Georgios Varnavides

Linear phase‐contrast scanning transmission electron microscopy (STEM) techniques compatible with high‐throughput 4D‐STEM acquisition are widely used to enhance phase contrast in weakly scattering and beam‐sensitive materials. In these modalities, contrast transfer is often suppressed at low spatial frequencies, resulting in a characteristic contrast gap that limits contrast. Approaches that retain low‐frequency phase contrast exist but typically require substantially increased experimental complexity, restricting routine use. Dark‐field STEM imaging captures this missing low‐frequency information through electrons scattered outside the bright‐field disk, but discards a large fraction of the scattered signal and is therefore dose‐inefficient. Fused Full‐field STEM (FF‐STEM) is introduced as a 4D‐STEM imaging modality that overcomes these limitations by combining ptychographic phase reconstruction with tilt‐corrected dark‐field imaging within a single acquisition. Bright‐field data are used to estimate probe aberrations and reconstruct a high‐resolution phase image, while dark‐field data provide complementary low‐frequency contrast. The two channels are fused in Fourier space using Wiener‐band weighting based on the spectral signal‐to‐noise ratio, yielding transfer‐gap‐free images with high contrast. FF‐STEM preserves the upsampling and depth‐sectioning capabilities of ptychography, adds robust low‐frequency contrast characteristic of dark‐field imaging, and enables dose‐efficient, near–real‐time reconstruction.

The contrast transfer function (CTF) is widely used to evaluate phase retrieval methods in scanning transmission electron microscopy (STEM), including center-of-mass imaging, parallax imaging, direct ptychography, and iterative ptychography. However, the CTF reflects only the maximum usable signal, neglecting the effects of finite electron fluence and the Poisson-limited nature of detection. As a result, it can significantly overestimate practical performance, especially in low-dose regimes. Here, we employ the spectral signal-to-noise ratio (SSNR), as a finite-dose statistical framework to evaluate the recoverable signal as a function of spatial frequency. Using numerical reconstructions of white-noise objects, we show that center-of-mass, parallax, and direct ptychography exhibit dose-independent SSNRs, with close-form analytic expressions. In contrast, iterative ptychography exhibits a surprising dose dependence: at low fluence, its SSNR converges to that of direct ptychography; at high fluence, it saturates at a value consistent with the maximum detective quantum efficiency predicted by recent quantum Fisher information bounds. The results highlight the limitations of CTF-based evaluation and motivate SSNR as a more accurate, finite-dose metric for assessing STEM phase retrieval methods.

Surface structure affects the growth, shape and properties of nanoparticles. In wet chemical syntheses, metal additives and surfactants are used to modify surfaces and guide nanocrystal growth. To understand this process, it is critical to understand how the surface structure, and hence its energy, is modified. However, measuring the type and arrangement of atoms at hard-soft interfaces on nanoscale surfaces, especially in the presence of surfactants, is extremely challenging. Here, we determine the atomic structure of the hard-soft interface in a metallic nanoparticle by developing low-dose imaging conditions in four-dimensional scanning transmission electron microscopy that are preferentially sensitive to surface adatoms. By revealing experimentally the copper additives and bromide surfactant counterion at the surface of a gold nanocuboid and quantifying their interatomic distances, our direct, low-dose imaging method provides atomic-level understanding of chemically sophisticated nanomaterial surface structures. These measurements of the atomic structure of the hard-soft interface provide the information necessary to understand and quantify surface chemistries and energies and their pivotal role in nanocrystal growth.

Electron cryo-tomography (cryo-ET) enables 3D imaging of complex, radiation-sensitive structures with molecular detail. However, image contrast from the interference of scattered electrons is nonlinear with atomic density and multiple scattering further complicates interpretation. These effects degrade resolution, particularly in conventional reconstruction algorithms, which assume linearity. Particle averaging can reduce such issues but is unsuitable for heterogeneous or dynamic samples ubiquitous in biology, chemistry, and materials sciences. Here, we develop a phase retrieval-based cryo-ET method, PhaseT3M. We experimentally demonstrate its application to an approximately 7 nm Co₃O₄ nanoparticle on an approximately 30 nm carbon substrate, achieving a maximum resolution of 1.6 Å, surpassing conventional limits using standard cryo-TEM equipment. PhaseT3M uses a multislice model for multiple scattering and Bayesian optimization for alignment and computational aberration correction, with a positivity constraint to recover ‘missing wedge’ information. Applied directly to biological particles, it enhances reconstruction quality and reduces artifacts, establishing a standard for routine 3D imaging with phase contrast.

