Alexandru-Sabin Bana
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alexandru-Sabin Bana has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Petar Popovski
4 shared publicationsElisabeth De Carvalho
Aalborg University,Department of Electronic Systems,Denmark
2 shared publicationsElisabeth de Carvalho
2 shared publications- Elisabeth de Carvalho
Department of Electronic Systems, Aalborg University, Aalborg, Denmark
2 shared publications - Jimmy Jessen Nielsen
Department of Electronic Systems, Aalborg University, Aalborg, Denmark
2 shared publications - Kasper Floe Trillingsgaard
Department of Electronic Systems, Aalborg University, Denmark
2 shared publications
Latest Publications
- 1 December 2019
- Published by Elsevier in Physical Communication
- Vol. 37
Massive MIMO for Internet of Things (IoT) connectivity
- 1 December 2019
- Published by Elsevier in Physical Communication
- Vol. 37
Massive MIMO for Internet of Things (IoT) connectivity
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1394-1398
Outage Analysis of Downlink URLLC in Massive MIMO systems with Power Allocation
Massive MIMO is seen as a main enabler for low- latency communications, thanks to its high spatial degrees of freedom. The channel hardening and favorable propagation properties of Massive MIMO are particularly important for multiplexing several URLLC devices. However, the actual utility of channel hardening and spatial multiplexing is dependent critically on the accuracy of channel knowledge. When several low- latency devices are multiplexed, the cost for acquiring accurate knowledge becomes critical, and it is not evident how many devices can be served with a latency-reliability requirement and how many pilot symbols should be allocated. This paper investigates the trade-off between achieving high spectral efficiency and high reliability in the downlink, by employing various power allocation strategies, for maximum ratio and minimum mean square error precoders. The results show that using max-min SINR power allocation achieves the best reliability, at the expense of lower sum spectral efficiency.
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1394-1398
Outage Analysis of Downlink URLLC in Massive MIMO systems with Power Allocation
Massive MIMO is seen as a main enabler for low- latency communications, thanks to its high spatial degrees of freedom. The channel hardening and favorable propagation properties of Massive MIMO are particularly important for multiplexing several URLLC devices. However, the actual utility of channel hardening and spatial multiplexing is dependent critically on the accuracy of channel knowledge. When several low- latency devices are multiplexed, the cost for acquiring accurate knowledge becomes critical, and it is not evident how many devices can be served with a latency-reliability requirement and how many pilot symbols should be allocated. This paper investigates the trade-off between achieving high spectral efficiency and high reliability in the downlink, by employing various power allocation strategies, for maximum ratio and minimum mean square error precoders. The results show that using max-min SINR power allocation achieves the best reliability, at the expense of lower sum spectral efficiency.
- Top Cited PapersOpen Access
- 3 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 67 (8) , 5783-5801
Wireless Access in Ultra-Reliable Low-Latency Communication (URLLC)
The future connectivity landscape and, notably, the 5G wireless systems will feature Ultra-Reliable Low Latency Communication (URLLC). The coupling of high reliability and low latency requirements in URLLC use cases makes the wireless access design very challenging, in terms of both the protocol design and of the associated transmission techniques. This paper aims to provide a broad perspective on the fundamental tradeoffs in URLLC, as well as the principles used in building access protocols. Two specific technologies are considered in the context of URLLC: massive MIMO and multi-connectivity, also termed interface diversity. The paper also touches upon the important question of the proper statistical methodology for designing and assessing extremely high reliability levels.
- 3 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 67 (8) , 5783-5801
Top Cited PapersOpen AccessWireless Access in Ultra-Reliable Low-Latency Communication (URLLC)
The future connectivity landscape and, notably, the 5G wireless systems will feature Ultra-Reliable Low Latency Communication (URLLC). The coupling of high reliability and low latency requirements in URLLC use cases makes the wireless access design very challenging, in terms of both the protocol design and of the associated transmission techniques. This paper aims to provide a broad perspective on the fundamental tradeoffs in URLLC, as well as the principles used in building access protocols. Two specific technologies are considered in the context of URLLC: massive MIMO and multi-connectivity, also termed interface diversity. The paper also touches upon the important question of the proper statistical methodology for designing and assessing extremely high reliability levels.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 188-192
Ultra Reliable Low Latency Communications in Massive Multi-Antenna Systems
Large number of antennas in Massive MIMO offer a significant spatial diversity, which makes them an attractive possibility for use in wireless settings that require very high reliability. However, in 5G ultra-reliability is coupled with low latency into ultra-reliable low-latency communications (URLLC). This is very challenging as an efficient use of Massive MIMO depends critically on training, which consumes significant resources when the latency requirement is very tight. In this paper we address this problem by exploiting the sparsity of the propagation channel and therefore rely on estimation of a small number of instantaneous channel coefficients. This leads to robust beamforming and departs from the conventional use of the instantaneous channel state information (CSI) at each transmit antenna. We compare the performance of maximum ratio transmission based on the conventional least-squares estimation of all channel coefficients and the one based on the estimation of the fading coefficients of the channel features i.e. the singular vectors of the covariance matrix. The singular vectors are assumed known and unchangeable over a long term. The results show that this approach makes massive MIMO a feasible technology in URLLC scenarios.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 188-192
Ultra Reliable Low Latency Communications in Massive Multi-Antenna Systems
Large number of antennas in Massive MIMO offer a significant spatial diversity, which makes them an attractive possibility for use in wireless settings that require very high reliability. However, in 5G ultra-reliability is coupled with low latency into ultra-reliable low-latency communications (URLLC). This is very challenging as an efficient use of Massive MIMO depends critically on training, which consumes significant resources when the latency requirement is very tight. In this paper we address this problem by exploiting the sparsity of the propagation channel and therefore rely on estimation of a small number of instantaneous channel coefficients. This leads to robust beamforming and departs from the conventional use of the instantaneous channel state information (CSI) at each transmit antenna. We compare the performance of maximum ratio transmission based on the conventional least-squares estimation of all channel coefficients and the one based on the estimation of the fading coefficients of the channel features i.e. the singular vectors of the covariance matrix. The singular vectors are assumed known and unchangeable over a long term. The results show that this approach makes massive MIMO a feasible technology in URLLC scenarios.
