Soroush Rasti Boroujeni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Soroush Rasti Boroujeni has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad-Reza Nezhad-Ahmadi
Department of ECE, Centre for Intelligent Antenna and Radio Systems (CIARS), University of Waterloo, Waterloo, ON, Canada
3 shared publications - Safieddin Safavi-Naeini
Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON, Canada
3 shared publications - Ali Basaligheh
Department of Electrical and Computer Engineering, Faculty of Engineering, University of Alberta, Edmonton, AB, Canada
2 shared publications - Ardeshir Palizban
Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON N2L 3G1, Canada
2 shared publications Ahmad Ehsandar
C-COM Satellite Systems Inc. Ottawa, Ontario. Canada and Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON N2L 3G1,Canada
1 shared publicationAmany El-Gouhary
Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, Canada
1 shared publication
Latest Publications
- 20 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 69 (11) , 4977-4985
A High-Efficiency 27–30-GHz 130-nm Bi-CMOS Transmitter Front End for SATCOM Phased Arrays
A high-efficiency 27–30 GHz 0.13- ${{\mu } \text {m}}$ BiCMOS transmitter front end for mobile satellite communication (SATCOM) phased arrays is presented. A system-level analysis for determining the key parameters of the RF front end for the case of a SATCOM user terminal for geostationary Earth orbit (GEO) is presented. The building blocks of the beamformer, consisting of a phase shifter, variable attenuator, and power amplifier, are fully characterized. A 360° phase shifter with an accuracy of 7 bits and amplitude error of ±1.5 dB is integrated with a variable attenuator that provides a gain variation of 16 dB with phase error of ±5°. The chip has a measured transducer gain of 23 dB and a power consumption of 45 mW at OP 1dB of 10.8 dBm. The power-added efficiency (PAE) of 26.7% is measured for the entire channel at OP 1dB . An error vector magnitude (EVM) of −28 dB at P out,avg of 6 dBm and PAE avg of 12% is measured for a 400-MHz bandwidth 64-QAM modulated signal. The overall size of the chip is ${1.18} \times {2.23}\,\,\text {mm}^{{2}}$ .
- 20 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 69 (11) , 4977-4985
A High-Efficiency 27–30-GHz 130-nm Bi-CMOS Transmitter Front End for SATCOM Phased Arrays
A high-efficiency 27–30 GHz 0.13- ${{\mu } \text {m}}$ BiCMOS transmitter front end for mobile satellite communication (SATCOM) phased arrays is presented. A system-level analysis for determining the key parameters of the RF front end for the case of a SATCOM user terminal for geostationary Earth orbit (GEO) is presented. The building blocks of the beamformer, consisting of a phase shifter, variable attenuator, and power amplifier, are fully characterized. A 360° phase shifter with an accuracy of 7 bits and amplitude error of ±1.5 dB is integrated with a variable attenuator that provides a gain variation of 16 dB with phase error of ±5°. The chip has a measured transducer gain of 23 dB and a power consumption of 45 mW at OP 1dB of 10.8 dBm. The power-added efficiency (PAE) of 26.7% is measured for the entire channel at OP 1dB . An error vector magnitude (EVM) of −28 dB at P out,avg of 6 dBm and PAE avg of 12% is measured for a 400-MHz bandwidth 64-QAM modulated signal. The overall size of the chip is ${1.18} \times {2.23}\,\,\text {mm}^{{2}}$ .
- 1 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 68 (7) , 3159-3171
A Broadband High-Efficiency Continuous Class-AB Power Amplifier for Millimeter-Wave 5G and SATCOM Phased-Array Transmitters
A broadband and compact harmonic-tuned power amplifier (PA) is presented for 5G and mobile satellite communication (SATCOM). A noninverting 1:1 transformer is the core of the output matching and provides an embedded second harmonic trap in a compact layout. The proposed PA is fabricated by the BiCMOS SiGe-8XP technology. At P1dB, an output power of 11 dBm and a collector efficiency of more than 30% from 30 to 39 GHz are achieved. The PA has a single-ended topology with electrostatic discharge (ESD) protection, which is well suited for deployment in the output stage of the multichannel beamformer transmitter (TX) monolithic microwave integrated circuit (MMICs). Detailed analysis, design methodology, and experimental results are presented.
- 1 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 68 (7) , 3159-3171
A Broadband High-Efficiency Continuous Class-AB Power Amplifier for Millimeter-Wave 5G and SATCOM Phased-Array Transmitters
A broadband and compact harmonic-tuned power amplifier (PA) is presented for 5G and mobile satellite communication (SATCOM). A noninverting 1:1 transformer is the core of the output matching and provides an embedded second harmonic trap in a compact layout. The proposed PA is fabricated by the BiCMOS SiGe-8XP technology. At P1dB, an output power of 11 dBm and a collector efficiency of more than 30% from 30 to 39 GHz are achieved. The PA has a single-ended topology with electrostatic discharge (ESD) protection, which is well suited for deployment in the output stage of the multichannel beamformer transmitter (TX) monolithic microwave integrated circuit (MMICs). Detailed analysis, design methodology, and experimental results are presented.
