Xiaoran Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xiaoran Wang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Tian He
School of Transportation Science and Engineering, Beihang University, Beijing 100191, China
2 shared publications Yingchun Shan
2 shared publications- Haijun Xing
Department of Mechanical Engineering, Shijiazhuang Tiedao University, Shijiazhuang 050043, China
1 shared publication Junfei Tai
1 shared publicationShaopu Yang
Department of Mechanical Engineering, Shijiazhuang Tiedao University, Shijiazhuang 050043, China
1 shared publicationXiandong Liu
School of Transportation Science and Engineering, Beihang University, Beijing, CO 100191 China
1 shared publication
Latest Publications
- 1 November 2019
- Published by Elsevier in Mechanical Systems and Signal Processing
- Vol. 133
A fast acoustic emission beamforming localization method based on Hilbert curve
- 1 November 2019
- Published by Elsevier in Mechanical Systems and Signal Processing
- Vol. 133
A fast acoustic emission beamforming localization method based on Hilbert curve
- Open Access
- 4 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 33169-33182
Analysis and Optimization of the Novel Inerter-Based Dynamic Vibration Absorbers
Passive dynamic vibration absorber (DVA) is widely used in structural vibration reduction, and the higher efficient DVA is always required for some special situations. This article aims to propose the novel inerter-based dynamic vibration absorbers (IDVAs) to enhance the performance of the passive DVA. Firstly, several novel IDVAs are presented by matching the inerter with DVA in different places. Then, the closed-form optimal parameters of six kinds of IDVAs are obtained based on the classical fixed-point theory. The obtained parameters demonstrates that all the inerters connected between the primary system and absorber system do not provide improvement for the performance of DVAs, while all the inerters connected to the earth can improve the performance of DVAs. Moreover, the comparisons among the IDVAs show that the inerter connected to the earth in the grounded DVA (IR2 in this paper) performs the best performance in vibration absorption. More than 30 % improvement can be obtained from IR2 as compared with other IDVAs. Finally, the further comparison among the IDVAs under white noise excitation also shows that IR2 is superior to other IDVAs. The results may provide theoretical basis for design of the optimal IDVA in engineering practice.
- 4 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 33169-33182
Open AccessAnalysis and Optimization of the Novel Inerter-Based Dynamic Vibration Absorbers
Passive dynamic vibration absorber (DVA) is widely used in structural vibration reduction, and the higher efficient DVA is always required for some special situations. This article aims to propose the novel inerter-based dynamic vibration absorbers (IDVAs) to enhance the performance of the passive DVA. Firstly, several novel IDVAs are presented by matching the inerter with DVA in different places. Then, the closed-form optimal parameters of six kinds of IDVAs are obtained based on the classical fixed-point theory. The obtained parameters demonstrates that all the inerters connected between the primary system and absorber system do not provide improvement for the performance of DVAs, while all the inerters connected to the earth can improve the performance of DVAs. Moreover, the comparisons among the IDVAs show that the inerter connected to the earth in the grounded DVA (IR2 in this paper) performs the best performance in vibration absorption. More than 30 % improvement can be obtained from IR2 as compared with other IDVAs. Finally, the further comparison among the IDVAs under white noise excitation also shows that IR2 is superior to other IDVAs. The results may provide theoretical basis for design of the optimal IDVA in engineering practice.
- Open Access
- 1 January 2016
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2016, 1-10
Parameters Optimization for a Kind of Dynamic Vibration Absorber with Negative Stiffness
A new type of dynamic vibration absorber (DVA) with negative stiffness is studied in detail. At first, the analytical solution of the system is obtained based on the established differential motion equation. Three fixed points are found in the amplitude-frequency curves of the primary system. The design formulae for the optimum tuning ratio and optimum stiffness ratio of DVA are obtained by adjusting the three fixed points to the same height according to the fixed-point theory. Then, the optimum damping ratio is formulated by minimizing the maximum value of the amplitude-frequency curves according tooptimization principle. According to the characteristics of negative stiffness element, the optimum negative stiffness ratio is also established and it could still keep the system stable. In the end, the comparison between the analytical and the numerical solutions verifies the correctness of the analytical solution. The comparisons with three other traditional DVAs under the harmonic and random excitations show that the presented DVA performs better in vibration absorption. This result could provide theoretical basis for optimum parameters design of similar DVAs.- 1 January 2016
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2016, 1-10
Open AccessParameters Optimization for a Kind of Dynamic Vibration Absorber with Negative Stiffness
A new type of dynamic vibration absorber (DVA) with negative stiffness is studied in detail. At first, the analytical solution of the system is obtained based on the established differential motion equation. Three fixed points are found in the amplitude-frequency curves of the primary system. The design formulae for the optimum tuning ratio and optimum stiffness ratio of DVA are obtained by adjusting the three fixed points to the same height according to the fixed-point theory. Then, the optimum damping ratio is formulated by minimizing the maximum value of the amplitude-frequency curves according tooptimization principle. According to the characteristics of negative stiffness element, the optimum negative stiffness ratio is also established and it could still keep the system stable. In the end, the comparison between the analytical and the numerical solutions verifies the correctness of the analytical solution. The comparisons with three other traditional DVAs under the harmonic and random excitations show that the presented DVA performs better in vibration absorption. This result could provide theoretical basis for optimum parameters design of similar DVAs.