- Top Cited Papers
- 2 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Network
- Vol. 32 (2) , 16-23
Wireless Access for Ultra-Reliable Low-Latency Communication: Principles and Building Blocks
URLLC is an important new feature brought by 5G, with a potential to support a vast set of applications that rely on mission-critical links. In this article, we first discuss the principles for supporting URLLC from the perspective of the traditional assumptions and models applied in communication/information theory. We then discuss how these principles are applied in various elements of system design, such as use of various diversity sources, design of packets, and access protocols. The important message is that there is a need to optimize the transmission of signaling information, as well as a need for lean use of various sources of diversity.
- 2 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Network
- Vol. 32 (2) , 16-23
Top Cited PapersWireless Access for Ultra-Reliable Low-Latency Communication: Principles and Building Blocks
URLLC is an important new feature brought by 5G, with a potential to support a vast set of applications that rely on mission-critical links. In this article, we first discuss the principles for supporting URLLC from the perspective of the traditional assumptions and models applied in communication/information theory. We then discuss how these principles are applied in various elements of system design, such as use of various diversity sources, design of packets, and access protocols. The important message is that there is a need to optimize the transmission of signaling information, as well as a need for lean use of various sources of diversity.
- Open Access
- 1 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 6608-6612
Short Packet Structure for Ultra-Reliable Machine-Type Communication: Tradeoff between Detection and Decoding
Machine-type communication requires rethinking of the structure of short packets due to the coding limitations and the significant role of the control information. In ultra-reliable low-latency communication (URLLC), it is crucial to optimally use the limited degrees of freedom (DoFs) to send data and control information. We consider a URLLC model for short packet transmission with acknow 1-edgement (ACK). We compare the detection/decoding performance of two short packet structures: (1) time-multiplexed detection sequence and data; and (2) structure in which both packet detection and data decoding use all DoFs. Specifically, as an instance of the second structure we use superimposed sequences for detection and data. We derive the probabilities of false alarm and misdetection for an AWGN channel and numerically minimize the packet error probability (PER), showing that for delay-constrained data and ACK exchange, there is a tradeoff between the resources spent for detection and decoding. We show that the optimal PER for the superimposed structure is achieved for higher detection overhead. For this reason, the PER is also higher than in the preamble case. However, the superimposed structure is advantageous due to its flexibility to achieve optimal operation without the need to use multiple codebooks.
- 1 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 6608-6612
Open AccessShort Packet Structure for Ultra-Reliable Machine-Type Communication: Tradeoff between Detection and Decoding
Machine-type communication requires rethinking of the structure of short packets due to the coding limitations and the significant role of the control information. In ultra-reliable low-latency communication (URLLC), it is crucial to optimally use the limited degrees of freedom (DoFs) to send data and control information. We consider a URLLC model for short packet transmission with acknow 1-edgement (ACK). We compare the detection/decoding performance of two short packet structures: (1) time-multiplexed detection sequence and data; and (2) structure in which both packet detection and data decoding use all DoFs. Specifically, as an instance of the second structure we use superimposed sequences for detection and data. We derive the probabilities of false alarm and misdetection for an AWGN channel and numerically minimize the packet error probability (PER), showing that for delay-constrained data and ACK exchange, there is a tradeoff between the resources spent for detection and decoding. We show that the optimal PER for the superimposed structure is achieved for higher detection overhead. For this reason, the PER is also higher than in the preamble case. However, the superimposed structure is advantageous due to its flexibility to achieve optimal operation without the need to use multiple codebooks.