Md Samiul Islam Sarker
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Md Samiul Islam Sarker has a total of 68 co-authors. Here are the top co-authors by number of shared publications:
M.K.R. Khan
7 shared publicationsM. M. Rahman
Department of Physics, Rajshahi University 1 , Rajshahi 6205, Bangladesh
5 shared publicationsM.M. Rahman
Department of Physics, University of Rajshahi, Rajshahi, 6205, Bangladesh
4 shared publicationsShunichi Sato
4 shared publications- Ali Hossain
Institute of Materials Informatics
3 shared publications M. K. R. Khan
Department of Physics, University of Rajshahi, Rajshahi, Bangladesh
3 shared publications
Latest Publications
- 8 September 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (25) , 1979
Annealing effect on microstructural, vibrational, magnetic, and dielectric properties of Sr0.9Co0.1Fe11.9Nb0.1O19
- 8 September 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (25) , 1979
Annealing effect on microstructural, vibrational, magnetic, and dielectric properties of Sr0.9Co0.1Fe11.9Nb0.1O19
- Open Access
- 25 June 2025
- Published by Wiley in Nano Select
- Vol. 6 (12)
Comparative Insights Into the Structural, Electronic, Elastic, Vibrational, and Optical Properties of Rare‐Earth Palladium Borides RBPd 3 (R = Lu, Yb)
The structural, electronic, elastic, acoustic, thermodynamic, vibrational, and optical properties of rare‐earth palladium borides, YbBPd 3 and LuBPd 3 of cubic perovskite structures, have been systematically explored in this work. The optimized lattice parameters of YbBPd 3 and LuBPd 3 are 4.291 and 4.313 Å, respectively, and both compounds exhibit mechanical stability. The band structures and density of states (DOS) indicate that the compounds possess metallic character in which Pd‐4d and B‐2p states are the dominating character at the Fermi level. Elastic constant and moduli suggest that LuBPd 3 is harder and stiffer than YbBPd 3 . Both compounds are ductile and elastically anisotropic, although LuBPd 3 shows greater anisotropy. LuBPd 3 has a higher acoustic velocity while YbBPd 3 has a higher Grüneisen parameter, indicating greater thermal expansion and lower thermal conductivity. Phonon dispersion spectra confirmed that both structures are dynamically stable, and the acoustic and optical modes are mainly influenced by Yb and Lu atoms. Both compounds exhibit strong metallic behavior in their optical properties. LuBPd 3 shows higher optical conductivity while YbBPd 3 demonstrates greater reflectivity and absorption. High reflectivity in the infrared (IR) region makes them good candidates for IR shielding materials. This study will be helpful for further theoretical and experimental research.
- 25 June 2025
- Published by Wiley in Nano Select
- Vol. 6 (12)
Open AccessComparative Insights Into the Structural, Electronic, Elastic, Vibrational, and Optical Properties of Rare‐Earth Palladium Borides RBPd 3 (R = Lu, Yb)
The structural, electronic, elastic, acoustic, thermodynamic, vibrational, and optical properties of rare‐earth palladium borides, YbBPd 3 and LuBPd 3 of cubic perovskite structures, have been systematically explored in this work. The optimized lattice parameters of YbBPd 3 and LuBPd 3 are 4.291 and 4.313 Å, respectively, and both compounds exhibit mechanical stability. The band structures and density of states (DOS) indicate that the compounds possess metallic character in which Pd‐4d and B‐2p states are the dominating character at the Fermi level. Elastic constant and moduli suggest that LuBPd 3 is harder and stiffer than YbBPd 3 . Both compounds are ductile and elastically anisotropic, although LuBPd 3 shows greater anisotropy. LuBPd 3 has a higher acoustic velocity while YbBPd 3 has a higher Grüneisen parameter, indicating greater thermal expansion and lower thermal conductivity. Phonon dispersion spectra confirmed that both structures are dynamically stable, and the acoustic and optical modes are mainly influenced by Yb and Lu atoms. Both compounds exhibit strong metallic behavior in their optical properties. LuBPd 3 shows higher optical conductivity while YbBPd 3 demonstrates greater reflectivity and absorption. High reflectivity in the infrared (IR) region makes them good candidates for IR shielding materials. This study will be helpful for further theoretical and experimental research.