Considerable inroads have recently been made on algorithms to determine the sample potential from four-dimensional scanning transmission electron microscopy data from thick samples where multiple scattering cannot be neglected. This paper further develops the scattering matrix approach to such structure determination. Through simulation, we demonstrate how this approach can be modified to better handle partial spatial coherence, unknown probe defocus, and information from the dark field region. By combining these developments we reconstruct the electrostatic potential of a monolithic SrTiO3 crystal showing good quantitative agreement with the expected structure.

Phase retrieval methods in scanning transmission electron microscopy (STEM) recover scattered phase information from far-field intensity measurements of a converged electron probe. We evaluate the performance of various phase retrieval techniques – including center-of-mass imaging (COM), tilt-corrected bright-field STEM (tcBF), and direct ptychographic methods such as single-side band (SSB) and Wigner distribution deconvolution (WDD) – under different experimental conditions. Through analytical derivation of contrast transfer functions (CTF) under the weak phase-object approximation and numerical validation using white-noise samples, we assess the impact of scan sampling, illumination aberrations, and detector geometries. Based on these findings, we develop a novel direct ptychographic algorithm that combines the relaxed scan-sampling advantages of tcBF while avoiding CTF zero-crossings through SSB recovery. Our analysis reveals fundamental limitations in using CTF as a performance metric and demonstrates the advantages of dose-invariant spectral signal-to-noise ratio (SSNR) for evaluating phase retrieval methods.

Electron cryo-tomography (cryo-ET) enables 3D imaging of complex, radiation-sensitive structures with molecular detail. However, image contrast from the interference of scattered electrons is nonlinear with atomic density and multiple scattering further complicates interpretation. These effects degrade resolution, particularly in conventional reconstruction algorithms, which assume linearity. Particle averaging can reduce such issues but is unsuitable for heterogeneous or dynamic samples ubiquitous in biology, chemistry, and materials sciences. Here, we develop a phase retrieval-based cryo-ET method, PhaseT∃M. We experimentally demonstrate its application to a ~7 nm Co3O4 nanoparticle on ~30 nm carbon substrate, achieving a maximum resolution of 1.6 Å, surpassing conventional limits using standard cryo-TEM equipment. PhaseT∃M uses a multislice model for multiple scattering and Bayesian optimization for alignment and computational aberration correction, with a positivity constraint to recover 'missing wedge' information. Applied directly to biological particles, it enhances resolution and reduces artifacts, establishing a new standard for routine 3D imaging of complex, radiation-sensitive materials.

Magnetic materials phase reconstruction using Lorentz transmission electron microscopy (LTEM) measurements have traditionally been achieved using longstanding methods such as off-axis holography (OAH) fast-Fourier transform technique and the transport-of-intensity equation (TIE). The increase in access to processing power alongside the development of advanced algorithms have allowed for phase retrieval of nanoscale magnetic materials with greater efficacy and resolution. Specifically, reverse-mode automatic differentiation (RMAD) and the extended electron ptychography iterative engine (ePIE) are two recent developments of phase retrieval that can be applied to analyzing micro-to-nano- scale magnetic materials. This work evaluates phase retrieval using TIE, RMAD, and ePIE in simulations of Permalloy (Ni₈₀Fe₂₀) nanoscale islands, or nanomagnets. Extending beyond simulations, we demonstrate total phase retrieval and image reconstructions of a NiFe nanowire using OAH and RMAD in LTEM and ePIE in Lorentz-mode-4D scanning transmission electron microscopy experiments and determine the saturation magnetization through corroborations with micromagnetic modeling. Finally, we demonstrate the efficacy of these methods in retrieving the total phase and highlight its use in characterizing and analyzing the proximity effect of the magnetic nanostructures.