SMSapna Mudgal

Sapna Mudgal

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sapna Mudgal has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Nickel Oxide Hole‐Selective Heterocontact for Silicon Solar Cells: Role of SiOx Interlayer on Device Performance

    by Mrutyunjay Nayak, Sourav Mandal, Ashutosh Pandey, Sapna Mudgal, Sonpal Singh, Vamsi K. Komarala

    Carrier‐selective contact‐based silicon heterojunction solar cells are fabricated using nickel oxide (NiOx) as a hole‐selective layer by thermal evaporation. The highest power conversion efficiency of ≈15.20% with a chemically grown SiOx interlayer is achieved from a Ag/ITO/NiOx/n‐Si/LiFx/Al cell structure in comparison with ≈12.43% without SiOx. The cells without and with the SiOx layer are analyzed by considering crucial parameters for conversion efficiency, such as minority carriers' diffusion lengths, lifetimes, recombination resistance, and density of interface defect states at the NiOx/n‐Si junction, by studying the dark/light current density–voltage, quantum efficiency, impedance, and parallel conductance characteristics. Device analysis provides evidence for the cell's open‐circuit voltage and short‐circuit current enhancement with the SiOx interlayer. This is due to an improvement in minority carrier lifetimes from ≈8.6 to ≈48.27 μs (photo‐conductance decay analysis), which is also estimated from ≈7.45 to ≈49.20 μs by impedance spectra analysis, increased minority carrier diffusion length from ≈171 to ≈952 μm, and decreased rear surface recombination velocity from ≈1106 to ≈170 cm s−1 (quantum efficiency analysis). These investigations reveal that engineering the n‐Si/LiFx interface by the SiOx interlayer is more important than the NiOx/n‐Si interface because of a thin unintentionally grown SiOx layer during NiOx evaporation simultaneously mediating silicon surface passivation.


  • Investigation of Electrical Parameters of Amorphous–Crystalline Silicon Heterojunction Solar Cells: Correlations Between Carrier Dynamics and S-Shape of Current Density–Voltage Curve

    by Sapna Mudgal, Sonpal Singh, Vamsi Krishna Komarala

    We have analyzed a-Si:H(p)/a-Si:H(i)/c-Si(n) heterojunction silicon solar cell having the S-shaped current density–voltage characteristics with a low fill factor and open-circuit voltage, using quantum efficiency (QE) characterization technique under forward/reverse voltage and different light (blue, infrared, and white) bias conditions. The curvature of S-shape is sensitive to excitation light intensities because of modification in junction barrier potential (variation in quasi-Fermi levels splitting). With forward-bias voltage alone near/above S-shaped region, cell's QE is uniformly reduced because of reduction in junction field and dominance of barrier for collection of holes. However, with blue and white light at bias voltages close to S-shaped characteristics, a uniform improvement of QE in broad wavelength region is observed because of defects saturation at the junction interface and photoconductivity in the a-Si layers. With white light and voltage bias, cell's QE is anomalously improved and it has even crossed the QE response at no voltage/light bias conditions in the blue region because of defects saturation in a-Si:H layers, whereas under infrared light and voltage bias conditions defect saturation is not displayed in the QE because of carrier generation in a deeper region of the cell after crossing unabsorbed photons front region.