- 26 February 2025
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 706
Synthesis of gallium (Ga) doped CdO/p-Si heterojunction and evaluation of junction parameters
- 26 February 2025
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 706
Synthesis of gallium (Ga) doped CdO/p-Si heterojunction and evaluation of junction parameters
- RetractedOpen Access
RETRACTED: Unlocking the mechanical, thermodynamic and thermoelectric properties of NaSbS2: A DFT scheme
- 16 November 2024
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 187
Atomic position dependent structural, electronic, mechanical and optical properties of ZnSbF3 fluoroperovskites
- 16 November 2024
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 187
Atomic position dependent structural, electronic, mechanical and optical properties of ZnSbF3 fluoroperovskites
- 30 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (22) , 45868-45879
Impact of annealing temperature on the structural, magnetic and dielectric properties of BaFe12-xYxO19 (x = 0.0, 0.2, 0.4, 0.6) nanocrystalline samples
- 30 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (22) , 45868-45879
Impact of annealing temperature on the structural, magnetic and dielectric properties of BaFe12-xYxO19 (x = 0.0, 0.2, 0.4, 0.6) nanocrystalline samples
- Open Access
- 1 April 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (4)
Enhanced electrical, optical and magnetic properties of BiFeO3 perovskite nanoparticles co-doped with Y and Cu
The present work includes the fabrication of pure BiFeO3 and Bi0.9Y0.1Fe1−xCuxO3 (x = 0.05, 0.10, 0.15) nanoparticles by the usual sol-gel route. The characterization of structural, morphological, optical, electrical, and magnetic properties of the synthesized samples was achieved through x-ray diffraction spectroscopy, Raman spectroscopy, Fourier transform infrared spectroscopy, scanning electron microscopy, an impedance analyzer, and a vibrating sample magnetometer. The Fourier transform infrared study confirmed the presence of Bi–O and Fe–O bonds. The x-ray diffraction patterns confirmed the rhombohedral (R3c) structure as a major phase with the orthorhombic (Pnma) structure as a secondary phase in all samples, and few amount of impurity phase of Bi25FeO40 was also determined. The surface morphology analysis showed the variation of particle size from 63 to 174 nm. The Raman spectra of 13 optical phonon modes, including 4A1 and 9E symmetric phonons, are observed for all samples, and the positions of these modes are almost similar, except the intensities of A1 modes. The optical measurements show a reduction in bandgap from 2.17 to 2.03 eV with co-doping, revealing itself as a more promising applicant in photovoltaics. An enhanced value of the dielectric constant is observed for different doped samples at different frequency regions from 100 Hz to 10 MHz. Magnetic investigation demonstrates the improved ferromagnetism with co-doping of Y and Cu due to distortion in the FeO6 octahedron. A maximum saturation magnetization of 0.26 emu/gm and a coercivity of 2915 Oe were found for Y concentration of 10% and Cu concentration of 15%.
- 1 April 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (4)
Open AccessEnhanced electrical, optical and magnetic properties of BiFeO3 perovskite nanoparticles co-doped with Y and Cu
The present work includes the fabrication of pure BiFeO3 and Bi0.9Y0.1Fe1−xCuxO3 (x = 0.05, 0.10, 0.15) nanoparticles by the usual sol-gel route. The characterization of structural, morphological, optical, electrical, and magnetic properties of the synthesized samples was achieved through x-ray diffraction spectroscopy, Raman spectroscopy, Fourier transform infrared spectroscopy, scanning electron microscopy, an impedance analyzer, and a vibrating sample magnetometer. The Fourier transform infrared study confirmed the presence of Bi–O and Fe–O bonds. The x-ray diffraction patterns confirmed the rhombohedral (R3c) structure as a major phase with the orthorhombic (Pnma) structure as a secondary phase in all samples, and few amount of impurity phase of Bi25FeO40 was also determined. The surface morphology analysis showed the variation of particle size from 63 to 174 nm. The Raman spectra of 13 optical phonon modes, including 4A1 and 9E symmetric phonons, are observed for all samples, and the positions of these modes are almost similar, except the intensities of A1 modes. The optical measurements show a reduction in bandgap from 2.17 to 2.03 eV with co-doping, revealing itself as a more promising applicant in photovoltaics. An enhanced value of the dielectric constant is observed for different doped samples at different frequency regions from 100 Hz to 10 MHz. Magnetic investigation demonstrates the improved ferromagnetism with co-doping of Y and Cu due to distortion in the FeO6 octahedron. A maximum saturation magnetization of 0.26 emu/gm and a coercivity of 2915 Oe were found for Y concentration of 10% and Cu concentration of 15%.
- Open Access
- 29 February 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (11) , 7314-7328
Structural, thermodynamic, and magnetic properties of SrFe 12 O 19 hexaferrite modified by co-substitution of Cu and Gd
A hard magnetic system of SrFe 12 O 19 nanomaterial was modified according to the composition of Sr 0.95 Gd 0.05 Fe 12− x Cu x O 19 with x = 0.0, 0.30, and 0.60 using the sol–gel technique.
- 29 February 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (11) , 7314-7328
Open AccessStructural, thermodynamic, and magnetic properties of SrFe 12 O 19 hexaferrite modified by co-substitution of Cu and Gd
A hard magnetic system of SrFe 12 O 19 nanomaterial was modified according to the composition of Sr 0.95 Gd 0.05 Fe 12− x Cu x O 19 with x = 0.0, 0.30, and 0.60 using the sol–gel technique.