent values of the water auto-ionization constant. These results can help interpretation of previous studies on ZSM-5 catalysis in hot liquid water and suggest future approaches to extend catalyst lifetime.
- 1 June 2019
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 25 (S2) , 1592-1593
Electron Microscopy Characterization of Copper Coatings for Canada's Used Nuclear Fuel Containers
- 1 June 2019
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 25 (S2) , 1592-1593
Electron Microscopy Characterization of Copper Coatings for Canada's Used Nuclear Fuel Containers
- 1 March 2019
- Published by Elsevier in Applied Materials Today
- Vol. 14, 102-107
Local strain mapping of GO nanosheets under in situ TEM tensile testing
- 1 March 2019
- Published by Elsevier in Applied Materials Today
- Vol. 14, 102-107
Local strain mapping of GO nanosheets under in situ TEM tensile testing