- 9 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (11) , 2452-2456
A 28–30 GHz CMOS Reflection-Type Phase Shifter With Full 360° Phase Shift Range
This brief presents a millimeter-wave passive reflection-type phase shifter (RTPS) capable of producing a 360∘ phase shift range with low insertion loss (IL) in 28-30 GHz range. The circuit consists of a 90∘ Lange coupler and two multi-resonance loads where a switched inductor and CMOS varactors are employed. As opposed to previously reported RTPS requiring multiple control voltages, the proposed reflective load requires only one control voltage for the varactors which results in simplicity and reduced dc power consumption of the control blocks. Fabricated in 65 nm CMOC process, this RTPS achieves a measured average insertion loss of 9.5 dB at 29 GHz while consuming zero dc power. The RTPS occupies only 388 × 615 μm2 of chip area.
- 9 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (11) , 2452-2456
A 28–30 GHz CMOS Reflection-Type Phase Shifter With Full 360° Phase Shift Range
This brief presents a millimeter-wave passive reflection-type phase shifter (RTPS) capable of producing a 360∘ phase shift range with low insertion loss (IL) in 28-30 GHz range. The circuit consists of a 90∘ Lange coupler and two multi-resonance loads where a switched inductor and CMOS varactors are employed. As opposed to previously reported RTPS requiring multiple control voltages, the proposed reflective load requires only one control voltage for the varactors which results in simplicity and reduced dc power consumption of the control blocks. Fabricated in 65 nm CMOC process, this RTPS achieves a measured average insertion loss of 9.5 dB at 29 GHz while consuming zero dc power. The RTPS occupies only 388 × 615 μm2 of chip area.
- 3 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 67 (8) , 5344-5352
An Integrated Circularly Polarized Transmitter Active Phased-Array Antenna for Emerging Ka-Band Satellite Mobile Terminals
This paper presents the design, development, and measurement results of a low-cost integrated circularly polarized active phased-array antenna (CP-APAA) technology with sidelobe level control, operating at Ka-band, for high throughput land-mobile satellite communication. The proposed CP-APAA comprises of (4 × 16) 64 elements in a rectangular grid array configuration. Eight commercial monolithic microwave integrated circuits (MMICs) with 8-RF output channels have been used to control the phase and amplitude over the antenna aperture. For simplicity, the array antenna was designed in three metal layers and fabricated by a low-cost printed circuit board (PCB) technology as a proof-of-concept for a modular and scalable Ka- band phased-array antenna with a wide steering angle. Measured radiation pattern shows a right-hand circularly polarized (RHCP) pattern with an axial-ratio (AR) level <3dB and low pointing error ≤ 1.5° over a scanning angular range of 0°–×40°. Moreover, the amplitude excitation of the CP-APAA was tapered exponentially to control and reduce the side lobe level from 11 dB to 25 dB in boresight direction. Finally, towards a multi-beam array implementation, a two RHCP beams have been generated at –30° and +20° scan angles simultaneously.
- 3 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 67 (8) , 5344-5352
An Integrated Circularly Polarized Transmitter Active Phased-Array Antenna for Emerging Ka-Band Satellite Mobile Terminals
This paper presents the design, development, and measurement results of a low-cost integrated circularly polarized active phased-array antenna (CP-APAA) technology with sidelobe level control, operating at Ka-band, for high throughput land-mobile satellite communication. The proposed CP-APAA comprises of (4 × 16) 64 elements in a rectangular grid array configuration. Eight commercial monolithic microwave integrated circuits (MMICs) with 8-RF output channels have been used to control the phase and amplitude over the antenna aperture. For simplicity, the array antenna was designed in three metal layers and fabricated by a low-cost printed circuit board (PCB) technology as a proof-of-concept for a modular and scalable Ka- band phased-array antenna with a wide steering angle. Measured radiation pattern shows a right-hand circularly polarized (RHCP) pattern with an axial-ratio (AR) level <3dB and low pointing error ≤ 1.5° over a scanning angular range of 0°–×40°. Moreover, the amplitude excitation of the CP-APAA was tapered exponentially to control and reduce the side lobe level from 11 dB to 25 dB in boresight direction. Finally, towards a multi-beam array implementation, a two RHCP beams have been generated at –30° and +20° scan angles simultaneously.